Fenton试剂氧化苯酚过程中Fe（Ⅱ）浓度的变化

考察了Fenton试剂氧化降解苯酚过程中Fe(Ⅱ)浓度的变化,并通过实验探讨了其变化的原因.实验结果表明,在Fenton反应发生的第1 rain内,Fe(Ⅱ)浓度可降低到初始浓度的60%左右,随着反应的继续Fe(Ⅱ)浓度在大约20min降低到最小值,然后开始增大,说明了Fe(Ⅲ)还原作用的存在;Fenton试剂氧化降解苯酚的中间产物包括对苯二酚、邻苯二酚、间苯二酚和苯醌等,其中前三者能对Fe(Ⅲ)有效还原,是Fenton试剂氧化降解苯酚过程中Fe(Ⅲ)还原的主要途径之一.     

光照条件下冰相中激发三线态溶解性有机物的生成及其对三甲基苯酚的光敏化降解作用

选用两种天然有机物Upper Mississippi River NOM(UMRNOM)和Suwannee River NOM(SRNOM)作为光敏化剂,以500 W高压汞灯模拟太阳光照,用2,4,6-三甲基苯酚（TMP）作为探针,进行光解实验.考察了TMP是否可以作为冰相中激发三线态溶解性有机物（3DOM*）的探针,以及溶解性有机碳（DOC）浓度、pH值和溶解氧含量对光反应生成3DOM*的影响.结果表明,TMP的直接光降解和单线态氧（1O2）、羟基自由基（·OH）对TMP检测3DOM*的影响可以忽略,TMP可以作为冰冻样品中3DOM*的探针.UMRNOM的荧光强度和光化学活性低于SRNOM,在光反应中3DOM*的生成量低.两种DOM的SUVA254、E2/E3和荧光指数均与pH没有相关性,产生的3DOM*也与pH不相关.3DOM*生成量随着DOC浓度的增加而增加,单位DOC的3DOM*生成量随着浓度的增加而减少.此外,充入氮气的样品中TMP的降解速率比空气饱和样品分别高13.15%和16.43%.     

Recharge signal identification based on groundwater level observations

This study applied a method of the rotated empirical orthogonal functions to directly decompose the space-time groundwater level variations and determine the potential recharge zones by investigating the correlation between the identified groundwater signals and the observed local rainfall records. The approach is used to analyze the spatiotemporal process of piezometric heads estimated by Bayesian maximum entropy method from monthly observations of 45 wells in 1999-2007 located in the Pingtung Plain of Taiwan. From the results, the primary potential recharge area is located at the proximal fan areas where the recharge process accounts for 88% of the spatiotemporal variations of piezometric heads in the study area. The decomposition of groundwater levels associated with rainfall can provide information on the recharge process since rainfall is an important contributor to groundwater recharge in semi-arid regions. Correlation analysis shows that the identified recharge closely associates with the temporal variation of the local precipitation with a delay of 1-2 months in the study area.     

Effects of coal spoil amendment on heavy metal accumulation and physiological aspects of ryegrass (<Emphasis Type="Italic">Lolium perenne</Emphasis> L.) growing in copper mine tailings

Copper mine tailings pose many threats to the surrounding environment and human health, and thus, their remediation is fundamental. Coal spoil is the waste by-product of coal mining and characterized by low levels of metals, high content of organic matter, and many essential microelements. This study was designed to evaluate the role of coal spoil on heavy uptake and physiological responses of Lolium perenne L. grown in copper mine tailings amended with coal spoil at rates of 0, 0.5, 1, 5, 10, and 20%. The results showed that applying coal spoil to copper mine tailings decreased the diethylenetriaminepentaacetic acid (DTPA)-extractable Cd, Cu, Pb, and Zn contents in tailings and reduced those metal contents in both roots and shoots of the plant. However, application of coal spoil increased the DTPA-extractable Cr concentration in tailings and also increased Cr uptake and accumulation by Lolium perenne L. The statistical analysis of physiological parameters indicated that chlorophyll and carotenoid increased at the lower amendments of coal spoil followed by a decrease compared to their respective controls. Protein content was enhanced at all the coal spoil amendments. When treated with coal spoil, the activities of superoxide dismutases (SOD), peroxidase (POD), and catalase (CAT) responded differently. CAT activity was inhibited, but POD activity was increased with increasing amendment ratio of coal spoil. SOD activity increased up to 1% coal spoil followed by a decrease. Overall, the addition of coal spoil decreased the oxidative stress in Lolium perenne L., reflected by the reduction in malondialdehyde (MDA) contents in the plant. It is concluded that coal spoil has the potential to stabilize most metals studied in copper mine tailings and ameliorate the harmful effects in Lolium perenne L. through changing the physiological attributes of the plant grown in copper mine tailings.     

SMBBR-AF-SMBBR组合工艺处理高氨氮农药废水

采用特异性移动床生物膜反应器(SMBBR)和厌氧生物滤池(AF)组合工艺处理高氨氮农药废水。考察了HRT、pH和DO等工艺条件对SMBBR-AF-SMBBR组合工艺运行稳定期COD和氨氮去除率的影响。试验结果表明,在进水COD为2 408~7 440 mg/L、ρ(NH_4~+-N)为160.21~433.84 mg/L、TN为208.27~537.65 mg/L、HRT为8d、pH为8.0、DO为4 mg/L的条件下,处理后出水平均COD为342 mg/L,COD去除率达92.3%;ρ(NH_4~+-N)小于4.0mg/L,氨氮平均去除率为89.2%;TN小于50 mg/L,平均TN去除达83.0%。出水各指标均优于原A2O工艺出水。     

口服纳米银对大鼠的生物有效性及其体内分布的研究

由于独特的抗菌特性,纳米银(AgNP)在诸多领域得到广泛应用,但是其生物有效性、动物组织分布及排出尚不清楚。将聚乙烯吡咯烷酮包被的AgNP溶液按照10 mg kg^-1给雌性SD大鼠灌胃,采用ICP-MS检测SD大鼠组织、粪便及尿液中总银浓度。实验结果表明,AgNP通过小肠吸收后,可以通过血液循环快速分布在肝、肾、脾、肺、脑等靶器官。灌胃后1 h,大鼠各组织中总银浓度达到最大值(肝、肾、脾、肺、脑中银浓度分别为0.29 ± 0.13 mg kg^-1、0.23 ± 0.04 mg kg^-1、0.17 ± 0.05 mg kg^-1、0.11 ± 0.01 mg kg^-1、0.06 ±0.02 mg kg^-1),之后银浓度随时间降低直至和对照组无显著性差异。在灌胃途径下,AgNP对SD大鼠的有效性为8.5%,且73%的AgNP是通过粪便的途径排出体外。     

KOH活化花生壳生物质炭对亚甲基蓝吸附性能研究

以花生壳生物质炭(P-BC)为原料,KOH为活化剂,采用化学活化法制得活化生物质炭(K-BC),通过考察对亚甲基蓝的吸附性能,研究了花生壳生物质炭的最佳活化条件,并利用N2吸附-脱附实验、SEM等对最佳活化条件下的生物质炭进行表征。结果表明,K-BC活化的最佳条件为碱炭比为1.5∶1,活化温度为800℃,活化时间为90 min,此时K-BC的比表面积达到597.93 m2/g,总孔容达到0.76 cm3/g。并考察了亚甲基蓝初始浓度、pH等对K-BC吸附亚甲基蓝的影响,随着初始浓度的增加,吸附平衡时间显著延长,亚甲基蓝去除率显著降低;当pH=6时,K-BC对亚甲基蓝的吸附量最大;K-BC对亚甲基蓝的吸附动力学曲线符合伪二阶动力学模型,吸附平衡时K-BC对亚甲基蓝的吸附能力为80~149.95 mg/g。     

城市生活垃圾和污水处理厂剩余污泥混合发酵的原料配比优化研究

以城市生活垃圾和污水处理厂的剩余污泥为混合原料,研究了混合原料的不同配比对厌氧发酵过程及产气的影响。结果表明:城市生活垃圾与剩余污泥以挥发性固体(VS)质量比为2∶1混合后,厌氧发酵效果最好,累计产气量最高,达到8 721mL,发酵后的总固体(TS)、VS、COD去除率分别达43.65%、35.98%、47.88%;各实验组在发酵过程中的pH、氨氮浓度和碱度均在合理范围内,未对厌氧发酵反应造成影响;以适当配比的城市生活垃圾和剩余污泥为混合原料,进行中温联合厌氧发酵是可行的,联合厌氧发酵可以弥补单一原料的缺陷,在一定程度上改善厌氧发酵效果。     

The Kinetics of Catalytic Incineration of Dimethyl Sulfide and Dimethyl Disulfide over an MnO/Fe2O3 Catalyst

ABSTRACT

The catalytic incineration of dimethyl sulfide and dimethyl disulfide [(CH₃)₂S and (CH₃)₂S₂] over an MnO/Fe₂O₃ catalyst was carried out in a bench-scale catalytic incinerator. Three kinetic models (i.e., the power-rate law, the Mars and Van Krevelen model, and the Langmuir-Hinshelwood model) were used to analyze the results. A differential reactor design was used for best fit of kinetic models in this study. The results show that the Langmuir-Hinshelwood model may be feasible to describe the catalytic incineration of (CH₃)₂S and (CH₃)₂S₂. This suggests that the chemical adsorption of O₂ molecules is important in this incineration.     

Preliminary study on removing Cs+/Sr2+ by activated porous calcium silicate—A by-product from high-alumina fly ash recycling industry

¹³⁷Cs⁺/⁹⁰Sr²⁺-containing radioactive wastewater is one of the most important problems that the world has been facing with. A by-product, activated porous calcium silicate, is generated at high levels by the pre-desiliconizing and soda-lime-sintering processes for producing Al₂O₃ from high-alumina fly ash. In order to examine if this by-product could be used as an absorbent for removal of ¹³⁷Cs⁺/⁹⁰Sr²⁺ from radioactive wastewater, various parameters, such as pH, adsorbent dose, contact time, and initial concentration, were discussed. Results indicated that the equilibrium reached in about 2 hr. Activated porous calcium silicate was highly pH sensitive and able to remove Cs⁺/Sr²⁺ in a near-neutral environment. The adsorption equilibrium was best described by Freundlich isotherm equations, and the adsorption of Cs⁺/Sr²⁺ was a physical process. The adsorption kinetic data could be better fitted by the pseudo-second-order model, and the adsorption was controlled by multidiffusion. Current study showed that activated porous calcium silicate has a good adsorption of Cs⁺/Sr²⁺ for their removal. However, other characteristics, such as selectivity because of coexisting cations, elution and regeneration, thermal stability, and acid resistance, should be discussed carefully before using it in an actual field.

Implications:Removing ¹³⁷Cs⁺/⁹⁰Sr²⁺ from radioactive wastewater is one of the tough issues that has been attracting more and more attention world widely, which is the same as fly ash. For recycling high-alumina fly ash, in which Al is extracted to produce Al₂O₃, a huge amount of activated porous calcium silicate is generated year by year. In this paper, this by-product was successfully used as an absorbent to remove ¹³⁷Cs⁺/⁹⁰Sr²⁺ from radioactive wastewater for the first time. Factors that affect the absorbability and the mechanisms were discussed in details, providing a possible choice for disposal of ¹³⁷Cs⁺/⁹⁰Sr²⁺-containing radioactive wastewater.