OPERATING POLICIES FOR A SURFACE/GROUND WATER SYSTEM1

The simulation of the conjunctive use of a surface reservoir and a limestone aquifer is described. The potential yields from each of the sources are of the same order. An important feature of the aquifer is that if the pumpage is reduced, much of the excess water is lost through springs. Five different operating policies are considered which determine whether pumpage should be taken from the reservoir or aquifer. The total safe yields for the historic period 1961–1977 are estimated for each policy and their relative advantages and disadvantages are discussed. The simulation is also carried out for 100 years of generated data to discover the long term consequences.     

Deposition and removal of fugitive dust in the arid southwestern United States: measurements and model results

This work was motivated by the need to better reconcile emission factors for fugitive dust with the amount of geologic material found on ambient filter samples. The deposition of particulate matter with aerodynamic diameter less than or equal to 10 microm (PM10), generated by travel over an unpaved road, over the first 100 m of transport downwind of the road was examined at Ft. Bliss, near El Paso, TX. The field conditions, typical for warm days in the arid southwestern United States, represented sparsely vegetated terrain under neutral to unstable atmospheric conditions. Emission fluxes of PM10 dust were obtained from towers downwind of the unpaved road at 7, 50, and 100 m. The horizontal flux measurements at the 7 m and 100 m towers indicated that PM10 deposition to the vegetation and ground was too small to measure. The data indicated, with 95% confidence, that the loss of PM10 between the source of emission at the unpaved road, represented by the 7 m tower, and a point 100 m downwind was less than 9.5%. A Gaussian model was used to simulate the plume. Values of the vertical standard deviation sigma(z) and the deposition velocity Vd were similar to the U.S. Environmental Protection Agency (EPA) ISC3 model. For the field conditions, the model predicted that removal of PM10 unpaved road dust by deposition over the distance between the point of emission and 100 m downwind would be less than 5%. However, the model results also indicated that particles larger than 10 microm (aerodynamic diameter) would deposit more appreciably. The model was consistent with changes observed in size distributions between 7 m and 100 m downwind, which were measured with optical particle counters. The Gaussian model predictions were also compared with another study conducted over rough terrain and stable atmospheric conditions. Under such conditions, measured PM10 removal rates over 95 m of downwind transport were reported to be between 86% and 89%, whereas the Gaussian model predicted only a 30% removal. One explanation for the large discrepancy between measurements and model results was the possibility that under the conditions of the study, the dust plume was comparable in vertical extent to the roughness elements, thereby violating one of the model assumptions. Results of the field study reported here and the previous work over rough terrain bound the extent of particle deposition expected to occur under most unpaved road emission scenarios.     

EIA training courses organized by the centre for environmental management and planning,University of Aberdeen: An analysis of experience

In 1980, the World Health Organization (Regional Office for Europe) invited The Centre for Environmental Management and Planning (CEMP) to organize a two-week training course on Environmental Impact Assessment (EIA) to provide a comprehensive introduction to EIA with emphasis on methods and techniques for impact identification, prediction and assessment. Not suprisingly the topic of environmental health impact assessment was to be a major focus. Since 1980, the course has been held each year at the University of Aberdeen. An analysis of participation in the course during its first five years yields several impressions about the success of this training effort and the ways in which it might be improved.     

Modeling future land cover and water quality change in Minneapolis,MN, USA to support drinking water source protection decisions

Continued alteration of the nitrogen cycle exposes receiving waters to elevated nitrogen concentrations and forces drinking water treatment services to plan for such increases in the future. We developed four 2011–2050 land cover change scenarios and modeled the impact of projected land cover change on influent water quality to support long-term planning for the Minneapolis Water Treatment Distribution Service (MWTDS) using Soil Water and Assessment Tool. Projected land cover changes based on relatively unconstrained economic growth led to substantial increases in total nitrogen (TN) loads and modest increases in total phosphorus (TP) loads in spring. Changes in sediment, TN, and TP under two “constrained” growth scenarios were near zero or declined modestly. Longitudinal analysis suggested that the extant vegetation along the Mississippi River corridor upstream of the MWTDS may be a sediment (and phosphorus) trap. Autoregressive analysis of current (2008–2017) chemical treatment application rates (mass per water volume processed) and extant (2001–2011) land cover change revealed that statistically significant increases in chemical treatment rates were temporally congruent with urbanization and conversion of pasture to cropland. Using the current trend in chemical treatment application rates and their inferred relationship to extant land cover change as a bellwether, the unconstrained growth scenarios suggest that future land cover may present challenges to the production of potable water for MWTDS.     

Kelp as a Bioindicator: Does it Matter Which Part of 5 M Long Plant is Used for Metal Analysis?

Kelp may be useful as a bioindicator because they are primary producers that are eaten by higher trophic level organisms, including people and livestock. Often when kelp or other algae species are used as bioindicators, the whole organism is homogenized. However, some kelp can be over 25 m long from their holdfast to the tip of the blade, making it important to understand how contaminant levels vary throughout the plant. We compared the levels of arsenic, cadmium, chromium, lead, manganese, mercury and selenium in five different parts of the kelp Alaria nana to examine the variability of metal distribution. To be useful as a bioindicator, it is critical to know whether levels are constant throughout the kelp, or which part is the highest accumulator. Kelp were collected on Adak Island in the Aleutian Chain of Alaska from the Adak Harbor and Clam Cove, which opens onto the Bering Sea. In addition to determining if the levels differ in different parts of the kelp, we wanted to determine whether there were locational or size-related differences. Regression models indicated that between 14% and 43% of the variation in the levels of arsenic, cadmium, chromium, manganese, mercury, and selenium was explained by total length, part of the plant, and location (but not for lead). The main contributors to variability were length (for arsenic and selenium), location (mercury), and part of the plant (for arsenic, cadmium, chromium and manganese). The higher levels of selenium occurred at Clam Cove, while mercury was higher at the harbor. Where there was a significant difference among parts, the holdfast had the highest levels, although the differences were not great. These data indicate that consistency should be applied in selecting the part of kelp (and the length) to be used as a bioindicator. While any part of Alaria could be collected for some metals, for arsenic, cadmium, chromium, and manganese a conversion should be made among parts. In the Aleutians the holdfast can be perennial while the blade, whipped to pieces by winter wave action, is regrown each year. Thus the holdfast may be used for longer-term exposure for arsenic, cadmium, chromium and manganese, while the blade can be used for short-term exposure for all metals. Cadmium, lead and selenium were at levels that suggest that predators, including people, may be at risk from consuming Alaria. More attention should be devoted to heavy metal levels in kelp and other algae from Adak, particularly where they may play a role in a subsistence diets.     

Managing Baltic Sea fisheries under contrasting production and predation regimes: ecosystem model analyses

Based on an earlier published ecosystem model, we have explored possible effects of different management scenarios for the Baltic Sea. The scenarios include an oligotrophication of the system, a drastic increase in the number of seals, and changes in the fishery management. From these simulations we conclude that fisheries, seals, and eutrophication all have strong and interacting impacts on the ecosystem. These interactions call for integrated management. The modeling highlights the potential for conflicts among management mandates such as flourishing fisheries, rebuilt seal populations, and substantially reduced eutrophication. The results also suggest that fisheries management reference points have to be adjusted in response to changes in the presence of natural predators or ecosystem productivity.     

The three-dimensional structure of 3, 3', 5'-trichloro-4-methoxybiphenyl, a "coplanar" polychlorinated biphenyl (PCB) derivative

The crystal structure of a "coplanar" polychlorinated biphenyl (PCB) derivative, 4-methoxy-3, 3', 5'-trichlorobiphenyl (C13H9Cl3O), is described. The torsion angle of the title compound is 41.31(07) degrees, which is in good agreement with the calculated torsion angle of 38.2 degrees in aqueous solution.     

Interactions between morphological and physiological plasticity optimize energy acquisition in corals

Morphological plasticity in response to environmental heterogeneity may be performance enhancing or may simply result from an intrinsic instability in morphology during development. Although patterns of morphological change are well documented for numerous taxa, it is often unclear whether this plasticity enhances the performance of organisms in the habitat to which they have acclimatized. Reef-building corals are an ideal model system in which to investigate this question. We here develop a three-dimensional geometric model and present a comprehensive photosynthesis data set with experimentally calibrated photosynthesis models that predicts energy acquisition by foliose corals as a function of colony shape. This allows us to assess the extent to which changes in colony morphology along an environmental gradient track the predicted optimal colony morphologies. Our results provide strong evidence that phenotypic plasticity in foliose corals optimizes photosynthetic energy acquisition and is not simply a mechanism to increase light capture. We show that the optimal morphology is constrained at the boundaries of the environmental gradient, with non-optimal morphologies in these habitats having greatly reduced energy acquisition. However, at the center of the environmental gradient, flexibility in photophysiology allows energy acquisition to be very similar for multiple morphologies. Our results highlight the importance of phenotypic plasticity at multiple scales. Variation in overall morphology is important at niche boundaries at which conditions are consistently more stressful, whereas physiological flexibility is important in intermediate and less predictable habitats in which a rapid and reversible response to environmental fluctuations is required.     

Cytoenzymatic investigation of intracellular digestion in the symbiont-bearing hydrothermal bivalve <Emphasis Type="Italic">Bathymodiolus azoricus</Emphasis>

Invertebrates harbouring endosymbiotic chemoautotrophic bacteria are widely distributed in a variety of reducing marine habitats, including deep-sea hydrothermal vents. Bathymodiolids are dominants of the biomass at geochemically distinct vent sites of the Mid Atlantic Ridge (MAR) and thus are good candidates to study biological processes in response to site-specific conditions. To satisfy their nutritional requirements, these organisms depend to varying extent on two types of chemoautotrophic symbionts and on filterfeeding. The quantitative relationships of the nutritional modes are poorly understood. Using enzyme cytochemistry, electron microscopy and X-ray microanalysis, the structural and functional aspects of the cellular equipment necessary for lysosomal digestion was studied. We provide evidence for the following: (1) the basis of intracellular digestion of symbionts in Bathymodiolus azoricus from two geochemically distinct vent sites was not mainly in the large lysosomal bodies as previously thought (based on the membranous content resembling bacteria); (2) senescent bacteria are autolysed, possibly by bacterial acid phosphatase, that is more likely a cell cycling of the symbionts rather than an active lysosomal digestion by the host; (3) the consistent absence of hydrolases may indicate the improper use of the name “lysosome” for large vesicles at the base of the gill bacteriocytes (4) nutrient transfer in B. azoricus, therefore, may more likely be accomplished through leaking of metabolites from the symbiont to the host, not excluding lysosomal resorption of dead bacteria as an auxiliary strategy for organic molecule transfer; (5) evidence is provided for microvillar transfer of substances from the seawater that may indicate filter-feeding, in non-symbiotic ciliated gill cells of mussels from Lucky Strike; (6) two types of lysosomal vesicles can be distinguished in digestive cells based on their enzymatic content and their elemental composition.