Investigations of an intense aerosol loading during 2007 cyclone SIDR – A study using satellite data and ground measurements over Indian region

Tropical cyclones are prominent weather systems characterized by high atmospheric pressure gradients and wind speeds. Intense tropical cyclones occur in India during the pre-monsoon (spring), early monsoon (early summer), or post-monsoon (fall) periods. Originating in both the Bay of Bengal (BoB) and the Arabian Sea (AS), these tropical cyclones often attain velocities of more than 100 km h^?1 and are notorious for causing intense rain and storm surge as they cross the Indian coast. In this study, we examine the changes in the aerosol properties associated with an intense tropical cyclone “SIDR”, that occurred during 11–16 November 2007 over BoB. This cyclone, accompanied with very strong surface winds reaching 223 km h^?1, caused extensive damage over Bangladesh. Ground-based measurements of Aerosol Optical Depth (AOD) in the neighboring urban environment of Hyderabad, India, showed significant variations due to changes in wind velocity and direction associated with the cyclone passage. The Terra-MODIS and AVHRR satellite images showed prevalence of dust particles mixed with emissions from anthropogenic sources and biomass-burning AS, while the aerosol loading over BoB was significantly lower. The positive values of Aerosol index (AI) obtained from the Ozone Monitoring Instrument (OMI) suggested the presence of an elevated aerosol layer over the West coast of India, AS and Thar Desert during and after the cyclone episode. Meteorological parameters from the MM5 mesoscale model were used to study the variations in winds associated with the cyclonic activity. Particulate matter loading over the region during the cyclone period increased by ～45% with an accompanying decrease in columnar aerosol optical depth. The variations in Angstrom parameters suggested coarse-mode particle loading due to dust aerosols as observed in satellite data.     

Carbon isotope analysis for source identification of atmospheric formaldehyde and acetaldehyde in Dinghushan Biosphere Reserve in South China

Formaldehyde and acetaldehyde are two most abundant carbonyls in ambient air. Biogenic emission has been proposed as a significant source other than anthropogenic emissions and atmospheric secondary formation. Here at a forest site in South China, the carbon isotopic compositions of formaldehyde and acetaldehyde emitted from leaves of three tree species (Litsea rotundifolia, Canarium album and Castanea henryi) were measured in comparison with the bulk carbon isotopic compositions of tree leaves. δ¹³C data of the emitted aldehydes (from ?31‰ to ?46‰) were quite different for tree species, which were all more depleted in ¹³C than the tree-leaf bulk δ¹³C values (from ?27‰ to ?32‰). Formaldehyde in ambient air at the forest site had δ¹³C values different from those of leaf-emitted formaldehyde, indicating other sources for ambient formaldehyde apart from direct emission from leaves, most probably the photooxidation of biogenic hydrocarbon like isoprene and monoterpene. The δ¹³C differences of acetaldehyde between ambient data and those of tree leaves emission were less than 1‰, implying direct biogenic emission as the dominant source.     

ABR反应器的两种快速启动方法对比

ABR反应器的启动是ABR反应器能否高效稳定运行的关键,其影响因素很多。为了更好地实现ABR反应器的启动,提出了通过2种不同启动方法的对比,即1^#反应器采用好氧预挂膜的方法,2^#反应器采用低负荷启动法,得出的结论为,好氧预挂膜启动法的启动时间短,COD去除率高,出水pH稳定,颗粒状污泥生长情况较好,是一种可推广的启动方法。     

铁改性海泡石除锑的影响因素研究

选择廉价海泡石, 用氯化铁对其改性。研究铁改性海泡石对锑的吸附特性。结果表明,氯化铁浓度、吸附时间、初始锑浓度以及温度等因素对锑的吸附影响较大,溶液初始pH影响不明显。在初始锑浓度50 mg/L,pH 6.8,5%氯化铁改性海泡石投加量为2 g/L,吸附90 min, 温度35℃下,吸附量可达21.6 mg/g。海泡石对吸附锑具有缓冲特性,溶液的初始pH值在3.1～10.1范围时,吸附后溶液的最终pH值为8～8.5。IMS吸附锑是放热过程。改性后海泡石比表面积增大,表面羟基数量增加,导致其吸附能力增强。通过XRD谱图并未发现铁晶体的存在。     

脂肪酰基氨基酸对矿物润滑油生物降解性的影响研究

通过生物降解试验研究了N-月桂酰基谷氨酸、N-月桂酰基甘氨酸、N-月桂酰基丙氨酸和N-油酰基甘氨酸4种脂肪酰基氨基酸对HVI 350矿物润滑油生物降解性的影响,采用高倍电子显微镜分析了生物降解过程中微生物数量和形态变化。结果表明,在矿物润滑油中添加少量脂肪酰基氨基酸后,矿物润滑油的生物降解性能明显改善,且生物降解过程中微生物数量增多、形态发生变化,这可能是脂肪酰基氨基酸增加了微生物的营养,且具有表面活性,有利于细胞的吸收,从而促进了矿物润滑油生物降解。     

砒霜生产化工厂危险废物处置工程设计

通过对砒霜生产化工厂原场址废渣及污染场地调查的基础上,进行了处置方案比选及技术经济比较,确定了就地安全填埋的处置方案。根据区域性危险废物集中安全填埋场的设计经验,本工程采用先进的HDPE双层防渗的安全填埋方式,并设置了雨水分流系统、渗滤液收集系统、封场处理和填埋气体导排系统,整个场区布置合理,对周围环境的影响小,投资少,取得了良好的社会效益和环境效益,并对危险废物处理处置工程设计中应注意的问题提出了建议。     

聚合氯化铝铁去除微污染水体中藻类的研究

以聚合氯化铝铁(PAFC)为絮凝剂,H2O2为预氧化剂,用正交实验研究了PAFC处理微污染水体中藻类和降低浊度,得出正交实验中各因素的主次关系及对除藻和除浊度的影响,研究表明,ρPAFC是影响除藻和除浊度的重要因素.在最佳处理条件,即ρPAFC为20 mg/L,ρH2O2为6 mg/L,pH为7,搅拌时间为4 min,能使水体中藻细胞街度从9.4×107 cells/L降至3.16×106 cells/L,除藻率为96.6%,浊度降至0.70 NTU,除浊度率达93.0%.     

垃圾填埋场微生物气溶胶粒径分布研究

为了了解垃圾填埋场微生物气溶胶粒径分布规律,在北京市某垃圾卫生填埋场填埋区、渗滤液处理区、生活区分别选定监测点,利用安德森六级微生物采样器,对填埋场空气微生物进行了系统的定点取样、测定和分析。研究结果表明,空气细菌粒径分布均为第Ⅰ级(>8.2 μm)最高,填埋区空气细菌粒径呈偏态分布,渗滤液处理区、生活区分别在第Ⅳ级和第Ⅲ级出现第2个峰值。携带细菌的可吸入微粒在渗滤液处理区比例最大。空气真菌与放线菌均在第Ⅳ级分布最高,携带真菌和放线菌的可吸入粒子的比例显著大于细菌(P<0.05)。填埋区不同作业时段空气微生物粒径在各级分布比例基本一致。填埋区细菌气溶胶中值直径为5.7 μm,渗滤液处理区为3.7 μm,生活区为5.3 μm,显著大于真菌气溶胶和放线菌气溶胶的中值直径(P<0.05)。     

氨水土壤混合物脱除CO2温室气体的实验研究

为了脱除CO2温室气体,提出了利用氨水土壤混合物去除CO2的新方法.分别考察了土壤颗粒粒径、CO2初始流量、氨水浓度(质量比)和温度对CO2脱除量和脱除率的影响.实验结果表明,该方法去除CO2的量较土壤物理吸附量和氨水化学吸收量的总和提高了大约15%;随着氨水浓度的增大,CO2的脱除率和脱除量都增大;随着土壤颗粒粒径和CO2初始流量的增大,CO2的脱除率和脱除量都减小;当温度由22℃升高到31℃,CO2的脱除率随着温度的升高而增大,但是继续升高温度到40 ℃,CO2的脱除率反而下降.     

湖岸缓冲带反硝化作用的研究进展

反硝化作用是湖岸缓冲带去除硝酸盐的重要途径。湖岸缓冲带是联系陆地与湖泊生态系的纽带,不仅为许多动植物提供适宜生境,而且通过反硝化作用能去除地下水中的硝酸盐,提高湖泊水质。概述不同检测反硝化速率的方法,并对比各种方法的优点与缺点。阐述反硝化作用的影响因素：厌氧环境、有机碳、湖岸坡度、缓冲带坡度、pH与温度、硝酸盐浓度。介绍反硝化速率模型的研究开发状况。最后,提出了目前国内外反硝化研究中存在的不足及发展方向。