超声波强化膜分离及清洗的研究进展

综述了超声波强化膜分离与膜清洗的机理,国内外超声波强化膜分离与清洗的研究现状以及影响该技术运用的问题所在。现有的研究成果表明:通过低功率超声波辐射处理污染膜可以减缓运行过程中的浓差极化及膜污染,而如何优化操作参数、如何减小超声波对膜体损害是近期的研究重点。     

RuO2/La2O3/TiO2悬浮体系中直接耐晒黑G的光催化降解

钛酸丁酯为前驱体,采用溶胶-凝胶-浸渍法制备RuO2/La2O3/TiO2复合光催化剂,以紫外灯为光源,研究了催化剂组成、煅烧温度、溶液pH值等因素对直接耐晒黑G(DFBG)光催化降解的影响.结果表明掺杂量w(La2O3)1.39%、w(RuO2)0.12%、煅烧温度500℃(2 h)、溶液pH值7.3时,光催化活性最佳.当通气量为200 mL/min,催化剂投加量为150mg时,50 mg/L的DFBG溶液经60 min降解,其降解率近100%.DFBG的光催化降解服从Langmuir-Hinshelwood动力学模型,测得相应的动力学参数k=7.42×10-3mmol/L·min,K=19.54 L/mmol.     

污染土壤电动修复增强方法研究进展

污染土壤电动修复是一项新兴绿色原位修复技术。其原理是在土壤上施加直流电场 ,利用电迁移和电渗去除污染物 ,土壤pH、Zeta电位以及土壤化学性质等因素影响电动修复效果。为了提高修复效率和扩大电动修复应用范围 ,现在已经发展了针对不同类型土壤和污染物的增强修复技术。本文归纳总结了 1995年以来土壤电动修复中常用增强处理效果的 8种方法 ,即酸碱中和法、阳离子选择膜法、电渗析法、络合剂法、表面活性剂法、氧化 还原法、EK 生物联用和LasagnaTM法 ,且对每种方法的典型实验装置、增强原理、方法特点和适用范围等进行了分析和讨论 ,为以后的实验设计提供了有益的参考     

2020年成都市典型臭氧污染过程特征及敏感性

2020年4月24日至5月6日成都市臭氧(O3)和细颗粒物(PM2.5)复合污染过程期间,在成都市城区开展大气臭氧及其前体物(NO,、VOCs)和气象参数观测实验,基于观测数据采用OBM模型对市区臭氧敏感性和主控因子进行识别,并采用PMF模型对关键VOCs物种进行来源解析.结果表明,臭氧超标日各污染物浓度均有所上升,VOCs物种中芳香烃和含氧(氮)化合物上升幅度较大;成都市城区O3超标天对应的臭氧处于显著VOCs控制区,芳香烃和烯烃对O3生成最为敏感,且存在削减NOx的不利效应;结合VOCs来源解析,城区VOCs主要来源:移动源(22.4％)、餐饮及生物质燃烧源(21.8％)、工业源(15.1％)和溶剂使用源(9.3％),臭氧超标天溶剂使用源、餐饮及生物质类燃烧源贡献率明显上升.成都市城区春季应以VOCs减排为重点,并加大芳香烃和烯烃相关源控制力度.     

Design of a novel non-equilibrium plasma-based water treatment reactor

A novel non-equilibrium plasma-based water treatment reactor consisting of high voltage multi-needle electrode submerged in aqueous phase and reticulated ground electrode suspended in gas phase above water was developed and applied to treat low concentrations of methyl orange (MO). The electrode configuration was optimized. Higher number and more uniform distribution of streamers were produced in gas phase when parallel five-needle configuration with needle spacing of 10mm for high voltage electrode, macroporous ground electrode with mesh size of 0.42mm, and electrode gap of 17mm were adopted. This case corresponds to the largest amount of hydrogen peroxide and ozone produced in aqueous phase and gas phase, respectively, and air flow rate presents an economical value. The injection of wastewater above ground electrode for pretreatment and the design of fixed mesh barriers further increase the amount of ozone dissolved in aqueous solution. The conversion of MO presents a positive correlation with input voltage and the increase of pulse repetition rate is conducive for the conversion. In addition, the effect of initial solution concentration and treating volume on the conversion, energy yield and COD removal was evaluated.     

Health risks of heavy metals in contaminated soils and food crops irrigated with wastewater in Beijing, China

Consumption of food crops contaminated with heavy metals is a major food chain route for human exposure. We studied the health risks of heavy metals in contaminated food crops irrigated with wastewater. Results indicate that there is a substantial buildup of heavy metals in wastewater-irrigated soils, collected from Beijing, China. Heavy metal concentrations in plants grown in wastewater-irrigated soils were significantly higher (P相似文献   

超声/Fenton联用技术处理垃圾渗滤液中的有机物

详细研究了超声/Fenton联用技术对垃圾渗滤液中有机物的处理效果.研究内容包括:超声波频率对垃圾渗滤液色度和COD去除率的影响,超声波功率对垃圾渗滤液色度和COD去除率的影响以及Fenton试剂用量和pH值对垃圾渗滤液色度去除率和COD去除率的影响.还利用一次正交回归实验确定了超声/Fenton联用技术处理垃圾渗滤液的优化条件,并在优化条件的基础上,对超声波技术、Fenton高级氧化技术和超声/Fenton联用技术对垃圾渗滤液的处理效果进行比较研究.研究结果表明:超声/Fenton联用技术对垃圾渗滤液的色度去除率和COD去除率最高,其色度去除率接近100%,COD去除率达到73.5%.超声/Fenton联用技术处理垃圾渗滤液的优化条件是:超声频率为28 kHz,超声功率为75W,Fe2 浓度为280 mg/L,H2O2浓度为1.29×104 mg/L,pH值为2.5.超声波的频率、功率和Fenton试剂用量之间存在优化匹配值.     

Degradation rates of CFC-11, CFC-12 and CFC-113 in anoxic shallow aquifers of Araihazar, Bangladesh

Chlorofluorocarbons CFC-11 (CCl(3)F), CFC-12 (CCl(2)F(2)), and CFC-113 (CCl(2)F-CClF(2)) are used in hydrology as transient tracers under the assumption of conservative behavior in the unsaturated and saturated soil zones. However, laboratory and field studies have shown that these compounds are not stable under anaerobic conditions. To determine the degradation rates of CFCs in a tropical environment, atmospheric air, unsaturated zone soil gas, and anoxic groundwater samples were collected in Araihazar upazila, Bangladesh. Observed CFC concentrations in both soil gas and groundwater were significantly below those expected from atmospheric levels. The CFC deficits in the unsaturated zone can be explained by gas exchange with groundwater undersaturated in CFCs. The CFC deficits observed in (3)H/(3)He dated groundwater were used to estimate degradation rates in the saturated zone. The results show that CFCs are degraded to the point where practically no (<5%) CFC-11, CFC-12, or CFC-113 remains in groundwater with (3)H/(3)He ages above 10 yr. In groundwater sampled at our site CFC-11 and CFC-12 appear to degrade at similar rates with estimated degradation rates ranging from approximately 0.25 yr(-1) to approximately 6 yr(-1). Degradation rates increased as a function of reducing conditions. This indicates that CFC dating of groundwater in regions of humid tropical climate has to be carried out with great caution.     

沼泽红假单胞菌W12对活性黑5的厌氧脱色和降解作用

从处理印染废水的厌氧移动床生物膜反应器（moving bed biofilm reactor, MBBR）中分离到一株具有高效脱色活性的沼泽红假单胞菌W12。经实验确定W12对活性黑5（reactive black 5,RB5）脱色的适宜条件为：pH＜10;有光照;谷氨酸盐或乳酸盐作为碳源,当乳酸钠为碳源时浓度应＞500 mg/L;盐度不超过5％;RB5浓度不大于700 mg/L。紫外可见光谱扫描结果表明,RB5的脱色和降解过程生成芳香胺类化合物,这些中间产物可进一步降解。此外发现,RB5诱导生成的胞外代谢物能提高W12的脱色活性。     

Comparative on Causes and Accumulation of Selenium in the Tree-rings Ambient High-selenium Coal Combustion Area from Yutangba, Hubei, China

Toxic trace elements emitted during coal combustion are the main sources of air pollution. They are released into the atmosphere mainly in the forms of fine ash, smoke and flue, and thus adversely affect plant, animal and human health. Selenium is one of toxic and the most volatile in coal. Large amount of atmospheric emission of selenium, as well as selenium present and scrubber stockpiles in ash may create serious environmental problems. In the paper, on the basis of investigating the abundance and distribution of selenium in plant-rings during recent 20 years, the bioaccumulation of selenium is explained that selenium in plant, which were collected from the village of selenium-rich coal combustion, is much higher than that in plants collected away from the village of selenium-rich coal combustion. The main origins of selenium are selenium-rich coal combustion and high-selenium rock weathered. The selenium recycle by food chain and selenium will accumulate and redistribute in environments.