Catalytic hydrolysis of urea from wastewater using different aluminas by a fixed bed reactor

In order to find an effective method for treating urea wastewater, the experiments on the hydrolysis of urea in wastewater were conducted in a fixed bed reactor with different aluminas (α-Al₂O₃, γ-Al₂O₃, and η-Al₂O₃) as catalysts respectively in contrast with inert ceramic particle. The results indicate that the three alumina catalysts show obvious catalytic activity for urea hydrolysis at 125 °C. The order of activity is η-Al₂O₃?>?γ-Al₂O₃?>?α-Al₂O₃, and the activity difference increases with increasing temperature. According to the characterization results, surface acidity has little impact on the activity of catalyst. However, it was found that surface basicity of alumina catalyst plays an important role in catalytic hydrolysis of urea, and the activity of catalyst may be also influenced by the basic strength. With η-Al₂O₃ as catalyst, the urea concentration in wastewater is reduced to 4.96 mg/L at a temperature of 165 °C. Moreover, the η-Al₂O₃ shows a good stability for urea hydrolysis. The hydrolysis of urea over η-Al₂O₃ catalyst can evidently reduce the reaction temperature and is promising to replace industrial thermal hydrolysis process.     

Behavior and mechanism of arsenate adsorption on activated natural siderite: evidences from FTIR and XANES analysis

Activated natural siderite (ANS) was used to investigate its characteristics and mechanisms of As(V) adsorption from aqueous solution. Batch tests were carried out to determine effects of contact time, initial As(V) concentration, temperature, pH, background electrolyte, and coexisting anions on As(V) adsorption. Arsenic(V) adsorption on ANS well-fitted pseudo-second-order kinetics. ANS showed a high-adsorption capacity of 2.19 mg/g estimated from Langmuir isotherm at 25 °C. Thermodynamic studies indicated that As(V) adsorption on ANS was spontaneous, favorable, and endothermic. ANS adsorbed As(V) efficiently in a relatively wide pH range between 2.0 and 10.0, although the removal efficiency was slightly higher in acidic conditions than that in basic conditions. Effects of background electrolyte and coexisting anions were not significant within the concentration ranges observed in high As groundwater. Results of XRD and Fe K-edge XANES analysis suggested ANS acted as an Fe(II)/(III) hybrid system, which was quite effective in adsorbing As from aqueous solution. There was no As redox transformation during adsorption, although Fe(II) oxidation occurred in the system. Two infrared bands at 787 and 872 cm^?1 after As(V) adsorption suggested that As(V) should be predominantly adsorbed on ANS via inner-sphere bidendate binuclear surface complexes.     

假单胞菌好氧降解四溴双酚A的特性

为了解四溴双酚A(TBBPA)的好氧降解特性,采用选择富集法从活性污泥中分离出一株能够高效降解四溴双酚A的菌株。根据其形态、生理生化特性及16S rDNA核苷酸序列分析,该菌株被鉴定为假单胞菌属(Pseudomonas sp.)。研究结果表明,该菌株可通过好氧共代谢方式实现四溴双酚A的降解,葡萄糖是四溴双酚A降解的最佳碳源,其最优降解条件为葡萄糖8 g/L,牛肉膏0.5 g/L,pH值为7.0,培养温度为35℃,摇床转速为150 r/min。在该条件下其生物降解过程符合一级动力学模型,6 d后的降解率高达95.6%。LC-MS结果表明,四溴双酚A在好氧降解过程中会生成异丙苯酚类物质。     

渗滤液耦合矿化垃圾制备甲烷氧化菌菌液

利用甲烷氧化菌菌液增加材料中甲烷氧化菌的数量,可以得到高甲烷氧化率的填埋场甲烷生物氧化覆盖材料。研究发现,渗滤液原水和渗滤液处理尾水均能促进甲烷氧化菌的生长,可利用渗滤液耦合矿化垃圾混合培养制备甲烷氧化菌菌液用于填埋场甲烷减排。填埋龄长的渗滤液原水有着较好的培养效果,得到的菌液在4 d内最高甲烷氧化速率达到2.68 mL/h,超过甲烷氧化菌培养液(nitrate minimal salt medium,NMS)的实验结果。渗滤液中总氮、无机碳、总有机碳和Ni元素的含量对甲烷氧化菌的培养过程影响较大,适用于甲烷氧化培养的渗滤液应满足:总氮1 400 mg/L,总有机碳55 mg/L,Ni元素0.4 mg/L,总磷含量较高。     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。     

微波活化过硫酸钾深度处理印染废水

为了深度处理印染废水生化出水,使其达到工业回用要求,利用微波活化过硫酸钾产生具有强氧化性的硫酸根自由基·SO-4,降解印染废水生化出水中的有机污染物。考察了硫酸亚铁的投加量,过硫酸钾的浓度及pH的影响,并通过对比实验讨论了微波活化作用效果。结果表明,过硫酸钾微波组合能够有效地去除生化出水中的TOC和色度。对于某印染废水生化出水,处理效果在pH=10时最好,当过硫酸钾浓度为14 g/L时,TOC去除率达57.60%,脱色率为98.28%。研究结果表明,过硫酸钾微波组合对于印染废水的深度处理效果良好,有较好的应用前景。     

5种植物材料的水解释碳性能及反硝化效率

碳源在硝酸盐去除过程中起电子供体的作用,是生物反硝化反应的关键物质之一。为解决污水处理脱氮时碳源不足抑制反硝化反应造成脱氮效率低的问题,本研究选取风车草、甘蔗渣、芦竹、美人蕉和稻草秆5种植物材料作为反硝化碳源,探讨不同植物材料的水解释碳能力和释放规律;并进一步以其水解液作为外加碳源,探讨其对反硝化脱氮效率的影响。研究结果表明,植物材料水解释碳过程符合二级动力学反应规律,不同植物材料的释碳能力具有显著性差异,以甘蔗渣在固液比1∶80时COD释放当量最大,为45.45 mg/L;添加植物水解液可显著提高反硝化脱氮效率,以芦竹水解液脱氮效果最好,达到71.9%。此外,碳氮比是影响脱氮效率的重要因素之一,以碳氮比为9时反硝化脱氮效果最佳。     

Enhanced degradation of ortho-nitrochlorobenzene by the combined system of zero-valent iron reduction and persulfate oxidation in soils

ortho-Nitrochlorobenzene (o-NCB) in soil poses significant health risks to human because of its persistence and high toxicity. The removal of o-NCB by both zero-valent iron (ZVI) and chemical oxidation (persulfate) was investigated by batch experiments. The o-NCB removal rate increases significantly from 15.1 to 97.3 % with an increase of iron dosage from 0.1 to 1.0 mmol g^?1. The o-NCB removal rate increases with the decrease of the initial solution pH, and a removal efficiency of 90.3 % is obtained at an initial pH value of 6.8 in this combined system. It is found that temperature and soil moisture could also increase the o-NCB removal rate. The o-NCB degradation rate increases from 83.9 to 96.2 % and from 41.5 to 82.4 % with an increase of temperature (15 to 35 °C) and soil moisture (0.25 to 1.50 mL g^?1), respectively. Compared to the persulfate oxidation system and ZVI system, the persulfate–iron system shows high o-NCB removal capacity. o-NCB removal rates of 41.5 and 62.4 % are obtained in both the persulfate oxidation system and the ZVI system, while the removal rate of o-NCB is 90.3 % in the persulfate–iron system.     

Effects of cadmium on the photosynthetic activity in mature and young leaves of soybean plants

Cadmium (Cd) is a widely spread pollutant and can be easily taken up by crop from soil, resulting in a serious health issue for humans. The objective of this study was to comparatively investigate the photosynthetic activity, chlorophyll a fluorescence, chlorophyll contents, and spectral reflectance in mature and young leaves of soybean plants after being treated with different concentrations of Cd for 10 days. The photosynthetic rate, chlorophyll contents, actual photochemical efficiency of PSII, and photochemical quenching in the young leaves decreased more significantly with increasing concentrations of Cd in the nutrient solution, compared with those in the mature leaves, though the young leaves had less Cd concentrations. Thus, there was more excessive excited energy produced in the young leaves than that in the mature leaves. In the young leaves, due to more excessive excited energy, more reactive oxygen species may be generated, which further damaged the photosynthetic apparatus. It was supported by the fact that the decrease of reflectance in near-infrared wavelengths of the young leaves was more noticeable than that of the mature leaves. In addition, the chlorophyll a fluorescence transients of the young leaves was significantly different from that in the mature leaves, indicating that the electron transport of young leaves were inhibited much more severely than that of the mature leaves. These observations imply that the responses of photosynthetic activity of soybean leaves to Cd stress depend on their growth stage, and the Cd-induced inhibition of photosynthetic activity might be attributed to the decrease in chlorophyll contents and the decrease in mesophyll CO₂ assimilation ability cause by the Cd, which further decreased the consumption of ATP and NADPH, leading to accumulation of NADPH on the acceptor sides of the PSI, and then feedback inhibited electron transport in chloroplasts.     

活性炭纤维负载TiO2催化剂的制备及其电催化性能

采用溶胶-凝胶法制备了活性炭纤维负载TiO₂催化剂（TiO₂/ACF）,并通过SEM和XRD等手段对TiO₂/ACF进行了表征。以邻苯二甲酸二甲酯（DMP）为目标降解物,考察了催化材料的电催化活性。实验结果表明：在反应温度为25 ℃、初始DMP质量浓度为100.0 mg/L、电解质Na₂SO₄质量浓度为100 mg/L、电流密度为62.5 mA/cm²、电极板间距为4 cm的条件下,经过40 min的降解,DMP质量浓度为1.8 mg/L,DMP去除率为98.2%;TiO₂/ACF在反应过程中可以原位再生,经6次重复使用后仍保持很高的催化活性,对DMP的去除率仍达90%以上。