Factors influencing Aerosol Characteristics over Urban Environment

Atmospheric aerosols are an important contributing factor to turbidity in urban areas besides having impact on health. Aerosol characteristics show a high degree of variability in space and time as anthropogenic share of total aerosol loading is quite substantial and is essential to monitor the aerosol features over long time scales. In the present study extensive observations of columnar aerosol optical depth (AOD), total columnar ozone (TCO) and precipitable water content (PWC) have been carried over a tropical urban city of Hyderabad, India. Significant variations of AOD have been observed during course of the day with low values of AOD during morning and evening hours and high values during afternoon hours. Spectral variation of AOD exhibits high AOD at smaller wavelengths and vice versa except a slight enhancement in AOD at 500 nm. Anomalies in AOD, particulate matter and black carbon concentrations have been observed during May, 2003. Back trajectory analysis of air mass during these episodes suggested variation in air mass trajectories. Analysis of the results suggests that air trajectories from land region north of study area cause high loading of atmospheric aerosols. The results are discussed in the paper.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Flow-injection analysis with fluorescence detection for the determination of trace levels of ammonium in seawater

A method using flow-injection, gas-diffusion, derivatisation and then fluorescent detection has been established for ammonium ion determination in seawater. The fluorescent derivative formed by reacting ortho-phthaldialdehyde (OPA) and sulfite with ammonia gives high sensitivity while removing potential interferences. This is required to measure the low concentrations of ammonium often seen in the open ocean. The experimental conditions (flow-rate, reagent concentrations, membrane configurations, etc.) were manipulated to improve performance. For a sample throughput of 30 samples h(-1), the limit of detection was 7 nM, the coefficient of variation was 5.7% at 800 nM, and the calibration curve was linear to at least 4 micromol L(-1). Interferences were minimised by a gaseous diffusion step. Volatile small molecular-weight amines as interferents were discriminated against by this method. They neither passed through the membrane as efficiently as ammonia, nor reacted as readily with OPA when sulfite was the reductant. Contamination by ammonia from laboratory and shipboard sources complicates application of the method to natural waters, especially measurement of low concentrations (<100 nM) in open-ocean waters. Steps to overcome contamination are described in detail. Some results are presented for ammonium determination in Southern Ocean and Huon Estuary (Tasmania) waters.     

The study of age influence on human bone lead metabolism by using a simplified model and X-ray fluorescence data

Long term lead metabolism in the human body has never been fully understood due to the lack of human data in this area. The technological improvement of bone lead measurement systems has made bone lead data of substantial populations available. In this study, a set of X-ray fluorescence bone lead data was used to test Leggett's lead metabolism model (R. W. Leggett, Environ. Health Perspect., 1993a, 101, 598-616), especially the model of metabolism in bone. The data set includes the bone lead concentration of 539 occupationally exposed workers, of whom 327 were measured twice in five years. The bone lead concentrations of both cortical bone (tibia) and trabecular bone (calcaneus) were obtained by Cd-109 gamma-ray induced XRF measurement. The histories of blood lead concentration for these workers were used to regulate the input file of the model. The results show that the bone lead concentrations predicted by Leggett's model greatly underestimate the measured values, especially for older workers. This data set was then organized into five age groups. A new simplified model was applied to estimate the lead transfer rates between blood and lead compartments for these age groups. The original transfer rates and the new transfer rates are compared, and the differences are discussed. When the transfer rates derived from measured bone lead data were put into the input file of the model to replace the existing parameters, the predicted values were much closer to the measured values for both cortical bone and trabecular bone.     

Influence of aluminium on the restoration potential of a terrestrial vascular plant,Portulaca Oleracea L. as a biomonitoring tool of fresh water aquatic environments

In the present study, the influence of aluminium on the regeneration potential of leaf and stem-cuttings of Portulaca oleracea was studied in order to identify a terrestrial plant species as an alternate biomonitoring toolof fresh water environment. The leaves and stem cuttings of theterrestrial plant, P. oleracea grew well in the distilled water producing adventitious and lateral roots. The aluminium treated leaves and stem cuttings showed a reduction in the growthof the adventitious and lateral roots and increase in the decay of leaves and stem cuttings with increasing aluminium concentration. The tolerance index calculated for the leaves and the stem cuttings showed that the leaves were more sensitivethan stems to aluminium. Since all the parameters studied showedconcentration dependent changes, the terrestrial plant, P. oleracea can be considered a suitable biomonitoring tool of fresh water environment besides its usage in the Al toxicity testing.     

Aerosol Scavenging: Model Application and Sensitivity Analysis in the Indian Context

Sulfate aerosols have been found to bethe major contributors to precipitation acidity. Thus,in view of the long-term ecological repercussions theyhave on aquatic ecosystems and their acidity-potential,the present analysis focuses on a case study applicationof the layer-averaged aerosol-scavenging model (Okita et al., 1996) for predicting values of the wet scavengingcoefficient and sulfate concentrations in precipitationsamples on the basis of the information available forsome selected Indian cities. Through sensitivityanalysis (Pandey et al., 1997) the scavengingcoefficient has been found to be very strongly dependenton precipitation intensity. Comparison of modelpredictions has been done with the measured values forDelhi, Mumbai, Calcutta and Chennai in India.     

Luminescence spectroscopy as a screening tool for the potential carcinogenicity of asphalt fumes

A subset of polycyclic aromatic compounds (PACs), which contain 4-6 annulated rings, has been documented as the source of carcinogenicity in animal skin painting studies of petroleum products and asphalt fumes (M. L. Machado, P. W. Beatty, J. C. Fetzer, A. H. Glickman and E. L. McGinnis, Fundam. Appl. Toxicol., 1993, 21, 492; T. A. Roy, S. W. Johnson, G. R. Blackburn and C. R. Mackerer, Fundam. Appl. Toxicol., 1988, 10, 466). Because of the chemical complexity of these materials, it has been difficult to identify the specific compounds within this broad range of PACs responsible for their carcinogenicity. An alternative approach using luminescence spectroscopy was taken in this study to quantify, without identification, a subset of these compounds that appears to cause cancer. The fluorescence response at a specific wavelength pair was obtained for 39 laboratory asphalt fume condensates from animal skin painting studies, yielding a linear correlation coefficient of R2 = 0.96 between the fluorescence response in these materials and the carcinogenicity found in animal studies. In the absence of other asphalt fume condensates from animal studies, 17 petroleum oils were also evaluated using this method and compared with the available animal skin painting data. The details of the method include a clean-up step that removes the highly polar compounds and spectral subtraction of two- and three-ring PAC interference, both of which add to the fluorescence response, yet were not found to contribute to a carcinogenic response from skin painting studies. Full scan fluorescence plots also produce a fingerprint which can be used to assess contamination, such as coal tar products or mixtures of materials, that are not defined as asphalt, yet may be present in the working environment.