The effects of dietary nickel on the detoxification enzymes, innate immunity and resistance to the fungus Beauveria bassiana in the larvae of the greater wax moth Galleria mellonella

In this study, we tested the effects of dietary nickel on the activity of glutathione S-transferase (GST), esterases, phenoloxidase, and encapsulation in the haemolymph of larvae of the greater wax moth Galleria mellonella. We also explored the effects of dietary nickel on larval resistance to infection by the fungus Beauveria bassiana. Larvae fed a low dose of nickel (10 μg g⁻¹) had significantly higher GST, phenoloxidase activity and encapsulation responses than controls fed on a nickel-free diet. We also found that larvae fed a sublethal dose of nickel (50 μg g⁻¹) had increased GST, esterase activity and encapsulation rates but decreased phenoloxidase activity. Although, a sublethal dose of dietary nickel enhanced innate immunity, we found that this reduced resistance against the real pathogen. Our results suggest that enhanced immunity and detoxification enzyme activity of insects may not be beneficial to resistance to fungal infection. It appears that there is a trade off between different resistance mechanisms in insects under different metal treatments.     

Estimating contaminant mass discharge: a field comparison of the multilevel point measurement and the integral pumping investigation approaches and their uncertainties

In this field study, two approaches to assess contaminant mass discharge were compared: the sampling of multilevel wells (MLS) and the integral groundwater investigation (or integral pumping test, IPT) that makes use of the concentration-time series obtained from pumping wells. The MLS approached used concentrations, hydraulic conductivity and gradient rather than direct chemical flux measurements, while the IPT made use of a simplified analytical inversion. The two approaches were applied at a control plane located approximately 40m downgradient of a gasoline source at Canadian Forces Base Borden, Ontario, Canada. The methods yielded similar estimates of the mass discharging across the control plane. The sources of uncertainties in the mass discharge in each approach were evaluated, including the uncertainties inherent in the underlying assumptions and procedures. The maximum uncertainty of the MLS method was about 67%, and about 28% for the IPT method in this specific field situation. For the MLS method, the largest relative uncertainty (62%) was attributed to the limited sampling density (0.63 points/m(2)), through a novel comparison with a denser sampling grid nearby. A five-fold increase of the sampling grid density would have been required to reduce the overall relative uncertainty for the MLS method to about the same level as that for the IPT method. Uncertainty in the complete coverage of the control plane provided the largest relative uncertainty (37%) in the IPT method. While MLS or IPT methods to assess contaminant mass discharge are attractive assessment tools, the large relative uncertainty in either method found for this reasonable well monitored and simple aquifer suggests that results in more complex plumes in more heterogeneous aquifers should be viewed with caution.     

Effects of C60 nanoparticle exposure on earthworms (Lumbricus rubellus) and implications for population dynamics

Effects of C₆₀ nanoparticles (nominal concentrations 0, 15.4 and 154 mg/kg soil) on mortality, growth and reproduction of Lumbricus rubellus earthworms were assessed. C₆₀ exposure had a significant effect on cocoon production, juvenile growth rate and mortality. These endpoints were used to model effects on the population level. This demonstrated reduced population growth rate with increasing C₆₀ concentrations. Furthermore, a shift in stage structure was shown for C₆₀ exposed populations, i.e. a larger proportion of juveniles. This result implies that the lower juvenile growth rate due to exposure to C₆₀ resulted in a larger proportion of juveniles, despite increased mortality among juveniles. Overall, this study indicates that C₆₀ exposure may seriously affect earthworm populations. Furthermore, it was demonstrated that juveniles were more sensitive to C₆₀ exposure than adults.     

Stepwise calibration of the activated sludge model no. 1 at a partially denitrifying large wastewater treatment plant

Activated sludge modeling technology is maturing; however, currently, there exists a great need to increase its use in daily engineering practice worldwide. A good way for building the capacities of the practitioners is to promote good modeling practices and standardize the protocols. In this study, a systematic procedure was proposed to calibrate the Activated Sludge Model No. 1 (ASM1) at a large wastewater treatment plant, by which the model adequately predicted the quality of the effluent and the sludge quantities. A hydraulics model was set up and validated through a tracer test. The Vesilind settling constants were measured and combined with the default value of the flocculent zone settling parameter, to calibrate the clarifiers. A virtual anoxic tank was installed in the return activated sludge to mimic the denitrification occurring in the settlers. In ASM1, the calibrated parameters were only two influent chemical oxygen demand fractions and one kinetic constant (oxygen half-saturation coefficient).     

Modeling transit bus fuel consumption on the basis of cycle properties

A method exists to predict heavy-duty vehicle fuel economy and emissions over an "unseen" cycle or during unseen on-road activity on the basis of fuel consumption and emissions data from measured chassis dynamometer test cycles and properties (statistical parameters) of those cycles. No regression is required for the method, which relies solely on the linear association of vehicle performance with cycle properties. This method has been advanced and examined using previously published heavy-duty truck data gathered using the West Virginia University heavy-duty chassis dynamometer with the trucks exercised over limited test cycles. In this study, data were available from a Washington Metropolitan Area Transit Authority emission testing program conducted in 2006. Chassis dynamometer data from two conventional diesel buses, two compressed natural gas buses, and one hybrid diesel bus were evaluated using an expanded driving cycle set of 16 or 17 different driving cycles. Cycle properties and vehicle fuel consumption measurements from three baseline cycles were selected to generate a linear model and then to predict unseen fuel consumption over the remaining 13 or 14 cycles. Average velocity, average positive acceleration, and number of stops per distance were found to be the desired cycle properties for use in the model. The methodology allowed for the prediction of fuel consumption with an average error of 8.5% from vehicles operating on a diverse set of chassis dynamometer cycles on the basis of relatively few experimental measurements. It was found that the data used for prediction should be acquired from a set that must include an idle cycle along with a relatively slow transient cycle and a relatively high speed cycle. The method was also applied to oxides of nitrogen prediction and was found to have less predictive capability than for fuel consumption with an average error of 20.4%.     

Experimental investigation of outdoor and indoor mean concentrations and concentration fluctuations of pollutants

Tracer gas was released upwind of a two-compartment complex shaped building under unstable atmospheric conditions. The mean wind direction was normal to or at 45° to the long face of the building. The general patterns of concentration distribution on the building external walls and inside the building were analysed and the influence of natural and mechanical ventilation on indoor concentration distributions was discussed. Mean concentration levels, as well as the concentration fluctuation intensity, were higher on the windward walls of the building, although concentration levels varied along each wall. Concentration fluctuations measured inside the building were lower than those measured outside. Inside the two compartments of the building, the time series of concentrations had a similar general behaviour; however, gas concentrations took approximately 1.5 times longer to reach the mean maximum concentration value at the downwind compartment 02 while they also decreased more rapidly in the upwind compartment 01 after the source was turned off. The highest indoor concentration and concentration fluctuation values were observed at the detectors located close to the windward walls, especially when the building windows were open. Experiments with and without natural ventilation suggested that infiltration and exfiltration of contaminants is much faster when the building windows are open, resulting to higher indoor concentration levels. Furthermore, mechanical ventilation tends to homogenize concentrations and suppress concentration fluctuations, leading to lower maximum concentration values.     

Printed wiring boards for mobile phones: characterization and recycling of copper

The popularization of mobile phones, combined with a technological evolution, means a large number of scrap and obsolete equipment are discarded every year, thereby causing economic losses and environmental pollution. In the present study, the printed wiring boards scrap of mobile phones were characterized in order to recycle some of the device components, using techniques of mechanical processing, hydrometallurgy and electrometallurgy. The use of the techniques of mechanical processing (milling, particle size classification, magnetic and electrostatic separation) was an efficient alternative to obtain a concentrated fraction (mainly iron in the magnetic fraction and copper in the conductive fraction) and another fraction containing polymers and ceramics. At the end of mechanical processing, a concentrated fraction of metals could be obtained with an average concentration of 60% copper. This concentrated fraction in metals was dissolved in aqua regia and sent to electrowinning to recover 92% of the dissolved copper. The obtained cathodes have a copper content above 95%, which demonstrates the technical feasibility of recovery of copper using the techniques of mechanical processing, hydrometallurgy and electrometallurgy.     

Developmental toxicity of two common corn pesticides to the endangered southern bell frog (Litoria raniformis)

To examine the link between corn agriculture and the observed decline of the endangered southern bell frog (SBF), the effects of two corn crop pesticides on larval growth and development were investigated. Tadpoles were exposed to terbufos sulfone (10 μg/L), a major breakdown product of the insecticide terbufos, and the herbicide atrazine (25 μg/L) individually and as a mixture until the completion of metamorphosis. Atrazine did not interact synergistically with terbufos sulfone or result in significant effects on growth and development alone, although there was some indication of accelerated metamorphosis in the pilot study. Terbufos sulfone alone and as a mixture (terbufos/atrazine) significantly slowed larval development and ultimately delayed metamorphosis. The observed developmental effects from an environmentally relevant concentration of terbufos sulfone indicates a risk posed by this persistent degradation product to the endangered SBF, which breeds and develops in the rice bays adjacent to corn fields treated with pesticides.     

Mobile passive samplers: concept for a novel mode of exposure

Integrative passive sampling with devices such as semipermeable membrane devices generally relies on rigs for month-long static exposures in water. We evaluate here whether mobile exposures of passive samplers can provide reliable estimates of dissolved contaminant concentrations. Mobile exposures were obtained by towing samplers fastened to the end of a benthic trawl net. Significant and reproducible absorption of polycyclic aromatic hydrocarbons during 5 h-long deployments was made possible by high sampling rates resulting from high water turbulences during towing at 1.2-1.5 knots. Sampling rates (72-215 L d⁻¹) estimated from the dissipation of performance reference compounds were supported by in situ calibration with samplers exposed for a 30 days in the vicinity of the test site. Higher fluoranthene and pyrene absorption in samplers exposed to the trawling-induced sediment plume could be attributed to desorption from re-suspended sediments. This mode of exposure has the potential to be used in monitoring programmes.