镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

臭氧氧化6-APA制药厂生化处理出水的特性及动力学简

通过现场实验研究了6-APA制药厂生化处理出水的臭氧氧化特性及其动力学规律。结果表明,当臭氧浓度为27.5 mg/L,气水接触时间为80 min时,COD、UV₂₅₄、NH₃-N和色度的去除率分别可达72.95%、73.28%、72%和96.25%,达到《发酵类制药废水工业水污染物排放标准》（GB 21903-2008）排放控制要求。拟合结果表明,在0~10、10~30和30~90 min时段内,臭氧氧化过程遵循拟一级反应,但反应速率逐渐降低。当气水接触时间为30 min时,废水可生化性可由0.1提高至0.35,采用臭氧/生物处理的联合工艺也有望使出水达到相同的排放控制要求。     

高铝粉煤灰提取氧化铝后硅钙渣用作水泥混合材

为了使高铝粉煤灰提取氧化铝后所产生的硅钙渣被大量的用作水泥混合材,通过水泥强度、水化放热和干缩性实验研究了原状硅钙渣和脱碱硅钙渣对水泥强度和稳定性的影响。结果表明,当硅钙渣掺量达30%时,硅钙渣水泥强度仍可满足P·C 32.5水泥要求。且随硅钙渣掺入量的增加,水泥早期水化放热速率增加的同时水泥累计水化放热量和干缩率还会显著降低。与原状硅钙渣相比,在同等掺量的情况下,脱碱硅钙渣更有利于保持水泥强度,降低其水化热和改善干缩性。     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

炼油废水污泥脱水工艺条件的优化

采用化学除油降黏—污泥调理—离心脱水工艺处理某炼油厂废水处理系统的混合污泥,并对工艺条件进行优化。实验结果表明,最佳的工艺条件为：化学除油降黏阶段处理体系的pH=4,反应温度35 ℃,H₂O₂加入量 2 g/L,m（H₂O₂）∶ m（Fe²⁺）=4,反应时间 60 min;污泥调理反应阶段的CaO加入量7.0 g/L;离心脱水阶段在分离因数为1 558时脱水5 min。在此条件下,得到的泥饼的含水率为70.0%~75.0%（w）,含油率小于2%（w）,污泥比阻约为3.0×10⁷ s²/g。     

Heavy metal pollution in vegetables grown in the vicinity of a multi-metal mining area in Gejiu,China: total concentrations,speciation analysis,and health risk

A field survey was conducted to investigate the present situation and health risk of arsenic (As), lead (Pb), cadmium (Cd), copper (Cu), and zinc (Zn) in soils and vegetables in a multi-metal mining area, Gejiu, China. Furthermore, three vegetables (water spinach, potato, and summer squash) containing high metal concentrations were selected to further analyze metal speciation. The results showed that the average concentrations of five metals in soil exceeded the limiting values, and their bioavailable concentrations were significantly positively correlated to the total ones. Heavy metals in the edible parts of vegetables also exceeded the corresponding standards. The leaves of pakchoi, peppermint, and coriander had a strong metal-accumulative ability and they were not suitable for planting. Except the residue forms, the main forms of metals in the edible parts of three selected vegetables were ethanol-, NaCl-, and HAc-extractable fractions for As, Pb, and Cd, respectively; however, Cu was mainly presented as NaCl-extractable and Zn as HAc-extractable fractions. A high proportion of ethanol-extractable As showed that As bioactivity and toxic effects were the highest. Although the total and bioavailable Cd were high in soil, its speciation in vegetables was mainly presented as HAc-extractable fraction, which has a relatively low bioactivity. Lead and arsenic were imposing a serious threat on the local residents via vegetable consumption.     

Risk for estrogen-dependent diseases in relation to phthalate exposure and polymorphisms of CYP17A1 and estrogen receptor genes

Evidence has shown that polymorphisms of various genes known to be involved in estrogen biosynthesis and function are associated with estrogen-dependent diseases (EDDs). These genes include CYP17A1, estrogen receptor 1 (ESR1), and 2 (ESR2). Phthalates are considered estrogenic endocrine disruptors, and recent research has suggested that they may act as a risk factor for EDDs. However, extremely few studies have assessed the effects of gene–environment interaction on these diseases. We recruited 44 patients with endometriosis or adenomyosis, 36 patients with leiomyoma, and 69 healthy controls from a medical center in Taiwan between 2005 and 2007. Urine samples were collected and analyzed for seven phthalate metabolites using liquid chromatography tandem mass spectrometry. Peripheral lymphocytes were used for DNA extraction to determine the genotype of CYP17A1, ESR1, and ESR2. Compared to controls, patients with leiomyoma had significantly higher levels of total urinary mono-ethylhexyl phthalate (ΣMEHP) (52.1 vs. 29.6 μg/g creatinine, p?=?0.040), mono-n-butyl phthalate (MnBP) (75.4 vs. 51.3 μg/g creatinine, p?=?0.019), and monoethyl phthalate (MEP) (103.7 vs. 59.3 μg/g creatinine, p?=?0.031). In contrast, patients with endometriosis or adenomyosis showed a marginally increased level of urinary MEHP only. Subjects who were homozygous for both the ESR1 C allele (rs2234693) and CYP17A1 C allele (rs743572) showed a significantly increased risk for leiomyoma (OR?=?19.8; 95 % CI, 1.70; 231.5; p?=?0.017) relative to subjects with other genotypes of ESR1 and CYP17A1. These results were obtained after adjusting for age, cigarette smoking, MEHP level, GSTM1 genotype and other covariates. Our results suggested that both CYP17A1 and ESR1 polymorphisms may modulate the effects of phthalate exposure on the development of leiomyoma.     

A/O工艺N_2O的产生与释放的影响因素

采用A/O工艺,在连续运行条件下,以DO、SRT和硝化液回流比(R)为影响因素,对A/O生物脱氮工艺处理模拟城市生活污水过程中N2O的释放进行了研究。实验结果表明,SRT对A/O工艺N2O释放的影响最大,其次是DO,R的影响最小。N2O转化率随着SRT的升高而降低,当SRT从10 d升高到20 d时,总N2O平均转化率从0.319%下降到0.002%。总N2O转化率随着好氧池DO的升高先降低后有所升高,当DO分别为0.6 mg O2/L、1.2 mg O2/L、2.5 mg O2/L时,反应器的总N2O平均转化率分别为0.306%、0.007%和0.013%。R对N2O释放的影响差异不明显,总N2O平均转化率在300%时最低,为0.007%。N2O释放量最低的工艺运行条件组合是SRT为20 d、DO为1.2 mg O2/L、R为300%。     

介质阻挡放电协同Ag/Al_2O_3对NO_x脱除的影响

为有效去除发电厂烟气中产生的NOx,利用介质阻挡放电(DBD)产生低温等离子体并结合催化剂Ag/Al2O3进行烟气脱硝实验,研究了在加入乙烯的条件下,平均负载量、催化温度和装置的布置方式对NOx脱除的影响。结果表明,随着负载的增多,NO脱除率呈现先增大后减小的趋势,5种负载量中最佳为1.76%;随着催化温度的升高,NO脱除率同样呈现先增大后减小的趋势,最佳的催化温度为150℃左右;3种不同布置方式对NO和NOx脱除有明显差别,单独催化剂在NO和NOx的脱除率都比较低;单独介质阻挡放电NO脱除率很高,但是NOx很却很低;而两者结合在NO和NOx都达到了很好的效果。     

改性活性炭对水中铬离子(Ⅵ)的吸附性能

为了研究改性前后活性炭对水中铬离子(Ⅵ)的吸附效果,以磷酸活性炭(PAC)为原料,用10%硝酸改性得到硝酸改性活性炭(N-PAC)及直接蒸发法载铁改性得到载铁活性炭(Fe-PAC)。通过静态吸附研究表明,改性后活性炭对Cr(Ⅵ)的吸附率有较大提高。在常温、自然pH条件下,0.2 g活性炭处理50 mL浓度为100 mg/L的含Cr(Ⅵ)溶液,N-PAC和Fe-PAC对Cr(Ⅵ)的吸附率分别为79.21%和90.59%,都高于原PAC对Cr(Ⅵ)的吸附率49.58%。pH从2.2升高到11.92,Fe-PAC对Cr(Ⅵ)的吸附率从99.86%降低到14.77%,N-PAC则从99.86%降低到3.23%,PAC从97.05%降低到2.53%。温度从25℃升高到70℃,3种活性炭对Cr(Ⅵ)吸附率都有较大提高,都增加到98%以上。且吸附过程较符合Langmuir等温吸附模型。