Dissipation of Tidal Energy and Associated Mixing in a Wide Fjord

This paper sets out to test the hypothesis that vertical mixing due to the dissipation of the internal tide accounts for a significant proportion of the total vertical mixing in a fjordic basin during a period of deep water isolation. During July and August 1999 two locations in the Clyde Sea were instrumented with moored RD Instruments Acoustic Doppler Current Profilers (ADCPs) and conductivity-temperature-pressure chains: Station C2, near the shallow entrance sill (55 m water depth), and station C1 in the deep basin (155 m water depth). A bottom pressure recorder was also deployed at station C3 by the seaward entrance to the Clyde Sea in the North Channel of the Irish Sea. A Free-falling Light Yo-yo shear microstructure profiler (FLY) was used to measure the dissipation rate of turbulent kinetic energy (TKE) throughout the water column over 25 h at both C1 and C2. These were interspersed with two-hourly conductivity-temperature-depth casts at both sites. The observations show agreement between the dissipation rate of TKE estimated by using a microstructure profiler and that estimated from the decay of the internal tide as measured by the two ADCPs. However, to account for all the implied mixing it is necessary to invoke an additional source of buoyancy flux, the most probable candidate mechanism is enhanced internal wave breaking near the sill and at the sloping boundaries of the deep basin. In addition, the vertical eddy diffusivity estimated from the micro-structure profiler (O(0.5 cm² s^–1) indicates that internal tide induced mixing away from any boundaries contributed significantly to the overall level of mixing which is required to account for the observed evolution of the deep basin water properties.     

Superoxide production by marine microalgae

This study investigated the possible roles of superoxide produced by raphidophyte and prymnesiophyte microalgae as an ichthyotoxic agent to damselfish and an allelopathic agent to bacteria. We found that the rate of superoxide production varied with algal cell density, with cell densities of the raphidophyte Chattonella marina >10,000 cells ml^–1 producing less environmental levels of superoxide per cell (94±14 chemiluminescence units) than cell densities <10,000 cells=">^–1 (390±54 units per cell). Microalgal cells have the capacity to change their superoxide production rate over a period of 1 h, dependent on cell density and metabolic activity. We also examined the effect of superoxide on suppression of bioluminescence of the marine bacterium Vibrio fischeri as a model for bacterial alleopathy and found that both superoxide and free fatty acids such as eicosapentaenoic acid (EPA; 20:53) present in raphidophyte microalgal cells cause suppression of bacterial bioluminescence. The combination of superoxide in the presence of EPA further enhanced bioluminescence suppression. Superoxide was also found to enhance the toxicity of free fatty acid EPA to damselfish (Acanthochromis polycanthus) at concentrations as low as 0.2 mg l^–1. In conclusion, consideration should be given to density dependent and/or metabolic variations of toxicity when publishing minimum alert levels for superoxide producing ichthyotoxic microalgal species. A secondary role of superoxide production may be to enhance the toxicity of algal exudates or serve as an allelopathic agent against bacterial fouling.     

Transport and metabolic fate of sewage particles in a recipient stream

Although the implementation of wastewater treatment plants (WWTP) has dramatically increased the quality of surface waters in urbanized areas, WWTPs can still discharge noticeable amounts of solutes and particles to recipient streams. Although the fate of WWTP nutrients has received considerable attention, transport and in-stream transformation of sewage-derived particulate organic matter (SDPOM) have not. To investigate the transport and transformation of SDPOM in recipient streams, we experimentally injected fluorescently labeled SDPOM into a headwater stream and tracked its downstream fate at baseflow. Most SDPOM disappeared from the streamwater within a 160-m long reach with an average deposition velocity of 0.14 mm s(-1). We further coupled hydrometric measurements of specific water fluxes through the streambed interface with a mixing model to estimate streambed oxygen removal, and found significantly higher oxygen removal in the deposition (0.75 g O2 m(-2) d(-1)) than in the downstream post-deposition (0.36 g O2 m(-2) d(-1)) subreach. Contrary to our expectations, we did not detect any apparent effect of SDPOM deposition on streambed clogging. Our results show the capacity of a recipient stream to retain SDPOM and to reduce its downstream export, and thus contribute to a better understanding of ecosystem services of human-altered streams.     

Breakdown products on metabolic pathway of degradation of benz[a]anthracene by a ligninolytic fungus

Cultures of the ligninolytic fungus Irpex lacteus incubated in a nutrient liquid medium degraded more than 70% of the initially applied benz[a]anthracene within 14 days. At the first step of metabolization, benz[a]anthracene was transformed via a typical pathway of ligninolytic fungi to benz[a]anthracene-7,12-dione (BaAQ). The product was further transformed by at least two ways, whereas one is complied with the anthracene metabolic pathway of I. lacteus. Benz[a]anthracene-7,12-dione was degraded to 1,2-naphthalenedicarboxylic acid and phthalic acid that was followed with production of 2-hydroxymethyl benzoic acid or monomethyl and dimethylesters of phthalic acid. Another degradation product of BaAQ was identified as 1-tetralone. Its transformation via 1,4-naphthalenedione, 1,4-naphthalenediol and 1,2,3,4-tetrahydro-1-hydroxynaphthalene resulted again in phthalic acid. None of the intermediates were identified as dead-end metabolites. Metabolites produced by ring cleavage of benz[a]anthracene using the ligninolytic fungus are firstly presented in this work.     

Passive sampler derived air concentrations of PBDEs along an urban-rural transect: spatial and temporal trends

Passive air samplers consisting of polyurethane foam (PUF) disks housed in chambers were deployed at several sites along a approximately 75 km urban-rural gradient in Toronto and analyzed for polybrominated diphenyl ethers (PBDEs). Samplers were allowed to integrate gas-phase PBDEs over three consecutive seasons starting in the summer of 2000. PBDEs were fairly uniform along the transect with air concentrations in Toronto (10-30 pgm(-3)) about a factor of two greater than at rural sites. Lowest concentrations were observed during the winter and probably associated with reduced inputs from indoor sources of PBDEs and to a preference for PBDEs to partition to the particle-phase at colder temperatures. The composition of PBDEs in the air samples did not differ across the transect or for the different seasons.     

Geochemical and Pb isotopic evidence for sources and dispersal of metal contamination in stream sediments from the mining and smelting district of Príbram, Czech Republic

Stream sediments from the mining and smelting district of Príbram, Czech Republic, were studied to determine the degree, sources and dispersal of metal contamination using a combination of bulk metal and mineralogical determinations, sequential extractions and Pb isotopic analyses. The highest metal concentrations were found 3-4 km downstream from the main polymetallic mining site (9800 mg Pb kg(-1), 26 039 mg Zn kg(-1), 316.4 mg Cd kg(-1), 256.9 mg Cu kg(-1)). The calculated enrichment factors (EFs) confirmed the extreme degree of contamination by Pb, Zn and Cd (EF>40). Lead, Zn and Cd are bound mainly to Fe oxides and hydroxides. In the most contaminated samples Pb is also present as Pb carbonates and litharge (PbO). Lead isotopic analysis indicates that the predominant source of stream sediment contamination is historic Pb-Ag mining and primary Pb smelting (206Pb/207Pb=1.16), while the role of secondary smelting (car battery processing) is negligible.     

Global pilot study for persistent organic pollutants (POPs) using PUF disk passive air samplers

Polyurethane foam (PUF) disks were deployed at global background sites, to test logistical issues associated with a global monitoring network for persistent organic pollutants (POPs). alpha-HCH, exhibited relatively high and uniform concentrations (17-150 pg/m3) at temperate and arctic sites with elevated concentrations associated with trans-Pacific inflow. Concentrations were much lower (<5 pg/m3) in Bermuda, Chile and Cape Grim. Concentrations for gamma-HCH, the main component of lindane, were spatially similar to the alpha-HCH pattern but lower in magnitude (typically, <10 pg/m3). Chlordane concentrations (sum of cis-chlordane, trans-chlordane and trans-nonachlor) were also low (<10 pg/m3). Dieldrin concentrations were in the range 2-25 pg/m3 at most sites but elevated in Bermuda. Back trajectories suggest that advection from Africa and the US may contribute. Endosulfan, a popular current-use pesticide, exhibited highest concentrations ranging from tens to hundreds of pg/m3. There was good agreement between duplicate samplers at each site and PUF disk-derived air concentrations agreed with high volume data. Few logistical/analytical problems were encountered in this pilot study.     

Passive air sampler as a tool for long-term air pollution monitoring: Part 2. Air genotoxic potency screening assessment

The capability of passive air sampling to be employed in the evaluation of direct genotoxicity of ambient air samples was assessed. Genotoxic effects of the total extracts from the polyurethane foam filters exposed for 28 days during a regional passive air sampling campaign were investigated. Twenty sampling sites were selected in Brno city on the area of approximately 20x20 km in October and November 2004. Brno is the second largest city of the Czech Republic, highly industrialized with approximately 370,000 of permanent inhabitants. The levels of PAHs, PCBs, and chlorinated pesticides were determined in all samples. Fraction of each extract was also assayed in the bacterial genotoxicity test using Escherichia coli sulA::lacZ. Complete dose-response relationships of the air extracts were determined. The statistical analysis showed significant correlation between observed biological effects and PAHs concentrations in samples.     

Socio-demographic determinants of municipal waste generation: case study of the Czech Republic

Journal of Material Cycles and Waste Management - Increasing pressure of the European Union on diverting municipal waste from landfills requires an active role of households and commands a radical...