菲高效降解菌的降解特性及其受蒙脱石的影响研究

通过选择性富集培养与纯化,从广州油制气厂附近的污染土壤中分离获得一株能以菲为唯一碳源和能源,快速生长的优势菌株（编号为YZ-1）。16S rDNA序列分析结果表明,YZ-1菌株为琼氏不动杆菌（Acinetobacter junii）。当无机盐培养液中菲初始质量浓度为100mg·L-1时,45h内该菌株对菲的降解率可达到99.5%。YZ-1菌株的最佳生长条件为pH7.4,温度30℃,摇床转速160r·min-1。加入蒙脱石矿物之后,在降解的初期（前16h）表现为促进菲的生物降解作用,但随着时间的延长,菲的降解速率逐渐低于不加蒙脱石体系,并随蒙脱石含量或菲质量浓度的增加,此抑制延缓现象愈加明显。矿物对高浓度的菲具有吸附分散作用,而对低浓度的菲具有吸附保护作用。     

河道综合治理后城市水体沉积物中微塑料污染特征研究 ——以汾河太原城区段为例

以先后经过3期综合整治工程(包括截污纳管 、湿地营建 、滨河景观建设等)的汾河太原城区段为研究对象,对其沉积物中微塑料进行了研究.结果表明:汾河太原城区段沉积物中微塑料丰度为108～732个/kg,上游未经河道治理的采样点丰度最高,河道综合治理后微塑料丰度明显下降;白色(35％)在所有微塑料颜色中占比(数量占比,下同)...     

复极性固定床电解反应器对活性染料的降解

本文用复极性固定床电解反应器对１６种活性染料的脱色降解进行了试验研究。结果表明：染料脱色率在９９．６％以上,出水上清液ＣＯＤ去除率绝大部分在９０％以上,对活性翠蓝ＫＮ－Ｇ和活性深蓝ＫＭ－ＧＲ的铜去除率分别为９７．０％和９９．７％。     

作业井场含油固体废弃物生物制剂法除油技术研究

采用生物制剂 (BS7# 酶 )洗涤法处理冀东油田作业井场固体废弃物 ,研究了该处理方法中制剂投加量、搅拌时间、固液比和洗涤次数对处理效果的影响 ,得到了最佳洗涤条件。并对其设备投资、处理综合成本等进行了经济效益分析。为冀东油田作业井场含油固体废弃物工业化处理提供重要依据     

水蒸气/氨活化在脉冲电晕脱硫工业中试装置上的应用

在工业中试装置上进行了水蒸气／氨活化实验,同时开展了脉冲电源的调试运行、脱硫副产物收集一体化、工艺参数以及对副产物成份分析等实验。在烟气流量4500～11000m^3／h、反应器入口温度60-70℃、氨硫化学计量比约1：1、系统连续运行和采用一体化的单电场进行脱硫副产物收集的条件下．得到结果：水蒸气／氨活化脱硫效果明显,并且有较好的副产物收集功能,收集效率20％～30％;副产物中SO4^2-：SO3^2-大于95：5,脱硫效率稳定大于90％,副产物收率大于85％。     

Functional Properties of Extruded Acetylated Starch-Cellulose Foams

Acetylated starches, with degrees of substitution (DS) of 2, 2.5 and 3, were blended with 3%, 7.5% and 12% -cellulose and 14%, 17% or 20% (d.b.) ethanol and twin-screw extruded at 165°C barrel temperature and 225 rpm screw speed. A response surface methodology experimental design was applied to the sub-plot and a completely randomized design to the whole plot design to test the differences among the acetylated starches and the effects of cellulose and ethanol. DS, cellulose and ethanol contents significantly affected the functional properties and specific mechanical energy requirement. DS had positive effects on radial expansion ratio (RER), compressibility and specific mechanical energy requirement and a negative effect on bulk density. Highest (RER) was obtained from 20% ethanol content. Extrudates containing 12% cellulose had the highest bulk density and the highest compressibility. Higher cellulose contents required more specific mechanical energy.     

改进气相色谱法测定总烃与非甲烷总烃

采用十通阀、双定量环进样(进样量0.5 m L),专用的甲烷柱和总烃柱分别分离两路气样,单FID检测器检测的方法测定环境空气和固定污染源废气中的总烃和非甲烷总烃(NMHC)。实验结果表明:总烃与甲烷工作曲线的相关系数分别为0.997 7和0.999 0;总烃与甲烷测定结果的相对标准偏差均未超过1.5%;总烃与NMHC的检出限均为0.04 mg/m~3;总烃的加标回收率为90.3%~113.0%,NMHC的加标回收率为91.1%~110.0%。上述指标均满足HJ 604—2011和HJ/T 38—1999中对总烃及NMHC的测定要求。用注射器采样后的气样应尽量避光保存,放置时间宜在8 h之内。该方法无需制备除烃空气,大幅提升了检测效率。     

Fate of polybrominated diphenyl ethers in the environment of the Pearl River Estuary, South China

Ninety-six riverine runoff samples collected at eight major outlets in the Pearl River Delta (PRD), South China, during 2005-2006 were analyzed for 17 brominated diphenyl ether (BDE) congeners (defined as Σ₁₇PBDE). Fourteen and 15 congeners were detected, respectively, in the dissolved and particulate phases. These data were further used to elucidate the partitioning behavior of BDE congeners in riverine runoff. Several related fate processes, i.e. air-water exchange, dry and wet deposition, degradation, and sedimentation, within the Pearl River Estuary (PRE), were examined to estimate the inputs of Σ₁₀PBDE (sum of the target BDE congeners, BDE-28, -47, -66, -85, -99, -100, -138, -153, -154, and -183) and BDE-209 from the PRD to the coastal ocean based on mass balance considerations. The results showed that annual outflows of Σ₁₀PBDE and BDE-209 were estimated at 126 and 940 kg/year, respectively from the PRE to coastal ocean. Besides sedimentation and degradation, the majority of Σ₁₀PBDE and BDE-209 discharged into the PRE via riverine runoff was transported to the coastal ocean.     

废旧电路板与碳酸钙共热解脱卤的研究

采用热重分析仪和石英管式炉热解反应器,分别对以酚醛树脂为基板的废旧电路板和混合碳酸钙后的废旧电路板进行热解实验研究,着重考察了添加碳酸钙后的酚醛树脂基板废旧电路板热解特性及添加量不同对卤素脱除效果的影响。实验结果表明,碳酸钙的加入对废旧电路板的降解行为和热解油的基本组成没有明显的影响,但热解油的各组分含量有所差异;随着热解温度的提高或者CaCO₃含量的增多,卤素可以更多地由有机卤向无机卤转变并束缚在固体残渣中,由此得到较好的脱卤效果。当60%PR-WPCBs与40%CaCO₃共热解,热解油中的溴化物也减少了7.6% 。在600℃等量CaCO₃与PR-WPCBs共热解时生成75.6%无机卤,其中70.62%束缚于固体残渣中,可见达到较好的脱卤效果。     

活性炭三维电极流化床处理洗车废水的研究

以经吸附处理的活性炭为填充粒子,对三维电极流化床反应器处理洗车废水进行了静态条件实验研究。结果表明：三维电极流化床处理洗车废水的效果明显好于三维电极固定床和单纯的活性炭吸附。在槽电压为30 V,通气量为3 L/min, 通电时间为30 min,活性炭用量为50 g时,COD去除率最高。