Deterioration of Polyamideamine–Epichlorohydrin (PAE) in Aqueous Solutions During Storage: Structural Changes of PAE

Structural changes of polyamideamine–epichlorohydrin (PAE) in solution during storage at 4 °C and pH 4.2–4.5 for up to 8.9 years were studied by ¹H- and ¹³C-NMR analyses, colloidal titration and others. NMR signals due to 3-hydroxy-azetidinium groups of PAE decreased during storage, and correspondingly 2, 3-dihydroxypropyl groups were formed by the ring opening. The content of 3-hydroxy-azetidinium groups in PAE determined by ¹H-NMR were similar to that determined by the colloidal titration, although the former was higher than the latter. About 50% of the 3-hydroxy-azetidinium groups present in the fresh PAE were lost during storage for 8.9 years. Furthermore, ¹³C-NMR analysis revealed that significant depolymerization of polyamideamine chains occurred by hydrolysis of the amide linkages during storage. Rough evaluation of number average degree of polymerization (DPn) of the amideamine repeating unit showed that the DPn decreased from 12 to 2 during storage for 8.9 years.     

Pulverization of waste printed circuit boards

A new pulverization method to reduce the volume of waste printed circuit boards is reported. About 50% of printed circuit boards with integrate circuits (ICs) could be pulverized by our method in one 20-min batch, but boards without ICs could not be pulverized. By repeating the process three times, about 95% of printed circuit boards with ICs could be made into a fine powder with particles less than 106µm. A weight-drop test was also performed to examine the strength of the printed circuit boards and clarify the mechanism of pulverization. When a weight was dropped on the solder-welding side of the board ruptures occurred more easily than when the weight was dropped on the IC-mounted side. With a heavy weight, the IC was fractured more easily when the potential energy was low. Where the stress was concentrated, two types of rupture location were found on printed circuit boards with ICs. One was where the IC was connected to the printed circuit board. The other was where the surface had undulations. It also became clear that the fracture of printed circuit boards depends on the impacting weight rather than on the potential energy.     

Dioxin-like potencies and extractable organohalogens (EOX) in medical, municipal and domestic waste incinerator ashes in Japan

Ash samples collected from medical, municipal and small-scale domestic incinerators in Japan were tested for dioxin-like activity using bioassay technique (ethoxyresorufin-O-deethylase: EROD assay) and for extractable organohalogens (EOX) using instrumental neutron activation analysis in order to estimate potential toxicity and responsible chemicals in those samples. Crude extracts and fractions cleaned-up for dioxin analysis from the samples were used for the analysis. The ranges of dioxins in the ashes were between 2.23 and 12.29 ng TEQ/g (dry weight). Relative potency ranges estimated by EROD assay in the medical incinerator ashes were 3.8-17.6 times higher than the results of conventional chemical analysis. EOX analysis suggested that ash samples contained plenty of organochlorine compounds apart from chlorinated dioxins. In addition, medical waste incinerator ashes were considered to have relatively higher amount of organoiodine compounds. In the cleaned-up fractions, bioassay potency ranges were lower than those in the crude extracts. However, some samples still exhibited higher potency than expected from chemical analysis. Though some polycyclic aromatic hydrocarbons were found in the fractions, the amounts were relatively low (0.39-10.56 ng/g). The results imply that some bioactive organohalogens that cannot be detected in the conventional chemical analysis might have potential for dioxin-like toxicity, and contribute to higher bioassay activities. The combination of the chemical analysis with the bioassay and EOX provides rough figure of dioxin-like toxicity and suggests types of organohalogen compounds that should be identified as a part of dioxin analysis for control emission from an incineration plant.     

Detonation characteristics of ammonium nitrate and activated carbon mixtures

To better understand the detonation characteristics of ammonium nitrate (AN) and activated carbon (AC) mixtures, steel tube tests were carried out for AN/AC mixtures of various compositions and different forms of AN (powdered, prilled, phase stabilized and granular), and the detonation velocity was measured. The powdered AN/AC mixtures gave higher detonation velocities than the other AN forms. For all the AN/AC mixtures, the experimentally observed detonation velocities at each loading density were far below the theoretically predicted values calculated by the CHEETAH code based on thermohydrodynamics, exhibiting so-called non-ideal detonation. The lowest detonation velocity of powdered AN/AC mixtures was obtained as D=1.25 km/s for an AC content of 0.1 wt%. This was considered to be close to the critical condition for stable detonation.     

A2O-IFAS工艺生物膜微生物群落的演替及分布特性

在A²O-IFAS工艺中探究了不同功能分区生物膜微生物群落的演替及分布特性.利用该工艺处理实际生活污水,总无机氮去除负荷可达（0.10±0.03）kg·m^-3·d^-1,总无机氮和COD的平均去除率分别为70%和79%.高通量测序结果显示,厌氧氨氧化菌Candidatus＿Brocadia在好氧区生物膜中的相对丰度最高（0.43%）,其次是缺氧区生物膜、活性污泥和厌氧区生物膜.此外,絮体污泥与好氧区生物膜有着相似的微生物群落,该结果表明,功能区非生物因素可驱使生物膜微生物群落在缺氧区和厌氧区发生演替现象,DO、C/N比等环境因素和微生物的互作机制是驱动微生物群落分布和厌氧氨氧化菌富集的关键.本研究可为主流厌氧氨氧化菌的富集和技术应用提供重要参考.     

Job Redesign Needs for Aged Workers

The aim of this paper is to explore and present a proposal for redesigning elements of the workplace for agech workers. The method of research was to observe, record, and measure the actions of sitting workers performing assembly operations on electrical products in the Kani Plant Nagoya Works of Mitsubishi Electric Co. (Japan). The evaluation index used in the experiment was obtained by measuring time motion elements, cycle time per product, and motion velocity waves of elderly workers. Those motion characteristics were then compared to the motion characteristics of young workers. The results led to job redesign elements being identified to reduce handling factors of high difficulty for aged workers and to the necessity to consider a coefficient of correction in Method Time Measurement (MTM) according to differences in the manufactured object’s weight.     

Anthropogenic impacts on water quality of the lagoonal coast of Fongafale Islet, Funafuti Atoll, Tuvalu

Water pollution, evident by negative values of redox potential in waters, occurs at the lagoonal coast located near the densely populated area of Fongafale Islet on Funafuti Atoll, Tuvalu, Central Pacific. Sediment microbial quinone analysis revealed that these coastal sediments exhibit 2.7–10.4 times more microbial biomass, significantly different microbial community structure and low microbial diversity, when compared to an undisturbed natural coastal sediment. Thus, the pollution is chronic. By considering the total land use/coverage on the islet, the situation of septic tank installations, temporal changes in water redox potential and Escherichia coli numbers in the coastal waters and the spatial distribution of acid volatile sulfide in the sediments, we conclude that domestic wastewater is the primary source of pollution. This pollution is proposed to occur via the following mechanism: during ebb tides, domestic wastewater leaking from bottomless septic tanks and pit toilets run off into the lagoonal coast. Tide changes control the pollution load of domestic wastewater.     

Effects of tributyltin maternal and/or waterborne exposure on the embryonic development of the Manila clam, Ruditapes philippinarum

We examined the effect of tributyltin (TBT) on embryonic development of the Manila clam, Ruditapes philippinarum. In a maternal exposure test, 100 clams were exposed to TBT at measured concentrations of <0.01 (control), 0.061, 0.310, or 0.350 microg/l at 20-22 degrees C for 3 weeks, and the embryo developmental success (the ratio of normal D-larvae to all larvae) was measured. There was a significant negative correlation between embryo developmental success and TBT concentration in the female Manila clams (p < 0.001). These results indicated that TBT accumulated in the female clam decreased embryo developmental success. In a waterborne exposure test, fertilized eggs (4 h after fertilization) were exposed to TBT at measured concentrations of <0.01 (control), 0.062, 0.140, 0.320, or 0.640 microg/l for 23 h. Embryo developmental success was also significantly decreased in all TBT treatment groups compared with that in the control group. TBT accumulated in female adults and waterborne TBT clearly inhibit reproductive success of the clam.