湖岸缓冲带反硝化作用的研究进展

反硝化作用是湖岸缓冲带去除硝酸盐的重要途径。湖岸缓冲带是联系陆地与湖泊生态系的纽带,不仅为许多动植物提供适宜生境,而且通过反硝化作用能去除地下水中的硝酸盐,提高湖泊水质。概述不同检测反硝化速率的方法,并对比各种方法的优点与缺点。阐述反硝化作用的影响因素：厌氧环境、有机碳、湖岸坡度、缓冲带坡度、pH与温度、硝酸盐浓度。介绍反硝化速率模型的研究开发状况。最后,提出了目前国内外反硝化研究中存在的不足及发展方向。     

Utilization of waste product (tamarind seeds) for the removal of Cr(VI) from aqueous solutions: Equilibrium, kinetics, and regeneration studies

In the present study, an adsorbent was prepared from tamarind seeds and used after activation for the removal of Cr(VI) from aqueous solutions. The tamarind seeds were activated by treating them with concentrated sulfuric acid (98% w/w) at a temperature of 150 °C. The adsorption of Cr(VI) was found to be maximum at low values of initial pH in the range of 1–3. The adsorption process of Cr(VI) was tested with Langmuir, Freundlich, Redlich–Peterson, Koble–Corrigan, Tempkin, Dubinin–Radushkevich and Generalized isotherm models. Application of the Langmuir isotherm to the system yielded a maximum adsorption capacity of 29.7 mg/g at an equilibrium pH value ranging from 1.12 to 1.46. The adsorption process followed second-order kinetics and the corresponding rate constants obtained were 2.605 × 10⁻³, 0.818 × 10⁻³, 0.557 × 10⁻³ and 0.811 × 10⁻³ g/mg min⁻¹ for 50, 200, 300 and 400 mg/L of initial Cr(VI) concentration, respectively. The regenerated activated tamarind seeds showed more than 95% Cr(VI) removal of that obtained using the fresh activated tamarind seeds. A feasible solution is proposed for the disposal of the contaminants (acid and base solutions) containing high concentrations of Cr(VI) obtained during the regeneration (desorption) process.     

Predicted concentrations of biocides from antifouling paints in Visakhapatnam Harbour

The concentrations of biocides leached from antifouling coatings are monitored in most of the developed countries. However, in India and many other developing countries, there is very little data available on the concentrations of biocides in ports and harbours. The first step was to obtain the order of magnitude levels of concentrations of biocides in the marine environment of the Visakhapatnam Harbour, and the MAM-PEC (Marine Antifoulant Model to Predict Environmental Concentrations) model was used to predict these values. The Visakhapatnam Port lies on the eastern coast of India, roughly halfway between Chennai and Kolkata, and is the largest port in India. This port is a natural harbour; the long and narrow outlet to the open sea makes it a 'poorly flushed' harbour. Predicted concentrations of tributyltin (TBT), copper, dichlofluanid, seanine, irgarol, diuron, tolylfluanid, and zinc pyrithione were computed. The results of the computations indicate that the levels of these biocides are comparable to those in many western countries. This gives credence to the fact that persistence of TBT and some other biocides is a global problem that cannot be ignored.     

活性艳蓝X-BR降解菌的筛选

从某印染厂废水排放出口的污泥中分离到一株活性艳蓝X-BR染料高效降解菌LPY68-14,经生理生化鉴定,该菌为埃希氏菌(Escherichia sp.).研究了影响菌株LPY68-14降解效果的因素,实验结果表明:在缺氧、质量分数为0.2%葡萄糖为外加碳源、温度37℃、接种量4 mL、pH 7的最佳条件下,质量浓度为30 mg/L的活性艳蓝X-BR经菌株LPY68-14处理24 h后的降解率可达80%;当活性艳蓝X-BR质量浓度为100～400 mg/L时,该菌处理48 h后的降解率可稳定在70%左右.     

混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.     

废聚碳酸酯水解法制双酚A

以1,4-二氧六环为溶剂、NaOH为催化剂,采用废聚碳酸酯(PC)常压水解法制双酚A(BPA).对反应影响因素进行了研究.实验结果表明,在反应温度为100℃、反应时间为8h、m(NaOH):m(水+溶剂)=1:33、m(溶剂):m(PC)=4:1、m(水):m(PC)=1:1的最佳反应条件下,PC水解率大于98%,BPA收率大于95%.     

Evaluation of environmental feasibility of steel pipe sheet pile cutoff wall at coastal landfill sites

An evaluation method that can express the local leakage of leachate from joint sections in steel pipe sheet pile (SPSP) cutoff walls is discussed in this study. In particular, the evaluation of environmental feasibility (containment of leachates containing toxic substances) considering a three-dimensional arrangement and hydraulic conductivity distribution of the joint sections in the SPSP cutoff wall is compared with an evaluation that uses the equivalent hydraulic conductivity. This equivalent hydraulic conductivity assumes that the joint section and the steel pipe are integrated; therefore, the hydraulic conductivity is substituted with a uniform permeable layer. However, in an evaluation that employs the equivalent hydraulic conductivity, it is difficult to consider the local leakage of leachate containing toxic substances from the joint sections in the SPSP cutoff wall. It was established that evaluations of the environmental feasibility of SPSP cutoff walls with joint sections must take into account the local leakage of leachates containing toxic substances from the joint sections. Also, it was clarified that technologies that lower the hydraulic conductivities of joint sections in SPSP cutoff walls and also facilitate the use of sparser joint arrangements contribute significantly to increasing the environmental feasibility of SPSP cutoff walls at landfill sites.     

Methanolysis and Hydrolysis of Polycarbonate Under Moderate Conditions

Alkali-catalyzed methanolysis and hydrolysis of polycarbonate (PC) in a solvent in which PC can substantially dissolve such as N-methyl-2-pyrrolidone, 1,4-dioxane, tetrahydrofuran and so on were studied. Reaction conditions were optimized for the purpose of recycling PC in the form of bisphenol A and carbon carbonate. The results showed that both the methanolysis and hydrolysis of PC could take place under moderate conditions. Under the conditions of reaction temperature 40 °C, m(PC):m(MeOH) = 1:1, m(PC):m(NaOH) = 50:1, reaction time 35 min and using tetrahydrofuran as solvent, the methanolysis conversion of PC was almost 100% and the yield of bisphenol A was over 95%. Moreover, under the conditions of reaction temperature 100 °C, m(PC):m(H₂O) = 1:0.7, m(PC):m(NaOH) = 10:1, reaction time 8 h and using 1,4-dioxane as solvent, the hydrolysis conversion of PC was almost 100% and the yield of bisphenol A was over 94%.     

Natural Weathering Studies of Polypropylene

Polypropylene (PP) has achieved a dominating position and hence, their consumption increases thereby littering, which lead to environmental pollution. Photodegradation seems to be a better choice because of naturally available sunlight as energy source for degradation. The present work involves the study of the variation of degradation behavior of PP film during tropical summer and winter seasons. The photodegradation is followed by Fourier transform infrared (FTIR) spectroscopic technique. Various indices like hydroxyl, carbonyl, vinylidene, lactones, ester, carboxylic acid and crystallinity are calculated and these values increased after a brief induction period. The variation in the mechanical properties like tensile strength and elongation at break percentages are determined. The scanning electron microscopic (SEM) images of weathered PP showed surface cracks when carbonyl index value increases sharply and the mechanical properties show a sudden decrease. Attempted life time prediction using mathematical models showed that the carbonyl growth is more affected by ultraviolet (UV) and cumulative total solar radiation for PP weathered during summer. The loss in tensile strength of PP weathered during summer is more dependent on the average temperature and the UV portion of the total solar radiation whereas, intensity of UV radiation has profound effect on the tensile strength of PP weathered during winter.     

Collective work and resilience of complex systems

This article aims to describe the characteristics of collective working situations in complex systems – especially those in nuclear power plants – related to common forms of cooperation, in order to improve systems resilience. In addition, we will try to detail some aspects of collective working situations, emphasizing the differences between various forms of control. The similarities between work activities (multi-addressed messages, linkage to regulation, central and peripheral information) are nonetheless exposed. We conclude by proposing a contribution to support systems design, thus facilitating cooperation in teamwork activities.