Nitrogen-efficient rice cultivars can reduce nitrate pollution

Introduction  

Environmental pollution by un-utilized nitrogenous fertilizer at the agricultural field is one of the key issues of the day. Rice-based cropping system, the mainstay of Indian agriculture, is one of the main sources of unused N-fertilizer since rice utilizes only 30–40% of total applied N, and the rest goes to waste and creates environmental as well as economic loss.     

Promoting the use of crumb rubber concrete in developing countries

The use of accumulated waste materials in third world countries is still in its early phases. It will take courage for contractors and others in the construction industry to recycle selected types of waste materials in the concrete mixes. This paper addresses the recycling of rubber tires accumulated every year in Jordan to be used in concrete mixes. The main objectives of this research were to provide more scientific evidence to support the use of legislation or incentive-based schemes to promote the reuse of accumulated waste tires. This research focused on using crumb tires as a replacement for a percentage of the local fine aggregates used in the concrete mixes in Jordan. Different concrete specimens were prepared and tested in terms of uniaxial compression and splitting tension. The main variable in the mixture was the volumetric percentage of crumb tires used in the mix. The test results showed that even though the compressive strength is reduced when using the crumb tires, it can meet the strength requirements of light weight concrete. In addition, test results and observations indicated that the addition of crumb rubber to the mix has a limited effect toward reducing the workability of the mixtures. The mechanical test results demonstrated that the tested specimens of the crumb rubber concrete remained relatively intact after failure compared to the conventional concrete specimens. It is also concluded that modified concrete would contribute to the disposal of the non-decaying scrap tires, since the amount being accumulated in third world countries is creating a challenge for proper disposal. Thus, obliging authorities to invest in facilitating the use of waste tires in concrete, a fundamental material to the booming construction industry in theses countries, serves two purposes.     

Removal of arsenic from groundwater by micellar-enhanced ultrafiltration (MEUF)

The removal characteristics of arsenate using micellar-enhanced ultrafiltration (MEUF) were investigated. Among four different cationic surfactants used, hexadecylpyridinium chloride (CPC) showed the highest removal efficiency of arsenic (96%), and the removal efficiency with hexadecyltrimethylammonium bromide (CTAB) was 94%. But the removal efficiency with benzalkonium chloride (BC) was the lowest (57%) due to higher critical micelle concentration (CMC) of BC than those of other surfactants. Over 80% of arsenic was removed with octadecylamine acetate (ODA). On the effect of solution pH on the arsenic removal, since the valance of arsenate decreases from trivalent to monovalent as pH decreases, the removal was reduced at lower pH. The presence of 0.45mM of nitrate and 0.01mM of phosphate reduced the removal efficiency by 5-8%. This decrease was because of the competition between the arsenate, nitrate and phosphate for the binding sites of the surfactant micelle. Similar decrease in the removal of arsenate was observed with CPC, CTAB and ODA in the presence of these anions. In cross-flow filtration, the removal efficiency of arsenic was similar to that in the dead-end system. However, the decline in flux was less than that in dead-end filtration. In order to lower the concentration of the surfactant in the effluent, the effluent was treated with powdered activated carbon (PAC) before discharging to the environment. Over 98% surfactant was removed with 1gl(-1) of PAC. In conclusions, the MEUF is considered as a feasible process using CPC or CTAB to remove the arsenate from groundwater compared with the other solid based adsorbent processes.     

The antioxidative response system in Glycine max (L.) Merr. exposed to Deltamethrin, a synthetic pyrethroid insecticide

Forty-five-day-old plants of Glycine max (soybean) were exposed to several Deltamethrin (synthetic pyrethroid insecticide) concentrations (0.00%, 0.05%, 0.10%, 0.15% and 0.20%) through foliar spray in the field conditions. In the treated plants, as observed at the pre-flowering (10 DAT), flowering (45 DAT) and post-flowering (70 DAT) stages, lipid peroxidation, proline content and total glutathione content increased, whereas the total ascorbate content decreased, as compared with the control. Among the enzymatic antioxidants, activity of superoxide dismutase, ascorbate peroxidase and glutathione reductase increased significantly whereas that of catalase declined markedly in relation to increasing concentration of Deltamethrin applied. The changes observed were dose-dependent, showing a strong correlation with the degree of treatment.     

Low cost sorbents for the removal of methyl parathion pesticide from aqueous solutions

Sorptive potential of selected agricultural waste materials i.e. rice (Oryza sativa) bran (RB), bagasse fly ash (BFA) of sugarcane (Saccharum officinarum), Moringa oleifera pods (MOP) and rice husk (RH) for the removal of methyl parathion pesticide (MP) from surface and ground waters has been investigated. Optimization of operating parameters of sorption process, i.e. sorbent dose, agitation time, pH, initial concentration of sorbate, and temperature have been studied. The sorption data fitted to Freundlich, Langmuir and Dubinin-Radushkevich (D-R) sorption isotherms. The maximum capacities of RB, BFA, MOP and RH for MP were calculated to be 3.6+/-0.8, 5.3+/-1.4, 5.2+/-1.5 and 4.7+/-1.0 mmolg(-1) by Freundlich, 0.39+/-0.009, 0.39+/-0.005, 0.36+/-0.004 and 0.35+/-0.008 mmolg(-1) by Langmuir and 0.9+/-0.08, 1.0+/-0.10, 1.0+/-0.10 and 0.9+/-0.07 mmolg(-1) by D-R isotherms respectively, employing 0.1g of each sorbent, at pH 6, 90 min agitation time and at 303 K. Application of first order Lagergren and Morris-Weber equations to the kinetic data yielded correlation coefficients, close to unity. Thermodynamic parameters of sorption process, i.e. DeltaH, DeltaS and DeltaG were computed and their negative values indicated the exothermic and spontaneous nature of sorption process. The pesticide may be stripped by sonication with methanol, making the regeneration and reutilization of sorbents promising. The sorbents investigated exhibited their potential applications in water decontamination, treatment of industrial and agricultural waste waters.     

Utility of cefixime as a complexing reagent for the determination of Ni(II) in synthetic mixture and water samples

A simple, sensitive, and accurate UV spectrophotometric method has been developed for the determination of nickel in synthetic mixture and water samples. The method is based on the complexation reaction of nickel ion with cefixime, thus leading to the formation of Ni–cefixime complex in ethanol-distilled water medium at room temperature. The complex showed the maximum absorption wavelength at 332 nm. Beer’s law is obeyed in the working concentration range of 0.447–4.019 μg?mL^?1 with apparent molar absorptivity of 7.314?×?10³?L?mol^?1?cm^?1 and Sandell’s sensitivity of 0.008 μg/cm²/0.001 absorbance unit. The limits of detection and quantitation for the proposed method are 0.016 and 0.054 μg?mL^?1, respectively. The factors such as cefixime concentration and solvent affecting the complexation reaction were carefully studied and optimized. The method is validated as per the International Conference on Harmonisation guideline. The method is successfully applied to the determination of Ni(II) in synthetic mixture and wadi water samples collected from Al Rustaq. The same water samples are also analyzed by atomic absorption spectrophotometry. Both methods determined the amount of Ni(II) in water sample and found to be approximately the same.     

Assessment of background levels of trace metals in water and soil from a remote region of Himalaya

Selected trace metals were estimated by atomic absorption spectrometry in the water and soil samples collected from the remote region of Himalaya. The soil samples were analysed for soluble and acid extractable fraction of trace metals. In water samples, Ca, Na, Mg and K emerged as dominant contributors, whereas, Ca, Na, K, Mg, Fe and Pb were estimated at comparatively higher levels in the water extract of the soil. In case of acid extract of the soil samples, Ca, K, Fe, Mg, Mn and Na were found at elevated concentrations. Based on mean levels of the metals, following decreasing concentration order was observed in water samples: Ca > Na > Mg > K > Pb > Co > Cu > Zn > Mn > Cr > Fe > Cd > Li, however, in the acid extract of the soil, following order was noted: Ca > K > Fe > Mg > Mn > Na > Pb > Zn > Cr > Li > Cu > Co > Cd. The correlation study revealed appreciably diverse mutual relationships of trace metals in the water and soil samples. The multivariate cluster analyses exhibited divergent apportionment of trace metals in water and soil samples. Among the trace metals, Cd, Pb, Li, Zn, Cr, Cu, Mn and Co exhibited extreme to significant anthropogenic enrichment in the soil samples, while the rest of the metals were mostly contributed by the natural processes.     

Exploring the asymmetries between trade and consumption-based carbon emissions: evidence from NPARDL approach

Environmental Science and Pollution Research - Global warming is one of the most serious environmental problems that the world faces today. Millions of human lives are at risk, hence the subject...