Treatment of digestate from a co-digestion biogas plant by means of vacuum evaporation: Tests for process optimization and environmental sustainability

Vacuum evaporation consists in the boiling of a liquid substrate at negative pressure, at a temperature lower than typical boiling temperature at atmospheric conditions. Condensed vapor represents the so called condensate, while the remaining substrate represents the concentrate.This technology is derived from other sectors and is mainly dedicated to the recovery of chemicals from industrial by-products, while it has not been widely implemented yet in the field of agricultural digestate treatment. The present paper relates on experimental tests performed in pilot-scale vacuum evaporation plants (0.100 and 0.025 m³), treating filtered digestate (liquid fraction of digestate filtered by a screw-press separator). Digestate was produced by a 1 MW_e anaerobic digestion plant fed with swine manure, corn silage and other biomasses. Different system and process configurations were tested (single-stage and two-stage, with and without acidification) with the main objectives of assessing the technical feasibility and of optimizing process parameters for an eventual technology transfer to full scale systems.The inputs and outputs of the process were subject to characterization and mass and nutrients balances were determined.The vacuum evaporation process determined a relevant mass reduction of digestate.The single stage configuration determined the production of a concentrate, still in liquid phase, with a total solid (TS) mean concentration of 15.0%, representing, in terms of mass, 20.2% of the input; the remaining 79.8% was represented by condensate. The introduction of the second stage allowed to obtain a solid concentrate, characterized by a content of TS of 59.0% and representing 5.6% of initial mass.Nitrogen balance was influenced by digestate pH: in order to limit the stripping of ammonia and its transfer to condensate it was necessary to reduce the pH. At pH 5, 97.5% of total nitrogen remained in the concentrate. This product was characterized by very high concentrations of total Kjeldhal nitrogen (TKN), 55,000 mg/kg as average.Condensate, instead, represented 94.4% of input mass, containing 2.5% of TKN. This fraction could be discharged into surface water, after purification to meet the criteria imposed by Italian regulation. Most likely, condensate could be used as dilution water for digestion input, for cleaning floor and surfaces of animal housings or for crop irrigation.The research showed the great effectiveness of the vacuum evaporation process, especially in the two stage configuration with acidification. In fact, the concentration of nutrients in a small volume determines easier transportation and reduction of related management costs. In full scale plants energy consumption is estimated to be 5–8 kWh_e/m³ of digestate and 350 kWh_t/m³ of evaporated water.     

A user evaluation of biodegradable cutlery

This paper summarizes a study evaluating the acceptance and perceived performance of disposable cutlery made from starch-based biodegradable resins relative to nondegradable polystyrene cutlery. Two hundred forty-three sailors onboard three U.S. Navy vessels ate their lunch using either biodegradable cutlery made with resins manufactured by one of two commercial companies or polystyrene cutlery. The cutlery was rated on several sensory and performance dimensions as well as for overall acceptability. Results indicated that sailors rated both the biodegradable and the polystyrene utensils as easy to hold. There were also no differences in the perceived ease of using each of the spoons. However, compared to the polystyrene utensils, both types of biodegradable utensils were viewed as less sturdy, as having a less attractive color, and as being less acceptable overall. The biodegradable forks and knives were also rated as more difficult to use for piercing and cutting food than the polystyrene ones. In addition, several significant differences emerged between the two types of biodegradable cutlery. The results are discussed in terms of the need for continued consumer testing of products developed from biodegradable polymeric materials.     

Preliminary evaluation of PAH sorptive changes in soil by Soxhlet extraction

This study was conducted to evaluate the influence of sorbent modification by synthetic, chemical/thermal weathering on the sorptive behavior of polycyclic aromatic hydrocarbons (PAHs). A clean sandy-clay-loam soil was subjected to Soxhlet extraction and PAH sorptive phenomena were evaluated based on quantity and quality changes in soil organic matter (SOM) and clay minerals. Critical changes in sorption capacity were found to depend on the initial PAH concentrations. Above 7 mg/l, weathering increased the PAH in comparison to that of unmodified soil, whereas it decreased when applied below this concentration. Similarly, less PAH was desorbed from the altered soil when PAH was applied above 7 mg/l. Therefore, when PAH was applied below 7 mg/l, quantitative reduction of sorbent amount (i.e., SOM and clay minerals) by soil weathering governed PAH sorptive behavior. However, when the PAH was applied above the critical limit, qualitative modifications in the sorbents facilitated an opposite trend. Sorbent swelling, removal of competing compounds, and possible changes in surface characteristics by Soxhlet extraction, together with increased concentration gradient effects were factors that resulted in dissimilar PAH sorptive phenomena, pivoting at the critical concentration.     

The behaviour of ashes and heavy metals during the co-combustion of sewage sludges in a fluidised bed

Co-combustion tests of dry sewage sludges with coal were performed in a pilot bubbling FBC aiming at the characterization of ashes and determining the behaviour of heavy metals in the process. The tests showed compliance with the regulatory levels as far as heavy metal emissions were concerned. The bottom ashes, which accounted for about 70% of the total ash production, were obtained in a granular form, with diameters ranging from 0.5 to 4 mm. The heavy metals were distributed in ashes obtained from different locations of the installation and their concentrations were found to vary depending on the location of capture. The increase in heavy metals content in bottom ashes was not found to lead to higher leachability and ecotoxicity compared to sewage sludges, suggesting that there could be opportunities for their further use. Mercury suffered vaporisation inside the reactor, thus leaving bottom ashes free of contamination by it. However, there was observed a strong retention of mercury in cyclone ashes due to the presence of unburned carbon which probably acted as an adsorbent. The effluent mercury was also found to be mostly associated with the particulate fraction, being less than 20% emitted in gaseous forms. The results suggested that the combustion of the sewage sludge could successfully be carried out and the amount of unburned carbon leaving the combustor but captured in cyclone was large enough to ensure substantial retention of mercury at low temperatures, hence could contribute to an improvement of the mercury release which still remains an issue of great concern to resolve during combustion of waste materials.     

Exposure of workers in mineral processing industries in Brazil

The mining, milling and processing of uranium and thorium bearing minerals may result in radiation doses to workers. A preliminary survey pilot program, that included six mines in Brazil (two coal mines, one niobium mine, one nickel mine, one gold mine and one phosphate mine), was launched in order to determine the need to control the radioactive exposure of the mine-workers. Our survey consisted of the collection and analysis of urine samples, complemented by feces and air samples. The concentrations of uranium, thorium and polonium were measured in these samples and compared to background data from family members of the workers living in the same dwelling and from residents from the general population of Rio de Janeiro. The results from the coal mines indicated that the inhalation of radon progeny may be a source of occupational exposure. The workers from the nickel, gold and phosphate mines that were visited do not require a program to control internal radiological doses. The niobium mine results showed that in some areas of the industry exposure to thorium and uranium might occur.     

Effect of culture conditions on the formation of struvite by Myxococcus xanthus

The amount of struvite (MgNH₄PO₄·6H₂O) produced by Myxococcus xanthus as well as the culture parameter values (pH, total phosphorus, total Kjeldahl nitrogen) were dependent on the culture medium used. Struvite formation started during the exponential phase and the maximum concentration was observed at the beginning of stationary growth phase. The addition of each medium component to the liquid culture influenced the amount of crystal produced. This amount did not depend on the pH increase during the culture period. The moment of the bacterial growth phase, at which each medium component was added, influenced the struvite formation.     

Distribution of nutrients and AOU in the Mediterranean Water (North Atlantic Ocean)

Water samples were collected in the Northeast Atlantic Ocean (33-37^° N and 11-16^° W) in May 1983, and vertical profiles of chemical and physical parameters allowed us to identify the different water masses. A significant difference in salinity and its maximum can be found at different places and depths, as a consequence of the spreading of the Mediterranean Water (MW) from the Strait of Gibraltar. The apparent oxygen utilization shows a correlation with nutrients in North Atlantic Central Water. The relative percentages of water masses were assessed in order to examine the depth of maximum influence of MW as a function of latitude and to apply this knowledge to the black scabbard fish long-line strategy. The long-line fishing depth location was adapted to the specific MW distribution of the different banks with improvements in the mean catch efficiency. The thickness of the MW prevalence layer has a pronounced decrease to the south. MW influence clearly sinks and decrease to south-west. The highest percentage of the MW was found in the Gorringe Bank area and the lowest in the Madeira area.