高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

以聚丁酸丁二醇酯为碳源去除含盐水体硝酸盐的研究

以可生物降解聚合物为碳源和生物膜载体可以解决异养反硝化有机碳源的添加不足或过量的问题.在序批式反应条件下,以聚丁酸丁二醇酯(PBS)为碳源和生物膜载体,对含盐水体异养反硝化过程中的细菌群落特征进行了研究.结果表明,试验条件下硝酸盐可以得到很好的去除,虽然有亚硝酸盐的明显积累,但最终被降低.硝酸盐的存在会降低含PBS水体中溶解性有机物的含量.应用变性梯度凝胶电泳和16S rDNA的方法鉴别到的细菌包括:Pseudomonas stutzeri,Pseudomonas sp.,Alteromonas sp.,Marinobacter salsuginis,Thalassospira xianheensis,Itellibacter vladivostokensis,Euplotopsis encysticus,Alcanivorax venustensis,Halomonas sp.,Agrobacterium tume aciens,Pannonibacter phragmitetus,Vitellibacter vladivostokensis.试验结果表明,反硝化条件下PBS具有较好的可生物降解性和明显的NO3--N去除能力,是比较理想的低C/N含盐水体异养反硝化碳源.     

曝气沉砂池除砂机理分析

针对曝气沉砂池小试装置模型,通过配砂实验对沉砂池除砂率进行统计分析,研究曝气强度与HRT对沉砂池除砂率的影响。实验结果表明,不同曝气强度下,随着HRT变化,除砂率逐渐上升,并最终趋于平衡状态;不同HRT下,曝气强度与除砂率近似呈现一定的线性关系,且随着曝气强度的增大,除砂率降低;在HRT小于1min时,砂粒的运行路径和沉降时间缩短,不利于砂粒的去除;在HRT大于1min时,其中1、3和4min,随着气水比的增加除砂率降低幅度相对较小,曝气所引起的横向环流在一定程度上有利于砂粒的沉降,而HRT为2min时,除砂率降幅却很大,这与砂粒在曝气沉砂池池体断面分布有关,即断面处旋转流速和水平流速的大小变化将影响砂粒的运动;相比曝气强度,HRT对除砂率的影响较大。     

漆酶对活性黑KN-B和直接大红染料的脱色性能

利用白腐真菌漆酶对活性黑KN-B和直接大红2种偶氮染料进行脱色实验。考察反应时间、加酶量、pH值、染料浓度、温度对脱色率的影响,研究了ABTS介体以及金属离子存在下的脱色效果,并分析了漆酶脱色的动力学性能以及其对偶氮染料的降解规律。结果表明,活性黑KN-B和直接大红脱色适宜条件为：反应时间为30 min,加酶量8 U/mL,pH=7,染料浓度分别为50 mg/L和80 mg/L,温度40~45℃。ABTS介体对酶促偶氮染料脱色没有明显促进作用。Fe²⁺对漆酶脱色有较强的抑制作用;Cu²⁺对漆酶催化活性黑KN-B促进作用较大,对直接大红影响较小。漆酶对2种染料的脱色反应符合米氏方程,其催化活性黑KN-B和直接大红染料的K_m值分别为114.81 mg/L,317.5 mg/L,v_max值分别为6.57 mg/（L·min）和26.0 mg/（L·min）。     

物化-生物组合工艺处理TNT红水

采用酸析+微电解+混凝沉淀+减压蒸馏+固定化微生物滤池+活性焦吸附组合工艺处理兵器八○五厂(襄樊分部)的TNT红水,出水中的硝基化合物浓度多小于0.8 mg/L,且多次未检出;COD最高值为76 mg/L,平均值为51.6 mg/L;色度为20°;苯胺浓度全部小于1 mg/L,达到了中试方案提出的要求,出水水质指标符合《兵器工业水污染物排放标准火炸药》(GB14470.1-2002)的要求.中试期间设备没有发生堵塞、燃烧等事故,减压蒸馏装置正常稳定运行,证实了减压蒸馏法处理TNT红水的安全可靠性.     

树脂法去除并回收富营养化河涌水中的磷

磷作为一种重要的元素而被广泛应用于农业与工业中,然而磷的过量排放已成为许多封闭半封闭水体富营养化和沿海赤潮频繁发生的原因之一.去除水体中的营养盐特别是磷酸盐,是有效控制水体富营养化的关键.广州市某河涌水含总磷2.6 mg/L,采用并选择DS离子交换树脂对水中磷进行动态吸附和去除,可使水中的磷降至排放标准以内,解决河涌水含磷高的富营养化问题.由DS树脂所吸附的磷,通过淋洗可得到含磷富集液,使磷从水体中完全分离出来并获得回收.DS树脂的再生能力强,经6次吸附-解吸-再生后,树脂对河涌水中磷的去除率仍可达到90％以上.     

臭氧氧化法深度处理生活垃圾焚烧厂沥滤液

采用臭氧氧化法对生活垃圾焚烧厂沥滤液经生化处理后的废水(称沥滤液生化处理水)进行深度处理。实验结果表明,COD降解速率随废水pH的提高明显增加,其中pH=10.5时的COD降解速率常数约为pH=4时的5.8倍。在臭氧投量为52.92 mg/min、pH=10.5的条件下反应70 min后,UV254和COD去除率分别达到84.7%和59.3%。向反应体系投加叔丁醇后COD去除率下降了约15%,由羟自由基氧化去除的COD占总COD去除量的26.7%。毒性实验结果表明,沥滤液生化处理水的96 h-EC50为38%,经臭氧氧化进一步处理后出水的96 h-EC50为77%,表明经臭氧深度处理后沥滤液生化处理水的毒性明显降低。     

Photo-dissociation of dimethylamine by KrBr excilamp

A study of dimethylamine photo-dissociation in the gas phase has been conducted using UV radiation delivered from a KrBr^* excilamp, driven by a sinusoidal electronic control gear with maximum emission at wavelength of 207 nm. The electrical input power and radiant power of the lamp were measured to determine their effects on the degradation. The influence of flow velocity and initial concentration of dimethylamine were also examined. In order to evaluate the photo-dissociation process comprehensively, several parameters were investigated, including removal efficiency, energy yield, carbon balance and CO₂ selectivity. It is shown that the removal efficiency increases with enhanced input power and decreased gas flow rate. A high removal efficiency of 68% is achieved for lamp power 102 W and flow velocity 15 m³ h⁻¹. The optimum dimethylamine initial concentration is around 3520 mg m⁻³, for which the energy yield reaches up to 442 g kW h⁻¹ when the input power is 65 W. In addition, two chain compounds (1,3-bis-dimethylamino-2-propanol; 3-penten-2-one, 4-amino) and three ring organic matters (1-azetidinecarboxaldehyde, 2,2,4,4-tetramethyl; N-m-tolyl-succinamic acid; p-acetoacetanisidide), were identified by GC–MS as secondary products, in order to demonstrate the pathways of the dimethylamine degradation.     

Full-scale blending treatment of fresh MSWI leachate with municipal wastewater in a wastewater treatment plant

Fresh leachate, generated in municipal solid waste incineration (MSWI) plants, contains various pollutants with extremely high strength organics, which usually requires expensive and complex treatment processes. This study investigated the feasibility of blending treatment of MSWI leachate with municipal wastewater. Fresh MSWI leachate was pretreated by coagulation–flocculation with FeCl₃ 2 g/L and CaO 25 g/L, plate-and-frame filter press, followed by ammonia stripping at pH above 12. After that, blending treatment was carried out in a full-scale municipal wastewater treatment plant (WWTP) for approximately 3 months. Different operational modes consisting of different pretreated leachate and methanol addition levels were tested, and their performances were evaluated. Results showed that throughout the experimental period, monitored parameters in the WWTP effluent, including COD (<60 mg/L), BOD₅ (<20 mg/L), ammonium (<8 mg/L), phosphorus (<1.5 mg/L) and heavy metals, generally complied with the Chinese sewage discharged standard. Under the experimental conditions, a certain amount of methanol was needed to fulfill TN removal. An estimation of the operation cost revealed that the expenditure of blending treatment was much lower than the total costs of respective treatment of MSWI leachate and municipal wastewater. The outcomes indicated that blending treatment could not only improve the treatability of the MSWI leachate, but also reduce the treatment cost of the two different wastewaters.