Estimates of black carbon and size-resolved particle number emission factors from residential wood burning based on ambient monitoring and model simulations

In this paper we derive typical emission factors for coarse particulate matter (PM(10)), oxides of nitrogen (NO(x)), black carbon (BC), and number particle size distributions based on a combination of measurements and air quality dispersion modeling. The advantage of this approach is that the emission factors represent integrated emissions from several vehicle types and different types of wood stoves. Normally it is very difficult to estimate the total emissions in cities on the basis of laboratory measurements on single vehicles or stoves because of the large variability in conditions. The measurements were made in Temuco, Chile, between April 18 and June 15, 2005 at two sites. The first one was located in a residential area relatively far from major roads. The second site was located in a busy street in downtown Temuco where wood consumption is low. The measurements support the assumption that the monitoring sites represent the impact of different emission sources, namely traffic and residential wood combustion (RWC). Fitting model results to the available measurements, emission factors were obtained for PM(10) (RWC = 2160 +/- 100 mg/kg; traffic = 610 +/- 51 mg/veh-km), NO(x) (RWC = 800 +/- 100 mg/kg; traffic = 4400 +/- 100 mg/veh-km), BC (RWC = 74 +/- 6 mg/kg; traffic = 60 +/- 3 mg/veh-km) and particle number (N) with size distribution between 25 and 600 nm (N(25-600)) (RWC = 8.9 +/- 1 x 10(14) pt/kg; traffic = 6.7 +/- 0.5 x 10(14) pt/veh-km). The obtained emission factors are comparable to results reported in the literature. The size distribution of the N emission factors for traffic was shown to be different than for RWC. The main difference is that although traffic emissions show a bimodal size distribution with a main mode below 30 nm and a secondary one around 100 nm, RWC emissions show the main mode slightly below 100 nm and a smaller nucleation mode below 50 nm.     

Elemental concentrations in air, water, and aquatic biota in two rural provinces in northern Vietnam

The present study on environmental pollution in northern Vietnam investigates elemental concentrations in fine particulate matter (PM_2.5), freshwater, and aquatic biota at two sites with differing levels of industrial activities. An Thin is situated 47 km east of Hanoi in the neighbourhood of a coal combustion power plant, whereas the reference site, Duy Minh, is situated in the agricultural province of Ha Nam, 40 km south of Hanoi. Elemental concentrations were analysed using energy-dispersive X-ray fluorescence, total reflection X-ray fluorescence, and graphite furnace atomic absorption spectro-metry. All investigated elements in fine particles (PM_2.5) had significantly higher concentrations in An Thin, thus identifying the air at this site as polluted. In contrast to the aerosol samples, elemental concentrations as well as quantitative differences between the sampling sites were low in freshwater and biota, indicating that the impact of atmospheric deposition was limited.     

Polychlorinated biphenyls in polysulfide sealants--occurrence and emission from a landfill station

Approximately 80,000 kg polysulfide sealant containing 10,000-18,000 kg polychlorinated biphenyls (PCB) was deposited at a Swedish municipal landfill station during 1965-1973. Investigations during 1994 showed that soil layers underneath the landfill had concentration of PCB not alarmingly high. The concentration of PCB congeners in ground water samples was elevated 4-750 times compared to a reference sample. Based on samples of ground water, leachate water, and flux chambers measuring evaporation of PCB from the landfill surface, the emission of PCB was estimated to be 1 g sigmaPCB/yr. This very low rate was attributed to the high sorptive capacity of the sealant. Compared to a reference site, the evaporation flux was elevated for the most volatile congeners, but factors 20-1400 lower than from another landfill which was contaminated with PCB in paper-pulp fibres.     

Mitigation of a radon-rich Belgian dwelling using active subslab depressurization

In a radon prone area in Belgium, a dwelling with high indoor radon concentrations was identified through a passive measurement. Next, a continuous, active radon monitoring device was installed for one month. A 20-a retrospective radon assessment was also performed. The house was subsequently mitigated through active subslab depressurization with a radial fan. Afterwards the dwelling was actively monitored for several more months to observe the effects of the mitigation and to study the effect of reducing the fan power. Dose evaluations were made to evaluate the health benefit of the mitigation. It was seen that the results of the three measuring techniques before mitigation all yielded between 1700 and 2000 Bq/m3. Clear diurnal radon variations showed up only after mitigation. After mitigation, the average radon concentration fell to less than 200 Bq/m3. The yearly average dose was reduced from potentially 45 mSv/y to less than 4.5 mSv/y through mitigation. Reducing fan power to 50% did not clearly influence the amount of radon entering into the dwelling.     

Pre-dispersal seed predation: the role of fruit abortion and selective oviposition

Oviposition sites of phytophagous insects should correlate with plant traits that maximize survival of the progeny. Plants, on the other hand, should benefit from traits and developmental patterns that complicate oviposition decisions. In the antagonistic interaction between plant and pre-dispersal seed predator the time lag between egg laying and seed development may allow for abortion of fruits in plants, potentially reducing fitness loss through predation. We studied the perennial herb Lathvrus vernus and the beetle pre-dispersal seed predator Bruchus atomarius in Sweden to determine the fitness consequences of nonrandom fruit abortion in the plant and oviposition patterns of the beetle. The beetle had a sophisticated ability to locate fruits with high probability of retention, partly by fruit position and phenology but also by some additional unidentified cue. Mortality of eggs was density dependent, but still the egg-laying pattern was clumped. We found no defensive strategy in the plant; instead the predictable fruit abortion pattern was associated with decreased plant fitness. We discuss how interactions may pose simultaneous selection pressures on plant and insect traits and how life history traits and other selective forces may shape the adaptive outcome of the interaction in plant and insect, respectively.     

Change in spring arrival of migratory birds under an era of climate change,Swedish data from the last 140 years

Many migratory bird species have advanced their spring arrival during the latest decades, most probably due to climate change. However, studies on migratory phenology in the period before recent global warming are scarce. We have analyzed a historical dataset (1873–1917) of spring arrival to southern and central Sweden of 14 migratory bird species. In addition, we have used relative differences between historical and present-day observations (1984–2013) to evaluate the effect of latitude and migratory strategy on day of arrival over time. There was a larger change in spring phenology in short-distance migrants than in long-distance migrants. Interestingly, the results further suggest that climate change has affected the phenology of short-distance migrants more in southern than in central Sweden. The results suggest that the much earlier calculated arrival to southern Sweden among short-distance migrants mirrors a change in location of wintering areas, hence, connecting migration phenology and wintering range shifts.