可用于水体污染控制的氨氮转化菌筛选及部分降解特性的实验研究

从南京禄口水产养殖基地淡水鱼塘取淤泥作为分离菌株的土源,采用选择性富集培养法,从中分离到能以硫酸铵为氮源的菌株7株,对7个菌株进行氨氮降解实验,它们氨氮转化率分别为14.8%、19.7%、53.4%、94.2%、29.1%、63.5%和41.7%,其中AN-4菌株的转化率最高且生长良好。通过AN-4菌株16S rRNA基因序列分析以及生理生化方法,鉴定此菌株为克雷伯氏菌属(Klebsiellasp.)。对菌株AN-4转化氨氮的特性及温度、pH值、氨氮初始浓度和菌株接种量对其氨氮转化率的影响研究,结果表明,菌株AN-4降解氨氮的最适条件为:温度为30℃和pH值为8.0;当氨氮初始浓度为30mg/L时,AN-4菌株在24 h内的氨氮降解率可达85%以上,且能耐受高达200 mg/L的氨氮浓度;AN-4活化菌液浓度为108cfu/mL,当接种量为3×106cfu/mL时,AN-4菌株在24 h内的氨氮降解率为87.75%。综合上述结果,符合淡水养殖水环境条件,说明AN-4菌株适合在水产养殖中应用,为将菌株AN-4应用于水产养殖环境修复提供了理论依据。     

新型活性炭固定化产品的制备及其处理焦化废水的特性

为解决优势菌种工程应用,研究不同固定化方法、载体和结构的固定化产品对焦化废水的降解特性。用活性炭粉末吸附菌种后,与聚乙烯醇和海藻酸钠混合制备了新型固定化球;用聚乙烯醇和海藻酸钠包埋吸附菌种的活性炭纤维毡,与立体弹性塑料填料连用,制备出3种不同形状的活性炭纤维膜片固定化产品复合填料。将游离菌和制备的4种活性炭固定化产品投入A/A/O工艺系统平行实验,考察处理焦化废水的效果。结果表明,活性炭纤维膜片固定化产品复合填料对焦化废水的降解能力优于其他固定化产品:缺氧池出水硝酸盐氮和亚硝酸盐氮浓度分别稳定在1.96 mg/L和0.49 mg/L,未产生氮的累积现象,COD去除率可达到60.92%。好氧池COD和氨氮降解效率分别为78.83%和85.52%,苯酚、氰化物降解效率均为97%以上。     

Characterization of an efficient catalytic and organic solvent-tolerant azoreductase toward methyl red from Shewanella oneidensis MR-1

The acyl carrier protein (ACP) phosphodiesterase gene (SO 4396) of Shewanella oneidensis MR-1 which was analyzed to have azoreductase activity was heterologously expressed in Escherichia coli. The ACP phosphodiesterase was found to reach maximum enzyme velocity 220.59 U/mg, named azoreductase in this study. The azoreductase had highest specific activity (153.16 U/mg) at pH 6.5, which showed a preference for nicotinamide adenine dinucleotide (NADH) as electron donor. The phylogenetic tree analysis indicated that the azoreductase had preference for NADH and dependence for flavin mononucleotide (FMN). However, the azoreductase from S. oneidensis MR-1 still had high enzyme activity in the absence of FMN. The Mg²⁺ had a positive influence on the enzyme activity with 25 mM concentration, whereas Cr³⁺, Cd²⁺ usually had significantly negative effect on enzyme activity. The purified azoreductase retained nearly 100 % activity after incubating in 30 % dimethyl sulfoxide (DMSO), 30 % acetone, 30 % methanol, 20 % ethanol, 20 % isopropanol, and 10 % propanol.     

Photochemical degradation of ciprofloxacin in UV and UV/H2O2 process: kinetics, parameters, and products

Photochemical degradation of fluoroquinolone ciprofloxacin (CIP) in water by UV and UV/H₂O₂ were investigated. The degradation rate of CIP was affected by pH, H₂O₂ dosage, as well as the presence of other inorganic components. The optimized pH value and H₂O₂ concentration were 7.0 and 5 mM. Carbonate and nitrate both impeded CIP degradation. According to liquid chromatography–tandem mass spectrometry analysis, four and 16 products were identified in UV and UV/H₂O₂ system, respectively. Proposed degradation pathways suggest that reactions including the piperazinyl substituent, quinolone moiety, and cyclopropyl group lead to the photochemical degradation of CIP. Toxicity of products assessed by Vibrio qinghaiensis demonstrated that UV/H₂O₂ process was more capable on controlling the toxicity of intermediates in CIP degradation than UV process.     

Removal of sulfamethoxazole and sulfapyridine by carbon nanotubes in fixed-bed columns

Sulfamethoxazole (SMX) and sulfapyridine (SPY), two representative sulfonamide antibiotics, have gained increasing attention because of the ecological risks these substances pose to plants, animals, and humans. This work systematically investigated the removal of SMX and SPY by carbon nanotubes (CNTs) in fixed-bed columns under a broad range of conditions including: CNT incorporation method, solution pH, bed depth, adsorbent dosage, adsorbate initial concentration, and flow rate. Fixed-bed experiments showed that pH is a key factor that affects the adsorption capacity of antibiotics to CNTs. The Bed Depth Service Time model describes well the relationship between service time and bed depth and can be used to design appropriate column parameters. During fixed-bed regeneration, small amounts of SMX (3%) and SPY (9%) were irreversibly bonded to the CNT/sand porous media, thus reducing the column capacity for subsequent reuse from 67.9 to 50.4 mg g^?1 for SMX and from 91.9 to 72.9 mg g^?1 for SPY. The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed. Findings from this study demonstrate that fixed-bed columns packed with CNTs can be efficiently used and regenerated to remove antibiotics from water.     

3种载体固定化菌藻共生系统脱氮除磷效果的对比

采用3种不同载体（海藻酸钠、聚乙烯醇、复合载体）,分别将小球藻和栅藻与活性污泥固定成菌藻共生系统,制成菌藻凝胶小球,单独菌、单独藻的凝胶小球,用于处理人工污水。结果表明,（1）复合载体固定的菌藻共生系统氮磷去除效果最好,PVA载体的脱氮除磷效果次于复合载体优于海藻酸钠;（2）固定化菌藻共生系统的脱氮除磷效果明显优于单独固定菌和单独固定藻,固定菌的效果较差;（3）3种载体包埋下的固定化小球藻的脱氮除磷效果均较相同载体固定化的栅藻效果好。     

pH对活化前后废弃铁铝泥吸附不同种磷动力学的影响

实验研究了300℃热活化前后的给水厂废弃铁铝泥（R-FARs和H300-FARs）对正磷酸盐、聚磷酸盐和有机磷酸盐的吸附动力学特性,并考察pH对不同磷吸附动力学的影响。结果表明,pH对不同磷吸附动力学过程的影响趋势相似,即低pH有利于吸附。准二级动力学模型能够更真实地反映不同磷在R-FARs和H300-FARs的吸附动力学行为,由拟合结果可知焦磷酸盐和六肌醇磷酸盐的初始吸附速率相对较大,而甘油磷酸盐最小;且活化作用明显提高了不同磷的初始吸附速率,并减弱了pH对初始吸附速率的影响。不同磷的吸附速率受到液膜扩散、颗粒内扩散和吸附反应三者共同控制,其中吸附反应是主要的控制步骤。     

Ti（Ⅳ）催化臭氧／过氧化氢预处理酸性难降解废水

在Ti（Ⅳ）和过氧化氢存在条件下,考察了臭氧化酸性苯乙酮溶液、硝基苯溶液和垃圾渗滤液（浙江衢州某垃圾填埋场）的预处理效能。结果表明,在pH2．86条件下,单独臭氧化处理对苯乙酮、硝基苯和垃圾渗滤液的COD去除率分别为10．1％、44％和28．6％。BOD,／COD值分别从原来的0．039、0．060和0．085提高到了0．130、0．158和0．174,仍属生化难降解废水。当体系加入Ti（Ⅳ）后,臭氧化苯乙酮和硝基苯的COD去除率分别达到了75．5％和65％,BOD;／COD则提高到了0．679和0．314,可生化性提升明显。对于垃圾渗滤液,只有当体系加入Ti（Ⅳ）和H22后,臭氧化COD的去除率达到66．6％,BOD、／COD提高至0．425。上述结果对酸性难降解废水的处理实际意义非常突出。     

A-O工艺污泥疏水比率与污泥活性的关系

通过A-O工艺对印染废水的降解处理,研究了不同污泥活性下微生物疏水比率和COD去除率的变化规律.结果表明,污泥活性指标ATP浓度与微生物疏水性之间存在一定关系,并对COD去除率产生一定的影响.缺氧污泥的活性指标ATP浓度在0.38～0.77 mg/L范围时,污泥微生物的疏水性最好且疏水比率最高值为84％,COD的去除率最高,为70.01％;好氧污泥的活性指标ATP浓度在0.86～2.17 mg/L范围时,污泥微生物的疏水性最好,疏水比率最高值为75％,COD的去除率最高为96.2％.