聚合硫酸铁/高锰酸钾/二氧化氯组合工艺用于聚氯乙烯废水回收的工程化研究

采用聚合硫酸铁复配高锰酸钾混凝结合二氧化氯氧化的组合工艺成功解决了某厂聚氯乙烯生产废水回收工艺CODMn不达标问题。工程运行结果表明,当原水CODMn=30～48 mg/L,浊度=25～46 NTU时,在CFe=16.8 mg/L,CKMnO4=45 mg/L,CClO2=20 mg/L的条件下,出水CODMn<10 mg/L,浊度<0.5 NTU,达到工业循环补给水的水质要求。     

4A沸石对复合污染水体中Pb2+、Cu2+和Cd2+的去除

采用静态吸附法以4A沸石为吸附剂研究其对复合污染水体中Pb2+、Cu2+和Cd2+的竞争吸附特性,并探讨了影响吸附的环境因素。实验表明,在室温条件下,溶液pH5～6,4A沸石15 mg对10 mL复合污染溶液(Pb2+、Cu2+和Cd2+浓度分别为100 mg/L)吸附20 min时,对溶液中3种重金属的吸附去除率均可达99.8%以上。反应过程中4A沸石对3种重金属的吸附速率大小为Pb2+>Cu2+>Cd2+。复合污染水体中4A沸石对Pb2+、Cu2+和Cd2+的吸附符合Langmuir和Fre-undlich等温吸附方程,相关系数分别为0.9981、0.9901、0.9916和0.9638、0.9194、0.9689。经计算,4A沸石对Pb2+、Cu2+和Cd2+的饱和吸附量分别为129.9 mg/g、107.5 mg/g和99.0 mg/g。4A沸石吸附重金属离子达到吸附平衡的时间较短,对溶液pH值的适应性较好。吸附后的4A沸石可以再生利用,对铅离子洗脱重复利用性较铜离子和镉离子强。     

Bioaccumulation, depuration and biotransformation of 4,4'-dibromodiphenyl ether in crucian carp (Carassius auratus)

Polybrominated diphenyl ethers (PBDEs) are extensively used as a class of flame retardants and have become ubiquitous environmental pollutants. Significant biotransformation of some PBDEs via reductive debromination has been observed. However, little is known about the fate of lower brominated BDEs in fish. In this study, the tissue distribution, excretion, depuration and biotransformation of 4,4′-dibromodiphenyl ether (BDE 15) were investigated in crucian carp (Carassius auratus) which were exposed to spiked water solution at different concentrations for 50 d, followed by a 14-d depuration period. Bioaccumulation parameters were calculated and the results showed that BDE 15 was mainly concentrated in the gill and liver. In particular, five biotransformation products of BDE 15 in carp were identified using GC-MS/MS. Besides two debrominated metabolites, three of the metabolites were mono-OH-BDE 15, diOH-BDE 15 and bromophenol. Our results unequivocally suggested that BDE 15 oxidation did occur via the formation of hydroxylated (OH-) metabolites in crucian carp exposed in vivo. These findings will be useful for determination of the metabolic pathways of PBDEs in freshwater fish, especially about their oxidation metabolism.     

Effects of excited-state structures and properties on photochemical degradation of polybrominated diphenyl ethers: a TDDFT study

This study presents new insight into the photochemical degradation of polybrominated diphenyl ethers (PBDEs), and it provides details about the structures and properties of 27 PBDE congeners in the electronically excited state using the time-dependent density functional theory method. Each PBDE congener exhibited remarkably different geometries in the ground state and the excited state. The significant lengthening of C-Br bond in each PBDE congener was observed in the excited state for the first time by theoretical calculation, which is directly involved in the photochemistry reductive debromination of n-BDE to (n−1)-BDE. Generally, the lengthening of C-Br bonds cannot occur at the para position. Furthermore, the calculated results demonstrated that the photoreactivity of PBDEs increased with an increase of bromination degree. It was also found that the pattern of Br substituents had an effect upon the photoreactivity of PBDEs. These findings suggest that the information obtained in the excited state is crucial to the mechanism explanation of the photochemical degradation of PBDEs.     

Ozonation of azo dye Acid Red 14 in a microporous tube-in-tube microchannel reactor: decolorization and mechanism

Despite the great success of time-weighted average passive sampling of hydrophobic contaminants, such as PCBs and PAHs, the sampling of polar organic compounds still presents a challenge because the equilibrium between water and most sampling phases is attained in a relatively short time. In this study, we proposed a new time-integrative sampler using in situ solvent extraction (TISIS) for polar organic chemicals. The sampler was composed of a 15 cm poly(dimethylsiloxane) (PDMS) tubing, with an internal diameter of 0.5 mm and wall thickness of 0.5 mm, through which an extraction solvent (acetonitrile) was passed. Four polar organic contaminants, caffeine, atrazine, diuron and 17α-ethynylestradiol, were chosen for the evaluation of the performance of the sampler. Without the use of in situ solvent extraction, the PDMS tubing when exposed to a constant aqueous concentration of the four model compounds was able to linearly accumulate those compounds for less than 12 h and equilibrium between the PDMS tubing and water was attained in 2 d under our laboratory conditions. However, TISIS when exposed to a constant aqueous concentration was able to linearly accumulate all the model compounds without any exposure time limitation. The measured sampling rates at three different extraction flow rates (0.2, 0.5, 1.5 mL min⁻¹) were similar, regardless of the chemicals, indicating that the overall mass transfer from aqueous solution to the extraction solvent was most likely dominated by partitioning to the PDMS tubing and the internal diffusion within PDMS. In addition, a pulsed exposure experiment confirmed that TISIS operated in a time-integrative mode when the environmental concentration was highly fluctuated.     

高浓度油田压裂废水降低CODCr的预处理方法

针对高浓度油田压裂废水黏度高、浊度大、含油量高等特点,强化预处理工艺,降低CODCr值。文章通过实验证明了强氧化剂(Fenton试剂)与混凝剂PAC+PAM相结合的工艺可有效降低高浓度含油废水CODCr值,进而通过Fenton试剂与混凝剂的投药量、pH值等因素对高浓度油田压裂废水的影响进行分析,得出采用该化学预处理方法出水水质清澈,可直接进入生化处理系统进行后续处理。     

长庆油田作业废水的处理与回用

介绍了长庆油田石油开发过程中的井场措施作业废水处理与回用技术应用现状和管理制度,并对下一步节水和资源化利用的研究方向进行了展望,通过技术引领和管理创新,促进石油开发与水资源利用的可持续发展。     

含硫化氢油田地面工程设计实践与认识

文章分析了硫化氢(H2S)的危害,提出了含H2S油田地面工程设计思路。在长庆油田现有工艺流程的基础上,针对硫化氢的危害,通过采用地面工艺全流程密闭、选用抗硫工艺设备、管材等工艺技术,实现油田安全清洁生产,确保油田安全、高效开发。     

Comparison of competitive and synergetic adsorption of three phenolic compounds on river sediment

Knowledge of toxic chemical sorption by soil/sediment is critical for environmental risk assessment of toxic chemicals, especially for the multi-sorbate system in river ecosystem. Sorption characteristics of 2, 4-Dichlorophenol, 2, 4-Dinitrophenol and 2, 4-Dimethyphenol on sediment were investigated. Adsorption isotherms in single- and multi-sorbate systems fitted well the Freundlich model. The adsorption effects were different among three selected phenolic compounds in single- and multi-sorbate systems. The synergetic affect that 2, 4-Dinitrophenol and 2, 4-Dimethyphenol bring to 2, 4-Dichlorophenol can be explained by the compression of double electronic layer and the charge neutrality. Adsorption kinetic results showed that pseudo-second-order model can be used to describe the experimental data and the adsorption affinity of phenolic compounds influenced greatly by the adsorption velocity. The present study suggests that the fate and transport of emerging pollutants such as phenolic compounds could be affected in the presence of different hydrophobic pollutants in aquatic systems.     

The changes of nitric oxide production during the growth of Microcystis aerugrinosa

This study characterized the changes of nitric oxide (NO) production during the growth of Microcystis aerugrinosa, a cyanobacterium which usually cause cyanobacterial blooms. Results showed a drastic NO release accompanying with cell density and Chl-a content sharp rises when M. aerugrinosa grew from fifth day to sixth day. Moreover, high N:P ratio accelerated the cyanobacterial growth and NO burst. Sodium nitroprusside, an exogenous NO donor, promoted M. aerugrinosa growth with the optimal concentration of 0.1 mg/L. Experiments by supplementing with sodium nitrite and l-arginine demonstrated NO production in M. aerugrinosa cells was mainly through nitrate reductase (NR) pathway while minorly through NO synthase pathway. All these data suggested M. aerugrinosa produced increasing NO during its growth mainly by NR pathway, during which NO positively regulated the growth of M. aerugrinosa.