Speciation of heavy metals in biosolids of wastewater treatment plants at Mysore,Karnataka, India

Urban wastewater treatment leads to the generation of large quantities of biosolids. Accumulation of biosolids is a problem of environmental relevance due to the existence of heavy metals in the biosolids. Determination of total metal in biosolid provides information relating pollution levels. Determination of their mobilization capacity and behaviour in the environment is an important task. An experimental approach commonly used for studying the mobility, transport and bioavailability of metal in biosolids is the use of selective sequential extraction procedure. In the present study an attempt has been made to study the heavy metal properties in biosolid samples collected from urban wastewater treatment plants located at Mysore, Karnataka. Few heavy metals selected for the present study are cadmium, chromium, copper, iron, nickel and zinc. The concentration of these metals in biosolids and their partition in different fractions are studied. The speciation of metals based on the sequential extraction scheme was carried out. The concentration of heavy metals is lower than that established by European legislation. The residual fraction has the maximum percentage of heavy metals whereas, only a small fraction of heavy metals (Fe, Zn and Cd) are extracted in the most soluble fractions, exchangeable and carbonate fractions.     

Heavy metal contamination in the Delhi segment of Yamuna basin

Concentration of heavy metals (Cd, Ni, Zn, Fe, Cu, Mn, Pb, Cr, Hg and As) in the waters of River Yamuna and in the soil of agricultural fields along its course in Delhi are reported from 13 sites, spread through the Delhi stretch of Yamuna, starting from the Wazirabad barrage till the Okhla barrage. Varying concentration of heavy metals was found. Peaks were observed in samples collected downstream of Wazirabad and Okhla barrage, indicating the anthropogenic nature of the contamination. The Wazirabad section of the river receives wastewater from Najafgarh and its supplementary drains, whereas the Shahdara drain releases its pollution load upstream of the Okhla barrage. Average heavy metal concentration at different locations in the river water varied in the order of Fe>Cr>Mn>Zn>Pb>Cu>Ni>Hg>As>Cd. The river basin soil shows higher level of contamination with lesser variation than the water samples among sampling locations, thereby suggesting deposition over long periods of time through the processes of adsorption and absorption. The average heavy metal concentration at different locations in soil varied in the order of Fe>Mn>Zn>Cr>Pb>Ni>Hg>Cu>As>Cd.     

Assessing reliable indicators to sewage pollution in coastal soft-bottom communities

Physicochemical characteristics of sediment and benthic communities were studied in the proximity of seven sewage outfalls with differences in flow and wastewater treatment in the Western Mediterranean Sea. Redox potential was the only abiotic parameter which showed a pattern related with distance to outfalls, whereas granulometry, percentage of organic matter, metal concentrations or pH did not show changes related with outfall presence. Benthic community analysis proved to be the most suitable monitoring tool. The results showed that the highest impacted stations corresponded with those closest to outfall with the highest flow and only pre-treatment, whilst a decrease of this tendency was detected in the locations where secondary treatment takes place. Meta-analysis showed a decrease of amphipods and tanaids abundance as well as redox potential, as the indicators with the clearest response to sewage presence.     

Chemical forms and ecological risk of arsenic in the sediment of the Daliao River System in China

The chemical forms and ecological risk of As were characterized in the sediment of the Daliao River System (DRS), which has been affected by long-term intensive industrial, urban, and agricultural activities. Twenty-seven samples of surface sediment were collected and analyzed for total As content and that of its chemical forms. The results indicated that the average total As content in the sediment was 9.83 mg kg^− 1 but that the levels ranged from 1.57 to 83.09 mg kg^− 1. At the sites near cities, mining sites, and the estuary of the DRS, it is likely that adverse effects on aquatic organisms occur, due to As levels in the sediment that are often higher than the threshold effect level and occasionally higher than the probable effect level. A selectively sequential extraction indicated that the majority of As in the sediment was bound to Fe oxides (62.1%), with moderate proportions of residual As (19.8%), specifically adsorbed As (17.9%), and a low proportion of non-specifically adsorbed As (1.1%). In addition, the content of Fe in the sediment was positively and significantly correlated with the contents of amorphous and crystalline Fe oxide-bound As, confirming the crucial role of Fe oxides in immobilizing high amounts of As in superficial environments. The average molar ratio of As to Fe was 1.18 × 10^− 4 in the surface sediment of the DRS, similar to that of natural Fe oxides, but much lower than that of synthesized Schwertmannite. Therefore, the release of As under reduced and low pH conditions can cause serious problems for water resources and for living organisms.     

Heavy metal concentration and speciation of seven representative municipal sludges from wastewater treatment plants in Northeast China

The analysis of heavy metals is very important for assessing the feasibility of the agricultural utilization for the municipal sludge. In this paper, a four-step sequential extraction method was applied to extract heavy metals (Cu, Zn, Mn, Cr, and Ni) in municipal sludges from seven individual wastewater treatment plants located in Jilin and Heilongjiang Province, China, for estimating the mobility and bioavailability of the metal ions in the agricultural application. The total concentrations of heavy metals and their chemical fractions after the sequential extraction were determined. Principal component analysis (PCA) was applied to analyze the relations of heavy metals fractions in the municipal sludges. Experimental results indicated that the total concentrations of Cu, Zn, Cr, and Ni in all sludge samples were below the threshold values set out by the Chinese legislation (GB18918-2002). Specially, Zn had a high bioavailability and mobility, Cu and Cr had potential bioavailability, while Mn mainly existed in the residual fraction of municipal sludge. On the other hand, Ni had different mobility in different municipal sludge. PCA results were confirmed by the environmental behavior of heavy metals.     

Trace element concentrations in surface estuarine and marine sediments along the Mississippi Gulf Coast following Hurricane Katrina

Hurricanes are relatively frequent ecological disturbances that may cause potentially long-term impacts to the coastal environment. Hurricane Katrina hit the Mississippi Gulf Coast in August 2005, and caused a storm surge with the potential to change the trace element content of coastal surface sediments. In this study, surface estuarine and marine sediments were collected monthly following the storm from ten sites along the Mississippi Gulf Coast (Mobile Bay, Grand Bay Bayous Heron and Cumbest, Pascagoula, Ocean Springs, Biloxi Gulf, Back Biloxi Bay, Gulfport Gulf, Gulfport Courthouse Rd, and Gulfport Marina). Concentrations of V, Cr, Mn, Fe, Co, Ni, Zn, As, Cd, and Pb were measured by inductively coupled plasma–mass spectrometry to evaluate their temporal and spatial variations in the year following Hurricane Katrina. Sediments were characterized by pH, particle size distribution and total carbon and nitrogen content. Trace element contents of the sediments were determined in both <2 mm and <63 μm grain size fractions. Results revealed no significant temporal and spatial variability in trace element concentrations, in either size fraction. Potential ecological risk of the sediments was assessed by using NOAA SQuiRTs’ guideline values; most concentrations remained below probable adverse effects guidelines to marine organisms suggesting that trace elements redistributed by Hurricane Katrina would not cause an adverse impact on resident organisms. Instead, the concentrations of trace elements were site-dependent, with specific contaminants relating to the use of the area prior to Hurricane Katrina.     

Water quality evaluation of two interconnected dam lakes with field-captured and laboratory-acclimated fish, <Emphasis Type="BoldItalic">Cyprinus carpio</Emphasis>

Karakaya and Sultansuyu Dam Lakes, located in the eastern part of Turkey, are important water sources, both for irrigation and fishery. The main goal of the study was to investigate water qualities of dam lakes using a set of biomarkers in the fish Cyprinus carpio. For this aim, field sample and laboratory-acclimated fish were compared to identify changes in selected biomarkers. The activities of ethoxyresorufin-O-deethylase, glutathione S-transferase, glutathione reductase, and carboxylesterase were determined in liver samples. Also, plasma and liver lactate dehydrogenase, aspartate aminotransferase, and alanine aminotransferase activities were assayed. Brain acetylcholinesterase and carboxylesterase activities were also determined. The hepatosomatic index and condition factors were calculated. Plasma vitellogenin assays were evaluated for the presence of xenoestrogen. Physicochemical values of water samples showed the existence of eutrophication risk, and also, some chemicals in both lakes were determined to be over tolerable limits. The comparisons of samples from both dam lake and laboratory-acclimated fish showed that the lakes may be at risk of pollution by some xenobiotics, namely xenoestrogens and acetylcholinesterase-inhibiting agents.     

Assessment of metal pollution in urban road dusts from selected highways of the Greater Toronto Area in Canada

Over the last several decades, there has been increased attention on the heavy metal contamination associated with highways because of the associated health hazards and risks. Here, the results are reported of an analysis of the content of metals in roadside dust samples of selected major highways in the Greater Toronto Area of Ontario, Canada. The metals analysed are lead (Pb), zinc (Zn), cadmium (Cd), nickel (Ni), chromium (Cr), copper (Cu), manganese (Mn), calcium (Ca), potassium (K), magnesium (Mg) and iron (Fe). In the samples collected, the recorded mean concentrations (in parts per million) are as follows: Cd (0.51), Cu (162), Fe (40,052), Cr (197.9), K (9647.6), Mg (577.4), Ca (102,349), Zn (200.3), Mn (1202.2), Pb (182.8) and Ni (58.8). The mean concentrations for the analysed samples in the study area are almost all higher than the average natural background values for the corresponding metals. The geo-accumulation index of these metals in the roadside dust under study indicates that they are not contaminated with Cr, Mn and Ca; moderately contaminate with Cd and K; strongly contaminated with Fe and Mg; strongly to extremely contaminated with Ni and Pb; and extremely contaminated with Cu and Zn. The pollution load index (PLI) is used to relate pollution to highway conditions, and the results show that PLI values are slightly low at different samples collected from Highways 401 and 404 and high in many samples collected from Highway 400 and the Don Valley Parkway. Highway 400 exhibits the highest PLI values.     

Interactive Influence of Biofiber Composition and Elastomer on Physico-Mechanical Properties of PLA Green Composites

The objective of this work was to improve the impact and thermal properties of polylactic acid (PLA)-based biocomposite by appropriate application of cellulosic fiber and a bioelastomer. Biocomposites formulations with fiber contents of up to 20% in combination with a bioelastomer were extrusion-compounded in a twin-screw extruder followed by molding in an injection molding system. Fibers used in the formulations included three types of cellulosic fiber; namely, raw fiber from oat hull biomass (RF), hydrolysis byproduct (ATF) which was the solid fraction obtained from an acid-catalyzed hydrolysis of RF, and delignified fibers (AD30, AD65, AD100) which were the products of delignification of ATF. Formulated biocomposites were characterized for thermal (glass transition and melting temperatures, and enthalpy of melting) and physico-mechanical (tensile and bending strengths, stiffness, impact energy, and water absorption) properties. Among all types of biofibers, RF resulted in poor properties in the biocomposites due to the high hemicellulose content in the structure. On the other hand, the ratio of lignin to cellulose (in the absence of hemicellulose) in the modified fibers did not significantly affect the physico-mechanical and thermal properties of the biocomposites. The elastomer applied in the formulations improved the impact energy, thermal properties, and elongation at break of the composites. However, it adversely affected the strength and water resistance of biocomposites, especially in the presence of hemicellulose. The results indicated that, depending on the application, a wide range of PLA green composites with different physico-mechanical properties can be achieved.     

Performance of Cow Dung Reinforced Biodegradable Poly(Lactic Acid) Biocomposites for Structural Applications

In this work, performance of cow dung (CD) reinforced poly(lactic acid) (PLA) biocomposites was investigated for the potential use in load bearing application. CD of average 4 mm size was blended with PLA at different CD ratios (0–50 wt%) and their effects on the biocomposite properties were studied. The results showed an improvement in the flexural properties, while the tensile and impact strength dropped by 20 and 28% with the addition of 50% CD. The decline in the tensile and impact strength was due to micro-cracking and voids formation at higher CD content. Also, the incorporation of CD slightly decreased the thermal stability of the biocomposite. However, dynamic mechanical properties of the biocomposites generally improved. SEM analysis of tensile and impact fractured surfaces indicated that the CD had a reasonable adhesion with matrix. Moreover, the SEM micrographs of soil burial studies showed an accelerated degradation of higher CD wt% biocomposites.