The Recovery of Ammonia and Hydrogen Sulflde from Ground-Level Area Sources Using Dynamic Isolation Flux Chambers: Bench-Scale Studies

Abstract

Controlled bench-scale laboratory experiments were conducted to evaluate the recovery of ammonia (NH₃) and hydrogen sulflde (H₂S) from dynamic isolation flux chambers. H₂S (80–4000 ppb) and NH₃ (5000–40,000 ppb) samples were diffused through the flux chamber to simulate ground level area source emissions while measuring the inlet and outlet flux chamber concentrations simultaneously. Results showed that the recovery of H₂S during a 30-min sampling time was almost complete for concentrations >2000 ppb. At the lowest concentration of 80 ppb, 92.55% of the H₂S could be recovered during the given sampling period. NH₃ emissions exhibited similar behavior between concentrations of 5000–40,000 ppb. Within the 30-min sampling period, 92.62% of the 5000-ppb NH₃ sample could be recovered. Complete recovery was achieved for concentrations >40,000 ppb. Predictive equations were developed for gas adsorption. From these equations, the maximum difference between chamber inlet and outlet concentrations of NH₃ or H₂S was predicted to be 7.5% at the lowest concentration used for either gas. In the calculation of emission factors for NH₃ and H₂S, no adsorption correction factor is recommended for concentrations >37,500 ppb and 2100 ppb for NH₃ and H₂S, respectively. The reported differences in outlet and inlet concentration above these ranges are outside the full-scale sensitivity of the gas sensing equipment. The use of 46–90 m of Teflon tubing with the flux chambers has apparently no effect on gas adsorption, because recovery was completed almost instantaneously at the beginning of the tests.     

Error propagation in pesticide residue measurements estimated by computational simulations and inter-laboratory sample analysis

An assessment of the error associated with conventional pesticide residue analysis has been conducted based on computer simulations and inter-laboratory residue analysis. Computational simulations were conducted based on (i) typical performance and regulatory acceptance criteria of analytical methods, and (ii) field residue distributions. In addition, field samples with incurred residues were sent to different private laboratories and the results compared. The relative difference in pesticide residues obtained when samples from the same field or produce lot are analyzed at separate laboratories was used to quantify the uncertainty associated with residue analyses performed using common analytical technology, and methods that are in compliance with current regulatory requirements. The study showed that differences of > 100% are common and should be expected when samples from the same crop are analyzed at different laboratories. The results also suggest that the error within residue measurements can be particularly detrimental when a result is reported near the maximum residue limit (MRL).     

Environmental and lifestyle factors affect benzene uptake biomonitoring of residents near a petrochemical plant

Background

We monitored urinary benzene excretion to examine factors affecting benzene uptake in a sample of the general population living near a petrochemical plant.

Methods

Our study population included 143 subjects: 33 petrochemical plant workers (W) with low level occupational benzene exposure; 30 residents in a small town 2 km from the plant (2kmR); 26 residents in a second small town located 2 to 4 km from the plant (4kmR); and 54 urban residents 25 km from the plant (25kmR). Exposure to benzene was evaluated by personal air sampling during one work-shift for the W group, and from 8.00 to 20:00 for general population subgroups, and by urinary benzene (BEN-U).

Results

Median airborne benzene exposure was 25, 9, 7 and 6 μg/m³ benzene among the W, 2kmR, 4kmR, and 25kmR subgroups, respectively; the highest level was found among the workers, while there was no significant difference among the other groups. Median BEN-U was 2 to 14-fold higher in smokers compared to non-smokers; among non-smokers BEN-U was the highest in W (median 236 ng/L), and lower in the 2kmR (48 ng/L) and 4kmR (63 ng/L) subgroups than in the 25kmR (120 ng/L) subgroup. A multiple linear regression analysis, explaining up to 73% of BEN-U variability, confirmed that active smoking and airborne benzene most strongly affected BEN-U. Among the non-smoking, non-occupationally exposed study subjects, a positive association was found between BEN-U and the distance of residence from the plant. This association was explained by increased exposure to urban traffic emissions in the study group residing at a greater distance from the plant. Environmental tobacco smoke had a marginally positive role.

Conclusion

Among factors affecting benzene uptake in non-occupationally exposed individuals, urban residence contributes to benzene exposure more than residing in close proximity to a petrochemical plant.     

Determining C/N ratios for typical organic wastes using biodegradable fractions

It is well established that an optimal aerobic and anaerobic microbial metabolism is achieved with a C/N ratio between 20 and 30. Most studies are currently based on chemically-measured carbon and nitrogen contents. However, some organic wastes can be composed of recalcitrant carbon fractions that are not bioavailable. To know the biodegradable C/N ratio, two different methods to determine the aerobic and anaerobic biodegradable organic carbon (BOC_AE and BOC_AN) are proposed and used to analyze a wide variety of different organic samples. In general, raw wastes and digested products have more amount of BOC_AE. On the contrast, the samples collected after an aerobic treatment have higher content of BOC_AN. In any case, all the BOC fractions are lower than the total organic carbon (TOC). Therefore, the C/N ratios based on BOC are always lower than the total C/N ratio based on the TOC measure. The knowledge of the real bioavailable C/N ratio is crucial for the biological treatments of organic materials. To reduce the test time necessary for BOC determination, the values of BOC for all the samples obtained at different times were compared and correlated with the final BOC. A method that allows for the determination of BOC_AE in 4 d is proposed. In relation to the anaerobic assay, the biogas potential calculated after 21 and 50 d was positively correlated with the final potential defined after 100 d of assay.     

Exergy analysis as a tool for the integration of very complex energy systems: The case of carbonation/calcination CO2 systems in existing coal power plants

A common characteristic of carbon capture and storage systems is the important energy consumption associated with the CO₂ capture process. This important drawback can be solved with the analysis, synthesis and optimization of this type of energy systems. The second law of thermodynamics has proved to be an essential tool in power and chemical plant optimization. The exergy analysis method has demonstrated good results in the synthesis of complex systems and efficiency improvements in energy applications.In this paper, a synthesis of pinch analysis and second law analysis is used to show the optimum window design of the integration of a calcium looping cycle into an existing coal power plant for CO₂ capture. Results demonstrate that exergy analysis is an essential aid to reduce energy penalties in CO₂ capture energy systems. In particular, for the case of carbonation/calcination CO₂ systems integrated in existing coal power plants, almost 40% of the additional exergy consumption is available in the form of heat. Accordingly, the efficiency of the capture cycle depends strongly on the possibility of using this heat to produce extra steam (live, reheat and medium pressure) to generate extra power at steam turbine. The synthesis of pinch and second law analysis could reduce the additional coal consumption due to CO₂ capture 2.5 times, from 217 to 85 MW.     

First flush in a combined sewer system

Pollutant first flush was examined in an urban catchment with area of 12.7 ha and drained by a combined sewer system located in northern Italy. A total of 23 rainfall-runoff events were monitored and 281 samples were analyzed. The selected quality parameters were biochemical oxygen demand, chemical oxygen demand, suspended solids, settleable solids, total phosphorus, total nitrogen, ammonium nitrogen, lead, and zinc, specific conductivity and hydrocarbons. A subset of representative storms was selected for first flush analysis. The catchment presented a strong first flush for almost all storms and most constituents. The analysis shows that treating the maximum amount of the early part of the runoff is a better strategy than treating a constant flow rate. Best management practices that can treat or store the first runoff are favored in this kind of system for these water quality parameters.     

Different compensatory mechanisms in two metal-accumulating aquatic macrophytes exposed to acute cadmium stress in outdoor artificial lakes

Mechanisms underlying cadmium (Cd) detoxification were compared in two aquatic macrophytes commonly used in phytoremediation, namely Pistia stratiotes L. and Eichhornia crassipes (Mart.) Solms. To simulate Cd pollution in the open environment, plants growing in outdoor artificial lakes were exposed for 21d to either 25 or 100microM Cd, in two consecutive years. Toxicity symptoms were absent or mild in both species. Metal accumulation was much higher in the roots of P. stratiotes, whereas in E. crassipes a comparatively higher fraction was translocated to the leaves. In both species, Cd was neither included in phenolic polymers or Ca-oxalate crystals, nor altered the levels of Cd-complexing organic acids. Glutathione levels were constitutively remarkably higher and much more responsive to Cd exposure in P. stratiotes than in E. crassipes. Abundant phytochelatin synthesis occurred only in P. stratiotes, both in roots and in leaves. In E. crassipes, on the other side, the constitutive levels of some antioxidant enzymes and ascorbate were higher and more responsive to Cd than in P. stratiotes. Thus, in these two aquatic plants grown in the open, different detoxification mechanisms might come into play to counterbalance Cd acute stress.     

产业联盟透视 关于中外产业联盟问题的10个答问

国内外产业联盟的形成和发展,原因在于经济全球化、高新技术特别是信息技术的快速发展。联盟按照自愿、平等、互利原则建立,这种组织形式有利于成员间的资源整合,有利于新技术的研发、统一标准、开拓全球市场,使联盟成员在市场竞争中获得更多的优势。联盟的发展需要有明确的定位,坚持战略性、市场化、互利性原则。目前安防行业成立的产业联盟,本质上是企业联盟。在企业家探索、实践产业联盟之际,我们对产业联盟的来龙去脉、对联盟的定位和功能进行了梳理,目的是抛砖引玉,希望大家对产业联盟、企业联盟有一个相对全面、直观的解读。