Evaluation of Regenerative-air Vacuum Street Sweeping on Geological Contributions to PM10

Street sweeping is often proposed as a means of reducing the emissions from paved roads. The objective of this study was to evaluate the effectiveness of street sweeping on ambient particulate matter concentrations and to determine the difference In source contributions to PM10 concentrations between street sweeping and non-street sweeping periods.

Chemically-speciated measurements of PM10 and PM2.5 were taken in the commercial section of Reno, Nevada, for a one-month sampling period. The Chemical Mass Balance (CMB) model was applied to these data and an average of approximately 50 percent of the PM10 was apportioned to resuspended geological material. During half of the sampling period, streets In the vicinity of the sampling site were completely swept with a regenerative-air vacuum sweeper, while no sweeping was performed during the remainder of the experiment. Ratios of primary geological contributions divided by primary motor vehicle contributions to PM10 were compared between sweeping and non-sweeping periods using analysis of variance. This ratio of source contributions minimizes the effects of variations in traffic volume and meteorological dispersion. No significant differences in geological contributions to PM10 were detected as a result of regenerative-air vacuum street sweeping.     

Ozone Control Strategies Based on the Ratio of Volatile Organic Compounds to Nitrogen Oxides

The 1990 Clean Air Act Amendments require states with O₃ nonattainment areas to adopt regulations to enforce reasonable available control technologies (RACT) for NO_X stationary sources by November 1992. However, if the states can demonstrate that such measures will have an adverse effect on air quality, NO_X requirements may be waived. To assist the states in making this decision, the U.S. EPA is attempting to develop guidelines for the states to use in deciding whether NO_X reductions will have a positive or negative impact on O3 air quality. Although NO_X is a precursor of O₃, at low VOC/NO_X ratios, the reduction of NO_X can result in increased peak O₃. EPA is examining existing information on VOC/NO_X ratios to develop “rules of thumb” to guide the states in their decision-making process. An examination of 6 a.m. to 9 a.m. VOC/NO_X ratios at a number of sites in the eastern U.S. indicates that the ratio is highly variable from day-to-day and there is no apparent relationship between ratios measured at different sites within the same area. In addition, statistical analysis failed to identify significant relationships between the 6 a.m. to 9 a.m. VOC/NO_X ratio and the maximum 1-hr. O₃ within a given area. Since we know from smog chamber and modeling studies that such a relationship exists, this further invalidates the assumption that a ratio measured at a single site is representative of the ratio for the entire region. Based on this Information, we conclude that having the 6 a.m. to 9 a.m. ambient VOC/NO_X ratio for a given area is insufficient information, by itself, to decide whether a VOC-alone, a NO_x-alone, or a combined VOC-NO_X reduction strategy is a viable or optimum O₃-reduction strategy.     

Limestone Dissolution in Flue Gas Scrubbing: Effect of Sulfite

Batch limestone dissolution experiments were carried out in a pH stat apparatus at 55°C with CO2 sparging and dissolved sulfite. Particle size distribution, utilization, sulfite in solution, limestone type, and the approach to calcite equilibrium were all found to contribute to the limestone reactivity. In the absence of sulfite, limestone dissolution was controlled solely by mass transfer. For a given stone under mass transfer control, film thickness was found to be independent of pH. The dissolution rate in the presence of sulfite was controlled by a combined surface kinetics/mass transfer regime. SEM micrographs supported this conclusion. A surface rate correlation was developed which accounted for observed inhibition by an inverse dependence on calcium sulfite concentration at the limestone surface. While the form of the rate expression was applicable to all stones, the surface rate constant was stone dependent. A computer code which accounted for mass transfer with surface kinetics was tested against experimental observations of four limestone types. Changes in pH and the concentrations of calcium, carbonate, sulfite, sulfate, and adipic acid were accurately modeled.     

Characterization of Municipal Solid Waste Incineration Residues From Facilities with Different Air Pollution Control Systems

Abstract

Municipal Solid Waste incinerator residues produced in two types of facilities were exhaustively characterized: granulometry, mineralogy, chemical composition, leaching behavior, and elemental distribution as a function of particle size. Air Pollution Control (APC) residues coming from a semi-dry scrubber have shown higher solubility than fly ashes originating in an Electrostatic Precipitator (ESP), as well as higher contents in volatile metals (Cd, Hg). Different metal speciation and distribution as a function of particle size have been found in fly ashes (ESP residues) and APC residues. In APC residues, heavy metals (with the exception of Hg) show a parabolic distribution with maxima in the smallest and largest particles, following the same profile as soluble salts. Metal distribution for APC residues exhibits that metals generally are not associated with silicate aluminate matrix. Results show the effect of adding lime to APC residues in metal speciation and distribution.     

Comparison of Computer Simulations of Total Lung Deposition to Human Subject Data in Healthy Test Subjects

ABSTRACT

A mathematical model was used to predict the deposition fractions (DF) of PM within human lungs. Simulations using this computer model were previously validated with human subject data and were used as a control case. Human intersubject variation was accounted for by scaling the base lung morphology dimensions based on measured functional residual capacity (FRC) values. Simulations were performed for both controlled breathing (tidal volumes [V_T] of 500 and 1000 mL, respiratory times [T] from 2 to 8 sec) and spontaneous breathing conditions. Particle sizes ranged from 1 to 5 um. The deposition predicted from the computer model compared favorably with the experimental data. For example, when V_T = 1000 mL and T = 2 sec, the error was 1.5%. The errors were slightly higher for smaller tidal volumes. Because the computer model is deterministic (i.e., derived from first principles of physics), the model can be used to predict deposition fractions for a range of situations (i.e., for different ventilatory parameters and particle sizes) for which data are not available. Now that the model has been validated, it may be applied to risk assessment efforts to estimate the inhalation hazards of airborne pollutants.     

Exposure of Chronic Obstructive Pulmonary Disease Patients to Particulate Matter: Relationships between Personal and Ambient Air Concentrations

ABSTRACT

Most time-series studies of particulate air pollution and acute health outcomes assess exposure of the study population using fixed-site outdoor measurements. To address the issue of exposure misclassification, we evaluate the relationship between ambient particle concentrations and personal exposures of a population expected to be at risk of particle health effects.

Sampling was conducted within the Vancouver metropolitan area during April-September 1998. Sixteen subjects (non-smoking, ages 54-86) with physician-diagnosed chronic obstructive pulmonary disease (COPD) wore personal PM_{2 5} monitors for seven 24-hr periods, randomly spaced approximately 1.5 weeks apart. Time-activity logs and dwelling characteristics data were also obtained for each subject. Daily 24-hr ambient PM₁₀ and PM_2.5 concentrations were measured at five fixed sites spaced throughout the study region. SO₄ ^2-, which is found almost exclusively in the fine particle fraction and which does not have major indoor sources, was measured in all PM_{2 5} samples as an indicator of accumulation mode particu-late matter of ambient origin.     

In Situ Monitoring of the Mutagenic Effects of the Gaseous Emissions of a Solid Waste Incinerator in Metropolitan São Paulo,Brazil, Using the Tradescantia Stamen-Hair Assay

ABSTRACT

The present work was designed to determine the potential genotoxicity at the vicinity of a solid waste incinerator in the metropolitan area of Sâo Paulo, using the Tradescantia stamen-hair bioassay. Experiments were carried out between December 1998 and April 1999 in four regions (40 pots of plants per site) selected on the basis of their pollution levels predicted by theoretical modeling of the dispersion of the incinerator's plume. The exposure sites were defined as follows: highest level (incinerator); a high level (museum) located 1.5 km from the emission point; a moderate level (school, at a distance of 3.5 km from the incinerator); and a control (at Jaguariuna countryside). The difference in genotoxicity among the groups was statistically significant (p < 0.001). The frequency of mutations observed in the countryside was significantly lower [2.25 ± 1.55, mean ± SD (standard deviation)] than that of the sites close to the incinerator. The frequency of mutations measured at the school (3.70 ± 1.36) was significantly lower than that measured at both the museum (4.89 ± 1.12) and the incinerator (5.69 ± 1.34). In conclusion, we found a positive correlation between the spatial distribution of the emissions of the incinerator located in an urban area and the mutagenic events measured by the Tradescantia stamen-hair assay. The in situ approach employed in this study was simple, efficient, and of low cost. No air or chemical extraction of pollutants was necessary for genotoxicity testing as required by other assays.     

An Environmental Decision-Making Tool for Evaluating Ground-Level Ozone-Related Health Effects

Abstract

A computer model called the Ozone Risk Assessment Model (ORAM) was developed to evaluate the health effects caused by ground-level ozone (O₃) exposure. ORAM was coupled with the U.S. Environmental Protection Agency’s (EPA) Third-Generation Community Multiscale Air Quality model (Models-3/CMAQ), the state-of-the-art air quality model that predicts O₃ concentration and allows the examination of various scenarios in which emission rates of O₃ precursors (basically, oxides of nitrogen [NO_x] and volatile organic compounds) are varied. The principal analyses in ORAM are exposure model performance evaluation, health-effects calculations (expected number of respiratory hospital admissions), economic valuation, and sensitivity and uncertainty analysis through a Monte Carlo simulation. As a demonstration of the system, ORAM was applied to the eastern Tennessee region, and the entire O₃ season was simulated for a base case (typical emissions) and three different emission scenarios. The results indicated that a synergism occurs when reductions in NO_x emissions from mobile and point sources were applied simultaneously. A 12.9% reduction in asthma hospital admissions is expected when both mobile and point source NO_x emissions are reduced (50 and 70%, respectively) versus a 5.8% reduction caused by mobile source and a 3.5% reduction caused by point sources when these emission sources are reduced individually.     

Weekday/Weekend Ozone Differences: What Can We Learn from Them?

Abstract

A national analysis of weekday/weekend ozone (O₃) differences demonstrates significant variation across the country. Weekend 1-hr or 8-hr maximum O₃ varies from 15% lower than weekday levels to 30% higher. The weekend O₃ increases are primarily found in and around large coastal cities in California and large cities in the Midwest and Northeast Corridor. Both the average and the 95th percentile of the daily 1-hr and 8-hr maxima exhibit the same general pattern. Many sites that have elevated O₃ also have higher O₃ on weekends even though traffic and O₃ precursor levels are substantially reduced on weekends. Detailed studies of this phenomenon indicate that the primary cause of the higher O₃ on weekends is the reduction in oxides of nitrogen (NO_x) emissions on weekends in a volatile organic compound (VOC)-limited chemical regime. In contrast, the lower O₃ on weekends in other locations is probably a result of NO_x reductions in a NO_x-limited regime. The NO_x reduction explanation is supported by a wide range of ambient analyses and several photochemical modeling studies. Changes in the timing and location of emissions and meteorological factors play smaller roles in weekend O₃ behavior. Weekday/weekend temperature differences do not explain the weekend effect but may modify it.     

Microwave Process for Volatile Organic Compound Abatement

ABSTRACT

The CHA Corporation has completed the U.S. Air Force Phase II Small Business Innovation Research program to investigate the feasibility of using a novel microwave-based process for the removal and destruction of volatile organic compounds (VOCs) in effluents from noncombustion sources, such as paint booth ventilation streams. Removal of solvents by adsorption, followed by the regeneration of saturated granular activated carbon (GAC) by microwave energy, was achieved in a single fixed-bed reactor. Microwave regeneration of the fixed-bed-saturated carbon restored the original GAC adsorption capacity. After 20 adsorption/regeneration cycles, the adsorption capacity dropped from 13.5 g methyl ethyl ketone (MEK)/100 g GAC to 12.5 g MEK/100 g GAC. During microwave regeneration of the GAC fixed bed, the concentrated desorbed paint solvent was oxidized by passing the solvent mixture through a fixed bed of an oxidation catalyst mixed with silicon carbide in a microwave reactor. A 98% oxidation efficiency was consistently achieved from the oxidation of VOCs in the microwave catalytic reactor.