Growth and uptake of exogenous phosphate by Microcystis aeruginosa in batch culture under different temperature, photoperiod, and turbulence were studied by the method of phosphate isotope tracer. Relatively high temperature, long photoperiod and strong turbulence increased the cell density of M. aeruginosa in these batch cultures. The initial rapid uptake of phosphate by M. aeruginosa was independent of the temperature, photoperiod, and turbulence. Similarly, maximum exogenous phosphate uptake was not related to these environmental factors. However, elevated temperature and turbulence shortened the time, required to obtain maximum P accumulation. The growth of M. aeruginosa could alleviate the phosphorous leakage. Total amounts of exogenous phosphate uptake to M. aeruginosa and the phosphorus leakage of M. aeruginosa were significantly influenced by the growth state of M. aeruginosa closely correlated with the environmental factors. The maximum volume of exogenous phosphate uptake to M. aeruginosa was 46% of added exogenous phosphate in water with 16 hours of photoperiod. Thus, total amounts of exogenous phosphate uptake to M. aeruginosa were more strongly affected by the photoperiod length than temperature and turbulence. 相似文献
A synthetic wastewater containing phenol as sole substrate was treated in a 2.8 L upflow anaerobic sludge blanket(UASB) reactor at ambient temperature. The operation conditions and phenol removal efficiency were discussed, microbial population in the UASB sludge was identified based on DNA cloning, and pathway of anaerobic phenol degradation was proposed. Phenol in wastewater was degraded in an UASB reactor at loading rate up to 18 gCOD/(L·d), With a 1:1 recycle ratio, at 26(1℃, pH 7.0-7.5. An UASB reactor was able to remove 99% of phenol up to 1226 mg/L in wastewater with 24 h of hydraulic retention time(HRT). For HRT below 24 h, phenol degradation efficiency decreased with HRT, from 95.4% at 16 h to 93.8% at 12 h. It further deteriorated to 88.5% when HRT reached 8 h. When the concentration of influent phenol of the reactor was 1260 mg/L(corresponding COD 3000 mg/L), with the HRT decreasing(from 40 h to 4 h, corresponding COD loading increasing), the biomass yields tended to increase from 0.265 to 3.08 g/(L·d). While at 12 h of HRT, the biomass yield was lower. When HRT was 12 h, the methane yield was 0.308 L/(gCOD removed), which was the highest. Throughout the study, phenol was the sole organic substrate. The effluent contained only residual phenol without any detectable intermediates, such as benzoate, 4-hydrobenzoate or volatile fatty acids(VFAs). Based on DNA cloning analysis, the sludge was composed of five groups of microorganisms. Desulfotomaculum and Clostridium were likely responsible for the conversion of phenol to benzoate, which was further degraded by Syntrophus to acetate and H2/CO2. Methanogens lastly converted acetate and H2/CO2 to methane. The role of epsilon-Proteobacteria was, however, unsure. 相似文献
The preparation of ethanol-diesel fuel blends and their emission characteristics were investigated. Results showed the absolute ethanol can dissolve in diesel fuel at an arbitrary ratio and a small quantity of water(0.2% ) addition can lead to the phase separation of blends. An organic additive was synthesized and it can develop the ability of resistance to water and maintain the stability of ethanol-diesel-trace amounts of water system. The emission characteristics of 10%, 20%, and 30% ethanol-diesel fuel blends, with or without additives, were compared with those of diesel fuel in a direct injection(DI) diesel engine. The experimental results indicated that the blend of ethanol with diesel fuel significantly reduced the concentrations of smoke, hydrocarbon(HC), and carbon monoxide(CO) in exhaust gas. Using 20% ethanol-diesel fuel blend with the additive of 2% of the total volume, the optimum mixing ratio was achieved, at which the bench diesel engine testing showed a significant decrease in exhaust gas. Bosch smoke number was reduced by 55%, HC emission by 70%, and CO emission by 45%, at 13 kW/1540 r/min. However, ethanol-diesel fuel blends produced a few ppm acetaldehydes and more ethanol in exhaust gas. 相似文献
Heavy metal(loid) extraction from soils in overlapped areas of farmland and coal resources (OAFCR) is crucial in understanding heavy metal bioavailability in soil and the subsequent risks to crops and consumers. However, limited attention has been paid to the extraction procedure of heavy metal(loid)s in OAFCR soils in the research. This study therefore explored different single and mixed extraction procedures, such as acetic acid (HOAc), citric acid, ammonium bicarbonate-diethylenetriaminepentaacetic acid (AB-DTPA), ethylene diamine tetraacetic acid + ammonium acetate (EDTA+NH4OAc), and total digestion (HNO3-HClO4-HF) to determine the bioavailability of As, Cd, Cr, Cu, Pb, and Zn in OAFCR soil in Xuzhou, China. The results showed the metal(loid) extraction capacity from soil of the different procedures could be ranked as AB-DTPA > EDTA+NH4OAc > HOAC > citric acid. The transfer ability of heavy metal(loid)s from soil to wheat tissues and from wheat roots to aerial parts was analyzed by calculating the bioconcentration factor and transfer factor, respectively. Transfer factors of all metal(loid)s were < 1 except Cr whose transfer factor from root to shell and straw were > 1. It is suspected that foliar uptake plays a dominant role in Cr uptake. Correlation analysis between the bioavailability of heavy metal(loid)s in soil and uptake in respective wheat tissues was performed to recommend the best extraction procedures for different studies. The results show that AB-DTPA extraction is recommended for Cu uptake to wheat roots, straws, shells and grains, Zn uptake to roots, and Cd uptake to roots and straws.
The organic carbon, permeability test, grain size, chemical composition, and mineral composition were analyzed for 147 samples collected from the Luan River catchment, Hebei province, China, to quantitatively characterize the effects of land use, climate change, sedimentary environment, mineral composition, and chemical composition on the spatial and temporal variation of soil organic carbon (SOC). The results indicate that there was higher SOC content and stronger variation in the south plain than in the northern low mountain. The effects of land use, climate change, and sedimentary environment on SOC distribution were greater than the effects of mineral composition and chemical composition. The cropping systems in the Luan River catchment resulted in significant difference in SOC concentration between the south plain and north mountain. The precipitation mainly transmitted its effects through the sedimentary environment to SOC, which caused the stronger temporal variation in SOC from June to October in the south plain. The north mountain did not have significant temporal variation because of the lower hydraulic conductivity of the sedimentary sequence. The spatial variation of SOC was correlated with land use, and their temporal variation was attributed to climate change and sedimentary environment. Apart from land use, the decision maker can also affect the organic carbon mineral and sequence through the sedimentary environment. 相似文献
Polyoxometalate, K6TiW11O39Sn·7H2O (TiW11Sn), was synthesized and characterized. TiW11Sn and K6ZrW11O39Sn·12H2O (ZrW11Sn) were evaluated for their photocatalytic degradation of triarylmethane (brilliant green and acid blue 9), bisazo (C.I. reactive black 5), and monoazo dyestuffs (C.I. reactive red 24, C.I. reactive red 194, and C.I. reactive orange 5) with natural sunlight in homogeneous aqueous solutions. TiW11Sn and ZrW11Sn effectively and photocatalytically decolorized the dyestuffs. The TiW11Sn- and ZrW11Sn-mediated photocatalytic degradation of the dyestuffs involved a pseudo-first-order reaction and was modeled by Langmuir–Hinshelwood-type kinetics. The observed pseudo-first-order rate constants (K/) of triarylmethane dyestuffs were generally bigger than that of the azo dyestuffs. Quantitative structure–property relationship models of the K/ of the dyestuffs were developed using partial least-square regression. The cumulative variance of the dependent variable explained by the partial least-square components was > 0.753 for each optimal model. This value indicated that the model had good predictive ability and robustness. The K/ values of the dyestuffs were related to the energy of the lowest unoccupied molecular orbital, and the most positive net atomic charges on a sulfur atom of dyestuffs. The linear correlation coefficients between the predicted and experimental values were all > 0.9950. 相似文献