Inter-Laboratory Comparison of Air Particulate Monitoring Data

ABSTRACT

This paper compares three analytical methods that are often used to analyze composition of atmospheric aerosol: Ion Chromatography (IC), Proton Induced X-ray Emission (PIXE), and X-Ray Fluorescence (XRF). Three monitoring studies are discussed: (1) a comparison of air particulate data collected by several independent sampler/ analytical technique suites run by different laboratories; (2) a study involving two identical samplers and a single suite of analytical techniques; and (3) analysis of identical aerosol samples by two different techniques (XRF vs. PIXE). While the XRF versus PIXE project shows a very good agreement for most elements, the first interlaboratory study demonstrates the “real-life” noise introduced into the final data set by various sampling complications and different collection characteristics of the samplers used. The XRF versus PIXE study also revealed an unexplained deviation in measured sulphur concentrations for very lightly loaded samples. In the five-sampler comparison, two data sets provided by IC were approximately 20% lower than the three data sets obtained by PIXE and XRF. When two identical IMPROVE-compat-ible samplers were used and samples were subjected to similar procedures and the same analytical techniques, the variability between the two air concentration data sets significantly decreased.     

Biodegradation of the herbicide glyphosate by filamentous fungi in platform shaker and batch bioreactor

The biodegradation conducted by microorganisms on herbicide glyphosate (N-phosphonomethylglycine) was investigated. Five strains of filamentous fungi belonging to the Fusarium genre were grown on Czapeck medium without phosphorous and supplemented with the addition of glyphosate. The assays were conducted to determine the ability of use as a phosphorous source, the inhibition caused by presence of herbicide, and the biodegradation in shaker and bioreactor by Fusarium strains. It was observed that the herbicide did not show any negative effect on microrganisms by quantity of the biomass. Among the strains tested, no inhibition was noted by the addition of glyphosate even at a high concentration. All strains studied were able to biodegrade it and use the herbicide as a phosphorous source. The formation of consortium was not better than the strains tested in pure culture. The biodegradation in the bioreactor was better than in the shaker. However, there wasn't any influence on biodegradation rate by changing the amount of oxygen in the system.     

Use of fungi for the bioconversion of rice straw into cellulase enzyme

Cellulase production was carried out by solid state bioconversion (SSB) method using rice straw, a lignocellulosic material and agricultural waste, as the substrate of three Trichoderma spp. and Phanerochaete chrysosporium in lab-scale experiments. The results were compared to select the best fungi among them for the production of cellulase. Phanerochaete chrysosporium was found to be the best among these species of fungi, which produced the highest cellulase enzyme of 1.43 IU/mL of filter paper activity (FPase) and 2.40 IU/mL of carboxymethylcellulose activity (CMCase). The “glucosamine” and “reducing sugar” parameters were observed to evaluate the growth and substrate utilization in the experiments. In the case of Phanerochaete Chrysosporium, the highest glucosamine concentration was 1.60 g/L and a high concentration of the release of reducing sugar was measured as 2.58 g/L obtained on the 4th day of fermentation. The pH values were also recorded. The range of the pH was about 5.15 to 5.56 in the case of Phanerochaete Chrysosporium.     

Residue determination and dissipation of ioxynil octanoate in maize and soil

A simple and efficient residue analysis method for direct determination of ioxynil octanoate in maize and soil was developed and validated with High Performance Liquid Chromatography-Ultra Violet (HPLC-UV). The samples were extracted with mixtures of acetonitrile and deionized water followed by Solid Phase Extraction (SPE) to remove co-extractives prior to analysis by HPLC-UV. The recoveries of ioxynil octanoate extracted from maize and soil samples ranged from 86 %–104 % and 84 %–96 %, respectively, with relative standard deviation (RSD) less than 7.84% and sensitivity of 0.01 mg kg^?1. The method was applied to determine the residue of ioxynil octanoate in maize and soil samples from experimental field. Data had shown that the dissipation rate in soil was described as pseudo-first-order kinetics and the half-life (t_1/2) was less than 1.78 days. No ioxynil octanoate residue (<0.01 mg kg^?1) was detected in maize at harvest time withholding period of 60 days after treatments of the pesticide. Direct confirmation of the analytes in field trial samples was realized by Liquid Chromatography-Mass Spectrometry (LC-MS).     

Mitigation of nutrient losses via surface runoff from rice cropping systems with alternate wetting and drying irrigation and site-specific nutrient management practices

Resource-conserving irrigation and fertilizer management practices have been developed for rice systems which may help address water quality concerns by reducing N and P losses via surface runoff. Field experiments under three treatments, i.e., farmers’ conventional practice (FCP), alternate wetting and drying (AWD), and AWD integrated with site-specific nutrient management (AWD + SSNM) were carried out during two rice seasons at two sites in the southwest Yangtze River delta region. Across site years, results indicated that under AWD irrigation (i.e., AWD and AWD + SSNM), water inputs were reduced by 13.4?~?27.5 % and surface runoff was reduced by 30.2?~?36.7 % compared to FCP. When AWD was implemented alone, total N and P loss masses via surface runoff were reduced by 23.3?~?30.4 % and 26.9?~?31.7 %, respectively, compared to FCP. However, nutrient concentrations of surface runoff did not decrease under AWD alone. Under AWD + SSNM, total N and P loss masses via surface runoff were reduced to a greater extent than AWD alone (39.4?~?47.6 % and 46.1?~?48.3 % compared to FCP, respectively), while fertilizer inputs and N surpluses significantly decreased and rice grain yields increased relative to FCP. Therefore, by more closely matching nutrient supply with crop demand and reducing both surface runoff and nutrient concentrations of surface runoff, our results demonstrate that integration of AWD and SSNM practices can mitigate N and P losses via surface runoff from rice fields while maintaining high yields.     

Oil spill cleanup using graphene

In this article, we study the use of thermally reduced graphene (TRG) for oil spill cleanup. TRG was synthesized by thermal exfoliation of graphite oxide and characterized by X-ray diffusion, Raman spectroscopy, SEM, TEM, elemental analysis, and Brunauer–Emmett–Teller (BET) surface area measurement. Various aspects of the sorption process have been studied including the sorption capacity, the recovery of the adsorbed oil, and the recyclability of TRG. Our results shows that TRG has a higher sorption capacity than any other carbon-based sorbents, with sorption capacity as high as 131 g of oil per gram TRG. With recovery of the sorbed oil via filtration and reuse of TRG for up to six cycles, 1 g of TRG collectively removes approximately 300 g of crude oil. Moreover, the effects of TRG bulk density, pore volume, and carbon/oxygen ratio and the oil viscosity on the sorption process are also discussed.     

Organochlorine pesticides and polychlorinated biphenyls in soils surrounding the Tanggu Chemical Industrial District of Tianjin, China

The spatial distribution of persistent organic pollutants (POPs) was examined in soils surrounding the Tanggu Chemical Industrial District in Tianjin, China. The concentrations of hexachlorocyclohexanes (HCHs), dichlorodiphenyltrichloroethanes (DDTs), hexachlorobenzenes (HCBs), and polychlorinated biphenyls (PCBs) were determined in 70 surface soils using accelerated solvent extraction and gas chromatography with electron capture detection. The results showed that the ranges of ∑HCH, ∑DDT, ΣHCB, and ∑PCB concentrations in soils were 2.1–12,549 μg?kg^?1 (average, 965 μg?kg^?1), n.d.–2,033 μg?kg^?1 (average, 88.4 μg?kg^?1), n.d.–1,924 μg?kg^?1 (average, 349 μg?kg^?1), and n.d.–373 μg?kg^?1 (average, 46.2 μg?kg^?1), respectively. Of these, HCHs were the dominant POPs, accounting for 75 % of the total organochlorine pesticide (OCP) residues. Overall, the spatial distribution of OCP concentrations showed a decreasing trend from the center of the Tanggu District to the surrounding areas. Two major pollution sources were Tianjin Dagu Chemical Co., Ltd. in the district center and the Tianjin Chemical Plant in Hangu District. In contrast, PCB concentrations were relatively high in the Haihe estuary to the east and low to the west of the study area. Component analysis of OCPs in these soils showed that they mainly came from industrial point sources. Compared with soils in other regions, soil DDT pollution was at a medium level in the Tanggu Chemical Industrial District, but associated HCH, HCB, and PCB pollution was relatively heavy. By multivariate statistical analyses, Tianjin Dagu Chemical Co., Ltd. was recognized as the main source of POPs, and soil properties were clarified to play an important role on the distribution and composition of POPs, especially the organic carbon content.     

Transition metal-modified zinc oxides for UV and visible light photocatalysis

In order to use photocatalysis with solar light, finding more active and especially visible light active photocatalysts is a very important challenge. Also, studies of these photocatalysts should employ a standardized test procedure so that their results can be accurately compared and evaluated with one another. A systematic study of transition metal-modified zinc oxide was conducted to determine whether they are suitable as visible light photocatalysts. The photocatalytic activity of ZnO modified with eight different transition metals (Cu, Co, Fe, Mn, Ni, Ru, Ti, Zr) in three different concentrations (0.01, 0.1, and 1?at.%) was investigated under irradiation with UV as well as with visible light. The employed activity test is the gas-phase degradation of acetaldehyde as described by the ISO standard 22197-2. The results suggest that the UV activity can be improved with almost any modification element and that there exists an optimal modification ratio at about 0.1?at.%. Additionally, Mn- and Ru-modified ZnO display visible light activity. Especially the Ru-modified ZnO is highly active and surpasses the visible light activity of all studied titania standards. These findings suggest that modified zinc oxides may be a viable alternative to titanium dioxide-based catalysts for visible light photocatalysis. Eventually, possible underlying mechanisms are proposed and discussed.     

Nitrogen concentrations in mosses indicate the spatial distribution of atmospheric nitrogen deposition in Europe

In 2005/6, nearly 3000 moss samples from (semi-)natural location across 16 European countries were collected for nitrogen analysis. The lowest total nitrogen concentrations in mosses (<0.8%) were observed in northern Finland and northern UK. The highest concentrations (≥1.6%) were found in parts of Belgium, France, Germany, Slovakia, Slovenia and Bulgaria. The asymptotic relationship between the nitrogen concentrations in mosses and EMEP modelled nitrogen deposition (averaged per 50 km × 50 km grid) across Europe showed less scatter when there were at least five moss sampling sites per grid. Factors potentially contributing to the scatter are discussed. In Switzerland, a strong (r² = 0.91) linear relationship was found between the total nitrogen concentration in mosses and measured site-specific bulk nitrogen deposition rates. The total nitrogen concentrations in mosses complement deposition measurements, helping to identify areas in Europe at risk from high nitrogen deposition at a high spatial resolution.