Synthesis of Soy-Polyol by Two Step Continuous Route and Development of Soy-Based Polyurethane Foam

Soy-polyol has been synthesized via a low energy two-step continuous route thus avoiding intermediate steps and chemicals. The functional groups of soy-polyol thus produced were identified by Fourier transform infrared (FTIR) spectroscopy which confirmed the cleavage of the double bonds, the formation of new epoxy linkages and the presence of hydroxyl groups. The change in chemical structure and physical properties of the soy polyol was further characterized and the results indicated a successful conversion with reduced unsaturation, increased hydroxyl number and increased viscosity. Polyurethane foam was prepared from soy-polyol using isocyanate and thermogravimetric analysis was used to study its thermal decomposition behaviour. Multiple transitions were identified in relation to depolymerization and bond dissociation. Density and compressive strength of the soy-foam were found to be satisfactory. An investigation of microstructure of soy foam by scanning electron microscope and X-ray computed tomography revealed the internal cell morphology and cell structure.     

Critical Steps for Continuing Advancement of Satellite Rainfall Applications for Surface Hydrology in the Nile River Basin1

Gebremichael, Mekonnen, Emmanouil N. Anagnostou, and Menberu M. Bitew, 2010. Critical Steps for Continuing Advancement of Satellite Rainfall Applications for Surface Hydrology in the Nile River Basin. Journal of the American Water Resources Association (JAWRA) 46(2):361-366. DOI: 10.1111/j.1752-1688.2010.00428.x. Abstract: Given the increasingly higher resolution and data accessibility, satellite precipitation products could be useful for hydrological application in the Nile River Basin, which is characterized by lack of reasonably dense hydrological in situ sensors and lack of access to the existing dataset. However, in the absence of both extreme caution and research results for the Nile basin, the satellite rainfall (SR) products may not be used, or may even be used erroneously. We identify two steps that are critical to enhance the value of SR products for hydrological applications in the Nile basin. The first step is to establish representative validation sites in the Nile basin. The validation site will help to quantify the errors in the different kinds of SR products, which will be used to select the best products for the Nile basin, include the errors in decision making, and design strategies to minimize the errors. Using rainfall measurements collected from the unprecedented high-density rain gauge network over a small region within the Nile basin, we indicate that SR estimates could be subject to significant errors, and quantification of estimation errors by way of establishing validation sites is critically important in order to use the SR products. The second step is to identify the degree of hydrologic model complexity required to obtain more accurate hydrologic simulation results for the Nile basin when using SR products as input. The level of model complexity may depend on basin size and SR algorithm, and further research is needed to spell out this dependence for the Nile basin.     

Variation in biogenic volatile organic compound emission pattern of Fagus sylvatica L. due to aphid infection

Volatile organic compounds (VOCs) have been the focus of interest to understand atmospheric processes and their consequences in formation of ozone or aerosol particles; therefore, VOCs contribute to climate change. In this study, biogenic VOCs (BVOCs) emitted from Fagus sylvatica L. trees were measured in a dynamic enclosure system. In total 18 compounds were identified: 11 monoterpenes (MT), an oxygenated MT, a homoterpene (C₁₄H₁₈), 3 sesquiterpenes (SQT), isoprene and methyl salicylate. The frequency distribution of the compounds was tested to determine a relation with the presence of the aphid Phyllaphis fagi L. It was found that linalool, (E)-β-ocimene, α-farnesene and a homoterpene identified as (E)-4,8-dimethyl-1,3,7-nonatriene (DMNT), were present in significantly more samples when infection was present on the trees. The observed emission spectrum from F. sylvatica L. shifted from MT to linalool, α-farnesene, (E)-β-ocimene and DMNT due to the aphid infection. Sabinene was quantitatively the most prevalent compound in both, non-infected and infected samples. In the presence of aphids α-farnesene and linalool became the second and third most important BVOC emitted. According to our investigation, the emission fingerprint is expected to be more complex than commonly presumed.     

Nocturnal boundary layer characteristics and land breeze development in Houston,Texas during TexAQS II

The nocturnal boundary layer in Houston, Texas was studied using a high temporal and vertical resolution tethersonde system on four nights during the Texas Air Quality Study II (TexAQS II) in August and September 2006. The launch site was on the University of Houston campus located approximately 4 km from downtown Houston. Of particular interest was the evolution of the nocturnal surface inversion and the wind flows within the boundary layer. The land–sea breeze oscillation in Houston has important implications for air quality as the cycle can impact ozone concentrations through pollutant advection and recirculation. The results showed that a weakly stable surface inversion averaging in depth between 145 and 200 m AGL formed on each of the experiment nights, typically within 2–3 h after sunset. Tethersonde vertical winds were compared with two other Houston data sets (High Resolution Doppler Lidar and radar wind profiler) from locations near the coastline and good agreement was found, albeit with a temporal lag at the tethersonde site. This comparison revealed development of a land breeze on three nights which began near the coastline and propagated inland both horizontally and vertically with time. The vertical temperature structure was significantly modified on one night at the tethersonde site after the land breeze wind shift, exhibiting near-adiabatic profiles below 100 m AGL.     

Improvements to lawn and garden equipment emissions estimates for Baltimore, Maryland

Lawn and garden equipment are a significant source of emissions of volatile organic compounds (VOCs) and other pollutants in suburban and urban areas. Emission estimates for this source category are typically prepared using default equipment populations and activity data contained in emissions models such as the U.S. Environmental Protection Agency's (EPA) NONROAD model or the California Air Resources Board's (CARB) OFFROAD model. Although such default data may represent national or state averages, these data are unlikely to reflect regional or local differences in equipment usage patterns because of variations in climate, lot sizes, and other variables. To assess potential errors in lawn and garden equipment emission estimates produced by the NONROAD model and to demonstrate methods that can be used by local planning agencies to improve those emission estimates, this study used bottom-up data collection techniques in the Baltimore metropolitan area to develop local equipment population, activity, and temporal data for lawn and garden equipment in the area. Results of this study show that emission estimates of VOCs, particulate matter (PM), carbon monoxide (CO), carbon dioxide (CO2), and nitrogen oxides (NO(x)) for the Baltimore area that are based on local data collected through surveys of residential and commercial lawn and garden equipment users are 24-56% lower than estimates produced using NONROAD default data, largely because of a difference in equipment populations for high-usage commercial applications. Survey-derived emission estimates of PM and VOCs are 24 and 26% lower than NONROAD default estimates, respectively, whereas survey-derived emission estimates for CO, CO2, and NO(x) are more than 40% lower than NONROAD default estimates. In addition, study results show that the temporal allocation factors applied to residential lawn and garden equipment in the NONROAD model underestimated weekend activity levels by 30% compared with survey-derived temporal profiles.     

Simulating the fine and coarse inorganic particulate matter concentrations in a polluted megacity

A three dimensional chemical transport model (PMCAMx) is applied to the Mexico City Metropolitan Area (MCMA) in order to simulate the chemical composition and mass of the major PM₁ (fine) and PM_1–10 (coarse) inorganic components and determine the effect of mineral dust on their formation. The aerosol thermodynamic model ISORROPIA-II is used to explicitly simulate the effect of Ca, Mg, and K from dust on semi-volatile partitioning and water uptake. The hybrid approach is applied to simulate the inorganic components, assuming that the smallest particles are in thermodynamic equilibrium, while describing the mass transfer to and from the larger ones. The official MCMA 2004 emissions inventory with improved dust and NaCl emissions is used. The comparison between the model predictions and measurements during a week of April of 2003 at Centro Nacional de Investigacion y Capacitacion Ambiental (CENICA) “Supersite” shows that the model reproduces reasonably well the fine mode composition and its diurnal variation. Sulfate predicted levels are relatively uniform in the area (approximately 3 μg m^?3), while ammonium nitrate peaks in Mexico City (approximately 7 μg m^?3) and its concentration rapidly decreases due to dilution and evaporation away from the urban area. In areas of high dust concentrations, the associated alkalinity is predicted to increase the concentration of nitrate, chloride and ammonium in the coarse mode by up to 2 μg m^?3 (a factor of 10), 0.4 μg m^?3, and 0.6 μg m^?3 (75%), respectively. The predicted ammonium nitrate levels inside Mexico City for this period are sensitive to the physical state (solid versus liquid) of the particles during periods with RH less than 50%.     

Equilibration time scales of organic aerosol inside thermodenuders: Evaporation kinetics versus thermodynamics

The interpretation of thermodenuder (TD) data often relies on the assumption that thermodynamic equilibrium is reached inside the instrument. We modeled the evaporation of three organic aerosol types (adipic acid, α-pinene SOA and aged OA) inside a thermodenuder with a mass transfer model, and calculated equilibration time scales for these systems at realistic conditions. The equilibrium times varied from less than a second to several hours, decreasing with increasing aerosol concentrations, decreasing particle sizes, decreasing volatilities and increasing mass accommodation coefficients. The results indicate that generally TDs measure particle evaporation rates rather than equilibria, and time-dependent modeling of the evaporation is usually needed to interpret the data. Measurements at varying residence times and temperatures, on the other hand, are desirable to investigate the equilibration of the studied aerosol and decouple the kinetic effects from the effects caused by the thermodynamic properties of the aerosol. Organic aerosol is likely to be further from equilibrium under typical field conditions compared with laboratory data. When determining the aerosol properties from TD data, assuming incorrectly equilibrium results in under-prediction of the vaporization enthalpy of the evaporating species. Similar under-estimation is predicted if multicomponent aerosols are approximated with single-component properties.     

Ambient TSP concentration and dustfall in major cities of China: Spatial distribution and temporal variability

Based on environmental monitoring data in 93 major cities and meteorological records at 398 weather stations in China from 1981 to 2007, total suspended particle (TSP) concentration, the intensity of dustfall, and sand and dust storm frequency (F_d) were analysed. During the past 27 years, the annual average TSP concentration (C_TSP) in 93 cities was 402 μg m^?3. Annual average C_TSP decreased from the north to the south and from inland to the coast areas with a peak value of 628.8 μg m^?3 in Lanzhou. In the 1980s, 1990s and 2000s, annual average C_TSP was 628.7, 319.2, and 250.1 μg m^?3, respectively. Annual average intensity of dustfall (I_d) was 240.5 t km^?2 a^?1, decreased from northern to southern China and from inland to the coast areas with the maximum value of 717.2 t km^?2 a^?1 in Baotou. In the 1980s, 1990s and 2000s, annual average I_d was 334.8, 220.9, 146 t km^?2 a^?1 respectively. Annual average I_d in the Loess Plateau region was commonly higher than 200 t km^?2 a^?1. The annual average F_d decreased from arid regions in northwestern China to humid areas in southeastern China with two sand and sand storm centers existing in Xinjiang Taklamakan Desert and western Inner Mongolia. The annual average F_d in the 1980s, 1990s, 2000s was 16, 8, 6 days respectively, decreased steadily from 18 days in 1981–5 days in 2007. Annual average I_d had a positive linear relation to annual average C_TSP (R² = 0.96). Annual average F_d had a positive relation with annual average C_TSP (R² = 0.97) as well as annual average I_d (R² = 0.94). TSP was the chief pollutant influencing Air Pollution Index (API) in northern China in spring and winter seasons. Sand and dust storm might be a major factor affecting the temporal variability and spatial distribution of TSP and dustfall in China.     

Improved land cover and emission factors for modeling biogenic volatile organic compounds emissions from Hong Kong

This paper describes a study of local biogenic volatile organic compounds (BVOC) emissions from the Hong Kong Special Administrative Region (HKSAR). An improved land cover and emission factor database was developed to estimate Hong Kong emissions using MEGAN, a BVOC emission model developed by Guenther et al. (2006). Field surveys of plant species composition and laboratory measurements of emission factors were combined with other data to improve existing land cover and emission factor data. The BVOC emissions from Hong Kong were calculated for 12 consecutive years from 1995 to 2006. For the year 2006, the total annual BVOC emissions were determined to be 12,400 metric tons or 9.82 × 10⁹ g C (BVOC carbon). Isoprene emission accounts for 72%, monoterpene emissions account for 8%, and other VOCs emissions account for the remaining 20%. As expected, seasonal variation results in a higher emission in the summer and a lower emission in the winter, with emission predominantly in day time. A high emission of isoprene occurs for regions, such as Lowest Forest-NT North, dominated by broadleaf trees. The spatial variation of total BVOC is similar to the isoprene spatial variation due to its high contribution. The year to year variability in emissions due to weather was small over the twelve-year period (?1.4%, 2006 to 1995 trendline), but an increasing trend in the annual variation due to an increase in forest land cover can be observed (+7%, 2006 to 1995 trendline). The results of this study demonstrate the importance of accurate land cover inputs for biogenic emission models and indicate that land cover change should be considered for these models.     

Why ozonolysis may not increase the hydrophilicity of particles

It is commonly assumed that atmospheric oxidation of hydrocarbon particles or hydrocarbon coatings on particles leads to polar products and increased water uptake, altering atmospheric visibility and increasing the likelihood they will act as cloud condensation nuclei (CCN). We show here through laboratory experiments that increased water uptake depends on the 3-dimensional structure of the particles. Laboratory studies of particles formed during ozonolysis of surface-bound alkenes, present as terminally unsaturated self-assembled monolayers (C8= SAM) on a silica substrate, were carried out at room temperature and 1 atm pressure. SAMs were exposed to ～10¹³ O₃ molecules cm^?3 for 40 min and resultant particles were analyzed using single particle Fourier transform infrared micro-spectroscopy (micro-FTIR) and secondary ion mass spectroscopy (SIMS). Spectroscopy results show that –COOH and other polar groups are formed but are buried inside a hydrophobic shell, consistent with earlier observations (McIntire et al., 2005, Moussa et al., 2009) that water uptake does not increase after reaction of the terminal alkene with O₃. These insights into the 3-D structure of particles formed on oxidation have important implications for the ability of secondary organic aerosols to act as CCN. In addition, the nature of the surface of the particles is expected to determine their uptake into biological systems such as the surface of the lungs.