Twentieth century droughts and agriculture: Examples from impacts on soybean production in Kentucky,USA

Drought is a significant natural hazard that slowly evolves over time. Because of its character, drought is difficult to monitor and impacts are often poorly documented. Agriculture is one of the most sensitive sectors that are prone to drought. The objective of this research is to assess the impacts of drought on soybean production and revenue in Kentucky. Soybeans are one of Kentucky’s most important commodities. In this study, impacts of 1930–1931, 1940–1942, 1952–1955, 1987–1988, 1999–2000, and 2007 droughts were considered. It was found that over the recent years, up to 56 % of the revenue from soybeans was lost due to drought. During the first half of the twentieth century, revenue loss reached up to 77 %. This research is valuable to the general public as well as planners and policy makers. Proper documentation of impacts of past droughts will help identify drought vulnerabilities and results in better risk management and mitigation.     

生物滴滤塔净化挥发性有机废气动力学模型研究

通过对生物滴滤塔净化VOCs废气过程的分析,建立了动力学模型,简化处理后得出了基于生物降解为一级反应动力学和零级反应动力学的污染物浓度沿填料层高度变化的方程,并通过实验数据对方程进行了验证,结果表明基于生物降解一级反应动力学的方程能较好地与实验数据吻合,但常数ξα/Q却随入口浓度Cgi的增大而升高。最后,采用实验数据回归出了ξα/Q随Cg变化的曲线。     

以膨润土为辅助添加剂固化/稳定化污泥的试验研究

针对传统以水泥固化污泥,带来的水泥用量大与固化体的浸出液pH过高等问题,提出了以膨润土为添加剂辅助水泥固化/稳定化污泥的思路.通过开展无侧限抗压强度试验、毒性浸出试验,测量掺入膨润土后污泥固化体的强度、重金属浸出率、浸出液COD及pH值,研究该固化/稳定化方法的效果.结果表明,膨润土的掺入极大地提高了固化体的抗压强度,将掺入量为0.4(相对污泥的质量比)的水泥一半用膨润土替代时,固化体的强度提高了6左右.体积安定性也能够满足要求.随膨润土掺入量增加,固化体中锌、铅的浸出率与浸出液的pH值呈现不断减小的趋势,锌与铅的浸出率分别由6.9%下降至0.25%,9.6%下降至5%,pH值由12.3下降至12.1.在强碱条件下及烘干或风干条件下,铜会随着有机物的分解而析出,从而增加铜的浸出率,而膨润土的加入能弥补水泥造成的强碱环境及风干或烘干过程对固化污泥中铜的稳定产生的不利影响.     

Water-soluble matter in PM2.5 in a coastal city over China: Chemical components, optical properties, and source analysis

Although marine and terrestrial emissions simultaneously affect the formation of atmospheric fine particles in coastal areas, knowledge on the optical properties and sources of water-soluble matter in these areas is still scarce. In this work, taking Qingdao, China as a typical coastal location, the chemical composition of PM_2.5 during winter 2019 was analyzed.Excitation-emission matrix fluorescence spectroscopy was combined with parallel factor analysis model to explain the component...     

Production of new concrete with leather tannery waste used as partial replacement of the natural sand

Journal of Material Cycles and Waste Management - Leather production is a technology that boosts the economy because of its versatility and durability. However, the wastes generated throughout the...     

Face mask and medical waste generation in the City of Baguio,Philippines: its current management and GHG footprint

Journal of Material Cycles and Waste Management - The daily use of facemask to prevent virus transmission increases the negative effect on the environment because of improper waste disposal. Due to...     

Capacity assessment to secure COVID-19 waste treatment in Vietnam

Journal of Material Cycles and Waste Management - The accelerated generation of COVID-19 waste under the Delta-fuelled outbreak placed a sudden burden on waste disposal in Vietnam. To secure the...     

Zinc removal from synthetic waters using magnetite/graphene oxide composites

The removal of heavy metals from wastewater has become a global challenge, which demands the continuous study of efficient and low-cost treatment alternatives such as adsorption. In this research, the removal of zinc was evaluated using batch adsorption processes with nonconventional materials such as graphene oxide (GO), magnetite (MG), and their composites (GO:MG), formulated with three weight ratios (2:1, 1:1, and 1:2). Graphene was synthesized by the modified Marcano method, using pencil lead graphite as a precursor. MG and the composites were synthesized by chemical coprecipitation of ferrous sulfate and ferric chloride. The materials were characterized by Raman and Fourier transform infrared spectroscopies, scanning electron microscopy, X-ray diffraction, and the Brunauer–Emmett–Teller method to determine the functional groups, microstructural and morphological characteristics, and specific surface area. Batch adsorption tests were carried out to optimize the adsorbent dose and contact time with zinc solutions of 10 ppm. Zinc adsorption reached equilibrium at 2 h, with an optimal dose between 0.25 and 1.0 g/L. The maximum zinc removal efficiencies/adsorption capacities were 98.6%/165.6, 83.4%/47.6, 83.5%/21.9, 72.8%/19.9, and 82.2%/9.25 mg/g using GO, 2GO:1MG, 1GO:1MG, 1GO:2MG, and MG, respectively. Furthermore, the analysis of the isotherm and adsorption kinetics models determined that the adsorption processes using MG and the composites fit the Sips and pseudo-second-order models.     

Nutrient pathways and their susceptibility to past and future change in the Eurasian Arctic Ocean

Climate change is altering nutrient cycling within the Arctic Ocean, having knock-on effects to Arctic ecosystems. Primary production in the Arctic is principally nitrogen-limited, particularly in the western Pacific-dominated regions where denitrification exacerbates nitrogen loss. The nutrient status of the eastern Eurasian Arctic remains under debate. In the Barents Sea, primary production has increased by 88% since 1998. To support this rapid increase in productivity, either the standing stock of nutrients has been depleted, or the external nutrient supply has increased. Atlantic water inflow, enhanced mixing, benthic nitrogen cycling, and land–ocean interaction have the potential to alter the nutrient supply through addition, dilution or removal. Here we use new datasets from the Changing Arctic Ocean program alongside historical datasets to assess how nitrate and phosphate concentrations may be changing in response to these processes. We highlight how nutrient dynamics may continue to change, why this is important for regional and international policy-making and suggest relevant research priorities for the future.Supplementary InformationThe online version contains supplementary material available at 10.1007/s13280-021-01673-0.     

Mineralogical characterization of the Tournemire argillite after in situ interaction with concretes

This study aims to investigate, through mineralogical characterization (SEM, XRD) and mass-balance calculations, the effects of contact time, concrete types and presence of free water on the Tournemire argillite under in situ conditions. Three sampling zones from Excavation Disturbed Zone (EDZ) areas have been chosen: (1) dry contacts, collected at the tunnel masonry/argillite interface (contact time - 125 years), (2) wet contacts, taken close to drained areas below the tunnel roadbed in contact with the canal draining the Cernon fault water (contact time - 15 and 7 years) and at the tunnel masonry/argillite interface over 70 m from the Cernon fault (contact time - 125 years). This study shows that: in the absence of water, no significant modification of argillite is observed after 125 years, except for pyrite dissolution and gypsum precipitation; in the presence of water, precipitation of gypsum, recrystallization of mixed-layer clays, neoformation of zeolites and K-feldspars overgrowths are observed. At the concrete/argillite interface near the Cernon fault, important dolomite neoformation and leaching of chlorite and kaolinite occur. These processes are enhanced with contact time, low flow rate and the nature of the concrete (compound cement Portland CEM II 32.5). Evidence for oxidation processes linked to the EDZ (pyrite oxidation, Fe-oxy-hydroxide and gypsum precipitation) is observed.