Economic evaluation of optional recycling processes for waste electronic home appliances

This paper presents an economic evaluation of three typical recycling processes for the five main types of waste electronic home appliances (EHA) (TV set, refrigerator, washing machine, air conditioner and personal computer) in Beijing, the capital of China. The main purpose is to identify the formal management framework with economic feasibility for the waste EHA generated in large municipalities of China. It is found that the advanced technologies, which have mechanical processing units, should be introduced to recover more valuable materials from the waste appliances. Net revenues with a range of 90–240 RMB (Chinese currency unit, 1.0 USD ≈ 8.0 RMB) per unit, depend on the type of appliance, could be expected in case of using the most complicated procedures which can separate both metals and plastics from the shredded mixtures. However, the recycling of waste refrigerator and waste washing machine will, respectively, spend about 100 and 6 RMB per unit if solely by simple manual dismantling. Revenues from recycling of the other three types of appliances are positive but quite low in this case. Although positive revenues could be achieved from the isolated evaluation of recycling, the entire management system, which also covers the phases of collection and transportation, is economically infeasible if the waste appliances are bought from the households still at current prices. Based on a survey of the householder's attitude to the cost for waste EHA management, which was conducted earlier, the practical way to construct a formal management system for waste EHA in Beijing is to reduce the citizen's traditional expectation to the values of waste appliances and encourage their transfer to the formal collection system at lower prices.     

Resource recovery treatment of waste sludge using a solubilizing reagent

The dewatering of waste sludge continues to be a major problem in wastewater treatment. In this study, the solubilization treatment of waste sludge and extracellular polymeric substances using a solubilizing reagent was examined experimentally. For this purpose, a compression test of thickened waste sludge obtained after solubilization treatment was carried out. The total solid content of the dewatered cake was over 30% when using hydrochloric acid or acetic acid as the solubilizing reagent; however, it was about 20% when using sodium hydroxide. The thickened waste sludge was effectively solubilized when the concentration of acetic acid in the sludge, assuming that it was diluted by free water and not bound water in the sludge, was greater than 0.3 kmol/m³. A flocculated sedimentation test using the supernatant water after solubilization treatment was also carried out, revealing that it functions in a similar manner to commercial flocculant in aggregating solid particles under gravity. This result indicates that the supernatant water can act as a bioflocculant. Methane fermentation of the supernatant water was subsequently carried out. The findings showed that by using acetic acid as a solubilizing reagent, solubilized organic substances in the supernatant water could be recovered as a bioenergy resource.     

Intervertebral neck injury criterion for prediction of multiplanar cervical spine injury due to side impacts

OBJECTIVE: Intervertebral Neck Injury Criterion (IV-NIC) is based on the hypothesis that dynamic three-dimensional intervertebral motion beyond physiological limits may cause multiplanar injury of cervical spine soft tissues. Goals of this study, using a biofidelic whole human cervical spine model with muscle force replication and surrogate head in simulated side impacts, were to correlate IV-NIC with multiplanar injury and determine IV-NIC injury threshold for each intervertebral level. METHODS: Using a bench-top apparatus, side impacts were simulated at 3.5, 5, 6.5, and 8 g horizontal accelerations of the T1 vertebra. Pre- and post-impact flexibility testing in three-motion planes measured the soft tissue injury, i.e., significant increase (p < 0.05) in neutral zone (NZ) or range of motion (RoM) at any intervertebral level, above corresponding physiological limit. RESULTS: IV-NIC in left lateral bending correlated well with total lateral bending RoM (R = 0.61, P < 0.001) and NZ (R = 0.55, P < 0.001). Additionally, the same IV-NIC correlated well with left axial rotation RoM (R = 0.50, P < 0.001). IV-NIC injury thresholds (95% confidence limits) varied among intervertebral levels and ranged between 1.5 (0.6-2.4) at C3-C4 and 4.0 (2.4-5.7) at C7-T1. IV-NIC injury threshold times were attained beginning at 84.5 ms following impact. CONCLUSIONS: Present results suggest that IV-NIC is an effective tool for determining multiplanar soft tissue neck injuries by identifying the intervertebral level, mode, time, and severity of injury.     

Culture and the environment in Japan

This article discusses the environmental problems of Japan from a cultural point of view. The traditional Japanese view of nature differs from that of Western culture. During the 19th century, Japan introduced Western technology to modernize its industries as quickly as possible. Its transition into the modern industrial world was successful but resulted in serious problems. One of these was the rapid destruction of the natural environment; another, the feeling of homelessness that the Japanese people experienced in their newly Westernized surroundings.The Japanese people have now reached the point where they must reevaluate their traditional ideas about nature and their responses to technology. Their solutions to some of the problems that result from industrialization may be useful to Western countries as well.     

Measurement of total OH reactivity by laser-induced pump and probe technique—comprehensive observations in the urban atmosphere of Tokyo

Total OH reactivity was observed by use of the laser-induced pump and probe technique, and the urban air quality in Tokyo was diagnosed comprehensively. The concentrations of NO_x, CO, O₃, non-methane hydrocarbons (NMHCs) and oxygenated volatile organic compounds (OVOCs) were observed simultaneously. The observations were conducted in July and August 2003, and in January, February, May, and November 2004. Generally, the observed OH reactivity was higher than the calculated values derived using the observed concentrations of the trace species. The differences between the observed and calculated values in summer, spring, and autumn were approximately 30%. However, the difference in winter was smaller than those in the other seasons. In addition, while the differences observed in summer, spring, and autumn correlated with the total reactivity of the OVOCs (Σ_i k_OVOCi[OVOC_i](s⁻¹), k_i is rate constant of its compounds with OH), the correlations were not confirmed in the case of winter because atmospheric oxidation was less active and OVOCs levels were low in winter. These results suggest that the secondary products of the photochemical reactions in the atmosphere would be a missing sink for the OH loss process in the urban area.     

Congener-specific intake fractions for PCDDs/DFs and Co-PCBs: modeling and validation

Intake fractions (iFs) for emissions to air, water, and soil for 17 PCDDs/DFs and 12 Co-PCBs were calculated with a level III multimedia model and a food-chain exposure model in succession. The two integrated models were tested by comparing the predicted and measured concentrations in the environment and by comparing intakes through food. Measurement-based iFs were also calculated and compared with the model-based iFs. The air concentrations predicted by the fate model were close to the median of the observed concentrations, whereas the predicted soil and water concentrations were one-third to one-tenth the observed concentrations. This difference was large in case of PCDDs and Co-PCBs, which was explained by the past pollution such as commercial PCB products and PCDD impurities in chloronitrofen (CNP) and pentachlorophenol (PCP). For fish, the predicted and observed exposures agreed well each other. For meat and milk, the predicted exposures were about 10 times the observed exposures for PCDDs/DFs, whereas the predicted and observed values agreed well for Co-PCBs. When the model was modified to consider feeding of fish meal to livestock and geographic bias in feed-grass production, the predicted congener profile was comparable to the measured profile. The comparison also suggested that chickens should be modeled separately from other terrestrial livestock. The model-based iFs for air emission of OCDD and 2378-TCDD were 0.001% and 0.1%, respectively. The iFs of most Co-PCBs were higher than those of PCDDs/DFs. These iF differences suggest the importance of the fate factor in assessing emissions of the 29 congeners.     

In-use polybrominated diphenyl ether (PBDE) stocks and atmospheric emissions in Japan

We estimated the in-use stocks of polybrominated diphenyl ethers (PBDEs) in Japan using a population balance model. The estimation is based on the domestic demand of PBDEs and the assumed survival rate of these products. Two cases relevant to the future regulation of commercial deca-BDE are considered, namely (1) deca-BDE declines at the same rate as the current rate of decline, and (2) deca-BDE is discontinued after 2020. The estimates of the decreasing rates of in-use penta-, octa-, and deca-BDE stocks were proportional with the measured decreases in the atmospheric concentrations of these substances. The in-use penta- and octa-BDE stocks could be depleted in the near future (500 and 60 tonne in 2013, and an estimated 20 and <1 tonne in 2020, respectively). Relevant to case 1, the in-use stocks of deca-BDE-containing products would be 28,000 tonne in 2013 and an estimated 1900 tonne in 2040, providing an ongoing source of deca-BDE emission to the environment. On the other hand, relevant to case 2, most of the deca-BDE would be phased out by 2040. The atmospheric emissions of deca-BDE were predicted at 84–841 kg/year in 2013 and an estimated 43–425 kg/year in 2020.     

Waste prevention for sustainable resource and waste management

Although the 2Rs (reduce and reuse) are considered high-priority approaches, there has not been enough quantitative research on effective 2R management. The purpose of this paper is to provide information obtained through the International Workshop in Kyoto, Japan, on 11–13 November 2015, which included invited experts and researchers in several countries who were in charge of 3R policies, and an additional review of 245 previous studies. It was found that, regarding policy development, the decoupling between environmental pressures and economy growth was recognized as an essential step towards a sustainable society. 3R and resource management policies, including waste prevention, will play a crucial role. Approaches using material/substance flow analyses have become sophisticated enough to describe the fate of resources and/or hazardous substances based on human activity and the environment, including the final sink. Life-cycle assessment has also been developed to evaluate waste prevention activities. Regarding target products for waste prevention, food loss is one of the waste fractions with the highest priority because its countermeasures have significant upstream and downstream effects. Persistent organic pollutants and hazardous compounds should also be taken into account in the situation where recycling activities are globally widespread for the promotion of a material-cycling society.     

Study of the effect of political measures on the citizen participation rate in recycling and on the environmental load reduction

Obtaining the cooperation of citizens to participate in separate waste collection is essential to create a recycling-oriented society. In this research, the degree of change in the citizen participation rate, which occurs when the contents of political measures such as the raising of awareness, provision of information, and the conditions of collection services were changed, was estimated together with the effect on the reduction in environmental load. A questionnaire survey was conducted, targeted at residents of Itabashi Ward, while logistic regression analyses were also conducted to create predictive models for recycling behavior, and sensitivity analyses of the models were carried out to estimate the increase in citizen participation rate achievable through the implementation of various political measures. It was found that the effect of "thorough perception of information" was the largest, followed by "minimization of evaluation of trouble" and "thorough perception of efficacy of measures." The effect of the improvement in the citizen participation rate on the reduction in environmental load was also evaluated quantitatively by life cycle inventory analyses. It was indicated that "maximization of perception of information" had the greatest effect. However, the reduction effect with "paper packs" and "PET bottles" was relatively small compared with that of "bottles/cans."