Enhanced activation of peroxymonosulfate by CNT-TiO2 under UV-light assistance for efficient degradation of organic pollutants

CNT-TiO₂ composite is used to activate PMS under UV-light assistance. Superior performance is due to the enhanced electron-transfer ability of CNT. SO₄•⁻, •OH and ¹O₂ play key roles in the degradation of organic pollutants. In this work, a UV-light assisted peroxymonosulfate (PMS) activation system was constructed with the composite catalyst of multi-walled carbon nanotubes (CNT) - titanium dioxide (TiO₂). Under the UV light irradiation, the photoinduced electrons generated from TiO₂ could be continuously transferred to CNT for the activation of PMS to improve the catalytic performance of organic pollutant degradation. Meanwhile, the separation of photoinduced electron-hole pairs could enhance the photocatalysis efficiency. The electron spin resonance spectroscopy (EPR) and quenching experiments confirmed the generation of sulfate radical (SO₄•⁻), hydroxyl radical (•OH) and singlet oxygen (¹O₂) in the UV/PMS/20%CNT-TiO₂ system. Almost 100% phenol degradation was observed within 20 min UV-light irradiation. The kinetic reaction rate constant of the UV/PMS/20%CNT-TiO₂ system (0.18 min⁻¹) was 23.7 times higher than that of the PMS/Co₃O₄ system (0.0076 min⁻¹). This higher catalytic performance was ascribed to the introduction of photoinduced electrons, which could enhance the activation of PMS by the transfer of electrons in the UV/PMS/CNT-TiO₂ system.     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

Reconsideration on the effect of nitrogen on mixed culture polyhydroxyalkanoate production toward high organic loading enrichment history

Effect of nitrogen on mixed culture PHA production was reconsidered. Enrichment history of PHA accumulating culture was discussed. Higher PHA content and biomass growth were achieved in presence of nitrogen. Enrichment strategy toward higher PHA accumulation was investigated. Microbial community succession in PHA accumulation phase was investigated. In most of the operating strategies for mixed microbial cultures polyhydroxyalkanoate (PHA) production, moderate organic loads and low nitrogen concentrations are used, however, the real waste streams contain variable concentrations of carbon and nitrogen. To evaluate the effect of enrichment history on PHA producer and production the various carbon and nitrogen levels were utilized during the accumulation phase. Different operating strategies were applied in three sequencing batch reactors (SBRs) subjected to aerobic dynamic feeding. The maximum PHA production of the enriched cultures under nutrient excess, limitation and starvation (Cmol/Nmol ratio of 8, 40 and ∞, respectively) was evaluated in batch assays. A higher PHA content and biomass growth were achieved in the nutrients presence in comparison to the nutrient starvation condition. The cultures from the SBR treated under short sludge retention time, high organic loading rate, short cycle length (SBR#3) and nutrient excess reached the maximum PHA content (54.9%) and biomass increase (38.9%). Under nutrient limitation, the negative biomass growth was observed under nutrient starvation because of the sampling loss. The succession of microbial communities in SBRs and batch assays was analyzed using terminal restriction fragment length polymorphism. The SBR#3 had the best overall PHA production performance considering its high PHA content and productivity in all nutrient content, it indicates that nitrogen has a substantial impact on PHA yield especially when high organic loading rate enrichment history is involved.     

基于非线性能量阱的悬吊摆对输电塔-振动控制的研究

针对输电塔结构在地震作用下动力响应过大的问题,提出一种基于非线性能量阱的悬吊摆以降低输电塔的动力响应。首先利用拉格朗日方程推导了这种悬吊摆的运动方程,再以一单自由度结构为例,建立了摆式非线性能量阱—结构的动力方程,计算了摆式非线性能量阱在正弦激励下的减振效果,并对正弦激励周期、悬吊摆周期、立方刚度、质量比等参数对减振效果的影响进行了分析。最后选取一柔性输电塔为例,研究了不同地震作用下摆式非线性能量阱的减振效果,并与传统的悬吊质量摆和线性弹簧摆进行对比。结果表明,在地震作用下,摆式非线性能量阱对输电塔动力响应的峰值和均值都有较好的减振效果。     

Comparison of CNT-PVA membrane and commercial polymeric membranes in treatment of emulsified oily wastewater

CNT-PVA membrane was fabricated and compared with polymeric membranes. The separation performance was evaluated by homemade and cutting fluid emulsions. The three membranes show similar oil retention rates. CNT-PVA membranes have higher permeation fluxes compared with polymeric membranes. CNT-PVA membrane shows higher fouling resistance. Membrane separation is an attractive technique for removal of emulsified oily wastewater. However, polymeric membranes which dominate the current market usually suffer from severe membrane fouling. Therefore, membranes with high fouling resistance are imperative to treat emulsified oily wastewater. In this study, carbon nanotube-polyvinyl alcohol (CNT-PVA) membrane was fabricated. And its separation performance for emulsified oily wastewater was compared with two commercial polymeric membranes (PVDF membrane and PES membrane) by filtration of two homemade emulsions and one cutting fluid emulsion. The results show that these membranes have similar oil retention efficiencies for the three emulsions. Whereas, the permeation flux of CNT-PVA membrane is 1.60 to 3.09 times of PVDF membrane and 1.41 to 11.4 times of PES membrane, respectively. Moreover, after five consecutive operation circles of filtration process and back flush, CNT-PVA membrane can recover 62.3% to 72.9% of its initial pure water flux. However, the pure water flux recovery rates are only 24.1% to 35.3% for PVDF membrane and 6.0% to 26.3% for PES membrane, respectively. Therefore, CNT-PVA membrane are more resistant to oil fouling compared with the two polymeric membranes, showing superior potential in treatment of emulsified oily wastewater.     

Carbon nanotubes-incorporated MIL-88B-Fe as highly efficient Fenton-like catalyst for degradation of organic pollutants

CNTs were incorporated into MIL-88B-Fe to get a new Fenton-like catalyst (C@M). Fe(II) was introduced in C@M to get a fast initiation of Fenton-like reaction. Fe(II) content in C@M was related with oxygen-containing functional groups on CNTs. C@M shows efficient catalytic degradation of pollutants over a wide pH range. Iron-based metal organic frameworks have been verified to be efficient heterogeneous Fenton catalysts due to their open pore channels and highly uniform distribution of metallic centers. In these catalysts, however, the iron element is mainly in the form of Fe(III), which results in a process required to reduce Fe(III) to Fe(II) to initiate Fenton reaction. To address this problem, carbon nanotubes (CNTs) with electron-rich oxygen-functional groups on the surface were incorporated into the metal organic frameworks (MIL-88B-Fe) to improve Fe(II) content for an enhanced Fenton-like performance. The prepared CNT@MIL-88B-Fe (C@M) showed much stronger catalytic ability toward H₂O₂ than MIL-88B-Fe. The pseudo-first-order kinetic constant for phenol degradation by C@M (0.32 min^–1) was about 7 times that of MIL-88B-Fe, and even higher than or comparable to the values of reported heterogeneous Fenton-like catalysts. Moreover, the Fenton-like system could effectively degrade various kinds of refractory organic pollutants and exhibited excellent catalytic activity over a wide pH range (4–9). XPS analysis confirmed that Fe(II) content of the catalyst gradually increased with CNT loadings. Electron spin resonance analysis showed that the signal intensity (•OH) of C@M was much higher than MIL-88B-Fe, which was consistent with the degradation efficiency of pollutants. Furthermore, the Fe(II) content of the catalyst gradually increased along with the oxygen-functional group content of CNTs. The result demonstrated that oxygen-containing functional groups of CNTs have a significant impact on the enhanced catalytic performance of C@M. This study provides a new insight to enhance Fenton reaction by using nanocarbon materials.     

Degradation of extracellular genomic,plasmid DNA and specific antibiotic resistance genes by chlorination

Extracellular DNA structure damaged by chlorination was characterized. Integrity of extracellular ARG genetic information after chlorination was determined. Typical chlorine doses will likely effectively diminish extracellular DNA and ARGs. Plasmid DNA/ARGs were less readily broken down than genomic DNA. The Bioanalyzer methodology effectively documented damage incurred to DNA. There is a need to improve understanding of the effect of chlorine disinfection on antibiotic resistance genes (ARGs) in order to advance relevant drinking water, wastewater, and reuse treatments. However, few studies have explicitly assessed the physical effects on the DNA. Here we examined the effects of free chlorine (1–20 mg Cl₂/L) on extracellular genomic, plasmid DNA and select ARGs. Chlorination was found to decrease the fluorometric signal of extracellular genomic and plasmid DNA (ranging from 0.005 to 0.05 mg/mL) by 70%, relative to a no-chlorine control. Resulting DNA was further subject to a fragment analysis using a Bioanalyzer, indicating that chlorination resulted in fragmentation. Moreover, chlorine also effectively deactivated both chromosomal- and plasmid-borne ARGs, mecA and tetA, respectively. For concentrations >2 mg Cl₂//L × 30 min, chlorine efficiently reduced the qPCR signal when the initial concentration of ARGs was 10⁵ copies/mL or less. Notably, genomic DNA and mecA gene signals were more readily reduced by chlorine than the plasmid-borne tetA gene (by ~2 fold). Based on the results of qPCR with short (~200 bps) and long amplicons (~1200 bps), chlorination could destroy the integrity of ARGs, which likely reduces the possibility of natural transformation. Overall, our findings strongly illustrate that chlorination could be an effective method for inactivating extracellular chromosomal- and plasmid-borne DNA and ARGs.     

Elevation of biochar application as regulator on denitrification/NH3 volatilization in saline soils

Environmental Science and Pollution Research - Denitrification and NH3 volatilization are the main removal processes of nitrogen in coastal saline soils. In this incubation study, the effects of...     

Contamination characteristics of trace metals in dust from different levels of roads of a heavily air-polluted city in north China

Concentrations of eight trace metals (TMs) in road dust (RD) (particles?<?25 μm) from urban areas of Xinxiang, China, were determined by inductively coupled plasma mass spectrometry. The geometric mean concentrations of Zn, Mn, Pb, As, Cu, Cr, Ni and Cd were 489, 350, 114, 101, 60.0, 39.7, 31.6, and 5.1 mg kg^?1, respectively. When compared with TM levels in background soil, the samples generally display elevated TM concentrations, except for Cr and Mn, and for Cd the enrichment value was 69.6. Spatial variations indicated TMs in RD from park path would have similar sources with main roads, collector streets and bypasses. Average daily exposure doses of the studied TMs were about three orders of magnitude higher for hand-to-mouth ingestion than dermal contact, and the exposure doses for children were 9.33 times higher than that for adults. The decreasing trend of calculated hazard indexes (HI) for the eight elements was As?>?Pb?>?Cr?>?Mn?>?Cd?>?Zn?>?Ni?>?Cu for both children and adults.     

Using hyper-spectral indices to detect soil phosphorus concentration for various land use patterns

This study provides earthworm population data obtained from localities with a substantial anthropogenic impact spoils. The spoil heaps were reclaimed at the end of an opencast brown coal mining period. We studied spoils reclaimed by the two most commonly used reclamation processes: forestry and agricultural. The results show the significance of the locality age and the utilized reclamation process and treatment and their effect on earthworm communities. Our data indicate that apart from soil physical and chemical properties, the reclamation process itself may also induce viability and distribution of earthworm communities. Under standardized soil properties, the changes in earthworm populations during the succession were larger within the agricultural reclamation process as opposed to the forestry reclamation process for earthworm ecological groups and individual species.