中国煤矿工人体能负荷、疲劳与工伤事故

煤矿井下事故对矿工威胁很大，体力负荷过重而导致疲劳是引起事故不可忽视的原因。测定不同工种井下矿工的体能负荷情况，并根据ＦＩＸ疲劳指数的测定，分析矿工劳动负荷与工伤事故发生之间的关系。研究表明，在疲劳状态下事故发生的危险性增加；劳动负荷越重，疲劳越重相对的事故发生率也越高。减轻疲劳对预防事故发生与保证工作安全具有很重要的意义     

The characterisation of polycyclic aromatic hydrocarbons emissions from burning of different firewood species in Australia

Four kinds of woods used for residential heating in Australia were selected and burned under two burning conditions in a domestic wood heater installed in a laboratory. The selected wood species included pine (Pinus radiata), red gum (Eucalvptus camaldulensis), sugar gum (Eucalyptus cladocalyx) and yellow box (Eucalyptus melliodora). The two different burning conditions represented fast burning and slow burning, with the air inlet of the combustion chamber respectively 'full open' and 'half open'. By sampling and analysing particulate and gaseous emissions from the burning of each load of wood under defined experimental conditions, PAHs emissions and their profiles in the particulate and gaseous phases were obtained. 16 species out of the 18 selected PAHs were detected. Of these, seven species were detected in the gaseous phase and most were lower molecular weight compounds.Similarly, more than 10 species of PAHs were detected in the particulate phase and these were mostly heavier molecular weight compounds. Under both burning conditions, emission levels for total PAHs and total genotoxic PAHs were the highest for pine and lowest for sugar gum, with red gum being the second highest, followed by yellow box. Using the specific sampling method, gaseous PAHs accounted for above 90% mass fraction of total PAHs in comparison to particulate PAHs (10%). The majority of the genotoxic PAHs were present in the particulate phase. PAHs emission levels in slow burning conditions were generally higher than those in fast burning conditions.     

Concentrations of heavy metals and polycyclic aromatic hydrocarbons in needles of Masson pine (Pinus massoniana L.) growing nearby di erent industrial sources

Emissions from industrial activities pose a serious threat to human health and impose the need for monitoring both inorganic and organic pollutants in industrial areas.We selected Masson pine (Pinus massoniana L.) as potential biomonitor and collected the current (C) and previous year (C+1) needles from three industrial sites dominated by petrochemical, ceramics manufacturing, and iron and steel smelting plants and one remote site to determine heavy metals (Cu, Cd, Pb, Zn, Cr, Ni and Co) and polycyclic aromatic hydrocarbons (PAHs) in unwashed and water-washed needles. Both unwashed and washed C+1 needles showed generally higher concentrations of heavy metals and PAHs than C needles, although the washed needles more clearly spotlighted the accumulation e ect of PAHs over exposure time. Water-washing resulted in a significant decrease in needle PAH concentrations with more significant e ects shown in C needles. By contrast, needle heavy metal concentrations were much less a ected by washing. Although heavy metals and PAHs might di er in adsorption and uptake strategies, their higher concentrations in the needles at the industrial sites indicated conspicuous contamination due to industrial emissions there. The PAH distribution patterns in pine needles accorded with the real types of energy consumption in the study sites and were e ciently used for pinpointing local pollutant sources.     

分光光度法测定水稻土中有机酸的研究

本文以三种有机酸为代表,研究并建立了测定水稻土中有机酸的分光光度法。结果表明,三种有机酸的有色络合物具有相同的吸收光谱,且具有相同的最大吸收波长(λ_(mss)=500um)和相近的表观摩尔吸光系数。水分对酯化反应影响很大,含水量达4ml时,吸光值下降85％。酯化温度在10℃以上时,酯化率达最大值且保持稳定。在25℃时,显色反应20min趋干稳定,且在1h内吸光值下降不超过1.2％。土样中的有机酸采用NaCl溶液为提取剂,以3:1的液土比振荡提取30min,NaCl溶液浓度为1％就能达到良好的提取、过滤效果。提取液在烘干前需进行碱化,否则有机酸将损失30％以上。本法平均回收率为92.2％(n=5),标准差为0-0.0478cmol k8~(-1)(n=2-6),平均0.0142cmol kg~(-1)(n=26);变异系数为0—10％(n=2-6),平均4.87％(n=26);线性范围为0—0.0018mol L~(-1)。     

原子吸收分光光度法测定植株中钙、镁的几种样品前处理方法的比较

本文比较了原子吸收分光光度法测定植株中钙、镁的三种样品前处理方法：干友化法、１ｍｏｌ／ＬＨＣｌ振荡提取法（振荡法）和１ｍｏｌ／ＬＨＣｌ静止浸泡提取法（浸泡法）．结果表明，振荡法和浸泡法对钙的测定结果平均分别为干灰化法的１０１％和９２．０％，对镁的测定结果平均分别为１０３％和９７．６％．振荡法和浸泡法与干灰化法之间不存在显著性差异（α＝０．０５），它们之间有极显著的正相关性（相关系数在０．９９以上）．因此，在大批量样品的常规分析中，１ｍｏｌ／ＬＨＣｌ提取法可代替干灰化法．     

农林复合经营研究──桉树人工林间种西瓜对林木和土壤的效应

本文调查研究了雷州林业局纪家、河头林场桉树人工林间种西瓜对林木和土壤的影响．结果表明，利用造林前空隙种一造西瓜或在桉树林地间种西瓜，均有利于桉树生长．单位面积林木蓄积量和年生长量均比对照林分显著增加，经济效益显著；土壤养分也有增加。作为农林复合经营的有益尝试，值得在有条件的地区推广。     

氯氧化锆生产中废碱液的回收利用

建立了以 CaO 为沉淀剂去除废碱液中 SiO2回收 NaOH 的工艺,研究了各工艺因素对siO2去除效果的影响,实验结果表明,CaO 沉淀除去废碱液中 SiO2的最佳工艺条件为:CaO 与废碱液中 SiO2摩尔比 3.0,反应温度80～95℃,反应时间 40～60 min,搅拌转速 200 r/min.在此条件下,S...     

城市空气质量达标规划编制中的关键技术及其案例应用

本文结合重庆市空气质量限期达标规划编制案例,介绍了城市空气质量达标规划编制中的几个关键技术及其具体应用,包括本地化污染源排放清单编制、污染物来源解析、污染物排放形势预测与减排潜力分析以及大气环境容量核算等。本地化污染源排放清单是城市空气质量达标规划编制的基础,针对现有污染源制定科学合理的减排方案是达标规划的核心内容。分析不同区域的污染物组分浓度特征、污染源贡献以及未来污染排放形势预测,有助于识别出制约未来空气质量达标的关键因素及污染源。基于污染源减排潜力和污染传输矩阵制定的污染源减排方案更具合理性和可行性,应用空气质量模型估算大气环境容量可为规划目标可达性提供依据。     

基于GIS的耕地土壤重金属污染与农业功能定位研究——以山东省聊城市为例

按8km×8km的网格将聊城市耕地分为137个采样点,调查砷、镉、铬、铜、汞、镍、铅、锌等重金属的污染状况。采用国家土壤环境质量标准、农产品安全质量标准和绿色食品产地环境条件作为评价标准,采用单因子指数和综合指数为评价方法进行污染评价。研究表明,聊城市土壤污染强度依次为铜〉镍〉锌〉砷〉铬〉镉〉铅〉汞,但均未超标。以GIS为操作平台显示聊城市重金属空间分布状况,并对区域耕地进行了功能的定位。聊城市西南部土壤质量最优,适宜种植绿色食品;无公害蔬菜和安全粮食种植区在各县市均有不同程度的分布。     

The Sustainable Development of ICTs in China： An Empirical Study of Small and Medium-Sized Enterprises

The wide application of new information and communication technologies （ICTs） has been argued to be critical to business success of small and medium-sized enterprises （SMEs）, especially to those in the developing countries. Drawing upon existing literature, this article will examine the determinants of ICTs application in SMEs in China based on data collected from interviews with top managers and/or owners of 70 SMEs. We identify 20 factors affecting ICTs application in SMEs in China and divide them into four broad categories, namely pressures, firm specific factors, technical factors and local milieu. We also pay special attention to the Chinese business environment affecting ICTs application. Our analysis shows that local ICT infrastructure, external pressures from competitors and ICT knowledge of employees are the determinants of Internet application by SMEs, while product characteristics and market target are important factors of e-commerce adoption.