Modeling in-situ uranium(VI) bioreduction by sulfate-reducing bacteria

We present a travel-time based reactive transport model to simulate an in-situ bioremediation experiment for demonstrating enhanced bioreduction of uranium(VI). The model considers aquatic equilibrium chemistry of uranium and other groundwater constituents, uranium sorption and precipitation, and the microbial reduction of nitrate, sulfate and U(VI). Kinetic sorption/desorption of U(VI) is characterized by mass transfer between stagnant micro-pores and mobile flow zones. The model describes the succession of terminal electron accepting processes and the growth and decay of sulfate-reducing bacteria, concurrent with the enzymatic reduction of aqueous U(VI) species. The effective U(VI) reduction rate and sorption site distributions are determined by fitting the model simulation to an in-situ experiment at Oak Ridge, TN. Results show that (1) the presence of nitrate inhibits U(VI) reduction at the site; (2) the fitted effective rate of in-situ U(VI) reduction is much smaller than the values reported for laboratory experiments; (3) U(VI) sorption/desorption, which affects U(VI) bioavailability at the site, is strongly controlled by kinetics; (4) both pH and bicarbonate concentration significantly influence the sorption/desorption of U(VI), which therefore cannot be characterized by empirical isotherms; and (5) calcium-uranyl-carbonate complexes significantly influence the model performance of U(VI) reduction.     

Mechanism of decolorization and degradation of CI Direct Red 23 by ozonation combined with sonolysis

The decolorization and degradation of CI Direct Red 23, which is suspected to be carcinogenic, were investigated using ozonation combined with sonolysis. The results showed that the combination of ozonation and sonolysis was a highly effective way to remove color from waste water. The operational parameters, namely concentration of the dye, pH, ozone dose and ultrasonic density, were investigated during the process. The decolorization of the dye followed pseudo-first-order kinetics. Increasing the initial concentration of Direct Red 23 led to a decreasing rate constant. The optimum pH for the reaction was 8.0, and both lower and higher pH decreased the removal rate. The effect of the ozone dose on the dye decolorization was much greater than that of the sonolysis density. Intermediates such as naphthalene-2-sulfonic acid, 1-naphthol, urea and acetamide were detected by gas chromatography coupled with mass spectrometry in the absence of pH buffer, while nitrate and sulfate ions and formic, acetic and oxalic acids were detected by ion chromatography. A tentative degradation pathway was proposed without any further quantitative analyses. During the degradation, all nitrogen atoms and phenyl groups of Direct Red 23 were degraded into urea, nitrate ion, nitrogen and formic, acetic and oxalic acids, etc.     

Effects of tributyltin on the energy metabolism of pen shell (Atrina pectinata japonica)

We examined the effects of tributyltin (TBT) on aerobic and anaerobic energy metabolism of pen shell (Atrina pectinata japonica). We exposed pen shells to TBT at nominal concentrations of 0 (control) and 1.0microg/l for 72h under aerobic condition. At the end of the exposure, half of the pen shells in each treatment were wrapped in plastic wrap to simulate exposure to hypoxia and held at 25 degrees C for another 12h. The concentrations of the products of energy metabolism, namely lactate, pyruvate, fumarate and succinate, in adductor muscle were measured. The exposure to TBT under aerobic condition significantly elevated lactate, pyruvate and fumarate concentrations (p<0.001). After subsequent exposure to anaerobic condition, the mean concentration of succinate in the TBT treatment group was 64% of that in the control group, but there were no significant differences. Our results suggest that the energy metabolism of pen shell is disrupted by exposure to TBT.     

Source analysis of particulate-phase polycyclic aromatic hydrocarbons in an urban atmosphere of a northern city in China

Particle-associated polycyclic aromatic hydrocarbon (PAH) concentrations were investigated at six sampling sites in the heating (February to March 2001) and nonheating (August to September 2001) periods in an industrial city in Northern China. Thirteen PAHs were measured. The total average concentrations (nanograms per meter cubed) of PAHs ranged between 78.93 and 214.63 during the heating period and from 31.48 to 102.26 in the nonheating period. Benzo(a)pyrene occurred at the highest level at a site near an industrial area but occurred at low concentrations far from the city center and industrial areas. In addition, ambient PAH profiles were studied. The five and six-ring species occurred in high fractions at the sampling site. By diagnostic ratio analysis, the major source at each sampling site in the city was coal combustion in the heating period; in the nonheating period, the major sources were relatively complex. Finally, the similarities among the six regions were assessed by principal component analysis, cluster analysis, and coefficient of divergence. These multivariate statistical analyses produced similar results, which agreed with the results from the diagnostic ratio analysis.     

Biohydrogen production through fermentation using liquid swine manure as substrate

In this paper, continuous production of hydrogen through fermentation with liquid swine manure as substrate was researched using a semi-continuously fed fermenter (8 L in total volume and 4 L in working volume). The pH and temperature for the fermenter were controlled at 5.3 +/- 0.1 and 35 +/- 1 degrees C, respectively, throughout the experiment. Three hydraulic retention times (16, 20, and 24 h) were investigated for their impact on the efficiency and performance of the fermenter in terms of hydrogen yields. The results indicate that hydraulic retention time (HRT) has a strong influence on the fermenter performance. An increasing HRT would increase the variation in hydrogen concentration in the offgas. To produce hydrogen with a fairly consistent concentration, the HRT of the fermenter should not exceed 16 h, which, however, did not appear to be short enough to control methanogenesis because the offgas still contained about 5% methane. When methane content in the offgas exceeded 2%, an inverse linear relationship between hydrogen and methane was observed with a correlation coefficient of 0.9699. To increase hydrogen content in the offgas, methane production has to be limited to below 2%. Also, keeping oxygen content in the fermenter below 1.5% would increase the hydrogen concentration to over 15%. The product to substrate ratio was found to be around 50% for the fermenter system studied, evidenced by the observation that for every 6 liters of manure fermented, 3 liters of pure hydrogen were produced, which was significant and encouraging.     

Survey of heavy metal pollution and assessment of agricultural soil in Yangzhong district, Jiangsu Province, China

We investigated concentrations of Hg, Cd, Pb, Zn, Cu, As, Ni, and Cr in samples of soil, cereal, and vegetables from Yangzhong district, China. Compared to subsoils, the sampled topsoils are enriched in Hg, Cd, Cu, Pb, Zn, and As. High levels of Cd and Hg are observed in most agricultural soils. Concentrations of Cr and Ni show little spatial variation, and high Cu, Pb, and Zn contents correspond well to areas of urban development. High As contents are primarily recorded at the two ends of the sampled alluvion. The contents of Cd, Hg, and total organic carbon (TOC) increase gradually to maximum values in the upper parts of soil profiles, while Cr and Ni occur in low concentrations within sampled profiles. As, Pb, Cu, and Zn show patterns of slight enrichment within the surface layer. Compared to data obtained in 1990, Cd and Hg show increased concentrations in 2005; this is attributed to the long-term use of agrochemicals. Cr and Ni contents remained steady over this interval because they are derived from the weathering of parent material and subsequent pedogenesis. The measured As, Cu, Pb, and Zn contents show slight increases over time due to atmospheric deposition of material sourced from urban anthropogenic activity. Low concentrations of heavy metals are recorded in vegetables and cereals because the subalkaline environment of the soil limits their mobility. Although the heavy metal concentrations measured in this study do not pose a serious health risk, they do affect the quality of agricultural products.     

Comparative on Causes and Accumulation of Selenium in the Tree-rings Ambient High-selenium Coal Combustion Area from Yutangba, Hubei, China

Toxic trace elements emitted during coal combustion are the main sources of air pollution. They are released into the atmosphere mainly in the forms of fine ash, smoke and flue, and thus adversely affect plant, animal and human health. Selenium is one of toxic and the most volatile in coal. Large amount of atmospheric emission of selenium, as well as selenium present and scrubber stockpiles in ash may create serious environmental problems. In the paper, on the basis of investigating the abundance and distribution of selenium in plant-rings during recent 20 years, the bioaccumulation of selenium is explained that selenium in plant, which were collected from the village of selenium-rich coal combustion, is much higher than that in plants collected away from the village of selenium-rich coal combustion. The main origins of selenium are selenium-rich coal combustion and high-selenium rock weathered. The selenium recycle by food chain and selenium will accumulate and redistribute in environments.     

Ambient Aerosol and its Carbon Content in Gainesville, a Mid-Scale City in Florida

Ambient aerosols were collected during 2000–2001 in Gainesville, Florida, using a micro-orifice uniform deposit impactor (MOUDI) to study mass size distribution and carbon composition. A bimodal mass distribution was found in every sample with major peaks for aerosols ranging from 0.32 to 0.56 μm, and 3.2 to 5.6 μm in diameter. The two distributions represent the fine mode (<2.5 μm) and the coarse mode (>2.5 μm) of particle size. Averaged over all sites and seasons, coarse particles consisted of 15% carbon while fine particles consisted of 22% carbon. Considerable variation was noted between winter and summer seasons. Smoke from fireplaces in winter appeared to be an important factor for the carbon, especially the elemental carbon contribution. In summer, organic carbon was more abundant. The maximum secondary organic carbon was also found in this season (7.0 μg m⁻³), and the concentration is between those observed in urban areas (15–20 μg m⁻³) and in rural areas (4–5 μg m⁻³). However, unlike in large cities where photochemical activity of anthropogenic emissions are determinants of carbon composition, biogenic sources were likely the key factor in Gainesville. Other critical factors that affect the distribution, shape and concentration were precipitation, brushfire and wind.     

Generalized models for prediction of pentachlorophenol dissipation dynamics in soils

Dissipation of pentachlorophenol (PCP) in soil was investigated and the chemical relationships with soil properties were addressed. The results indicate that the dissipation of extractable PCP residues can be described using first-order kinetics equations, with a half-dissipation time (T(1/2)) ranging from 6.5 to 173.3d. The sharply different patterns of PCP dissipation in different soils were closely related to soil properties. Correlations of stepwise regression equations obtained were significant at 0.01 probability level between soil parameters and extractable PCP residues (R(2)=0.974**) as well as T(1/2) values (R(2)=0.882**). Using pH together with organic carbon content (OC) and soil particle size distribution, the dissipation dynamics of PCP in soil could be accurately predicted.     

Evaluation of marine outfall with three-dimensional hydrodynamic and water quality modeling

Numerical models are often used to evaluate the potential impact of human alternation of natural water bodies and to help the design of the alternation to mitigate its impacts. In the past decade, three-dimensional hydrodynamic and reactive transport modeling has matured from a research subject to a practical analysis technology. This paper presents a practical study in which a three-dimensional hydrodynamic and water quality model [hydrodynamic eutrophication model (HEM-3D)] was applied to determine the optimal location for treated wastewater discharged from marine outfall system in the Keelung harbor and the adjacent coastal sea. First, model validation was conducted with respect to surface elevation, current, and water quality variables measured in the Keelung harbor station and its coastal sea. The overall performance of the model was in qualitative agreement with the available field data. The model was then used to evaluate several scenarios of the locations from marine outfall system. Based on model simulation results, a location at the northeast of Ho-Ping Island was recommended for adoption because the environmental impact is smaller than any other alternative.