Contribution of Nitrate and Carbonaceous Species to PM2.5 Observed in Canadian Cities

ABSTRACT

At a variety of Canadian monitoring sites, carbonaceous compounds were estimated to account for an average of 50% of fine particle mass. These estimates were determined by subtracting the total fine particle mass associated with inorganic compounds from the total fine mass determined gravimetrically. This approach, which yields an upper limit estimate of the total amount of carbon-related mass was necessary since particulate carbon was not measured in the Canadian National Air Pollution Surveillance (NAPS) network. In this paper, total carbon estimates are evaluated against organic and elemental carbon measurements at locations in the Greater Vancouver area and Toronto. In addition, particle nitrate measurements at seven Canadian locations are used to determine the importance of nitrate relative to total mass and to examine the sampling artifacts due to the loss of particle nitrate from Teflon filters used in the NAPS di-chotomous samplers.

Measurements of organic and elemental carbon indicated that the total carbon estimation approach provides representative estimates of the average contribution by carbonaceous material to the total fine and coarse mass. The average total carbon among all Vancouver area measurements (N = 225) was 4.28 μg m^-3, while the estimated value was 4.34 μg m^-3. There was a larger discrepancy between Toronto total carbon measurements (12.1 μg m^-3) and estimates (8.8 μg m^-3), which is attributed in part to sampling of particles above 10 mm in diameter. However, the R² relating the measurements and estimates was about 0.71 for both areas. Linear regression slopes of 0.98 for Vancouver and 0.78 for Toronto (nonsignificant intercepts) indicate little bias in the Vancouver estimates, but a tendency for underestimation as the observed total carbon concentration increased in Toronto.

Annually, nitrate was responsible for 17% and 12% of the fine mass in the Vancouver area and Ontario, respectively. In contrast, at two rural locations in southern Quebec and Nova Scotia, only 6% of fine mass was associated with nitrate. Due to filter losses, nitrate concentrations determined through the NAPS dichot sampling were much lower than actual concentrations (0.44 μg m^-3 vs. 2.63 μg m^-3). As a result of these losses (attributed mostly to loss during laboratory storage), previous total carbon estimates for the Canadian NAPS sites were likely to have been overestimated on average by about 10%.     

Assessing Sorbents for Mercury Control in Coal-Combustion Flue Gas

Abstract

Sorbent injection for Hg control is one of the most promising technologies for reducing Hg emissions from power-generation facilities, particularly units that do not require wet scrubbers for SO₂ control. Since 1992, EPRI has been assessing the performance of Hg sorbents in pilot-scale systems installed at full-scale facilities. The initial tests were conducted on a 5000-acfm (142-m³/min) pilot baghouse. Screening potential sorbents at this scale required substantial resources for installation and operation and did not provide an opportunity to characterize sor-bents over a wide temperature range.

Data collected in the laboratory and in field tests indicate that sorbents are affected by flue gas composition and temperature. Tests carried out in actual flue gas at a number of power plants also have shown that sorbent performance can be site-specific. In addition, data collected at a field site often are different from data collected in the laboratory, with simulated flue gas mixed to match the major components in the site’s gas. To effectively estimate the costs of Hg sorbent systems at different plants, a measure of sorbent performance in the respective flue gases must be obtained. However, injection testing at multiple facilities with large pilot systems is not practical.

Over the past five years, fixed-bed characterization testing, modeling studies, and bench-scale injection testing have been undertaken to develop a low-cost technique to characterize sorbent performance in actual flue gas and subsequently to project normalized costs for Hg removal prior to full-scale demonstration. This article describes the techniques used and summarizes field-testing results from two plants burning Powder River Basin (PRB) coal for commercial activated carbon and several other sorbent types. Full-scale projections based on the results and data collected on larger-scale systems also are included.     

Assessing seasonal and spatial trends of persistent organic pollutants (POPs) in Indian agricultural regions using PUF disk passive air samplers

The first survey of persistent organic pollutant (POP) concentrations in air across several Indian agricultural regions was conducted in 2006-2007. Passive samplers comprising polyurethane foam (PUF) disks were deployed on a quarterly basis at seven stations in agricultural regions, one urban site and one background site. The project was conducted as a sub-project of the Global Atmospheric Passive Sampling (GAPS) Network. In addition to revealing new information on air concentrations of several organochlorine pesticides (OCPs) and polychlorinated biphenyls (PCBs), the study has demonstrated the feasibility of conducting regional-scale monitoring for POPs in India using PUF disk samplers. The following analytes were detected with relatively high concentrations in air (mean for 2006 and 2007, pg/m³): α- and γ-hexachlorocyclohexane (HCH) (292 and 812, respectively); endosulfan I and II (2770 and 902, respectively); p,p′-DDE and p,p′-DDT (247 and 931, respectively); and for the sum of 48 PCBs, 12,100 (including a site with extremely high air concentrations in 2007) and 972 (when excluding data for this site).     

Do earthworms impact metal mobility and availability in soil? - A review

The importance of earthworms to ecosystem functioning has led to many studies on the impacts of metals on earthworms. Far less attention has been paid to the impact that earthworms have on soil metals both in terms of metal mobility and availability. In this review we consider which earthworms have been used in such studies, which soil components have been investigated, which types of soil have been used and what measures of mobility and availability applied. We proceed to review proposed reasons for effects: changes in microbial populations, pH, dissolved organic carbon and metal speciation. The balance of evidence suggests that earthworms increase metal mobility and availability but more studies are required to determine the precise mechanism for this.     

A new direct thermal desorption-GC/MS method: Organic speciation of ambient particulate matter collected in Golden, BC

Particulate matter having an aerodynamic diameter less than 2.5 μm (PM2.5) is thought to be implicated in a number of medical conditions, including cancer, rheumatoid arthritis, heart attack, and aging. However, very little chemical speciation data is available for the organic fraction of ambient aerosols. A new direct thermal desorption-gas chromatography/mass spectrometry (TD-GC/MS) method was developed for the analysis of the organic fraction of PM2.5. Samples were collected in Golden, British Columbia, over a 15-month period. n-Alkanes constituted 33–98% by mass of the organic compounds identified. PAHs accounted for 1–65% and biomarkers (hopanes and steranes) 1–8% of the organic mass. Annual mean concentrations were: n-alkanes (0.07–1.55 ng m⁻³), 16 PAHs (0.02–1.83 ng m⁻³), and biomarkers (0.02–0.18 ng m⁻³). Daily levels of these organics were 4.89–74.38 ng m⁻³, 0.27–100.24 ng m⁻³, 0.14–4.39 ng m⁻³, respectively. Ratios of organic carbon to elemental carbon (OC/EC) and trends over time were similar to those observed for PM2.5. There was no clear seasonal variation in the distribution of petroleum biomarkers, but elevated levels of other organic species were observed during the winter. Strong correlations between PAHs and EC, and between petroleum biomarkers and EC, suggest a common emission source – most likely motor vehicles and space heating.     

Further studies on the uptake of persistent organic pollutants (POPs) by polyurethane foam disk passive air samplers

Passive air samplers (PAS) can be used to monitor semi-volatile organic compounds in the atmosphere. Polyurethane foam (PUF) disks are a popular sampling medium because they have a high retention capacity for such compounds. This paper reports a highly time-resolved uptake study, to derive uptake rate data under field conditions, and investigate the effects of using different foam densities on the uptake rate. PUF disks were deployed alongside an active sampler, for periods of up to 12 weeks. The uptake rates were measured for a range of gas- and particle-bound persistent organic pollutants (polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers (PBDEs)), of different properties, to explore whether gas–particle partitioning affected uptake rate. Uptake rates for two different densities of foam (0.021 and 0.035 g cm^?3) were not statistically significantly different from each other. Uptake rates of light PCBs averaged ～6.5 m³ day^?1, somewhat higher than in previous studies; higher wind speeds and lower temperatures in this study are the likely reason for this difference. The study showed: i) the uptake rate of the compound with lowest K_OA considered in this study (PCB-28/31) declined in the later weeks, indicating an approach to equilibrium; ii) uptake rates of lighter BDEs and heavier PCBs (compounds of intermediate K_OA in this study) remain similar throughout the study period, indicating that they are not approaching equilibrium during the 12-week-study; iii) uptake rates were typically: ～8 m³ day^?1 for PCB-52; ～9.5 m³ day^?1 for PCB-95; ～11 m³ day^?1 for BDE-28 and ～2 m³ day^?1 BDE-99. The latter compound has an important particle-bound component and this lowers the sampling rate compared to predicted uptake rates for compounds which are in the gas phase only. It is shown that knowledge of gas–particle partitioning is needed to correct for this effect, and to improve predicted uptake rates.     

A comparison of mesh-adaptive LES with wind tunnel data for flow past buildings: Mean flows and velocity fluctuations

In this paper we address two important aspects of micro-scale urban airflow model evaluation: (a) the identification of key flow features as dictated by the physics of the problem and as captured by the simulations, and (b) the comparison of important model output parameters (mean flows and fluctuations) with experimental data. A series of mesh-adaptive large eddy simulations (LES) was carried out for the study of air flows within two intersecting street canyons with varying building configurations. The novelty of the approach lies in the combination of LES with mesh adaptivity, which allows a variable-filter length and the implementation of an anisotropic eddy-viscosity model. Both coarse and fine-mesh simulations were carried out, using single and parallel-processor systems respectively. The simulations showed clearly that the expected flow patterns such as the street canyon recirculation and the street-mouth vortices, as well as the exchange of air flow at the street intersections, can readily be captured by the mesh-adaptive LES.In addition, the detailed comparisons of mean flows and fluctuations of the resolved velocity field with the measured data showed that the simulation results agreed well with the patterns and trends of the wind tunnel measurements. In most cases the finer-mesh simulations improved considerably the accuracy of the mean flows, especially for the symmetrical configuration. The improvement in the predicted fluctuations was less obvious, with several detector locations underpredicting the measured values, although the overall comparison was also satisfactory. The typical errors for the mean flows for all three building configurations were less than 30%, whilst for the velocity fluctuations less that 40%. Both the simulated means flows and turbulence levels were generally more accurate in the streets parallel to the wind (streamwise direction) than in the streets normal to the wind.     

Think global,act local: The effect of goal and mindset specificity on willingness to donate to an environmental organization

This paper investigated the effect of goal and mindset specificity on goal-related behavior in the environmental domain. Two studies demonstrated that goal-related behavior was maximized when participants focused on an abstract goal in combination with a specific mindset, or when they focused on a specific goal in combination with an abstract mindset. When goals and mindsets instead matched in terms of abstractness, goal-related behavior was reduced. Study 2 demonstrated that the effect of goal specificity on behavior was mediated by different processes in each of the mindset conditions. When mindsets were abstract, self-efficacy mediated the positive effect of specific goals on behavior; when mindsets were specific, the value of collective environmental action mediated the positive effect of abstract goals on behavior. The results are discussed in the framework of a complementarity approach. It is argued that complementarity of levels of specificity of goals and mindsets may affect behavior particularly strongly in domains where the discrepancy between the abstract and the specific is large (e.g. the environmental domain).     

Walking in the Irish countryside: landowner preferences and attitudes to improved public access provision

This paper explores the attitudes of landowners across Ireland to the wider provision of public access for recreational walking using a multinomial logit model. The study also investigates the level of compensation required to improve the supply of this public good. Results indicate that 51% of landowners are not willing to provide access (non-providers), 21% are willing to provide access free of charge (free providers) and 28% seek compensation (willing providers). The findings indicate that participation by landowners in a proposed public access scheme is influenced by landowners' experience with walkers, farm type, farm insurance costs, household demographics, regional variations, opportunity cost of land and participation in other agri-environment schemes. Mean willingness-to-accept for landowners willing to facilitate improved public access for walking was found to be €0.27 per metre of walkway.