Photochemical Reactivities of Paraffinic Hydrocarbon-Nitrogen Oxide Mixtures Upon Addition of Propylene or Toluene

Effects associated with photochemical air pollution were measured during irradiation of n-butane-nitrogen oxide or n-butane-ethane-nitrogen oxide mixtures, with small amounts of propylene or toluene added. The effects measured including nitrogen dioxide and oxidant dosages, yields of formaldehyde and peroxy-acetyl nitrate, and eye irritation response. The results obtained clearly show that beneficial effects result from selective changes in hydrocarbon composition as well as from reduction of total hydrocarbon concenfration. Exclusion of olefins and alkylbenzenes was highly effective in reducing oxidant dosage, formaldehyde and peroxyacetyl nitrate concentrations, and eye irritation response. The only penalty was a modest increase in nitrogen dioxide dosage. A large reduction in nitrogen oxide concentration reduced nitrogen dioxide dosage and eye irritation response, but with the penalty of a large increase in oxidant dosage. The desirability of preferentially reducing olefins and alkylbenzenes rather than paraffinic hydrocarbons, acetylene, and benzene is strongly supported by this study. Research and development efforts should be directed toward preferential hydrocarbon control by mechanical or catalytic control     

The Role of Disaggregation of Asset Values in Flood Loss Estimation: A Comparison of Different Modeling Approaches at the Mulde River,Germany

In loss estimation there is a spatial mismatch of hazard data that are commonly modeled on an explicit raster level and exposure data that are often available only for aggregated administrative units. Usually disaggregation methods that use ancillary information to distribute lumped exposure data in a finer spatial resolution help to bridge this gap. However, the actual influence of different mapping techniques and ancillary data on the final loss estimation has not been analyzed yet. In this paper three methods are applied to disaggregate residential building assets using two kinds of land use/land cover (LULC) data. The resulting disaggregated assets are validated and compared using census data of the residential building number on the community and constituency level. In addition, the disaggregated assets are taken to estimate residential building losses due to the flood in August 2002 in 21 municipalities on the River Mulde in Saxony, Germany. Losses are calculated with the help of four loss models. In general, disaggregation helps to decrease the error variance within the loss estimation. It must, however, be stated that the application of sophisticated disaggregation methods does not lead to significant improvements compared to the straightforward binary method. Therefore more effort should instead be put into the provision of high-resolution LULC data. Finally, the remaining uncertainties in loss estimation are high and demand further improvements in all modeling aspects.     

The role of technology innovation and people’s connectivity in testing environmental Kuznets curve and pollution heaven hypotheses across the Belt and Road host countries: new evidence from Method of Moments Quantile Regression

Environmental Science and Pollution Research - The Belt and Road Initiative (BRI) is closely linked to the ecological sustainability of the infrastructure ventures that intrinsically include the...     

Time study on the uptake of four different beta-blockers in garden cress (Lepidium sativum) as a model plant

Environmental Science and Pollution Research - The aim of this study was to investigate the uptake of four beta-blockers by the model plant Lepidium sativum (garden cress) and their possible...     

Structure and activity of thermophilic methanogenic microbial communities exposed to quaternary ammonium sanitizer

Food processing facilities often use antimicrobial quaternary ammonium compound (QAC) sanitizers to maintain cleanliness. These QACs can end up in wastewaters used as feedstock for anaerobic digestion. The aim of this study was to measure the effect of QAC contamination on biogas production and structure of microbial communities in thermophilic digester sludge. Methane production and biogas quality data were analyzed in batch anaerobic digesters containing QAC at 0, 15, 50, 100 and 150 mg/L. Increasing sanitizer concentration in the bioreactors negatively impacted methane production rate and biogas quality. Microbial community composition data was obtained through 16S rRNA gene sequencing from the QAC-contaminated sludges. Sequencing data showed no significant restructuring of the bacterial communities. However, significant restructuring was observed within the archaeal communities as QAC concentration increased. Further studies to confirm these effects on a larger scale and with a longer retention time are necessary.     

Influence of coagulation mechanisms and floc formation on filterability

Minimizing particles in water is a key goal for improving drinking water quality and safety.The media filtration process,as the last step of the solid–liquid separation process,is largely influenced by the characteristics of flocs,which are formed and controlled within the coagulation process.In a laboratory-based study,the impacts of the physical characteristics of flocs formed using aluminum sulfate on the filtration treatment of two comparative water samples were investigated using a photometric dispersion analyzer and a filterability apparatus.In general,the optimum dosage for maximizing filterability was higher than that for minimizing turbidity under neutral p H conditions.For a monomeric aluminum-based coagulant,the charge neutralization mechanism produced better floc characteristics,including floc growth speed and size,than the sweep flocculation mechanism.In addition,the charge neutralization mechanism showed better performance compared to sweep flocculation in terms of DOC removal and floc filterability improvement for both waters,and showed superiority in turbidity removal only when the raw water had high turbidity.For the different mechanisms,the ways that floc characteristics impacted on floc filterability also differed.The low variation in floc size distribution obtained under the charge neutralization mechanism resulted in the flocs being amenable to removal by filtration processes.For the sweep flocculation mechanism,increasing the floc size improved the settling ability of flocs,resulting in higher filter efficiency.     

Seasonal changes in burrow geometry of the common mole rat (Rodentia: Bathyergidae)

Sociality in mole rats has been suggested to have evolved as a response to the widely dispersed food resources and the limited burrowing opportunities that result from sporadic rainfall events. In the most arid regions, individual foraging efficiency is reduced, and energetic constraints increase. In this study, we investigate seasonal differences in burrow architecture of the social Cryptomys hottentotus hottentotus in a mesic region. We describe burrow geometry in response to seasonal weather conditions for two seasons (wet and dry). Interactions occurred between seasons and colony size for the size of the burrow systems, but not the shape of the burrow systems. The fractal dimension values of the burrow systems did not differ between seasons. Thus, the burrow complexity was dependent upon the number of mole rats present in the social group.     

Power matters in closing the phenotyping gap

Much of our understanding of physiology and metabolism is derived from investigating mouse mutants and transgenic mice, and open-access platforms for standardized mouse phenotyping such as the German Mouse Clinic (GMC) are currently viewed as one powerful tool for identifying novel gene-function relationships. Phenotyping or phenotypic screening involves the comparison of wild-type control mice with their mutant or transgenic littermates. In our study, we explored the extent to which standardized phenotyping will succeed in detecting biologically relevant phenotypic differences in mice generated and provided by different collaborators. We analyzed quantitative metabolic data (body mass, energy intake, and energy metabolized) collected at the GMC under the current workflow, and used them for statistical power considerations. Our results demonstrate that there is substantial variability in these parameters among lines of wild-type C57BL/6 (B6) mice from different sources. Given this variable background noise in mice that serve as controls, subtle phenotypes in mutant or transgenic littermates may be overlooked. Furthermore, a phenotype observed in one cohort of a mutant line may not be reproducible (to the same extent) in mice coming from a different environment or supplier. In the light of these constraints, we encourage researchers to incorporate information on intrastrain variability into future study planning, or to perform advanced hierarchical analyses. Both will ultimately improve the detectability of novel phenotypes by phenotypic screening. Carola W. Meyer and Ralf Elvert contributed equally to this work.     

A direct observation study of nighttime safety belt use in Indiana

INTRODUCTION: Nearly all direct observation studies of safety belt use are conducted exclusively during daylight hours. Recent work has suggested that safety belt use at night may differ from daytime belt use. METHODS: An observational study of nighttime safety belt use, utilizing specialized night vision equipment, was conducted in Indiana surrounding the Click It or Ticket 2006 safety belt mobilization activities. A pre- and a post-mobilization statewide direct observation survey was conducted at night coinciding with daytime safety belt use data collection conducted by the state of Indiana. Daytime and nighttime belt use rates were compared. RESULTS: The comparisons across the mobilization period revealed a significant increase during the day, but a significant decrease at night. Comparisons between daytime and nighttime belt use revealed no overall difference during the pre wave, but a significant difference during the post wave. Finally, many common daytime trends in belt use were also found at night, with the exception of the typical age and seating position effects. DISCUSSION: The mobilization activities had a positive effect on daytime belt use, but no effect on nighttime belt use, likely resulting in the differences between daytime and nighttime belt use observed during the post wave. IMPACT ON INDUSTRY: The findings of this study suggest that safety belt mobilizations implemented only during the day do not influence nighttime safety belt use. Changes to how these programs are implemented or additional programs specifically targeting belt use at night should be considered, along with continued monitoring of nighttime belt use.