Review of information on pesticide residues in the Canadian environment

Summary Pesticide residues in soil, water, food, wildlife and other media have been analysed in several monitoring studies. The purpose was to establish the distribution of these residues across a defined area, ascertain their trend over a specific period and use the results to assess environmental compliance and safety. In the present review the availability of information on pesticide residues in various Canadian environmental components was sought. With the possible exception of localized pesticide contamination of some private water supply wells, ground and surface water, most analyses revealed concentrations below guideline limits. Only a few cases were reported of mishandling, misuse and poisoning from pesticides. Continuing surveillance programmes and in-depth and well-organized monitoring studies, with special focus on areas that are vulnerable to contamination, by both provincial and federal governments, are largely responsible for the encouraging results. This experience in the control of pesticide use and monitoring of residues in the environment should be of particular interest in developing countries.Dr A.Y. Sangodoyin is a senior lecturer in the Department of Agricultural Engineering at the University of Ibadan. He was recently involved in a study visit to the University of Alberta, Edmonton, Alberta, Canada T6G 2G7, where his co-author Dr D.W. Smith is a member of staff in the Department of Civil-Engineering.     

Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Design parameters for fixed bed reactors of activated carbon developed from fertilizer waste for the removal of some heavy metal ions

Activated carbon, developed from fertilizer waste, has been used for the removal of Hg²⁺, Cr⁶⁺, Pb²⁺, and Cu²⁺. Mass transfer kinetic approach has been successfully applied for the determination of various parameters necessary for designing a fixed-bed absorber. Parameters selected are the length of the (PAZ) primary adsorption zone (δ), total time involved for the establishment of primary adsorption zone (t_x), mass rate of flow to the absorber (F_m), time for primary adsorption zone to move down its length (t_δ), amount of adsorbate adsorbed in PAZ from breakpoint to exhaustion (M_s), fractional capacity (f), time of initial formation of PAZ (t_f) and per cent saturation of column at break point. Chemical regeneration has been achieved with 1 M HNO₃.     

Modelling nitrogen fluxes at the landscape scale

The distribution and impacts of different nitrogen pollutants are inextricably linked. To understand the problem fully, the interactions between the different pollutants need to be taken into account. This is particularly important when it comes to abatement techniques, since measures to reduce emissions of one nitrogen pollutant can often lead to an increase in another. This project represents a step towards greater understanding of these issues by linking together new and existing nitrogen flux models into a larger framework. The modelling framework has been constructed and some of the nitrogen flows between fields, farms and the atmosphere have been modelled for a UK study area for typical farm management scenarios.     

Nitrous Oxide in Agricultural Drainage Waters Following Field Fertilisation

Dissolved nitrous oxide (N₂O), nitrate (NO₃ ^-), and ammonium (NH₄ ⁺) concentrations in an agricultural field drain were intensively measured over the period of field nitrogen (N) fertilisation and for several weeks thereafter. Supersaturations of dissolved N₂O were observed in field drain waters throughout the study. On entry to an open drainage ditch, concentrations of dissolved N₂O rapidly decreased and a total N₂O-N emission via this pathway of 13.2 g over the period of study (45 days) was calculated. This compared with a predicted emission of the order of 300 g, based on measured losses of NO₃ ^- and NH₄ ⁺ in the field drainage water, and the default IPCC emission factor of 0.01 kg N₂O-N per kg Nentering rivers and estuaries. In contrast to widespread evidence of a clear relationship between the amount of N applied to agricultural land and subsequent direct N₂O emission from the soil surface, the relationship between the amount of N₂O in soil drainage waters and the amount of N applied was poor. We conclude that the complexity, both spatially and temporally, of the processes ultimately responsible for the amount of N₂O in agricultural drainage waters make a straightforward relationship between N₂O concentration and N application rate unlikely in all but the simplest of systems.     

Assessing the Performance Level of a Water System

Water, Air, &; Soil Pollution: Focus - What should System Managers prefer? Systems that never fail or systems that remain safe during a failure? The present paper tries to give an answer to this...     

Review of in situ remediation technologies for lead,zinc, and cadmium in soil

This article presents a review of in situ technologies for the remediation of soils contaminated with lead, zinc, and/or cadmium. The objective of this review is to assess the developmental status of the available in situ technologies and provide a general summary of typical applications and limitations of these technologies. The literature review identified seven in situ remediation technologies—solidification/stabilization, vitrification, electrokinetic remediation, soil flushing, phytoextraction, phytostabilization, and chemical stabilization. These technologies were considered for their ability to meet a specific set of remediation objectives under a range of conditions. Each of these technologies has both strengths and weaknesses for addressing particular remedial situations discussed in the article for each of the technologies. A general summary of which technologies are most applicable to common remedial scenarios is also provided. © 2004 Wiley Periodicals, Inc.     

Electroremediation: A study of the influence of buffering behavior in contaminated soils

This article presents the results of an experimental study conducted to evaluate the behavior of two types of andisol soils found in Tenerife, Canary Islands, Spain. The soils were evaluated in relation to their buffering capacity when confronted with acid and alkaline fronts generated during electroremediation treatment. The study was conducted using a cell, which established a continuous flow of distilled water through electrode chambers to remove H⁺ and OH^? generated during electrolysis. The results indicate that the soils had sufficient buffer capacity to support variations in pH independent of the maintenance of flow of solution in the electrode chambers. Although the mechanism of migration was not affected, the flow of water favored the movement of ions by diffusion monitoring of the electrolytic current allowed for a real‐time parameter to act as an indicator of the quantity of ions available in regions near the electrodes. © 2004 Wiley Periodicals, Inc.     

Steady-state analyses for reactive distillation control: An MTBE case study

An approach, based purely on steady-state analyses, for synthesizing effective control structures for reactive distillation (RD) columns is presented. The main idea is to analyze the steady-state relationships between the manipulated (input) variables and the potential controlled (output) variables to identify input–output (IO) pairings that are sensitive and avoid steady-state multiplicities providing a large range of nearly linear operating region around the base case design. Traditional SISO control loops are then implemented using these IO pairings to obtain control structures that maintain the column near the design product purity and conversion for the anticipated primary disturbances. The Niederlinski Index is used to eliminate dynamically unstable pairings in control structures with multiple loops. The approach is demonstrated on an example MTBE RD column. The impact of steady-state multiplicities on control structure design is highlighted.     

Sustainable land application: an overview

Man has land-applied societal nonhazardous wastes for centuries as a means of disposal and to improve the soil via the recycling of nutrients and the addition of organic matter. Nonhazardous wastes include a vast array of materials, including manures, biosolids, composts, wastewater effluents, food-processing wastes, industrial by-products; these are collectively referred to herein as residuals. Because of economic restraints and environmental concerns about land-filling and incineration, interest in land application continues to grow. A major lesson that has been learned, however, is that the traditional definition of land application that emphasizes applying residuals to land in a manner that protects human and animal health, safeguards soil and water resources, and maintains long-term ecosystem quality is incomplete unless the earning of public trust in the practices is included. This overview provides an introduction to a subset of papers and posters presented at the conference, "Sustainable Land Application," held in Orlando, FL, in January 2004. The USEPA, USDA, and multiple national and state organizations with interest in, and/or responsibilities for, ensuring the sustainability of the practice sponsored the conference. The overriding conference objectives were to highlight significant developments in land treatment theory and practice, and to identify future research needs to address critical gaps in the knowledge base that must be addressed to ensure sustainable land application of residuals.