Arsenic release from arsenic-bearing Fe-Mn binary oxide: effects of E(h) condition

Ferric and manganese binary oxide (FMBO) has been successfully used to remediate arsenic-polluted river, but there still lacks sufficient data to evaluate its effects on environments. The release behaviors of iron (Fe), manganese (Mn), and arsenic (As) in different E_h ranges were investigated for As-bearing FMBO sediment after remediating As-polluted DaSha River by FMBO. Under high E_h range (+550 to +400 mV), slight dissolution of Fe and Mn, which corresponded to 12.2% and 25.6%, and less than 5% of As release were observed in 336 h. Under lower E_h range (+50 to −100 mV), elevated extent of the dissolution of Mn and Fe were observed, which corresponded to as high as 61.3% and 70.1%. Under such conditions, the dissolution rate of Mn was higher than that of Fe. Furthermore, from the established relationship of As release and the dissolution of Fe and Mn, the release of As seemed dominated by the dissolution of Fe. X-ray photoelectron spectroscopy (XPS) analysis demonstrated the release of Fe, Mn, As(III), and As(V) after sodium ascorbate-treatment, and the re-adsorption of As(V), as indicated from the increased binding energy of As 3d from 44.78 to 45.83 eV. Surface element composition analysis indicated significant decrease of Mn from 3.22% to 0.54%, slight increase of Fe from 12.45% to 13.67%, and elevated ratio of As from 0.11% to 0.32% accordingly. The main reactions of Fe and Mn dissolution and the pathways of As release under different E_h ranges were also proposed.     

Sequestration of organochlorine pesticides in soils of distinct organic carbon content

In the present study, five soil samples with organic carbon contents ranging from 0.23% to 7.1% and aged with technical dichlorodiphenyltrichloroethane (DDT) and hexachlorocyclohexane (HCH) for 15 months were incubated in a sealed chamber to investigate the dynamic changes of the OCP residues. The residues in the soils decreased over the incubation period and finally reached a plateau. Regression analysis showed that degradable fractions of OCPs were negatively correlated with soil organic carbon (SOC) except for α-HCH, while no correlation was found between degradation rate and SOC, which demonstrated that SOC content determines the OCP sequestration fraction in soil. Analysis of the ratio of DDT and its primary metabolites showed that, since it depends on differential sequestration among them, magnitude of (p,p′-DDE + p,p′-DDD)/p,p′-DDT is not a reliable criterion for the identification of new DDT sources.     

钛基IrO2-SnO2电极在烟气海水脱硫恢复系统中的应用

采用浸渍-热分解法制备了含IrOx-TiO2中间层的IrO2-SnO2电极,得到的电极具有较高的析氯电催化活性和较强的稳定性,并通过电化学氧化法对Na2SO3海水脱硫模拟液进行处理,考察了电流密度、温度、pH值和电解时间等电解工艺参数对Na2SO3去除率和化学需氧量COD的影响。结果表明,在电流密度为200 mA/cm^2,pH值为3.5,电解440 mg/L的Na2SO3海水脱硫模拟液,15 min时Na2SO3去除率可达96.5%,COD去除率可达82.6%。     

氯氧化锆生产中废碱液的回收利用

建立了以 CaO 为沉淀剂去除废碱液中 SiO2回收 NaOH 的工艺,研究了各工艺因素对siO2去除效果的影响,实验结果表明,CaO 沉淀除去废碱液中 SiO2的最佳工艺条件为:CaO 与废碱液中 SiO2摩尔比 3.0,反应温度80～95℃,反应时间 40～60 min,搅拌转速 200 r/min.在此条件下,S...     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

脱硫废碱液还原废水中的Cr(Ⅵ)

利用脱硫废碱液对酸化后的含铬废水进行处理,研究了废水初始pH、脱硫废碱液加入量和静置时间等对Cr(Ⅵ)转化率的影响.实验结果表明,在废水初始pH为1.4、静置时间为30 min的条件下,处理30 mL Cr(Ⅵ)质量浓度为126.5 mg/L的含铬废水,适宜的脱硫废碱液加入量为6 mL,此条件下Cr(Ⅵ)转化率接近10...     

铁盐与铝盐对腈纶废水生化出水混凝特性的对比

针对腈纶废水生化单元出水,对比研究了Al2(SO4)3和Fe2(SO4)3在不同絮凝剂投量和p H时的混凝处理效果,并利用紫外-可见分光光度法(UV-Vis)、三维荧光光谱(EEM)、凝胶渗透色谱(HPSEC)等对混凝特性进行了初步探讨。研究显示,2种混凝剂在投量为63.5 mg/L时可获得30%以上的COD去除率,且最佳p H为中性附近。当投量小于32 mg/L时,Al2(SO4)3较Fe2(SO4)3具有更高的COD去除率,进一步增大混凝剂的投量很难提高Al2(SO4)3对COD的去除率,而Fe2(SO4)3则在有限范围内能持续提高COD去除率。EEM光谱分析显示,与Al2(SO4)3相比,Fe2(SO4)3对有机物具有更广的处理范围和更好的去除效果。HPSEC分析表明,Fe2(SO4)3相对于Al2(SO4)3在去除重均分子量为2 776、1 856和1 325 Da的有机物组分方面具有优势。铁盐或铝盐混凝是深度净化腈纶废水生化单元出水的可行方案之一。     

APSFZn在富营养化湖泊型水体中的应用

采用复合共聚法制备一种新型无机高分子絮凝剂凹凸棒-聚硅酸铁锌(APSFZn),并应用于富营养化湖泊型原水的实验研究。考察了水体p H、投加量、搅拌强度影响因素对絮凝效果的影响。研究表明,APSFZn具有较宽的p H使用范围。当p H为7.6、投加量为20 mg/L、搅拌强度为快搅速度200 r/min,快搅时间2 min,慢搅速度50 r/min,慢搅时间15 min时,APSFZn絮凝剂对Chl-a、CODMn、TP和TN的去除率分别为91.57%、87.11%、93.48%和48.98%。与传统絮凝剂PAC、PFS、PSFZn对比,APSFZn的絮凝效果明显优于传统絮凝剂。该絮凝剂制备简单、具有良好的稳定性和絮凝特性、工艺无二次污染,将APSFZn应用于富营养化湖泊型原水具有良好的絮凝效果。     

Fe~(3+)和Cu~(2+)对饮用水氯消毒副产物三卤甲烷形成的影响

为了研究水中存在Br-的情况下,Fe3+和Cu2+对三卤甲烷(THMs)的生成及CHCl3、CHBr Cl2、CHBr2Cl、CHBr34种消毒副产物相对分布的影响,以腐殖酸模拟氯消毒过程中的前体物进行实验。结果表明,在p H为6、7和9 3种条件下,Fe3+抑制了THMs的生成,p H=6时只有CHCl3生成量随着Fe3+浓度的增加逐渐减少,其余3种消毒副产物均在增加,p H=7时4种消毒副产物浓度均减小并在Fe3+浓度为2 mg/L时生成量最低,p H=9时的生成趋势与p H=6时类似。Cu2+能促进THMs的生成,在p H为6、7和9时,当加入0.5 mg/L Cu2+时,THMs总量分别增加了16.7%、22.6%和2.5%,随着p H增加,THMs总量增加。在3种p H环境中,Cu2+对THMs生成的影响大于Fe3+,在偏酸性环境中,Fe3+影响THMs生成,产生的致癌风险高,当金属离子浓度为2.5 mg/L时,致癌风险相差最高为15%,在中性和偏碱性环境中,Cu2+影响THMs生成,产生的致癌风险高。