Wet weather impact on trihalomethane formation potential in tributaries to drinking water reservoirs

During rain storm events, land surface runoff and resuspension of bottom sediments cause an increase in Trihalomethane (THM) precursors in rivers. These precursors, when chlorinated at water treatment facilities will lead to the formation of THMs and hence impact drinking water resources. In order to evaluate the wet weather impact on the potential formation of THMs, river samples were collected before, during and after three rain storms ranging from 15.2 to 24.9 mm precipitation. The samples were tested for THM formation potential and other indicators including UV254 absorbance, turbidity and volatile suspended solid (VSS). Average levels of THMs increased from 61 μg/l during dry weather to 131 μg/l during wet weather, and then went back to 81 μg/l after rain ended. Wet weather values of THM are well above the maximum contaminant level (MCL) 80 μg/l, set by EPA for drinking water. THM indicators also exhibited similar trends. Average levels increased from 0.6 to 1.8 abs; 2.6 to 6 ntu; and 7.5 to 15 mg/l respectively for UV254, turbidity and VSS. A positive correlation was observed between THM formation and THM indicators. The t-test of significance (p-value) was less than 0.05 for all indicators, and R values ranged from 0.85 to 0.92 between THMs and the indicators, and 0.72 to 0.9 among indicators themselves.     

Indoor and outdoor PM mass and number concentrations at schools in the Athens area

Simultaneous indoor and outdoor PM₁₀ and PM_2.5 concentration measurements were conducted in seven primary schools in the Athens area. Both gravimetric samplers and continuous monitors were used. Filters were subsequently analyzed for anion species. Moreover ultrafine particles number concentration was monitored continuously indoors and outdoors. Mean 8-hr PM₁₀ concentration was measured equal to 229 ± 182 μg/m³ indoors and 166 ± 133 μg/m³ outdoors. The respective PM_2.5 concentrations were 82 ± 56 μg/m³ indoors and 56 ± 26 μg/m³ outdoors. Ultrafine particles 8-h mean number concentration was measured equal to 24,000 ± 17,900 particles/cm³ indoors and 32,000 ± 14,200 particles/cm³ outdoors. PM₁₀ outdoor concentrations exhibited a greater spatial variability than the corresponding PM_2.5 ones. I/O ratios were close or above 1.00 for PM₁₀ and PM_2.5 and smaller than 1.00 for ultrafine particles. Very high I/O ratios were observed when intense activities took place. The initial results of the chemical analysis showed that accounts for the 6.6 ± 3.5% of the PM₁₀ and for the 3.1 ± 1.4%.The corresponding results for PM_2.5 are 12.0 ± 7.7% for and 3.1 ± 1.9% for . PM_2.5 indoor concentrations were highly correlated with outdoor ones and the regression line had the largest slope and a very low intercept, indicative of no indoor sources of fine particulate . The results of the statistical analysis of indoor and outdoor concentration data support the use of as a proper surrogate for indoor PM of outdoor origin.     

Using the polychaete Arenicola marina to determine toxicity and bioaccumulation of PAHS bound to sediments

Transportation system has contributed significantly to the development of human civilization; on the other hand it has an enormous impact on the ambient air quality in several ways. In this paper the air and noise pollution at selected sites along three sections of National Highway was monitored. Pakistan National Highway Authority has started a Highway Improvement program for rehabilitations and maintenance of National highways to improve the traffic flows, and would ultimately improve the air quality along highways. The ambient air quality and noise level was monitored at nine different locations along these sections of highways to quantify the air pollution. The duration of monitoring at individual location was 72 h. The most of the sampling points were near the urban or village population, schools or hospitals, in order to quantify the air pollution at most affected locations along these roads. A database consisting of information regarding the source of emission, local metrology and air quality may be created to assess the profile of air quality in the area.     

Magnesium hydroxide bulk and colloid-associated 152Eu in an alkaline environment: colloid characterisation and sorption properties in the presence and absence of carbonate

The distribution of 152Eu between magnesium hydroxide bulk, colloids and solution has been assessed under alkaline conditions, such as those in nuclear fuel storage ponds. The colloidal phase has been characterised by two complementary methods: coupled ultrafiltration-ICP-AES and scanning electron microscopy. The quantity and the size distribution of the colloidal phase is strongly ionic strength-dependent. A decrease of the quantity of colloids, in particular the larger size ranges, has been observed with increasing ionic strength. Small colloids (1 kDa-10 kDa fraction) are predominant at all ionic strengths. The morphology of colloids, observed by field-emission gun scanning electron microscopy, appears to change from hexagonal prismatic (characteristic to the mineral) to spherical (energetically more favourable) as size decreases. The distribution of 152Eu between the solid and liquid/colloidal phases has been investigated at carbonate concentrations ranging from 0 to 10(-2) M by coupled ultrafiltration and gamma-spectrometry. Mg(OH)2 bulk appears to be a very strong sorbent for 152Eu, since complete sorption onto the bulk happens for carbonate concentrations as high as 10(-3) M. Scavenging of 152Eu by Mg(OH)2 colloids is negligible in the presence of Mg(OH)2 bulk. The distribution of 152Eu between liquid and colloidal phases has been investigated in the absence of bulk at various carbonate concentrations. A significant uptake of 152Eu by the colloids in solution has been observed, which decreases with increasing carbonate concentration. 152Eu appears to be mainly associated to the smallest colloids (1 kDa-10 kDa fraction). There is a strong correlation between the sorption properties and the surface area of the colloids.     

Simplified determination of lipophilic metabolites of nonylphenol ethoxylates: method development and application in aqueous samples from Buenos Aires, Argentina

In the present work we have developed an analytical methodology for the determination of nonylphenol (NP) and nonylphenol mono- and di-ethoxylates (NP1EO and NP2EO) in water samples. The applicability of this methodology was proved by means of the analysis of environmentally relevant aqueous samples from Buenos Aires. This constitutes a starting point for a rigorous assessment of the incidence of NPnEO surfactants in Argentina, as only very few, qualitative or semi-quantitative data on the occurrence of these compounds in local systems were available up to this time. Enrichment of the analytes was carried out by solid-phase extraction on a C-18 sorbent, followed by elution with ethyl acetate. Normal-phase high performance liquid chromatography on an amino-silica column and fluorescence detection at excitation-emission wavelengths of 230-300 nm were employed for separation and quantification of the analytes. Confirmation of peak assignment in selected real samples was performed by off-line coupling HPLC with GC-MS analysis. A non-polar GC capillary column was used, and a characteristic peak pattern was obtained for the alkyl chain isomers of each ethoxylated homologue and NP. GC-MS analyses yielded in all cases purity levels higher than 80% for the HPLC collected fractions. The elevated concentrations found for the estrogenic metabolites of NPnEO are in accordance with an unrestricted use of this class of non-ionic surfactants in the country.     

Passive sampling of glycol ethers and their acetates in indoor air

This study examined the performances of a thermal desorbable radial diffusive sampler for the weekly measurement of eight glycol ethers in indoor air and described the results of an application of this method carried out as part of HABIT'AIR Nord - Pas de Calais program for the air monitoring of these compounds in sixty homes located in northern France. The target compounds were the four glycol ethers banned from sale to the public in France since the 1990s (i.e. 2-methoxy ethanol, 2-ethoxy ethanol and their acetates) and four other glycol ethers derivatives of which the use have increased considerably (i.e. 1-methoxy-2-propanol, 2-butoxy ethanol and their acetates).A test program was carried out with the aim of validating the passive sampling method. It allowed the estimation of all the parameters of a method for each compound (calibration, analytical precision, desorption efficiency, sampling rate in standard conditions, detection limit and stability of sample before and after exposure), the examination of the influence of environmental factors on the sampling rate by some exposure chamber experiments and the assessment of the uncertainty of the measurements.The results of this evaluation demonstrated that the method has turned out to be suitable for six out of eight glycol ethers tested. The effect of the environmental factors on the sampling rates was the main source of measurement uncertainty. The measurements done in sixty homes revealed a relative abundance of 1-methoxy-2-propanol that was found in more than two thirds of homes at concentration levels of 4.5 microg m(-3) on average (a maximum value of 28 microg m(-3)). 1-methoxy-2-propanol acetate and 2-butoxy ethanol were also detected, but less frequently (in 19% of homes) and with the concentrations below 12 microg m(-3). The highest levels of these glycol ethers appear to be in relation to the emissions occurring at the time of cleaning tasks.     

Preliminary assessment of polybrominated diphenyl ethers (PBDEs) in the Scottish aquatic environment, including the Firth of Clyde

This paper presents preliminary data on polybrominated diphenyl ethers (PBDEs) in the Scottish aquatic environment. Sediment and biota (fish liver, fish muscle and mussels) from a number of locations around Scotland were analysed for PBDEs with samples being from both remote and from potentially contaminated areas such as the former sewage sludge dump site at Garroch Head in the Clyde. PBDEs were measured in both cultivated, rope grown mussels and wild mussels collected from 5 sites around Scotland in 2006. Total PBDE concentrations (sum of tri- to hepta-BDEs) ranged from 相似文献   

Hydrologic–Economic Model for Managing Irrigation Intensity in Irrigation Areas under Watertable and Soil Salinity Targets

This paper gives mathematical details and sample applications of SWAGMAN Farm (SWAGMAN, Salt Water and Groundwater Management), a farm-scale hydrologic economic model that integrates agronomic, climatic, irrigation, hydrogeological and economic aspects of irrigated agriculture. The model is capable of determining optimum mix of land use to keep watertable and soil salinity within acceptable limits while maximising the economic returns. Alternatively, the model can simulate water and salt balance and economics of a given cropping preference. Web-based and Geographic Information Systems versions of the model are available for integration with the environmental reporting systems of the irrigation areas.     

Quantitative arsenic speciation in two species of earthworms from a former mine site

The relationship between the total arsenic concentration and the chemical speciation of arsenic in two species of earthworm (Lumbricus rubellus and Dendrodrilus rubidus) in relation to the host soil, was investigated for 13 sites of varying arsenic content, including a background level garden soil and a former mine site at the Devon Great Consols, UK. Earthworms were collected with the host soil (As soil concentration range 16-12, 466 mg kg(-1) dry weight) and measured for their total arsenic (concentration range 7-595 mg kg(-1) dry weight) using inductively coupled plasma mass spectrometry (ICP-MS). A methanol-water mixture was used to extract arsenic species from the earthworms prior to determination of the individual arsenic species by a combination of anion and cation exchange high performance liquid chromatography coupled to inductively coupled plasma mass spectrometry (HPLC-ICP-MS). A gradient elution anion exchange method is presented whereby nine arsenic species could be measured in one sample injection. Arsenic species were identified by comparison of retention times and sample spiking with known standards and a fully characterised seaweed extract. Arsenic was generally present in the earthworm as arsenate (As(V)) or arsenite (As(III)) and arsenobetaine (AB). Methylarsonate (MA), dimethylarsinate (DMA) and three arsenosugars (glycerol, phosphate, sulfate) were present as minor constituents. These results are discussed in relation to the mechanisms for coping with exposure to soil bound arsenic.