Characterization of particulate matter from diesel passenger cars tested on chassis dynamometers

Emission characterization of particle number as well as particle mass from three diesel passenger cars equipped with diesel particulate filter(DPF), diesel oxidation catalyst(DOC)and exhaust gas recirculation(EGR) under the vehicle driving cycles and regulatory cycle.Total particle number emissions(PNEs) decreased gradually during speed-up of vehicle from 17.3 to 97.3 km/hr. As the average vehicle speed increases, the size-segregated peak of particle number concentration shifts to smaller size ranges of particles. The correlation analysis with various particulate components such as particle number concentration(PNC),ultrafine particle number concentration(UFPNC) and particulate matter(PM) mass was conducted to compare gaseous compounds(CO, CO_2, HC and NOx). The UFPNC and PM were not only emitted highly in Seoul during severe traffic jam conditions, but also have good correlation with hydrocarbons and NOxinfluencing high potential on secondary aerosol generation. The effect of the dilution temperature on total PNC under the New European Driving Cycle(NEDC), was slightly higher than the dilution ratio. In addition, the nuclei mode(DP: ≤ 13 nm) was confirmed to be more sensitive to the dilution temperature rather than other particle size ranges. Comparison with particle composition between vehicle speed cycles and regulatory cycle showed that sulfate was slightly increased at regulatory cycle, while other components were relatively similar. During cold start test, semivolatile nucleation particles were increased due to effect of cold environment. Research on particle formation dependent on dilution conditions of diesel passenger cars under the NEDC is important to verify impact on vehicular traffic and secondary aerosol formation in Seoul.     

Implication of the cluster analysis using greenhouse gas emissions of Asian countries to climate change mitigation

Climate change caused by excessive emission of greenhouse gases (GHGs) into the atmosphere has gained serious attention from the global community for a long time. More and more countries have decided to propose their goals such as Paris agreements, to reduce emitting these heat trapping compounds for sustainability. The Asian region houses dramatic changes with diverse religions and cultures, large populations as well as a rapidly changing socio-economic situations all of which are contributing to generating a mammoth amount of GHGs; hence, they require calls for related studies on climate change strategies. After pre-filtering of GHG emission information, 24 Asian countries have been selected as primary target countries. Hierarchical cluster analysis method using complete linkage technique was successfully applied for appropriate grouping. Six groups were categorized through GHG emission properties with major and minor emission sectors based on the GHG inventory covering energy, industrial processes, agriculture, waste, land use change, and forestry and bunker fuels. Assigning six groups using cluster analysis finally implied that the approach to establish GHG emission boundaries was meaningful to develop further mitigation strategies. Following the outcome of this study, calculating amount of reduction potential in suitable sectors as well as determining best practice, technology, and regulatory framework can be improved by policy makers, environmental scientists, and planners at the different levels. Therefore, this work on reviewing a wide range of GHG emission history and establishing boundaries of emission characteristics would provide further direction of effective climate change mitigation for sustainability and resilience in Asia.     

Control of petroleum-hydrocarbon contaminated groundwater by intrinsic and enhanced bioremediation

In the first phase of this study, the e ectiveness of intrinsic bioremediation on the containment of petroleum hydrocarbons was evaluated at a gasoline spill site. Evidences of the occurrence of intrinsic bioremediation within the BTEX (benzene, toluene, ethylbenzene, and xylenes) plume included (1) decreased BTEX concentrations; (2) depletion of dissolved oxygen (DO), nitrate, and sulfate; (3) production of dissolved ferrous iron, methane, and CO2; (4) deceased pH and redox potential; and (5) increased methanogens, total heterotrophs, and total anaerobes, especially within the highly contaminated areas. In the second phase of this study, enhanced aerobic bioremediation process was applied at site to enhance the BTEX decay rates. Air was injected into the subsurface near the mid-plume area to biostimulate the naturally occurring microorganisms for BTEX biodegradation. Field results showed that enhanced bioremediation process caused the change of BTEX removal mechanisms from anaerobic biodegradation inside the plume to aerobic biodegradation. This variation could be confirmed by the following field observations inside the plume due to the enhanced aerobic bioremediation process: (1) increased in DO, CO2, redox potential, nitrate, and sulfate, (2) decreased in dissolved ferrous iron, sulfide, and methane, (3) increased total heterotrophs and decreased total anaerobes. Field results also showed that the percentage of total BTEX removal increased from 92% to 99%, and the calculated total BTEX first-order natural attenuation rates increased from 0.0092% to 0.0188% per day, respectively, after the application of enhanced bioremediation system from the spill area to the downgradient area (located approximately 300 m from the source area).     

Isolation,identification, Pb(Ⅱ) biosorption isotherms and kinetics of a lead adsorbing Penicillium sp. MRF-1 from South Korean mine soil

A heavy metal contaminated soil sample collected from a mine in Chonnam Province of South Korea was found to be a source of heavy metal adsorbing biosorbents. Chemical analyses showed high contents of lead (Pb) at 357 mg/kg and cyanide (CN) at 14.6 mg/kg in the soil. The experimental results showed that Penicillium sp. MRF-1 was the best lead resistant fungus among the four individual metal tolerant fungal species isolated from the soil. Molecular characterization of Penicillium sp. MRF-1 was determined using ITS regions sequences. E ects of pH, temperature and contact time on adsorption of Pb(II) by Penicillium sp. MRF-1 were studied. Favorable conditions for maximum biosportion were found at pH 4 with 3 hr contact time. Biosorption of Pb(II) gradually increased with increasing temperature. E cient performance of the biosorbent was described using Langmuir and Freundlich isotherms. Adsorption kinetics was studied using pseudo first-order and pseudo second-order models. Biosorbent Penicillium sp. MRF-1 showed the maximum desorption in alkali conditions. Consistent adsorption/desorption potential of the biosorbent in repetitive cycles validated the e cacy of it in large scale. SEM studies given notes on surface modification of fungal biomass under metal stress and FT-IR results showed the presence of amino groups in the surface structure of the biosorbent. In conclusion, the new biosorbent Penicillium sp. MRF-1 may potentially be used as an inexpensive, easily cultivatable material for the removal of lead from aqueous solution.     

Applying model simulation and photochemical indicators to evaluate ozone sensitivity in southern Taiwan

Ozone sensitivity was investigated using CAMx simulations and photochemical indicator ratios at three sites (Pingtung City, Chao- Chou Town, and Kenting Town) in Pingtung County in southern Taiwan during 2003 and 2004. The CAMx simulations compared fairly well with the hourly concentrations of ozone. Simulation results also showed that Pingtung City was mainly a volatile organic compounds (VOC)-sensitive regime, while Chao-Chou Town was either a VOC-sensitive or a NOx-sensitive regime, depending on the seasons. Measurements of three photochemical indicators (H2O2, HNO3, and NOy) were conducted, and simulated three transition ranges of H2O2/HNO3 (0.5–0.8), O3/HNO3 (10.3–16.2) and O3/NOy (5.7–10.8) were adopted to assess the ozone sensitive regime at the three sites. The results indicated that the three transition ranges yield consistent results with CAMx simulations at most times at Pingtung City. However, both VOC-sensitive and NOx-sensitive regimes were important at the rural site Chao-Chou Town. Kenting Town, a touring site at the southern end of Taiwan, was predominated by a NOx-sensitive regime in four seasons.     

Vaporization reduction characteristics of aqueous ammonia solutions by the addition of ethylene glycol, glycerol and glycine to the CO2 absorption process

Aqueous ammonia (NH₃) solution can be used as an alternative absorption for the control of CO₂ emitted from flue gases due to its high absorption capacity, fast absorption rate and low corrosion problem. The emission of CO₂ from iron and steel plants requires much attention, as they are higher than those emitted from power plants at a single point source. In the present work, low concentration ammonia liquor, 9 wt.%, was used with various additives to obtain the kinetic properties using the blast furnace gas model. Although a solution with a high ammonia concentration enables high CO₂ absorption efficiency, ammonium ions are lost as ammonia vapor, resulting in reduced CO₂ absorption due to the lower concentration of the ammonia absorbent. To decrease the vaporization of ammonia, ethylene glycol, glycerol and glycine, which contain more than one hydroxyl radical, were chosen. The experiments were conducted at 313 K similar to the CO₂ absorption conditions for the blast furnace gas model.