Cryptic invasion of northeast Pacific estuaries by the Asian polychaete, Hediste diadroma (Nereididae)

The estuarine polychaete, Hediste diadroma (Nereididae), of eastern Asia was found at all six sites sampled in October 2009 in northeast Pacific estuaries, including the Columbia River, along a 300-km stretch of coastline in Washington and Oregon, USA. The immature worms were returned to the laboratory in Japan where 13 of them were cultured to sexual maturity after 5–7 months. These worms had the diagnostic, epitoke-specific spinigers that distinguish H. diadroma from all other Hediste species. Their egg sizes (140–170 μm), paragnath numbers on the proboscis, and chromosome number (2n = 28) were also consistent with those previously reported for the Japanese population of H. diadroma. The widespread distribution of H. diadroma indicates that it is a successful invader of the North American Pacific and it may have long escaped detection because of its morphological similarity to the native species, H. limnicola. The long pelagic life of H. diadroma larvae could have facilitated its successful trans-ocean dispersal with ballast water of ships.     

Application of recording films of solar radiation for environmental and ecological research

Global solar radiation is recorded by fading of the colored film into which azo-dye is impregnated with use of organic solvent. Oil Red O, Sudan I, Sudan IV and Pyridylazonaphthol are used as the azo dye. These films can be applied to measure the solar radiation in many kinds of environmental or ecological conditions. The merits of the film compared with usual measurements are to be: unnecessary of any electric sources; cheap and mass-productive easily; suitable to integrate solar radiation for long time; easy dealing in out-door or underwater conditions; possible to use on leaves of any plants because of light weight; possible to use in a lot of points at the same time.     

Photo-oxidation of biodegraded crude oil and toxicity of the photo-oxidized products

We investigated the physicochemical changes resulting from irradiation by sunlight of biodegraded crude oil. An Arabian light crude oil sample was first subjected to microbial degradation. n-Alkanes and aromatic compounds such as naphthalenes, fluorenes, dibenzothiophenes and phenanthrenes possessing short, alkyl side chain(s) were almost completely degraded, while the contents of the saturated and aromatic fractions were reduced by 70% and 40%, respectively. This biodegraded oil was then suspended in seawater and exposed to sunlight irradiation for several weeks. The most remarkable change caused by the irradiation was a substantial decline in the aromatic fraction with a concomitant increase in the resin and asphaltene fractions. A 13C-nuclear magnetic resonance (NMR) spectroscopic analysis showed that the aromaticity of the biodegraded oil was significantly lower in the irradiated sample. A field desorption-mass spectrometric (FD-MS) analysis showed that sunlight irradiation reduced the average molecular weight of the oil components and formed oxygenated compounds. Consistent with this observation is that the oxygen content in the oil increased as the irradiation was prolonged. The bioavailability of the biodegraded oil was increased by the photo-oxidation: the growth of seawater microbes was minimal when the non-irradiated biodegraded oil was used as the source of carbon and energy; however, growth was significant when irradiated biodegraded oil was used. The concentration of dissolved organic carbon (DOC) increased linearly during the sunlight irradiation of the biodegraded oil, and this increase was matched by an increase in ultraviolet-absorptive materials in the seawater. The photochemically formed, water-soluble fraction (WSF) showed acute toxicity against the halophilic crustacean, Artemia.     

Incorporating differences between genetic diversity of trees and herbaceous plants in conservation strategies

Reviews that summarize the genetic diversity of plant species in relation to their life history and ecological traits show that forest trees have more genetic diversity at population and species levels than annuals or herbaceous perennials. In addition, among-population genetic differentiation is significantly lower in trees than in most herbaceous perennials and annuals. Possible reasons for these differences between trees and herbaceous perennials and annuals have not been discussed critically. Several traits, such as high rates of outcrossing, long-distance pollen and seed dispersal, large effective population sizes (N_e), arborescent stature, low population density, longevity, overlapping generations, and occurrence in late successional communities, may make trees less sensitive to genetic bottlenecks and more resistant to habitat fragmentation or climate change. We recommend that guidelines for genetic conservation strategies be designed differently for tree species versus other types of plant species. Because most tree species fit an LH scenario (low [L] genetic differentiation and high [H] genetic diversity), tree seeds could be sourced from a few populations distributed across the species’ range. For the in situ conservation of trees, translocation is a viable option to increase N_e. In contrast, rare herbaceous understory species are frequently HL (high differentiation and low diversity) species. Under the HL scenario, seeds should be taken from many populations with high genetic diversity. In situ conservation efforts for herbaceous plants should focus on protecting habitats because the typically small populations of these species are vulnerable to the loss of genetic diversity. The robust allozyme genetic diversity databases could be used to develop conservation strategies for species lacking genetic information. As a case study of reforestation with several tree species in denuded areas on the Korean Peninsula, we recommend the selection of local genotypes as suitable sources to prevent adverse effects and to insure the successful restoration in the long term.     

Investigation of the properties of the accidental release and explosion of liquefied dimethyl ether at a filling station

Dimethyl ether (DME) has been focused as a substitute for diesel fuel, and a number of studies have investigated engines fueled with DME because DME has a low auto-ignition temperature and does not generate particulate matter (PM). Therefore, in the last few years, the construction of DME filling stations for trucks in Japan has been planned. The introduction of DME vehicles requires expansion of DME supply stations, which in turn requires the collection of safety data and the establishment of safety regulations. The present paper describes an experimental investigation of the hypothetical scenario in which liquid DME is accidentally released and an explosion occurs. In the present study, large-scale leakage and ignition of DME were investigated and flame propagation data was obtained. We also measured the overpressure of the blast wave and the heat flux from the fireball. When the ignition position is near the nozzle, the flame propagation velocity is higher. The overpressure from the DME fireball is stronger than that from DME/air mixture deflagration. In summary, these results provide safety data for safety management of DME filling stations.     

Study on the influence of material thermal characteristics on dust explosion parameters of three long-chain monobasic alcohols

Sensitivity and severity parameters are critical for risk assessment and safety management of dust explosions. In this paper, to reveal the effects of material thermal characteristics on dust explosions parameters during monobasic alcohols dust explosions, three long chain monobasic alcohols, being solid at room temperature and similar in physical–chemical properties, were chosen to carry out experiments in different functional test apparatus according to the internationally accepted ASTM standards. As a result, it was found that the material thermal characteristics strongly affected these basic explosive parameters. On the one hand, for the sensitivity parameters, Minimum Ignition Temperature, Minimum Ignition Energy and Electrical Resistivity were the highest in the Eicosanol dust cloud, while Minimum Explosible Concentration in this cloud was the lowest. On the other hand, for severity parameters, Maximum Explosion Pressure in Eicosanol dust cloud always maintained the highest values as varying the dust concentrations. In contrast, Deflagration Index showed a complex trend.     

Use of two population metrics clarifies biodiversity dynamics in large-scale monitoring: the case of trees in Japanese old-growth forests

An alkaline comet assay and a micronucleus test were carried out on erythrocytes of the European chub, Squalius cephalus L., collected in spring and autumn in 2005 and 2006 at three sampling sites in River Sava, near Zagreb, Croatia. The results of comet assay showed the lowest genotoxic influence at the least polluted site, while higher DNA damage was observed at the polluted sites. Although the basal levels of DNA damage were elevated, a clear gradation of DNA damage was found due to pollution intensity in all sampling periods. The lowest cytogenetic damage as revealed by the micronucleus test (MNT) was observed as well at the least polluted site. High variations in MN frequency were observed between sampling periods, although the number of micronucleated erythrocytes was consistently the highest one at the polluted site. The comet assay as a biomarker of genotoxic effect exhibited higher sensitivity in discriminating the genotoxic capacity of studied polluted sites while the MNT was less sensitive. However, both tests should be used together in biomonitoring studies because they can reveal different aspects of DNA damage; comet assay, the early event of genotoxic exposure, and MNT, its final result as a mutagenic potential.