The Chattanooga School Children Study: Effects of Community Exposure to Nitrogen Dioxide

Elementary schools in four areas of Greater Chattanooga were selected for a study of the effects of community exposure to nitrogen dioxide. One area, in close proximity to a large TNT plant, had high NO₂ exposure, another had relatively high suspended particulate exposure, and two areas served as “clean” controls. The similarity of the economic levels of the High-NO₂ and Control areas and the moderately lower economic level of the High-Particulate area were documented. Pollutant concentrations for NO₂ gas, suspended nitrates and sulfates, total suspended particulates, and soiling index were measured at stations located within the study areas. Ventilatory performance of second-grade school children in the High-NO₂ exposure area was significantly lower than the performance of children in the Control areas. The data suggested that ventilatory performance was adversely affected only when an NO₂ threshold was exceeded but that above this threshold no further impairment of performance could be detected.     

A Sampling Protocol for Composting,Recycling, and Re-use of Municipal Solid Waste

Abstract

This article reports on development of a protocol for characterizing municipal solid waste (MSW). This protocol is similar to that recommended by the American Society for Testing and Materials but includes a distinction between pure and mixed loads of MSW. Thirteen component categories were used with a focus on material feed stock for composting, recycling, and reuse. The required number of samples was determined to achieve a 80%, 90%, and 95% statistical accuracy for characterizing MSW categories at 1% and 2% sampling error. This study found that a maximum of 25 randomly collected samples of 200 pounds will reflect each component category of mixed load MSW with at least a 95% confidence level and 2% error. This protocol was successfully tested in Monongalia County, West Virginia, to provide a “snapshot” MSW characterization during early summer.     

Atmospheric Particulate Matter and Polycyclic Aromatic Hydrocarbons for PM10 and Size-Segregated Samples in Bangkok

Abstract

Air samples of particulate matter (PM) with an aerodynamic diameter less than 10 µm (PM₁₀) were collected from six sites in Bangkok, Thailand, using high-volume air samplers. Daily samples were taken at intervals of 12 days from November 1999 to November 2000. Size-selected sampling using a multislit Andersen size-fractionated cascade impactor was undertaken at one site in central Bangkok to identify particulate size distribution. The annual average PM₁₀ concentration at all six sites exceeded the Thailand National Ambient Air Quality Standard (NAAQS) of 50 µg/m³. The daily PM₁₀ concentrations at heavy traffic roadside areas ranged between 30 and 160 µg/m³. The highest PM₁₀ level occurred during the winter period (November–February), which is the dry season. From our results, which are based on a 1-yr survey, it can be observed that the particulate concentrations are associated with traffic volumes and seasonal factors (temperature and rainfall). The relative importance of size fractions in contributing to PM load is presented and discussed. Twenty polycyclic aromatic hydro-carbons (PAHs) associated with PM have been identified and quantified. The summed PAHs based on the 20 species had an average concentration of 60 ng/m³. Benzo(e)pyrene, indeno(123cd)pyrene, and benzo(ghi)perylene were the major compounds with average concentrations of 8, 10, and 13 ng/m³, respectively. Results indicate that more than 97% of PAHs were found in the small particulate size range of <0.95 µm.     

Spatial Variability of Different Fractions of Particulate Matter within an Urban Environment and between Urban and Rural Sites

ABSTRACT

The spatial variability of different fractions of particulate matter (PM) was investigated in the city of Basel, Switzerland, based on measurements performed throughout 1997 with a mobile monitoring station at six sites and permanently recorded measurements from a fixed site. Additionally, PM₁₀ measurements from the following year, which were concurrently recorded at two urban and two rural sites, were compared.

Generally, the spatial variability of PM₄, PM₁₀, and total suspended particulates (TSP) within this Swiss urban environment (area = 36 km²) was rather limited. With the exception of one site in a street canyon next to a traffic light, traffic density had only a weak tendency to increase the levels of PM. Mean PM₁₀ concentration at six sites with different traffic densities was in the range of less than ±10% of the mean urban PM₁₀ level. However, comparing the mean PM levels on workdays to that on weekends indicated that the impact of human activities, including traffic, on ambient PM levels may be considerable.

Differences in the daily PM₁₀ concentrations between urban and more elevated rural sites were strongly influenced by the stability of the atmosphere. In summer, when no persistent surface inversions exist, differences between urban and rural sites were rather small. It can therefore be concluded that spatial variability of annual mean PM concentration between urban and rural sites in the Basel area may more likely be caused by varying altitude than by distance to the city center.     

Public Reaction to Air Pollution in Nashville,Tennessee

Extensive air pollution studies have been completed in Nashville. One part of the study involved collection of opinions from nearly 8000 people. Opinions were solicited relative to awareness and concern about possible adverse effects of air pollution on health, property, materials, and aesthetics. Responses of the interviewed people are related to several types of pollutant measurements. The results indicate widespread concern about air pollution, and the degree of concern is, in general, closely related to the degree of air contamination experienced by interviewed people. Methodology is discussed, data are analyzed statistically, and conclusions are presented.     

Emissions Control and Ambient Air Quality at a Secondary Steel Production Facility

Steel production from electric arc furnaces has been continuously rising over the past few years. The trend is expected to continue due to both the anticipated increase in demand for steel, and to the replacement of obsolete open hearth furnaces. In 1972 steel produced in electric arc furnaces, which makes up 25 to 30% of the annual United States steel production, was produced primarily from recycled scrap steel in approximately 300 electric arc furnaces operated by 99 companies at 121 locations.¹ Over half of these furnaces are smaller than 50 tons, and many are located in small bar mills producing a variety of merchant steel products.     

A Canadian Federal Viewpoint on the Regulatory Process for Air Pollution Control

The following remarks are excerpted from an address presented by Mr. Rivers on October 7, 1980 to the 4th annual meeting of the Atlantic Canada Chapter of APCA's Northeast Atlantic International Section.     

Estimation of Process Change for Industrial Pollution Abatement

Abstract

When forecasting the impacts of pollution control regulations upon industries which produce pollutants jointly with ordinary outputs, potential input and production process adjustments must be identified and assessed. The problem addressed here is that the empirical approximation of Joint production processes by a single-equation Least Squares (LS) regression misrepresents restrictions on input substitution possibilities. In such cases, some inputs are allocated to both production processes, which provides the jointness. But other inputs contribute to only one process and do not contribute to adjustment opportunities in the other process. Since single-equation LS regression assumes that all inputs can be substituted throughout the production process, its application results in a misspecified empirical model. This paper presents a theoretical framework that motivates the use of Seemingly Unrelated Regression (SUR) estimators to directly approximate such processes. The advantage to using the SUR estimators is that they exploit the related nature of the input decisions so that a more accurate model of the processes can be estimated. The framework is demonstrated with an application to the case of SO₂ abatement by coal-fired electricity generating units. The results indicate that these units could efficiently burn more low-BTU, low-sulfur coal to maintain the same electricity output with a lower SO₂ emission rate. More generally, this application demonstrates the usefulness of the framework developed here.     

Observations Less than the Analytical Limit of Detection: A New Approach

Abstract

Solutions are given for plume rise assuming a power-law wind speed profile in a stably stratified layer for point and finite sources with initial vertical momentum and buoyancy. For a constant wind speed, these solutions simplify to the conventional plume rise equations in a stable atmosphere. In a shear layer, the point of maximum rise occurs further downwind and is slightly lower compared with the plume rise with a constant wind speed equal to the wind speed at the top of the stack. If the predictions with shear are compared with predictions for an equivalent average wind speed over the depth of the plume, the plume rise with shear is higher than plume rise with an equivalent average wind speed.     

Comments On “Particulate Pollutants in the Air of the United States”

This study was undertaken to identify seasonal and source effects on the par-ticulate contaminants of the New York City atmosphere and ultimately to relate the concentrations of these contaminants to the tissue concentrations in residents of New York City. Continual weekly samples of particulates have been collected at three stations in the New York area on 8 by 10 in. glass fiber filters at a flow rate of 20 cfm.

The sample is ashed with a Tracerlab Low Temperature Asher and leached with nitric acid. Metals analyzed by the Atomic Absorption method include Pb, V, Cd, Cr, Cu, Mn, Ni, and Zn. Lead-210, total particulate, and benzene and acetone soluble organic material are also determined.

The data have been related to various meteorological parameters over a one year period to define significant seasonal and source influences, as well as site to site variations. Very significant inverse correlations to temperature are obtained for suspended particulates, vanadium, and nickel at both Manhattan and Bronx sites. Particulates show a less significant inverse correlation to temperature In lower Manhattan. Oil-fired space heating sources appear to account for as much as 50% of the particulates in the Bronx at the peak demand period.

Lead, copper, and cadmium show a general inverse correlation to average wind speed, and a direct correlation to temperature. The latter is most likely due to an inverse relation between wind speed and temperature. The heating season input for particulates, vanadium, and nickel is so great as to overcome most of the dilution effect due to winds. The other elements having more constant nonseasonal inputs, definitely reflect the effects of the wind.

The most significant site effect occurs with cadmium, which has a concentration in lower Manhattan three times that of the Bronx over a period of six to seven months in the summer and fall. The differences observed for cadmium and particulates may be explained by emission source factors which have not as yet been studied.