Preparation and Properties of Poly (Lactic Acid) Nanocomposites Filled with Functionalized Single-Walled Carbon Nanotubes

This work prepared poly (lactic acid) (PLA)/single-walled carbon nanotubes (SWCNTs) composites using a solution blend method, and investigated the influence of the physical properties of PLA/SWCNTs composites. In order to enhanced interfacial interactions between PLA and SWCNTs, the purified SWCNTs were given functionalisation treatments with a nitric acid/sulfuric acid mixture. These acid-treated SWCNTs (A-SWCNTs) were then grafted with 3-isocyanatopropyl triethoxysilane (A-SWCNTs-Si). When these functionalized SWCNTs were used to fill the PLA matrix, the fractured surface of composite does not present the pullout phenomenon. The dimensional stability obviously increased by a factor of approximately 72. The storage modulus was also significantly improved. The surface resistivity of the PLA/SWCNTs composites decreased from 1 × 10¹⁶ to 2.22 × 10⁴ Ω/cm².     

Triazine and metolachlor herbicide residues in farm areas of the Lower Fraser valley, British Columbia, Canada

Crop soils, ditch sediments and water flowing from several Lower Fraser River (LFR) farm areas of British Columbia, Canada, to salmon tributary streams of that river were sampled in 2004-2005 to quantify for residues of triazine [atrazine, desethylatrazine (a transformation product of atrazine), propazine, and simazine] and metolachlor (a chloroacetamide) herbicides. Average concentrations [microg kg-1 dry weight (d.w.)] of triazine (10,110) and metolachlor (8,910) herbicides detected in crop soils at the start (May 2004, 2005) of the growing season were about 17 and 6 times, respectively, higher than those found for both herbicide groups during (June-Sept, 2004, 2005) the growing season. In contrast, mean concentrations (microg L-1) of triazines (0.092) and metolachlor (0.014) in permanent ditches adjacent to farms were about 7 and 28 times, respectively, lower at the start than during the growing season. Both herbicide groups in ditch sediments were detected only during the growing season at concentrations averaging about 315 microg kg-1 d.w. The risk potential of these herbicides for non-target aquatic organisms inhabiting permanent farm ditches contiguous to tributary streams of the LFR during the growing season is evaluated and discussed.     

污泥粉煤灰混合基质中结缕草发芽率的测定

本文研究了结缕草在污泥与粉煤灰构成的混合基质中的初期成活率,力求使粉煤灰场表层特性适合先锋植被生长,从而加快生态恢复速度,达到以废治污的目的。     

我国县城污水处理设施投融资路径优化研究

县城污水处理设施水平是决定城镇开发利用的关键因素,也是防止新冠疫情二次传播的有效防线.中国县城污水处理能力已从2001年的454.8万t/d增长至2019年的3587.0万t/d,污水处理及其再生利用投资也从5.3亿元增长至176.0亿元,但仍面临财政筹资不足、吸引社会资金难度增加、收费定价机制尚需完善等问题和障碍.针...     

典型离子交换水处理技术在低浓度氨氮回收中的应用分析

离子交换技术具有交换容量高、能耗低、可再生效率高、操作过程简单、环境友好,并且能同时实现水质净化和资源原位回收等优势,在水处理领域应用十分广泛。在文献及工程调研的基础上,综述了3种典型离子交换剂：沸石、粉末树脂、磁性离子交换树脂的技术原理及其在污水处理中的应用现状;分析了三者在低浓度氨氮回收过程中存在的问题,并提出了相应的研究策略;评价了3种离子交换剂在工程化应用中的经济性,主要介绍了成熟的磁性离子交换树脂工艺;通过分析可知,将离子交换技术从污水治理领域应用到污水中低浓度氨氮原位富集回收领域,对污水全面资源化利用具有重要意义。     

Recycling rates of waste home appliances in Taiwan

The objective of this study is to provide a calculation of recycling rates of waste home appliances in Taiwan, for the EPA to amend these rates in order to increase the recycling efficiency. The recycling rate is calculated by a formula according to the statistical results obtained through: (1) an estimation of domestic use of home appliances using time series analysis with multiplicative seasonal ARIMA model, (2) a further estimation of generated waste home appliances based upon the estimated domestic use and the corresponding distribution of lifetime span, and (3) a cost analysis of recycling home appliances based on a sampling survey with stratified systematic sampling conducted among collectors and a survey on five recycling plants of waste home appliances. The suggested recycling rates in this study finally used by the EPA show that all of the recycling rates have increased compared with the rates in previous years. This study also implies that amending the recycling rates may only solve some recycling problems temporarily; however, the recycling system of waste home appliances in Taiwan has to be reformed to increase the recycling efficiency for the long term.     

Vitrification for reclaiming spent alkaline batteries

The object of this study is to stabilize spent alkaline batteries and to recover useful metals. A blend of dolomite, limestone, and cullet was added to act as a reductant and a glass matrix former in vitrification. Specimens were vitrified using an electrical heating furnace at 1400 °C and the output products included slag, ingot, flue gas, and fly ash. The major constituents of the slag were Ca, Mn, and Si, and the results of the toxicity leaching characteristics met the standards in Taiwan. The ingot was a good material for use in production of stainless steel, due to being mainly composed of Fe and Mn. For the fly ash, the high level of Zn makes it economical to recover. The distribution of metals indicated that most of Co, Cr, Cu, Fe, Mn, and Ni moved to the ingot, while Al, Ca, Mg, and Si stayed in the slag; Hg vaporized as gas phase into the flue gas; and Cd, Pb, and Zn were predominately in the fly ash. Recovery efficiency for Fe and Zn was >90% and the results show that vitrification is a promising technology for reclaiming spent alkaline batteries.     

Modeling competitive adsorption of molybdate, sulfate, selenate, and selenite using a Freundlich-type multi-component isotherm

This study examined the interactions of MoO4(2-) + SO4(2-), MoO4(2-) + SeO4(2-), and MoO4(2-) + SeO3(2-) systems on gamma-Al2O3 to better understand the competitive adsorption of these anions in the natural environment. The Freundlich isotherms of anionic adsorption onto gamma-Al2O3 in single and binary solutes were also investigated to estimate the competition between these anions. Experimental results indicate that a higher concentration of competitive solute yields a higher efficiency of the competitive solute's prevention of MoO4(2-) adsorption. The most significant result was found in the MoO4(2-) + SeO3(2-) system. The Freundlich isotherm constant (n) increases with the competitive solute concentration. The suitability of a Freundlich-type isotherm, the Sheindorf-Rebuhn-Sheintuch (SRS) equation, and the modified SRS equation in representing the competitive adsorption of MoO4(2-), SO4(2-), SeO4(2-), and SeO3(2-) on gamma-Al2O3 surface, was also examined. Each set of isotherm data was found to conform to linear SRS expressions, allowing competition coefficients to be derived on a concentration basis for each binary-solute system. The competition coefficient aij and relative affinity coefficients alphaij can be seen as a way to quantify competitive interactions. The proposed SRS and modified SRS equations are simple mathematical expressions accounting for competitive interactions of anions present in a mixture for the range of concentrations over which each individual component exhibits Freundlich behavior.     

WATER QUALITY MODELING FOR THE FEITSUI RESERVOIR IN NORTHERN TAIWAN1

ABSTRACT: Field data collected from the Feitsui Reservoir in Taiwan indicate that the water is at a stage between mesotrophic and eutrophic. Recent measurements such as total phosphorus, chlorophyll a and Secchi depth levels suggest that the water quality has been declining. A two‐dimensional, laterally averaged, finite difference hydrodynamic and water quality model was used to simulate the water quality in the Feitsui Reservoir in an effort to determine sound water quality management strategies. The model was calibrated and verified using data collected in 1996 and 1997. The calibrated model was used to simulate algal biomass (in terms of chlorophyll a) levels under various wasteload reduction scenarios. Model results show that 50 percent reduction of the total phosphorus load will improve the existing water quality, shifting the trophic status from eutrophic/mesotrophic to oligotrophic. The modeling effort has yielded valuable information that can be used by decision makers for the evaluation of different management strategies of reducing watershed nutrient loads.     

Experiences of Coal Ash Artificial Reefs in Taiwan

A feasibility study for using fly-ash from Taiwan coal-fired power stations for artificial reef production was started in 1983. Various mixtures of fly ash stabilized with lime, cement, or industrial wastes and formed into blocks were tested in the laboratory. the results showed that the development of compressive strength of those blocks immersed in the sea water was much better than those exposed in the air. Heavy metal (Cd, Cr, Cu, Ni, Pb, Zn) content of the blocks has been monitored routinely to determine the leaching rates. the result indicates that solidification of fly-ash could indeed immobilize heavy metals better than the original fly ash. From March 1984 to February 1987, 3,682 coal ash stabilized blocks with total weight of 300 tons were designed, fabricated and installed at both Hsin-ta, south western coast, and Kuei-hou, northern coast of Taiwan, for field trials. After four years' underwater observations on 100 cubic blocks at Wan-Li, northern Taiwan, it was shown that the physical integrity of the ash reef blocks had been maintained. the compressive strength and durability was better than the concrete artificial reefs nearby. the ash reefs could also attract fishes and the colonization by benthic organisms was similar to that on concrete reefs. Eighty-eight species of fishes were observed, of which 27 were commercially important, comprising more than 80% of the total biomass. These results demonstrate a potential use for stabilized coal ash as artificial reefs to replace traditionally used concrete reefs to protect and enhance the coastal fishery resources in Taiwan in the future.