反硝化除磷菌驯化富集方式的探讨

以SBR反应器分别采用一段式和二段式培养方法对反硝化除磷菌进行了驯化富集.结果表明,一段式和二段式培养方法驯化完成后的活性污泥沉降性能均较好,污泥体积指数(SVI)分别约为60、50 mL/g,反硝化除磷菌占聚磷菌的比例达到了77%和71%.两种培养方法下反硝化除磷菌PO3-4-P去除率和脱氮率分别达到了97%和95%以上,缺氧结束时水中PO3-4-P质量浓度小于1 mg/L.驯化完成后污泥的含磷率最高达到了3.7%(质量分数).因此,采用一段式或二段式驯化方法均能实现反硝化除磷菌的有效富集.     

折板絮凝池流场的粒子图像测速试验研究

利用粒子图像测速(PIV)技术对折板絮凝池模型中的复杂流场进行测量,分析了折板絮凝池的缩放单元和转折单元内部流场对絮凝效果的影响机制.絮凝试验表明,90°异波折板与90°同波波折板组合的浊度去除率最高,达到了97.7%,这对折板絮凝池的成本效益设计提供了理论依据.     

新型SBBR处理畜禽废水脱氮实验研究

以畜禽废水为处理对象,将序批式运行模式应用到好氧三相内循环生物流化床中,考察在不同模式下的处理效果及氮的转化情况。实验结果表明,在室温条件下,进水COD浓度为2 000 mg/L左右,总氮为140 mg/L左右时,保持溶解氧在2~2.5 mg/L,交替好氧/缺氧运行方式处理效果优于单一的好氧/缺氧方式;模式为3 h(曝气)-1.5 h(停曝)-1.5 h(曝气)-1 h(停曝)时系统对总氮和氨氮处理效果最好,总氮去除率达到90%,系统主要脱氮方式为同步硝化反硝化和短程硝化反硝化。     

Catalytic destruction of pentachlorobenzene in simulated flue gas by a V2O5-WO3/TiO2 catalyst

Pentachlorobenzene (PeCB) in simulated flue gas was destructed by a commercial V₂O₅-WO₃/TiO₂ catalyst in this study. The effects of reaction temperature, oxygen concentration, space velocity and some co-existing pollutants on PeCB conversion were investigated. Furthermore, a possible mechanism for the oxidation of PeCB over the vanadium oxide on the catalysts was proposed. Results show that the increase of gas hourly space velocity (GHSV) and the decrease of operating temperature both resulted in the decrease of PeCB removal over the catalyst, while the effect of the oxygen content in the range of 5-20% (v/v) on PeCB conversion was negligible. PeCB decomposition could be obviously affected by the denitration reactions under the conditions because of the positive effect of NO but negative effect of NH₃. The introduction of SO₂ caused the catalyst poisoning, probably due to the sulfur-containing species formed and deposited on the catalyst surface. The PeCB molecules were first adsorbed on the catalyst surface, and then oxidized into the non-aromatic acyclic intermediates, low chlorinated aromatics and maleic anhydride.     

Identification of priority pharmaceuticals in the water environment of China

In recent years, increasing attention has been paid to the trace-level contamination of pharmaceuticals in the water environment all over the world. Considering a large number of pharmaceuticals used, it is crucial to establish a priority list of pharmaceuticals that should be monitored and/or treated first. In the present study, we developed a ranking system based on the pharmaceutical consumption, removal performance in the wastewater treatment plants (WWTPs) and potential ecological effects, and applied to the situation of China. 39 pharmaceuticals, which had available consumption data and also been reported previously in the WWTPs of China, were selected as candidate pharmaceuticals. Among them, seventeen pharmaceuticals were considered as priority pharmaceuticals, out of which, erythromycin, diclofenac acid and ibuprofen, had the high priority. Compared with other literatures, we found that some pharmaceuticals given concerns to globally should also be included in the priority list in China; while some pharmaceuticals, not mentioned in other literatures, such as cefalexin, ketoconazole, should be also given prior consideration in China. Among all the therapeutic classes, antibiotics, which were grossly abused in China, contributed the most to the priority pharmaceuticals. However, priority antibiotics accounted for only 32% of candidate antibiotics, while 71% and 100% of the candidate anti-inflammatory and antilipidemic respectively were identified as the priority pharmaceuticals, indicating that antibiotics might be overanxiously considered in the previous studies on their behaviors in the WWTPs of China.     

无砾石微孔管地下渗滤系统处理生活污水的中试研究

进行了无砾石微孔管地下渗滤系统处理生活污水的中试研究。基于不同土壤、不同管径、不同植物的协同效应,对比研究了不同系统处理污水中有机物、氮、磷和SS的去除效果及其影响因素。结果表明,不同土壤、不同管径及不同植物组成的系统,对生活污水中有机物、氮、磷和SS的去除效果差别较大。中试系统对COD、总磷、氨氮、总氮和SS的最佳去除率分别达到86.13%、90.20%、61.24%、65.49%和97.43%,对应的出水COD、总磷、氨氮、总氮和SS的平均浓度分别为64.29、0.69、22.13、26.19和5.56 mg/L。分析表明,进水SS浓度过高、外界温度下降等共同作用是导致系统对生活污水中NH4+-N和TN的去除率相对较低的主要原因。     

高分子量高纯度阳离子聚丙烯酰胺的合成

以丙烯酰胺与丙烯酰氧乙基三甲基氯化铵为单体,在复合引发剂的作用下,选择水溶液共聚法合成高分子量与高纯度阳离子型聚丙烯酰胺(CPAM)。实验表明,有机偶氮引发剂A用量0.5‰、氧化还原引发剂用量0.45‰、还原剂与氧化剂摩尔比2∶1、反应体系pH为4与反应时间5 h条件下,CPAM分子量为1 042万,且溶解性好。通过对聚合物残单含量影响因素添加剂用量、反应时间的研究,结果表明,添加剂EDTA和增溶剂D对残留AM含量影响小,而苯甲酸钠对聚合物残留AM的含量影响显著;延长反应时间至7 h,残单含量可降低至0.27%,CPAM的纯度高。通过与国内外3种同类型产品进行对比,结果表明,自制产品的分子量明显高于其他产品,且残单含量比国内产品降低了50%～75%。     

Regional distribution of cadmium minerals and risk assessment for potential cadmium pollution of soil in China

系统地分析和评价了中国镉矿的区域分布及长期采选冶活动所带来的土壤镉污染风险.研究结果表明,截至2005年底,中国累计探明镉资源储量约为719.47kt,保有镉资源储量约为587.37 kt,且多与铅矿、锌矿等以共、伴生形式存在.中国镉矿主要分布在中部、西南部及华东地区,这些地区的镉资源探明储量占中国累计探明总储量的88.0％,保有储量占中国总保有储量的87.1％.据统计,中国镉采出量约为136.10 kt,主要集中在西南地区,其镉采出量占中国总采出量的59.4％.镉污染事件主要发生在镉矿相对丰富及采选冶活动较密集的云南、广东、湖南、贵州等地区,大部分矿冶区及周边土壤呈现重度镉污染,农作物中含镉量超出《食品中污染物限量》(GB2762-2005)中限值.     

厦门市大气PM_(2.5)中重金属污染特征及健康风险评价

用ICP-MS对厦门市夏冬两季城区和郊区PM_(2.5)(当量直径≤2.5 μm的颗粒物)及其中10种重金属(V、Cr、Mn、Co、Ni、Zn、As、Cd、Pb和Cu)含量进行测定,分析其污染特征,并对重金属的健康风险进行评价。结果表明,采样期间厦门市PM_(2.5)中重金属含量水平表现为ZnPbCuMnVAsNiCrCdCo,其中Zn、Pb、As、Cd和Cu富集因子远远大于10,受人为影响较严重。健康风险评价结果表明,PM_(2.5)中重金属的非致癌健康风险可以忽略;几乎所有重金属的致癌健康风险都高于最大可接受风险值10~(-6)。     

纳米涂层/铝合金在不同pH值的海水溶液中的腐蚀行为研究

目的评价纳米涂层/铝合金在不同pH值海水溶液中的腐蚀行为。方法通过测试纳米涂层/铝合金试样在不同pH值海水溶液中的EIS值,分析试样阻抗谱图及Bode谱图的演化规律,建立不同EIS图谱的不同电极阻抗模型,并采用ZView软件解析涂层体系不同时期的电化学阻抗谱,获得涂层电阻的变化趋势,及不同pH值海水浸泡的纳米涂层体系腐蚀失效速度。结果随着浸泡时间的增加及pH值的降低,纳米涂层/铝合金体系腐蚀损伤失效速率在浸泡前期整体趋势增大,但中后期由于腐蚀产物逐渐堵塞了涂层的微孔,腐蚀介质向铝合金表面渗透的速率逐渐减小。结论 pH为2.0海水浸泡下的3涂层失效最快,其次是pH为4.0海水浸泡下的2涂层,最后为p H为6.0海水浸泡下的1涂层,该涂层体系应采用等效电路模型C进行拟合。