An examination of antecedents to coal miners' hearing protection behaviors: a test of the theory of planned behavior

PROBLEM: The National Institute for Occupational Safety and Health's [NIOSH] National Occupational Research Agenda (DHHS Publication No. 96-115) reports that approximately 50% of miners will experience hearing loss by age 50, compared to only 9% of the general population. The present investigation examines three antecedents believed to be associated with miner's use of hearing protection. METHOD: A posttest-delayed-posttest-control group field research design was employed to assess antecedents toward wearing hearing protection. RESULTS: Following the initial posttest, miners' attitudes and subjective norms were antecedents to intentions to wear hearing protection devices. Also, intentions toward wearing hearing protection predicted hearing protection behaviors. Approximately six weeks later, miners' attitudes and perceived behavioral control were each significant predictors of intentions to wear hearing protection and again, intentions were positively associated with hearing protection behaviors. IMPACT ON INDUSTRY: Our results indicate that appeals to normative influences may be the most effective antecedent to employ when persuading coal miners to wear hearing protection. However, messages designed to impact attitudes and perceived behavioral control were also effective.     

Rhamnolipid morphology and phenanthrene solubility at different pH values

The effect of pH and rhamnolipids on the solubility of phenanthrene was investigated in a sand-water system. Batch phenanthrene solubilization experiments in this system showed that the highest phenanthrene solubility occurred at pH 5 in the presence of 240 and 150 mg L(-1) rhamnolipids. As the pH was increased from 5 to 7, the apparent solubility of phenanthrene decreased and then stabilized from pH 7 to 8. At pH 4, a dramatic decrease in phenanthrene solubility was observed. This result is in contrast to previous findings obtained in an aqueous system without soil particles. To investigate the reason for this decrease, the critical micelle concentrations (CMCs) were measured in the presence or absence of sand particles, and the maximum amount of sorbed biosurfactant at each pH was calculated based on the differences of the two CMC values. More rhamnolipid molecules were lost by the sorption into sand particles at pH 4 than at other pH values; this explains the dramatic decrease of solubility at pH 4 in the sand-water system. To confirm the explanation for the different solubilizing capacity that results from the structural change of biosurfactant aggregate, cryo-transmission electron microscopy was used. Micrographs showed that the rhamnolipid morphology changed from large lamellar sheets, to vesicle, and then to micelle as the pH increased. The large and multilamellar vesicles at pH 5 were considered to be the most effective structure for the solubilization of phenanthrene.     

Detecting deforestation with a spectral change detection approach using multitemporal Landsat data: a case study of Kinabalu Park, Sabah, Malaysia

Tropical deforestation is occurring at an alarming rate, threatening the ecological integrity of protected areas. This makes it vital to regularly assess protected areas to confirm the efficacy of measures that protect that area from clearing. Satellite remote sensing offers a systematic and objective means for detecting and monitoring deforestation. This paper examines a spectral change approach to detect deforestation using pattern decomposition (PD) coefficients from multitemporal Landsat data. Our results show that the PD coefficients for soil and vegetation can be used to detect deforestation using change vector analysis (CVA). CVA analysis demonstrates that deforestation in the Kinabalu area, Sabah, Malaysia has significantly slowed from 1.2% in period 1 (1973 and 1991) to 0.1% in period 2 (1991 and 1996). A comparison of deforestation both inside and outside Kinabalu Park has highlighted the effectiveness of the park in protecting the tropical forest against clearing. However, the park is still facing pressure from the area immediately surrounding the park (the 1km buffer zone) where the deforestation rate has remained unchanged.     

Mass Load-Based Pollution Management of the Han River and Its Tributaries, Korea

Spatio-temporal variations of biochemical oxygen demand (BOD) and total coliform (TC) in the Han River, Korea, were investigated in terms of concentration-based and mass loading-based approaches. Considering the river water quality criteria regulated by the Ministry of Environment in Korea, the tributaries linked to the mainstream of the Han River were found to be highly contaminated with respect to both BOD and TC and, in fact, most of the tributaries exceeded the maximum water quality criteria. To evaluate the pollution impact of tributaries on the mainstream, the monthly water quality monitoring data for six years (from 1995 to 2000) were collected from the Han River basin, and statistically analyzed using Pearson’s correlation coefficient. The results revealed that mass loading-based approach was superior to the concentration-based approach for effective Han River watershed management. Overall results supported that the mass loading-based approach associated with total maximum daily loads (TMDL) management would be a useful and suitable protocol in watershed management for improving the water quality of the Han River and protecting public health. Therefore, this study supporting TMDL management can be applicable to a wide array of contaminants and watershed settings in Korea.     

Uncertainty Reduction of the Flood Stage Forecasting Using Neural Networks Model1

Abstract: The Elman Discrete Recurrent Neural Networks Model (EDRNNM), which is one of the special types of neural networks model, is developed and applied for the flood stage forecasting at the Musung station (No. 1) of the Wi‐stream catchment, which is one of the International Hydrological Program representative basins, Korea. A total of 135 different training patterns, which involve hidden nodes, standardization process, data length, and lead‐time, are selected for the minimization of the architectural uncertainty. The model parameters, such as optimal connection weights and biases, are estimated during the training performance of the EDRNNM, and we apply them to evaluate the validation performance of the EDRNNM. Sensitivity analysis is used to reduce the uncertainty of input data information of the EDRNNM. As the results of sensitivity analysis, the Improved EDRNNM consists of four input nodes resulting from the exclusion of Dongkok station (No.5) in initial five input nodes group of the EDRNNM. The accuracy of flood stage forecasting during the training and validation performances of the Improved EDRNNM remains the same as that of the EDRNNM. The Improved EDRNNM, therefore, gives highly reliable flood stage forecasting. The best optimal EDRNNM, so called the Improved EDRNNM, is determined by elimination of the uncertainties of architectural and input data information in this study. Consequently, we can avoid unnecessary data collection and operate the flood stage forecasting system economically.     

Feasibility of phosphate fertilizer to immobilize cadmium in a field

To reduce effectively cadmium (Cd) phytoextractability by phosphate fertilizer in Cd contaminated soil, fused and superphosphate (FSP) was applied at the rate of 0, 33.5 (recommendation level), 167.5, and 335 kg P ha⁻¹ for radish (Raphanus sativa L.). Unlike from what we expected, soil Cd extractability and Cd concentration in radish increased with increasing FSP application in the field. To determine the effect of FSP on Cd immobilization, FSP was mixed with the selected soil at the rate of 0, 200, 400, 800, and 1600 mg P kg⁻¹ and then incubated for 8 weeks. As observed in the field study, NH₄OAc extractable Cd concentration increased slightly with FSP addition up to 400 mg P kg⁻¹ and thereafter dramatically decreased upon increasing its application rate. Soil pH and negative charge were decreased at low level of FSP application up to 400 mg P kg⁻¹, but thereafter continually increased with increasing application level. This could be indirect evidence that net soil negative charge was increased by the specific adsorption of phosphate at the high rate of FSP application over 400 mg P kg⁻¹. The labile Cd fraction (water soluble and exchangeable + acidic fraction) increased with increasing FSP application by 400 mg P kg⁻¹ and thereafter gradually decreased with corresponding increase in unlabile fraction (oxidizable and residual fraction). Based on these results, FSP might be applied with a very high rate over 800 mg P kg⁻¹ to decrease Cd extractability in the selected field. However, this level is equivalent to 1440 kg P ha⁻¹, which is about 43 times higher than the recommendation levels for radish production and resulted in a significant increase in water soluble P concentration creating a new environmental problem. Therefore, the feasibility of FSP to reduce Cd extractability in the field is very low.     

Influence of HCl on oxidation of gaseous elemental mercury by dielectric barrier discharge process

The influence of HCl on the oxidation of gaseous elemental mercury (Hg0) has been investigated using a dielectric barrier discharge (DBD) plasma process, where the temperature of the plasma reactor and the composition of gas mixtures of HCl, H2O, NO, and O2 in N2 balance have been varied. We observe that Cl atoms and Cl2 molecules, created by the DBD process, play important roles in the oxidation of Hg0 to HgCl2. The addition of H2O to the gas mixture of HCl in N2 accelerates the oxidation of Hg0, although no appreciable effect of H2O alone on the oxidation of Hg0 has been observed. The increase of the reaction temperature in the presence of HCl results in the reduction of Hg0 oxidation efficiency probably due to the deterioration of the heterogeneous chemical reaction of Hg0 with chlorinated species on the reactor wall. The presence of NO shows an inhibitory effect on the oxidation of Hg0 under DBD of 16% O2 in N2, indicating that NO acts as an O and O3 scavenger. At the composition of Hg0 (280 microg m(-3)), HCl (25 ppm), NO (204 ppm), O2 (16%) and N2 (balance) and temperature 90 degrees C, we obtain the nearly complete oxidation of Hg0 at a specific energy density of 8 J l(-1). These results lead us to suggest that the DBD process can be viable for the treatment of mercury released from coal-fired power plants.     

Single-well, gas-sparging tests for evaluating the in situ aerobic cometabolism of cis-1,2-dichloroethene and trichloroethene

This study developed single-well, gas-sparging tests for assessing the feasibility of in situ aerobic cometabolism of trichloroethene (TCE) and cis-1,2-dichloroethene (cis-DCE) using propane and methane as growth substrates. Tests were performed in groundwater contaminated with TCE (100-400 microg l(-1)) and cis-DCE (20-60 microg l(-1)). A series of gas-sparging tests was performed by first sparging ("bubbling") gas mixtures in a well fitted with a "straddle" packer and then periodically sampling groundwater from the same well to develop concentration profiles and to estimate transformation rate coefficients. Evidence that gas-sparging of propane (or methane) and oxygen had stimulated organisms expressing a propane (or methane) monooxygenase enzyme system and the capability to transform TCE and cis-DCE included: (1) the transformation of sparged ethylene and propylene to their corresponding cometabolic by-products, ethylene oxide and propylene oxide, (2) the transformation of both cis-DCE and TCE in the propane-sparged well, (3) the transformation of cis-DCE in the methane-sparged well, and (4) the inhibition of ethylene and propylene transformations in the presence of acetylene, a known monooxygenase inactivator. At a well sparged with propane, first-order rate coefficients for propane utilization and ethylene and propylene transformation were similar, ranging from 0.007 to 0.010 h(-1). At the well sparged with methane, the propylene first-order transformation rate coefficient was 0.028 h(-1), a factor of 1.8 and 1.6 greater than methane and ethylene, respectively. The results demonstrated that gas-sparging tests are a rapid, low-cost means of assessing the potential for the in situ aerobic cometabolism of cis-DCE and TCE.     

Response of microbial growth to orthophosphate and organic carbon influx in copper and plastic based plumbing water systems

Consequences of orthophosphate addition for corrosion control in water distribution pipes with respect to microbial growth were investigated using batch and dynamic tests. Batch tests showed that the release of copper in either low or high organic carbon content water was decreased by 69% and 56% with addition 206 microg PO(4)-P, respectively. Dosing of orthophosphate against corrosion did not increase microbial growth potential in the water and in the biofilm in both corroded and uncorroded systems receiving tap water with a low content of organic carbon and of biodegradable organic fraction. However, in tap water having a high concentration of organic carbon from acetate addition, orthophosphate addition promoted the growth of bacteria, allowed more bacteria to assemble on corroded and uncorroded surfaces, and increased the consumption of organic carbon. Orthophosphate consumption did not exceed 1% of the amount of easily biodegradable organic carbon required for microbial growth, and the orthophosphate demand for corrosion control greatly exceeded the nutritional requirement of microbial growth. The results of the dynamic tests demonstrated that there was a significant effect of interaction between biodegradable organic carbon and orthophosphate on biofilm growth, whereby the effect of orthophosphate flux on microbial growth was dependent on the levels of biodegradable organic carbon. Controlling an easily biodegradable organic carbon would be therefore necessary to minimize the microbial growth potential induced by orthophosphate-based anticorrosion treatment.     

Reactive transport modeling of column experiments on the evolution of saline-alkaline waste solutions

Leakage of saline-alkaline tank waste solutions often creates a serious environmental contamination problem. To better understand the mechanisms controlling the fate of such waste solutions in the Hanford vadose zone, we simulated reactive transport in columns designed to represent local site conditions. The Pitzer ion interaction module was used, with principal geochemical processes considered in the simulation including quartz dissolution, precipitation of brucite, calcite, and portlandite, multi-component cation exchange, and aqueous complexation reactions. Good matches were observed between the simulated and measured column data at ambient temperature ( approximately 21 degrees C). Relatively good agreement was also obtained at high temperature ( approximately 70 degrees C). The decrease of pH at the plume front is examined through formation of secondary mineral phases and/or quartz dissolution. Substantial formation of secondary mineral phases resulting from multi-component cation exchange suggests that these phases are responsible for a decrease in pH within the plume front. In addition, a sensitivity analysis was conducted with respect to cation exchange capacity, selectivity coefficient, mineral assemblage, temperature, and ionic strength. This study could serve as a useful guide to subsequent experimental work, to thermodynamic models developed for the concentrated solutions at high ionic strength and to other types of waste plume studies.