Monitoring of Heavy Metal Pollution of Groundwater in a Phreatic Aquifer in Mersin-Turkey

In this study, heavy metal contents of groundwater from the Mersin aquifer were determined with photometric methods and used to determine the main factors controlling the pollution of groundwater in the area. Using MapInfo GIS software, spatial analysis and integration were carried out for mapping drinking water quality in the basin. From the photometric heavy metal analysis, it is inferred that the excess concentration of Fe, Ni, Mn, Mo and Cu at some locations is the cause of undesirable quality for drinking purposes. Similarly, the EC thematic map shows that considerable areas in the basin are having high salinity hazards. The reason for excess concentration of various heavy metals is the industrial activities and petroleum pipelines and salinity levels show the sea water intrusion.     

Disinfection By-Products in Water Produced by Ozonation and Chlorination

Water produced by advanced treatment of a groundwater was evaluated to determine the amount of DBPs (Disinfection By-Products) including trihalomethanes (THMs). Both Gas Chromatography (GC) and Gas Chromatography/Mass Spectrometry (GS/MS) were adopted for detection and identification of DBPs such as trihalomethanes (THMs), halo-acetic acids (HAAs) and aldehydes. Two disinfection modes (ozonation followed by chlorination and chlorination alone) were compared to determine the DBPs generation. The mutagenitic acivity of ozonated water, chlorinated water after ozonation and potable water was assessed using the Ames test. Chloroform, dichloroacetic acid (DCAA) and trichloroacetic acid (TCAA) were the main constituents of THMs and HAAs, respectively. THMs accounted for more than 85% of all DBPs measured, whereas haloacetic acids accounted for around 14%. Ozonation followed by chlorination proved to be better in terms of THMs and HAAs control. The combined system produced 28.3% less DBPs compared to chlorination alone. Ozonation was found capable of reducing mutagenic matter in the groundwater by 54.7%. The combined system also resulted in water with no mutagenicity.     

Measurement and assessment of carrying capacity of the environment in Ningbo, China

Carrying Capacity of the Environment (CCE) provides a useful measure of the sustainable development of a region. Approaches that use integrated assessment instead of measurement can lead to misinterpretation of sustainable development because of confusion between Environmental Stress (ES) indexes and CCE indexes, and the selection of over-simple linear plus models. The present paper proposes a comprehensive measurement system for CCE which comprises models of natural resources capacity, environmental assimilative capacity, ecosystem services capacity, and society supporting capacity. The corresponding measurable indexes are designed to assess CCE using a carrying capacity surplus ratio model and a vector of surplus ratio of carrying capacity model. The former aims at direct comparison of ES and CCE based on the values of basic indexes, and the latter uses a Euclidean vector to assess CCE states. The measurement and assessment approaches are applicable to Strategic Environmental Assessment (SEA) and environmental planning and management. A case study is presented for Ningbo, China, whereby all the basic indexes of ECC are measured and the CCE states assessed for 2005 and 2010.     

Electrocoagulation of palm oil mill effluent as wastewater treatment and hydrogen production using electrode aluminum

Palm oil mill effluent (POME) is highly polluting wastewater generated from the palm oil milling process. Palm oil mill effluent was used as an electrolyte without any additive or pretreatment to perform electrocoagulation (EC) using electricity (direct current) ranging from 2 to 4 volts in the presence of aluminum electrodes with a reactor volume of 20 L. The production of hydrogen gas, removal of chemical oxygen demand (COD), and turbidity as a result of electrocoagulation of POME were determined. The results show that EC can reduce the COD and turbidity of POME by 57 and 62%, respectively, in addition to the 42% hydrogen production. Hydrogen production was also helpful to remove the lighter suspended solids toward the surface. The production of Al(OH)XHO at the aluminum electrode (anode) was responsible for the flocculation-coagulation process of suspended solids followed by sedimentation under gravity. The production of hydrogen gas from POME during EC was also compared with hydrogen gas production by electrolysis of tap water at pH 4 and tap water without pH adjustment under the same conditions. The main advantage of this study is to produce hydrogen gas while treating POME with EC to reduce COD and turbidity effectively.     

Validity and reliability of a job factors questionnaire related to the work tasks of physical therapists

Physical therapists engage in work tasks that expose them to occupational risk factors related to musculoskeletal disorders. Due to the gap in the literature on instruments focused on those workers, this study adapted a job factors questionnaire to physical therapists, and assessed its psychometric properties. The questionnaire was adapted and its content validity was established. The psychometric properties were evaluated among 142 physical therapists. Reliability was verified using the temporal-stability design and internal consistency. Construct validity was assessed with the known-groups technique. Test-retest results demonstrated intraclass correlation coefficients between .82 and .90 (p < .001). Cronbach's α of .91 verified the reliability of the questionnaire. The known-groups technique demonstrated a statistically significant difference on the scores of the items when physical therapists were compared to office workers. The results indicated that the adapted questionnaire had acceptable psychometric properties for assessing problematic job factors among physical therapists working in hospitals.     

Investigation of seat belt use among the drivers of different education levels

Seat belt use habit has been investigated according to the education level of drivers. Copies of a questionnaire were distributed to 1000 participants of four different education levels. Factors such as seat belt usage habit, restricting factors and crash data have been investigated. Data have been analyzed with SPSS 15.0 software. Increased level of education leads to increased seat belt usage, lower numbers of crashes and crash severities. The factors restricting seat belt use are lack of habit, discomfort and short distance driving. The use of precaution signal and increases in comfort can increase seat belt usage. The primary and high school education on traffic safety and seat belt usage has been serving the purpose.     

Reduction of SO2 emissions by ammonia gas during unstaged combustion

The reduction of SO₂ by the addition of ammonia gas has been studied in a 2 m high fluidized bed combustor having a 30 cm static bed height and a freeboard height of 170 cm. Ammonia gas was injected at 52 cm above the distributor where the temperature is ca. 700° C by an uncooled stainless steel tube injector. Experiments were carried out to investigate the effects of amminia gas injection on sulphur dioxide emissions at unstaged conditions of: (i) excess air level, (ii) NH₃:SO₂ molar ratio, (iii) fluidizing velocity and (iv) bed height.A maximum reduction of 75% in SO₂ emissions was found at 40% excess air, at an NH₃:SO₂ molar ratio of 5.4. The onset of SO₂ reduction occurred at an NH₃:SO₂ ratio of 1.5 However, the most effective ratio was found to be between 3 and 5. Fluidizing velocity and bed height were also found to have significant influence on SO₂ reduction.It is difficult to determine how the SO₂ reduction varied with operating conditions. When ammonia is added in the main combustor zone, the temperature is much higher than that required for the occurrence of sulphur dioxide-ammonia and sulphur trioxide-ammonia reactions. However, this paper points out the significance of ammonia addition in the reduction of sulphur dioxide.     

Interspecific and intraspecific identification of Dendrobium based on the psbAtrnH intergenic region sequences and the 5S rRNA gene spacer sequences北大核心CSCD

This research aimed to investigate the interspecific and intraspecific identification of Dendrobium by using the multi-locus method so as to provide a molecular basis for Dendrobium identification through the combination of chloroplast psbA-trnH intergenic region sequences and ribosome 5S rRNA gene spacer sequences. PCR direct sequencing was applied to detect the chloroplast psbA-trnH intergenic region sequences as well as the ribosome 5S rRNA gene spacer sequences of 12 Dendrobium species, while the psbA-trnH intergenic region sequences of Dendrobium denneanum dq-2 variety and dq- 5line were cloned and sequenced for single nucleotide polymorphism (SNP) analyzing. The sequences were analyzed by the software Sequencher4.14, Bioedit7.0, MEGA5.2 and Dansp5.0; the interspecific and intraspecific Kimara-2-Parameter(K2P) distances were also calculated. The phylogenetic tree (using Neighbor joining method) was constructed with Bulbophyllum odoratissimum and Bletilla striata as outgroup. The results showed an average length of chloroplast psbA-trnH gene sequences in Dendrobium as 742.3 bp, with 72 variable sites, including 33 information sites; the average length of the ribosome 5S rRNA gene spacer sequences in Dendrobium was 336.4 bp, with 213 variable sites including 139 information sites. Using psbAtrnH intergenic region sequences in combination with ribosome 5S rRNA gene spacer sequences can not only identify D. denneanum, D. hancockil, D. thysiflorum, D. devonianum, D. moniliforme, D. chrysotoxum, D. officinale, D. heterocarpum and D. nobile, but also differentiate D. officinale from different geographical populations, and distinguish the dq-2 variety and dq 5line with SNP in the multi locus of D. denneanum.     

Effects of initial decomposing leaf litter of Cinnamomum camphora on the growth and physiology of Impatiens balsamina北大核心CSCD

A pot experiment was conducted to study the allelopathic effects of initial decomposing leaf litter of Cinnamomum camphora on growth and physiology of Impatiens balsamina. Three leaf litter treatments included 20, 40 and 80 g of C. camphora leaf litter mixed with 8 kg of soil, namely T1, T2, and T3, respectively. In order to test the effect of leaf litter addition on the permeability and ventilation of soil simultaneously, a parallel trial with steamed leaf litter was conducted with the three treatments of the leaf litter. The leaf litter was steamed for 2 d to remove the secondary metabolites as much as possible, dried, and then mixed with 8 kg of soil, namely Z1, Z2, and Z3, respectively. No leaf litter was added in control (CK). The growth parameters of I. balsamina were determined at the 20 d, 60 d, 100 d and 120 d after sowing and the main physiology indicators were determined at the 60 d. The results indicated that: (1) The ground surface diameter and height of I. balsamina were inhibited significantly at 60 d (P < 0.05). Photosynthetic pigments and gas exchange parameters of I. balsamina were inhibited significantly at 60 d, and the inhibition effect was stronger with increased amount of leaf litter addition. The chlorophyll content, Pn and Ls decreased significantly with increased amount of leaf litter (P < 0.05). The activity of superoxide dismutase (SOD) and peroxidase (POD) in leaves of I. balsamina decreased with the increase of leaf litter addition. The content of MDA in treatments T1, T2 and T3 were all higher than that in CK, which indicated that I. balsamina suffered oxidative damage in a certain degree. The content of free proline (Pro) and soluble sugar (SS) in leaves of I. balsamina decreased significantly with the increase of the leaf litter (P < 0.05), while the content of soluble protein (SP) increased. (2) In the parallel trial, 60 d after sowing, no obvious difference was observed between CK and any steamed leaf litter treatment in terms of the morphological and physiological features stated above (P > 0.05). It indicated that the soil physical properties were not greatly influenced by leaf litter addition in the dose interval designed, or that the release of secondary metabolites from decomposing leaf litter was probably a better reason to explain the inhibition of leaf litter treatment to I. balsamina growth. (3)The compound effect (CE) of leaf litter decomposition on I. balsamina was enhanced with increase of the leaf litter, to 0.169, 0.354, and 0.497, respectively, in treatments of T1, T2 and T3. The study indicated that initial decomposition of C. camphora leaf litter in soil reduces the content of photosynthetic pigments, inhibits photosynthetic capacity and resistance physiology of I. balsamina, weakens its adaptability to the environment, and restrains growth of the plant. © 2015, Science Press. All rights reserved.