CuO/γ-Al2O3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH(4~5)条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为:pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为:pH>反应时间>H2O2用量>催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。     

重庆主城区秋冬季逆温对空气质量影响的观测分析

2013年9—11月利用RPG-HATPRO地基多通道微波辐射计对重庆主城区大气进行连续探测,统计了大气逆温情况,并对典型重污染天气下大气逆温与空气质量状况进行综合分析。结果表明,逆温出现的频率为63.3%,基本为接地逆温类型,逆温层厚度为953 m,逆温强度为0.3℃/hm;逆温的存在为气溶胶的积聚和凝聚创造了有利条件。     

基于CA-MAS的水域总有机碳扩散模拟研究

当前水环境污染扩散研究一般基于普通数值模型模拟,忽略了水污染扩散微观驱动力的影响。为能更真实地反映其动态扩散过程,针对水域总有机碳(TOC)扩散机理,基于CA和MAS技术,将影响TOC扩散的自然和社会经济因素抽象为微观的水流Agent、风速Agent、径流量Agent、污水排放口Agent、人工管理Agent以及农业生产地Agent,将研究水域抽象为CA元胞空间,建立了CA-MAS水域总有机碳扩散模型,对水域总有机碳的动态演化过程进行模拟,并以武汉理工大学鉴湖水域作为实验区域,借助NetLogo仿真平台完成了模型的实现与验证。模拟结果表明,该模型基本能够反映水体总有机碳的扩散规律,可以为水环境污染控制提供参考。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

温度对正渗透工艺性能的影响

正渗透技术是一种以渗透压差为驱动力的新型膜分离工艺。温度是影响正渗透过程的关键因素。为考察温度在工艺运行中的重要作用,研究了温度对正渗透膜特性及工艺性能的影响,探讨通量衰减机制。结果表明,温度影响汲取液动态稀释、浓差极化和膜污染等的效应程度,进而影响正渗透性能。高温能够明显增加水通量和回收率,且汲取液温度影响比原料液显著。因此,合理优化温度条件是降低能耗提高正渗透性能的有效途径。     

Treating solid dairy manure using microwave-enhanced advanced oxidation process

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat separated solid dairy manure for nutrient release and solids reduction. The MW/H₂O₂-AOP was conducted at a microwave temperature of 120°C for 10 minutes, and at three pH conditions of 3.5, 7.3 and 12. The hydrogen peroxide dosage at approximately 2 mL per 1% TS for a 30 mL sample was used in this study, reflecting a range of 0.53–0.75 g H₂O₂/g dry sludge. The results indicated that substantial quantities of nutrients could be released into the solution at pH of 3.5. However, at neutral and basic conditions only volatile fatty acids and soluble chemical oxygen demand could be released. The analyses on orthophosphate, soluble chemical oxygen demands and volatile fatty acids were re-examined for dairy manure. It was found that the orthophosphate concentration for untreated samples at a higher % total solids (TS) was suppressed and lesser than actual. To overcome this difficulty, the initial orthophosphate concentration had to be measured at 0.5% TS.     

Micronucleus frequency in sheep lymphocytes after in vitro exposure to fungicide tolylfluanid

The fungicide tolylfluanid (N - dichlorofluoromethylthio-N′, N - dimethyl - N - p - tolylsulfamide), was investigated by cytokinesis-block micronucleus assay. Tolylfluanid at the lowest concentration (1 × 10^{? 6}mol L^{? 1})did not influence significantly the frequency of micronuclei in sheep lymphocyte cultures in comparison with control (32.33 ± 3.51/1000 binucleated cells versus 30.33 ± 2.82/1000 binucleated cells in dimethylsulfoxide (DMSO) control, P = 0.44). Higher tolylfluanid concentrations (1 × 10^{? 4} and, 1 × 10^{? 5} mol L^{? 1}) resulted in a significant dose-dependent increase in the number of micronuclei in comparison with control (74.00 ± 13.00/1000 binucleated cells and 52.67 ± 10.12/1000 binucleated cells versus 30.33 ± 2. 82/1000 binucleated cells in DMSO control, P = 0.005 and 0.02, respectively, ANOVA followed by Tukey test P < 0.05). Many of the treated cells also possessed multiple micronuclei. Tolylfluanid did not affect the nuclear division index at all treatment concentrations. Our in vitro results thus demonstrate that tolylfluanid had a significant genotoxic effect at only the highest concentration tested.     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H₂O₂ addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H₂O₂ and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.