石油化工废水处理技术新进展

针对石油化工废水处理领域目前尚存在的问题,介绍了有关石油化工废水处理的各种方法,阐述了物理化学处理技术、生物处理技术、生物法与物理化学法组合技术等方面的研究进展,指出难生物降解废水的处理是继续研发的重点.     

Biofiltration treatment of odors from municipal solid waste treatment plants

An in situ compost biofilter was established for the treatment of odors from biostabilization processing of municipal solid waste. The concentrations of total volatile organic compounds (VOCs) in odors and their components were measured. Biofilter media was characterized in terms of total carbon (TC), total nitrogen (TN), total phosphorus (TP), organic matter (OM), pH value and determination of bacterial colony structure. Gas chromatography–mass spectrometry (GC–MS) analysis showed that the main components of the produced gas were benzene, toluene, ethylbenzene and xylene (BTEX) along with other alkanes, alkenes, terpenes, and sulphur compounds. The compost biofilter had remarkable removal ability for alkylated benzenes (>80%), but poor removal for terpenes (～30%). Total VOC concentrations in odors during the biostabilization process period ranged from 0.7 to 87 ppmv, and the VOC removal efficiency of the biofilter varied from 20% to 95%. After about 140 days operation, TN, TC, TP and OM in compost were kept almost stable, but the dissolved N, NH₄–N and NO₃–N experienced an increase of 44.5%, 56.2% and 76.3%, respectively. Dissolved P decreased by 27.3%. The pH value experienced an increase in the early period and finally varied from 7.38 to 8.08. Results of bacterial colony in packing material indicated that bacteria and mold colony counts increased, but yeasts and actinomyces decreased along with biofilter operation, which were respectively, 3.7, 3.4, 0.04 and 0.07 times of their initial values.     

利用含铬废水和含铅废水制备铬黄

利用净化后的含铬废水和含铅废水制备铬黄.采用沉淀法对废水进行净化预处理,最佳工艺条件:100mL含铬废水中加入20 g Na_2CO_3,及10 mL H_2O_2,用NaOH调节含铬废水pH为10.00;用NaOH调节含铅废水pH为2.65.将净化后的10 mL含铬废水和25 mL含铅废水混合,在55-60℃条件下反应10 min,合成的铬黄达到GB/T 3184-2008<铬酸铅颜料和钼铬酸铅颜料>的质量标准.经重金属吸附剂处理Pb~(2+)后铬黄合成滤液中的Cr~(6+)和Pb~(2+)质量浓度均达到GB8978-1996<污水综合排放标准>的指标.     

GC-PID联用直接测定大气中痕量烃类化合物

作者把气相色谱仪(GC)与自行研制的光离子化检测器(PID)联用,实现了大气中痕量烃类化合物的直接测定,给出了仪器的构成和性能指标及测量结果.     

Effective removal of coordinated copper from wastewater using a new dithiocarbamate-type supramolecular heavy metal precipitant

A new dithiocarbamate-type heavy metal precipitant, sodium 1,3,5-hexahydrotriazinedithiocarbamate (HTDC), was prepared and used to remove coordinated copper from wastewater. In the reported dithiocarbamate-type precipitants, HTDC possesses the highest percentage of the effective functional groups. It could effectively precipitate copper to less than 0.5 mg l⁻¹ from both synthetic and actual industrial wastewater containing CuEDTA in the range of pH 3–9. UV–vis spectral investigation and elemental analysis suggested that the precipitate was a kind of coordination supramolecular compound, [Cu₃(HTDC)₂]_n. The toxicity characteristic leaching procedure (TCLP) and semi-dynamic leaching test (SDLT) indicated that the supramolecular precipitate was non-hazardous and stable in weak acid and alkaline conditions. Tests of an anion exchange resin D231 provided a clue to simultaneously remove excess HTDC and residual CuEDTA in practical process of wastewater treatment.     

ABR反应器的启动研究

研究了添加填料对折流式厌氧反应器(ABR)启动性能的影响.反应器启动时,控制COD负荷为0.15 kg/(m3*d),逐渐提升至0.6 kg/(m3*d).未加填料的反应器经过约60 d,加入填料的反应器经过约35 d的连续运行,出水COD去除率稳定,启动基本完成.研究表明,添加填料的复合式反应器启动速度明显快于普通ABR,且运行稳定性更好,COD去除率较高,能够较好地截留污泥,有利于反应器生物效应的形成.     

关于犀牛保护及犀角持续利用的建议

简述了犀牛在中国灭绝的原因,介绍了犀牛角的利用价值,针对目前犀牛在中国的状况,提出了犀牛保护及犀角持续利用的建议。     

高效降解环己酮红球菌JDM-3-12的分离及其系统发育分析

从岳阳巴陵石化公司环己酮生产车间总出水口的污泥中筛选到一株环己酮降解菌株,菌号为JDM-3-12;该菌能以环己酮为唯一碳源且能忍受5000 mg/L的环己酮,当环己酮的质量浓度为2000 mg/L时,在温度为30℃,转速为150 r/m in,pH=7的条件下,72小时内该菌株对环己酮的降解率达到97.91%。通过形态观察、生理生化特征检测和基于16S rRNA基因序列的系统发育分析,初步鉴定其为赤红球菌(Rhodococcus ruber)中的一个菌株,该菌最适生长温度为35℃,最适生长pH 7。     

Adsorption of basic dye from aqueous solution onto fly ash

The fly ash treated by H₂SO₄ was used as a low-cost adsorbent for the removal of a typical dye, methylene blue, from aqueous solution. An increase in the specific surface area and dye-adsorption capacity was observed after the acid treatment. The adsorption isotherm and kinetics of the treated fly ash were studied. The experimental results were fitted using Langmuir and Freundlich isotherms. It shows that the Freundlich isotherm is better in describing the adsorption process. Two kinetic models, pseudo-first order and pseudo-second order, were employed to analyze the kinetic data. It was found that the pseudo-second-order model is the better choice to describe the adsorption behavior. The thermodynamic study reveals that the enthalpy (ΔH⁰) value is positive (5.63 kJ/mol), suggesting an endothermic nature of the adsorption.