废弃中药渣催化热解制取生物油的研究

利用热重分析仪(TGA)对植物类中药渣的热解特性进行了研究,用Coats-Redfern积分法计算了其热解动力学参数,得出中药渣热解反应符合一级反应动力学方程,其活化能较低,为36.0kJ/mol。考察了热解温度对气体、液体、固体产物的影响,在723K时,液体产物生物油产率最高,为39%。以介孔分子筛SBA-15以及分别负载Al、Sn、Ni、Cu和Mg的SBA-15作为催化剂,研究催化热解对气体、液体、固体产率及生物油组分的影响。研究表明,Al-SBA-15的催化效果较好,液体产率最高,为36%;采用元素分析仪和热值测定仪,得到用Al-SBA-15作为催化剂时生物油的氧质量分数最低,低位热值最高。用GC/MS对生物油组分的分析结果表明,添加Al-SBA-15后,热解产物中脂肪族和芳香族化合物增加,而含氧化合物减少。     

CeO_2/Al_(0.2)Ti_(0.6)Zr_(0.2)O_(1.9)/ATS复合脱硝催化剂的制备及其抗硫抗水性能研究

将预先经酸处理的铝钛硅(ATS)多相陶瓷片先后负载Al0.2Ti0.6Zr0.2O1.9复合氧化物与CeO2活性组分,制得新型CeO2/Al0.2Ti0.6Zr0.2O1.9/ATS复合脱硝催化剂。运用X射线衍射(XRD)、扫描电镜(SEM)手段对该催化剂进行表征,研究催化剂的晶相、微观形貌。评价了催化剂的脱硝活性,研究了H2O和SO2对其脱硝活性的影响。实验结果表明,CeO2/Al0.2Ti0.6Zr0.2O1.9/ATS具有良好的脱硝活性,高活性温度窗口在100～350℃,当反应温度为250℃时,NO的转化率达98.49%。SO2和H2O在一定程度抑制该催化剂的低温脱硝活性,但随着温度的升高,其脱硝活性逐渐恢复。催化剂中活性组分CeO2具有储硫作用,当有SO2存在时,活性温度窗口向高温区偏移了100℃,在250～400℃时,H2O的存在反而提高了催化剂的脱硝活性。     

WRF-Chem simulation of East Asian air quality: Sensitivity to temporal and vertical emissions distributions

This study develops fine temporal (seasonal, day-of-week, diurnal) and vertical allocations of anthropogenic emissions for the TRACE-P inventory and evaluates their impacts on the East Asian air quality prediction using WRF-Chem simulations in July 2001 at 30-km grid spacing against available surface measurements from EANET and NEMCC. For NO₂ and SO₂, the diurnal and vertical redistributions of emissions play essential roles, while the day-of-week variation is less important. When all incorporated, WRF-Chem best simulates observations of surface NO₂ and SO₂ concentrations, while using the default emissions produces the worst result. The sensitivity is especially large over major cities and industrial areas, where surface NO₂ and SO₂ concentrations are reduced by respectively 3–7 and 6–12 ppbv when using the scaled emissions. The incorporation of all the three redistributions of emissions simulates surface O₃ concentrations higher by 4–8 ppbv at night and 2–4 ppbv in daytime over broad areas of northern, eastern and central China. To this sensitivity, the diurnal redistribution contributes more than the other two.     

Measurement of the surface charge of ultrafine particles from laser printers and analysis of their electrostatic force

Ultrafine particles (UFPs) released from laser printers are electrostatically charged during the working processes of the devices, and the electrostatic force can obviously influence the dynamics of the particles. Due to the measurement difficulty and scarcity of relevant research, this issue was not reported. This study tried to address this issue through experimental measurement of the surface charge of UFPs and numerical investigation on the influence of electrostatic force on the dynamics of UFPs. A test chamber was set up to collect the UFPs, and the Scanning Electron Microscope was used to observe the morphologies of the UFPs. Based on the particle diameter and surface zeta potential, the surface charge of UFPs was calculated. The measurement results gave that particle emitted from laser printers are negatively charged and the average surface charge of particle emissions for four laser printers is in a range of about ?4.16 × 10^?17 to ?6.07 × 10^?17 C (～?260 to ?379 e). This paper also discussed the influence of electrostatic force on the dynamics of UFPs. According to the numerical investigation, it was found that, in the absence of electric field, the electrostatic force has to be considered when the surface charge is larger than 1 × 10^?16 C and when the UFP is very close to the wall with a distance of less than 0.01 m. These findings will guide constructively in predicting the dispersion and deposition of particles emitted from laser printers.     

可用于水体污染控制的氨氮转化菌筛选及部分降解特性的实验研究

从南京禄口水产养殖基地淡水鱼塘取淤泥作为分离菌株的土源,采用选择性富集培养法,从中分离到能以硫酸铵为氮源的菌株7株,对7个菌株进行氨氮降解实验,它们氨氮转化率分别为14.8%、19.7%、53.4%、94.2%、29.1%、63.5%和41.7%,其中AN-4菌株的转化率最高且生长良好。通过AN-4菌株16S rRNA基因序列分析以及生理生化方法,鉴定此菌株为克雷伯氏菌属(Klebsiellasp.)。对菌株AN-4转化氨氮的特性及温度、pH值、氨氮初始浓度和菌株接种量对其氨氮转化率的影响研究,结果表明,菌株AN-4降解氨氮的最适条件为:温度为30℃和pH值为8.0;当氨氮初始浓度为30mg/L时,AN-4菌株在24 h内的氨氮降解率可达85%以上,且能耐受高达200 mg/L的氨氮浓度;AN-4活化菌液浓度为108cfu/mL,当接种量为3×106cfu/mL时,AN-4菌株在24 h内的氨氮降解率为87.75%。综合上述结果,符合淡水养殖水环境条件,说明AN-4菌株适合在水产养殖中应用,为将菌株AN-4应用于水产养殖环境修复提供了理论依据。     

混凝与Fenton联用处理垃圾渗滤液的效能及成本

为对混凝/Fenton工艺与Fenton/混凝工艺处理垃圾渗滤液的效果和成本进行比较,分别对年轻渗滤液和老龄渗滤液原液按照混凝/Fenton工艺与Fenton/混凝工艺2种技术路线进行处理。实验结果表明,Fenton试剂对年轻垃圾渗滤液和老龄垃圾渗滤液COD去除率最高的反应条件为pH=3.5、H2O2和Fe2+的摩尔比为6、H2O2和渗滤液原液的COD质量比为3、反应时间4 h;在PAC与渗滤液原液的COD质量比为0.6时,PAC混凝对渗滤液原液的COD去除率最高。在对渗滤液COD去除率最高的Fenton反应和PAC混凝反应条件下,混凝/Fenton工艺对年轻渗滤液和老龄渗滤液的COD去除率分别为90.56%和86.56%;Fenton/混凝工艺对年轻渗滤液和老龄渗滤液的COD去除率分别为89.99%和85.99%,2种技术路线对渗滤液COD的去除率相差不大,但先PAC混凝后Fenton氧化工艺比先Fenton后混凝工艺每t节省62.6元,是更优化的渗滤液处理工艺。     

藻类打捞对水体营养循环的影响及其生态效果研究

富营养化水体中的藻华是氮磷的富集器,太湖打捞藻样中的总氮、总磷、游离磷及有机物含量分别为98.87g/kg、3.25 g/kg、0.21 g/kg和95.65%。在底泥中沉降藻类的矿质化周期随着温度的升高而缩短;且其向上覆水中释放氮、磷的强度具有随水温升高而增强的趋势。但在水层厚/底泥比不同的区域,这种营养物释放强度又存在显著的差异。实验证明,藻类的打捞是一种人工延长食物链去除氮磷等污染物的有效方法。     

PEM式臭氧消毒在地上游泳池水处理中的应用

采用臭氧法水处理系统对地上游泳池的循环水进行灭菌消毒,研究了臭氧用量、循环水流量和运行时间等因素对臭氧法灭菌效果的影响。结果表明,3组PEM臭氧发生器应用于21.2 m3的地上游泳池,在4 m3/h的循环水流量下运行12 h后,水中的细菌总数与大肠杆菌群数达到国家标准,去除率均在99%以上。与盐电解法水处理系统相比较,臭氧法水处理系统的优势在于:杀菌快速高效、出水水质的理化指标较好和运行费用低廉。     

两阶段曝气生物滤池的硝化性能

曝气生物滤池(BAF)是近年来受到广泛关注的一种新型污水处理技术,具有占地面积少、投资费用低、处理效率高、出水水质好等优点。现已被应用于许多污水处理厂的二级处理、深度处理以及污水的回用。实验以陶粒为填料,自行设计了升流式两阶段BAFs(UBAFs)处理模拟生活污水,考察了反应器运行条件对COD与氨氮去除影响,并探讨了UBAFs反应器内氮流失及同步硝化反硝化情况。结果表明,UBAFs对生活污水处理具有良好的净化效果。在进水COD和氨氮浓度分别为200~363 mg/L和16.8~31.3 mg/L条件下,UBAFs处理出水水质均达到《城市污水再生利用城市杂用水水质》(GB/T 18920-2002)标准,能够满足回用要求。通过采用氮平衡分析方法和借助电子扫描电镜技术,初步认为UBAFs反应器脱氮方式是由于在UBAFs第一阶段局部厌氧环境中以传统方式进行硝化反硝化脱氮,第二阶段是在好氧条件下,异养好氧硝化菌的同步硝化反硝化脱氮。     

混凝沉淀-高级氧化联合处理垃圾转运站污水的实验研究

城市生活垃圾转运站污水具有水质水量变化大、有机污染负荷高、具有强烈恶臭、色度高等显著特点,已成为城市重要的点源污染。为有效消减转运站污水有机负荷,探讨了混凝沉淀-高级氧化联合使用的物化处理方法,考察了联合处理过程中双氧水/亚铁、亚铁投加量、酸化后pH值、混凝剂投加量、中和后pH值等因素对处理效果的影响。小试研究结果表明,在混凝剂投加400 mg/L,亚铁0.06 mol/L,酸化后pH为3,双氧水/亚铁=4∶1,中和后pH为7.5的条件下,污水COD消减量达到60%以上,色度去除率98%,恶臭基本消除。