Volatilization and degradation of soil-applied dimethylselenide

Dimethylselenide (DMSe) is a highly volatile gas that is produced by indigenous microorganisms in seleniferous soils and sediments; however, little is known about the soil conditions that affect the persistence of DMSe and its transport to the atmosphere. In this study we investigated the effect of moisture content, temperature, and organic amendments on the degradation of soil-applied DMSe. The degradation of DMSe was entirely a result of biological mechanisms, but changes in temperature (20-40 degrees C) and soil moisture content (30-70% of the maximum water holding capacity) had little influence on the degradation rate. In contrast, amending soil with either 1% casein or gluten (by weight) had an inhibitory effect on the degradation of DMSe. After 18 d, 2.1 times more DMSe was present in the casein-amended soil and 2.6 times more DMSe was present in the gluten-amended soil. The transport of DMSe in packed soil columns was also investigated. Increasing the depth to soil surface was found to significantly decrease the amount of DMSe transported to the air. After 6 d, 57% of DMSe injected 10 cm below the soil surface was volatilized. At an injection depth of 20 cm the cumulative emissions were reduced by 38% and at 30 cm the cumulative emissions were reduced by 51%. In columns containing 1% casein or gluten in the top 5 cm of soil the cumulative loss of DMSe was about 9% higher than in unamended soil. Increasing our understanding of the soil conditions that influence the gaseous diffusion of DMSe should help in determining the feasibility of using Se volatilization as a remediation technique.     

Retooling the ethanol industry: thermophilic anaerobic digestion of thin stillage for methane production and pollution prevention.

Anaerobic digestion of corn ethanol thin stillage was tested at thermophilic temperature (55 degrees C) with two completely stirred tank reactors. The thin stillage wastestream was organically concentrated with 100 g/L total chemical oxygen demand and 60 g/L volatiles solids and a low pH of approximately 4.0. Steady-state was achieved at 30-, 20-, and 15-day hydraulic retention times (HRTs) and digester failure at a 12-day HRT. Significant reduction of volatile solids was achieved, with a maximum reduction (89.8%) at the 20-day HRT. Methane yield ranged from 0.6 to 0.7 L methane/g volatile solids removed during steady-state operation. Effluent volatile fatty acids below 200 mg/L as acetic acid were achieved at 20- and 30-day HRTs. Ultrasonic pretreatment was used for one digester, although no significant improvement was observed. Ethanol plant natural gas consumption could be reduced 43 to 59% with the methane produced, while saving an estimated $7 to $17 million ($10 million likely) for a facility producing 360 million L ethanol/y.     

SPATIAL DISTRIBUTION OF POINT SOIL MOISTURE ESTIMATES USING LANDSAT TM DATA AND FUZZY-C CLASSIFICATION1

ABSTRACT: Many hydrologic models have input data requirements that are difficult to satisfy for all but a few well-instrumented, experimental watersheds. In this study, point soil moisture in a mountain watershed with various types of vegetative cover was modeled using a generalized regression model. Information on sur-ficial characteristics of the watershed was obtained by applying fuzzy set theory to a database consisting of only satellite and a digital elevation model (DEM). The fuzzy-c algorithm separated the watershed into distinguishable classes and provided regression coefficients for each ground pixel. The regression model used the coefficients to estimate distributed soil moisture over the entire watershed. A soil moisture accounting model was used to resolve temporal differences between measurements at prototypical measurement sites and validation sites. The results were reasonably accurate for all classes in the watershed. The spatial distribution of soil moisture estimates corresponded accurately with soil moisture measurements at validation sites on the watershed. It was concluded that use of the regression model to distribute soil moisture from a specified number of points can be combined with satellite and DEM information to provide a reasonable estimation of the spatial distribution of soil moisture for a watershed.     

Prompting safety-belt use in the context of a belt-use law: the flash-for life revisited

PROBLEM: Safety-belt use reduces motor vehicle crash-related morbidity and mortality, yet an estimated 18% of drivers do not consistently buckle up (NHTSA, 2005). In 1985, Geller and colleagues developed an interpersonal Flash-for-Life prompt that increased belt use among 22% of 1,087 unbuckled drivers (Geller, Bruff, & Nimmer, 1985). METHOD: The Flash-for-Life intervention was re-introduced at a large university with high safety-belt use (i.e., 80%). College students stood at parking-lot entrance/exits and "flashed" signs with the message, "Please Buckle Up, I Care" to unbuckled drivers. RESULTS: Of 427 unbuckled drivers observed, 30% of these complied with the prompt. Male drivers were significantly more likely to comply with prompts delivered by females. DISCUSSION: Compliance was higher than in the 1985 study, indicating a high baseline rate of safety-belt use does not negate potential beneficial influence of a prompting intervention. This intervention is particularly effective with college-aged males, a sub-group of the driving population least likely to buckle-up. IMPACT ON INDUSTRY: A simple behavioral prompt could be used at most industrial complexes to increase safety-belt use among vehicle occupants who are not buckled-up.     

Preparing future engineers for challenges of the 21st century: Sustainable engineering

The field of engineering is changing rapidly as the growing global population puts added demands on the earth's resources: engineering decisions must now account for limitations in materials and energy as well as the need to reduce discharges of wastes. This means educators must revise courses and curricula so engineering graduates are prepared for the new challenges as practicing engineers. The Center for Sustainable Engineering has been established to help faculty members accommodate such changes through workshops and new educational materials, including a free access website with peer-reviewed materials.     

Household disposal of pharmaceuticals: attitudes and risk perception in a UK sample

Pharmaceuticals can enter the environment through disposal in toilets, sinks and general waste. In the UK, household medicines are correctly disposed of by returning them to a pharmacy. This study examined household patterns of medicine waste, storage and disposal practices via a cross-sectional survey with 663 UK adults. Multiple regression was used to explore the contribution of key variables on self-reported medicines disposal behaviour. Analysis demonstrated that age, information, awareness, probability, attitude and intention all predicted correct disposal behaviour. Results indicate that multiple factors influence different disposal destinations uniquely. Affect and age increase disposal in sink/toilet but reduce disposal in bin. Presence of children increase bin and sink/toilet disposal but decrease pharmacy returns. Awareness and received information on correct disposal reduce bin disposal and increase pharmacy returns. The results suggest people use different mental models for each destination with disposal in sink/toilets and bins considered quicker and safer in the presence of children or for those feeling anxious. It is important to understand the capability, opportunity and motivation people have to return medicines to the pharmacy in addition to raising awareness of correct medicine disposal.

     

Bioreduction of nitrate in groundwater using a pilot-scale hydrogen-based membrane biofilm reactor

A long-term pilot-scale H₂-based membrane biofilm reactor (MBfR) was tested for removal of nitrate from actual groundwater. A key feature of this second-generation pilot MBfR is that it employed lower cost polyester hollow fibers and still achieved high loading rate. The steady-state maximum nitrate surface loading at which the effluent nitrate and nitrite concentrations were below the Maximum Contaminant Level (MCL) was at least 5.9 g·N·(m²·d)^?1, which corresponds to a maximum volumetric loading of at least 7.7 kg·N·(m³·d) ^?1. The steady-state maximum nitrate surface area loading was higher than the highest nitrate surface loading reported in the first-generation MBfRs using composite fibers (2.6 g·N·(m²·d)^?1). This work also evaluated the H₂-utilization efficiency in MBfR. The measured H₂ supply rate was only slightly higher than the stoichiometric H₂-utilization rate. Thus, H₂ utilization was controlled by diffusion and was close to 100% efficiency, as long as biofilm accumulated on the polyester-fiber surface and the fibers had no leaks.     

A performance estimate for the detection of undeclared nuclear-fuel reprocessing by atmospheric 85Kr

To test the sensitivity of using atmospheric (85)Kr to detect undeclared separation of plutonium from irradiated nuclear-reactor fuel, measurements of atmospheric (85)Kr taken in Tsukuba, Japan are analyzed to determine: (1) a lower limit of detection for discovering anthropogenic (85)Kr emissions, (2) the probability of detecting plutonium separation at the Tokai Reprocessing Plant, and (3) the extent to which these results can be generalized to other sites. A LLD of at least 3.4 sigma=0.14 Bq/m(3) with a theoretical false-positive rate of 0.05% is recommended for safeguards' purposes. At this threshold, the continuous separation of 100, 300, and 900 g equivalent weapon-grade plutonium per day was found to correspond to 10%, 50%, and 80% probability of detection, respectively. The smallest detected concentration was for the continuous separation of 45 g/day, with a probability of detection of about 0.6%. It was found that the detection rate is determined predominantly by the weather.     

Predicting methyl iodide emission, soil concentration, and pest control in a two-dimensional chamber system

Due to ever-increasing state and federal regulations, the future use of fumigants is predicted on reducing negative environmental impacts while offering sufficient pestcontrol efficacy. To foster the development of a best management practice, an integrated tool is needed to simultaneously predict fumigant movement and pest control without having to conduct elaborate and costly experiments. The objective of this study was (i) to present a two-dimensional (2-D) mathematical model to describe both fumigant movement and pestcontrol and (ii) to evaluate the model by comparing the simulated and observed results. Both analytical and numerical methods were used to predict methyl iodide (MeI) transport and fate. To predict pest control efficacy, the concentration-time index (CT) was defined and a two-parameter logistic survival model was used. Dose-response curves were experimentally determined for MeI against three types of pests (barnyardgrass [Echinochloa crus-galli] seed, citrus nematode [Tylenchulus semipenetrans], and fungi [Fusarium oxysporum]). Methyl iodide transport and pest control measurements collected from a 2-D experiimental system (60 by 60 cm) were used to test the model. Methyl iodide volatilization rates and soil gas-phase concentrations over time were accurately simulated by the model. The mass balance analysis indicates that the fraction of MeI degrading in the soil was underestimated when determined by the appearance of iodide concentration. The experimental results showed that after 24 h of MeI fumigation in the 2-D soil chamber, fungal population was not suppressed; > 90% of citrus nematodes were killed; and barnyardgrass seeds within 20-cm distance from the center were affected. These experimental results were consistent with the predicted results. The model accurately estimated the MeI movement and control of various pests and is a powerful tool to evaluate pesticides in terms of their negative environmental impacts and pest control under various environmental conditions and application methods.