Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

On the Relation Between the Indoor and Outdoor Concentrations of Nitrogen Oxides

Simultaneous measurements were made of the concentrations of NO, NO₂, and CO inside and outside of a building. The building is located in the Los Angeles area, which is heavily polluted by photochemical smog, and the experiments were conducted at a time of the year when the pollutants in question tend to be high. The results shows that there is a direct relationship between the inside and outside concentrations, and that the phase lag between the concentrations depends principally on the ratio of the building volume to the ventilation rate. Although the outside concentrations of the pollutants in question did not follow the same pattern every day, peak concentrations seemed to be related to “rush-hour” traffic. By reducing ventilation rates during these periods, it may be possible to reduce the concentration peaks inside of the building. The building involved in the current study was not located in the immediate vicinity of heavy traffic, and the indoor concentrations of NO, NO₂, and CO did not appear to be very severe when compared to those defined by present air quality standards. Finally, the results support the belief that NO and O₃ do not co-exist indoors except in very small quantities.     

Performance of Wet Scrubbers on Liquid and Solid Particulate Matter

A general discussion of packed scrubbers for particle collection is presented. Data on liquid entrainment separation, ammonium chloride fume collection, and clay particle collection are given.     

Emissions from Slash Burning and the Influence of Flame Retardant Chemicals

Pollutants sampled during the burning of 30 lb ponderosa pine fuel beds yielded emission factors for CO, hydrocarbon gases, and par-ticulate matter of 146, 8.4, and 9.1 lb/ton of fuel, respectively. When similar beds were treated with diammonium phosphate flame retardant, these factors increased to 166, 11.7, and 19.3 lb/ton of fuel, respectively.

Gas chromatographic analysis of hydrocarbon gases showed that 15-40% of this material was composed of methane and eth-ylene. Ethane and acetylene were the next most abundant materials, with photochemically important materials constituting minor portions of this gaseous component. Fuel beds treated with flame retardant produced more oiefins, and this production lasted throughout the smoldering phase of burning.

These tests showed that the smoldering phase of combustion is of major importance to air pollutant production during slash burning. The initial 80% of the fuel burned accounted for only 20-30% of HC and CO emissions. This suggests that a rapid mop-up of slash burns could substantially reduce air pollutant production.     

Stack Sampling of Hygroscopic Particulates In an Entrained Water Environment

Reference methods for the determination of mercury emissions from stationary sources typically include collection of mercury by solutions which are acidic and oxidizing. In the presence of high levels of SO₂ the oxidizing capacity of these absorbing solutions will be degraded and the collection efficiency for mercury compromised. This seriously limits the usefulness of the reference methods as they apply to the mining and smelting industries. In the present work peroxide is used to remove SO₂ and acidic permanganate is used to collect mercury. At a mean sampling rate of 10 L/min concentrations of at least 12 mg/m³ mercury can be satisfactorily collected in the presence of up to 20,000 ppm SO₂.     

interpretation of air quality data with respect to the national ambient air quality standards

San Diego Gas &; Electric has developed a quality assurance program for continuous emission monitors (CEM). Extractive, rather than in situ, monitors were selected as a result of an in-house evaluation program. Two extractive systems have been certified and a good operating and maintenance record has been established on these systems. A successful program requires the involvement and support of all affected personnel. It is desirable to have one or two key personnel coordinate the development of the program. It is also highly desirable to have good in-house source testing capabilities.     

Infrared Photography as an Air Pollution Surveillance Instrument

Remote sensing is an extremely new science which developed from World War II technology. At that time, infrared sensitive film (false color) was used to detect such things as troop movements and camouflaged war materials. In essence, the film displayed a color contrast between the artificial and organic vegetation.     

Objective Evaluation of Emergency Plans for Oxidant Control

Emergency plans for oxidant controls provide the basis for taking preventive action to protect public health. Historic oxidant data (1970 to Sept. 1974) from the South Coast Air Basin (SCAB), were evaluated to assess episode characteristics in an area where emergency strategies are most likely to be enforced. These findings, together with an objective study of a test case episode (June 1974) using a photochemical air quality simulation model, suggest that the currently conceived emergency plans for oxidant control are unlikely to be effective. It is concluded that, because of the chemical and mefeorofogfcal complexities of the episodes, they are extremely difficult both to predict and concurrently to control over their short-lived duration.     

A comparison of techniques to sample salamander assemblages along highland streams of Maryland

Amphibians may be useful indicators of biological condition in small streams so determining which sampling technique maximizes encounters at the least cost and at the optimal time of year is important. Area constrained surveys (ACS), used by the Maryland Biological Stream Survey, were tested against cover board surveys, drift fences with pitfall and funnel traps, quadrat leaf litter searches, and leaf litter bags. Sixteen, 100 m-long sites were established in headwater streams in the Savage River State Forest in Garrett County, Maryland. Each technique was randomly assigned to a 25 m stream section within each overall sampling site, and sites were sampled once each month from May to October (2005) with additional sampling in March and April (2006). Area constrained surveys yielded means of 2.7 taxa and 14.9 total individuals per sampling visit, which was significantly higher than the yield of all other methods in all months except October and March, when yields were low for all techniques. Area constrained surveys were also significantly more cost-effective per taxon and per individual compared to all other methods. September produced the most taxa and individuals, October and March produced the least, and yields for April through August were similar to September. We employed removal sampling at four sites in April 2006, but abundance could not be estimated because a significant linear decrease in the accumulated catch versus catch per unit effort did not occur for three of the sites.