INVESTIGATION OF TURBIDITY MAXIMUM IN A MESOTIDAL ESTUARY,TAIWAN1

ABSTRACT: To comprehend the distributions of salinity, temperature, and suspended sediment in the Danshuei River estuary in Taiwan, monthly field surveys were conducted in 2003. These included several high and low slackwater surveys and intensive surveys. The results show that the Danshuei River estuary is predominately a partially mixed estuary. The highest concentration of suspended sediment is typically observed at the Chung‐Hsin Bridge, the most upstream sampling station. The suspended sediment concentration exhibits a general decreasing trend in the downstream direction. It may be concluded that the sediments mostly come from the upstream reach. A locally high concentration of suspended sediment is found at the Kuan‐Du station because of the local deep channel bathymetry and two‐layered estuarine circulation. A vertical two‐dimensional hydrodynamic and sediment transport model is applied to investigate the tidally averaged salinity distribution, residual circulation, and suspended sediment concentration. The modeling results reveal that, under the Q₇₅ flow condition (i.e., low flow), a turbidity maximum occurs at the Kuan‐Du station due to the strong estuarine circulation. The model simulation with a much higher river flow condition results in a weaker residual circulation and weaker turbidity maximum.     

Degradation of di-butyl-phthalate by soil bacteria

Twelve Gram-positive phthalate ester degraders were isolated from soil. Using Biolog GP2 plates, eight of them were identified as belonging to the Corynebacterium-Mycobacterium-Nocardia group, while the remaining four were unidentifiable. When cultured in the presence of di-butyl-phthalate (DBP) in basal salts solution, five of these isolates accomplished more than 90% of DBP degradation within 48 h (fast group), three were placed in the medium group, and the remaining four were placed in the slow group which caused less than 30% of DBP degradation within the same period of time. A 420 bp DNA fragment was amplified from six isolates and none of them fell within the slow group. When compared with the large subunit of phthalate dioxygenase gene (phtA) of Arthrobacter keyseri, 83% and 91% similarities were evident in the nucleotide and amino acid sequences, respectively. However, no correlation between cell surface hydrophobicity and phthalate degradation ability was evident. Six surfactants (Brij 30, Brij 35, Tergitoltype NP-10, Triton N-101, Triton X-100 and SDS) were tested for their abilities to increase degradation rate. When added at the critical micellar concentration (CMC), they all displayed strong growth inhibition against the three bacteria tested, with Brij 30 been the least toxic to isolates G2 and G11, and Brij 35 had the least inhibitory effect for G1. When half the CMC of Brij 30 was incorporated into the basal salts, the inhibitory effect on DBP degradation remained. Soil helped to minimize surfactant toxicity of surfactant and increase the degradation potential of some of the test bacteria. When DBP-amended soil had been aged for three months, decreases in bioavailability were observed but the effect varied tremendously between different organisms. For isolates G1, G2, G5, G7 and G17 the aging effects were almost non-exist. The present study indicates that selection of a suitable degrader may minimize the undesired effect of aging on bioremediation process.     

Solar photocatalytic decolorization of methylene blue in water

In this study, a photocatalytic decolorization system equipped with immobilized TiO2 and illuminated by solar light was used to remove the color of wastewater. To examine the decoloring efficiency of this system, photocatalytic decolorization of an organic dye such as methylene blue was studied as an example. The effects of light source, pH, as well as the initial concentration of dye were also investigated. It was observed that the solution of methylene blue could be almost completely decolorized by the solar light/TiO2 film process while there was about 50% color remaining with solar irradiation only. In addition, it was found that the decoloring efficiency of solution was higher with solar light irradiation than with artificial UV light irradiation, even though the artificial UV light source supplied higher UV intensity at 254 nm. The color removal rate of methylene blue with solar light irradiation was almost twice that of artificial UV light irradiation. This phenomena was mainly attributed to that some visible light range of solar light was useful for exciting the methylene blue molecules adsorbed on TiO2 film, leading to a photosensitization process undergoing and decoloring efficiency promoted. This solar-assisted photocatalytic device showed potential application for decoloring organic dyes in wastewater.     

Photocatalytic oxidation of pesticide rinsate

Pesticide rinsate has been considered as one of the major threats for the environment. In this study, photocatalysts such as TiO2 and O3 were used to promote the efficiency of direct UV photolysis to prevent such wastewater pollution. Carbofuran (a carbamate pesticide) and mevinphos (an organophosphate pesticide) with a concentration of 100 mg/L were selected as the test pesticide rinsates. Parent pesticide compound, COD, and microtoxicity analysis were employed to investigate the effect of photocatalyst on the degradation efficiency of pesticide in rinsate. It was found that the photocatalytic oxidation process (UV/O3, UV/TiO2) showed much higher COD removal and microtoxicity reduction efficiency for pesticide rinsate than did direct UV photolysis under the imposed conditions, suggesting that photocatalytic oxidation processes such as UV/O3 and UV/TiO2 could be a better alternative to treat pesticide rinsate. In addition, it was noted that increasing the initial pH of mevinphos rinsate to a basic level was required to reach higher COD removal efficiency and positive microtoxicity reduction efficiency while it was not necessary for the treatment of carbofuran rinsate.     

Characteristics of aerosols collected in central Taiwan during an Asian dust event in spring 2000

Aerosol samples for PM(2.5) and PM(2.5-10) were collected at four locations in central Taiwan from 26 to 31 March 2000, a period that experienced exceedingly high PM levels from 29 to 30 March due to the passage of an Asian dust storm. The samples were analyzed for mass, metallic elements, ions, and carbon. The purpose of this paper is to investigate the influence of the dust storm on the characteristics of local ambient particulate matter. The results indicate that the concentrations of the crustal elements Ca, Mg, Al, Fe and the sea salt species Na+ and Cl- in PM(2.5-10) during the dust episode exceed the mean concentrations in the non-dust period by factors of 3.1, 2.9, 2.6, 2.2, 2.3 and 2.1 respectively. Enrichment factors of Ca, Fe, and Mg in PM(2.5-10) during the dust event are close to unity, indicating that these elements are from soil. Reconstruction of aerosol compositions revealed that soil of coarse particulates elevated approximately 50% in the dust event. It is noted that during the dust event, the ratio of Mg/Al in PM(2.5-10) ranged from 0.21 to 0.25 while that of Ca/Al ranged from 0.6 to 0.9, levels more constant than those obtained in non-dust period.     

The application and evaluation research of coffee residue ash into mortar

Coffee residue is usually regarded as a kind of agriculture waste; as its quantity increases the treatment of coffee residue will become an environmental problem. This research is innovative in that it derives the possibility of recycle application using coffee residue ash for cement replacement. In this research, coffee residue is burned in an electronic oven to three kinds of coffee residue ash at 500, 600 and 700 °C, and then appropriate apparatus is used to check the chemical and physical properties of these three types of coffee residue ash. After a general comparison, this study selected 500 and 600 °C coffee residue ashes with 2, 3, 5, 10 and 15 % cement replacements to make 5 cm³ cube mortar specimen to test different curing ages’ compressive strength. Through measurement and experiment, this research found that the compressive strength decreased by adding 500 or 600 °C coffee residue ash into the mortar. By considering waste reduction and practice application, this research derives that using the 600 °C coffee residue ash with 10 % replacement is better than others application, such using result also can get valuable efficiencies of financial and CO₂ reduction.     

Biodegradation of coplanar polychlorinated biphenyls by anaerobic microorganisms from estuarine sediments.

In this study, we investigated the biodegradability of biphenyl and 5 congeners (one non-planar and four coplanar) of polychlorinated biphenyl (PCB). Biphenyl, the non-planar congener 2,3',4',5-tetrachlorobiphenyl (25-34 CB), and the four coplanar congeners 3,3',4,4'-tetrachlorobiphenyl (34-34 CB), 3,4,4',5-tetrachlorobiphenyl (345-4 CB), 3,3',4,4',5-pentachlorobiphenyl (345-34 CB), and 3,3',4,4',5,5'-hexachlorobiphenyl (345-345 CB) were amended at a concentration of 10 mg/L into anoxic sediment slurries collected from the estuaries of the Tansui River and the Erjen River. During 2 years' incubation under sulfidogenic conditions, biphenyl was persistent, while all other chlorinated congeners, except for 345-345 CB, were dechlorinated with or without a lag period in sediment slurries collected from both rivers. Dechlorination of coplanar and non-planar congeners began with para chlorine removal. All para chlorines from the mono-, di-, and trichlorobiphenyl groups could be removed by sediment slurries from both rivers. Microbial communities in sediment from the Erjen River additionally fostered meta-dechlorination activity, but only after removal of all the para chlorines. Addition of Tween 20 (0.05%, v/v) into sediment slurries from the Tansui River did not enhance dechlorination rates or extents, but the addition of toluene- or 3-chlorobenzoate-adapted sediments enhanced dechlorination of 34-34 CB and 345-4 CB.