高锰酸钾预氧化-缺氧/好氧生物铁法处理乙酰嘧啶废水工艺研究

采用高锰酸钾预氧化-缺氧/好氧生物铁法处理维生素B1厂乙酰嘧啶生产段实际废水,实验结果表明该组合工艺对嘧啶生产废水具有良好的处理效果:预氧化将嘧啶废水中大分子难降解乙酰嘧啶几乎全部转化为具有饱和碳氢键的小分子有机物,使乙酰嘧啶去除率达90%以上,且COD去除率在40%以上,BOD5/COD由0.17~0.23提高至0.35~0.44。通过与后续A/O生物铁工艺相结合,使COD、TN和氨氮总去除率分别达到93.3%、81.7%和78.6%,出水pH为6.6~7.5。     

剩余污泥减量化工艺条件优化研究

运用超声处理连续流活性污泥系统中不同种类的污泥,并将其回流至原系统中,研究其剩余污泥减量化效果。按正交实验设计并进行试验,确定最优工艺条件。结果表明:当声能密度为0.6 W/mL,作用时间为5 min,超声污泥为混合污泥,回流比为7∶120时,减量效果最佳。且在该条件下经一周期的运行,污泥减量效果达到96.24%,COD由进水的830 mg/L降至44 mg/L,NH4+-N和TN分别由进水的62.43 mg/L和103.19 mg/L,降解到2.31 mg/L和6.52 mg/L,达到《城镇污水处理厂污染物排放标准》(GB18918-2002)一级排放标准。     

丁酸胁迫对产氢污泥以厨余为底物的产氢影响

采用丁酸对产氢污泥进行胁迫处理,经胁迫后的污泥接种厨余垃圾进行产氢实验,考察丁酸胁迫对提高产氢性能的影响。结果表明,低浓度胁迫能提高产氢污泥的耐丁酸性,从而提高产氢量,而胁迫浓度过高则抑制产氢污泥活性,胁迫浓度呈"horm esis"效应。实验采用的4 g/L胁迫浓度为最佳,反应结束后,丁酸浓度和产氢量分别为8 417.1 mg/L和63.72 mL/g VS,比空白提高了31.3%和114%。产氢过程中SCOD的主要来源是有机酸。对产氢污泥胞外多聚物(EPS)的测定表明,厨余垃圾酸化速率、氢气产生速率和EPS总量成正相关。     

好氧活性污泥中自养硝化细菌分离方法研究

分别采用琼脂平板、琼脂糖平板、水洗洋菜平板和硅胶平板分离培养城市污水处理厂好氧活性污泥中的硝化细菌。在相同的培养条件下,琼脂平板和水洗洋菜平板有杂菌生长;硅胶平板制作过程繁琐,培养后期出现失水性干裂;琼脂糖平板没有杂菌生长。通过对分离菌株的表观形态观察和NorB基因检测鉴定分离菌株,证明琼脂糖分离出了目的菌株,适合生长周期长的自养硝化细菌分离培养。     

生物强化处理石油污染土壤理化性质和微生物学特性的纵向分布特征

采用原位强化生物修复技术对某区块石油污染土壤进行为期16个月的生物修复,考察了处置后污染土壤理化性质、微生物学特性以及石油烃组成的纵向分布特征。实验结果表明,经过修复后各土层的石油烃去除率是表层土IN-3(50.42%)中层土IN-2(23.54%)底层土IN-1(10.51%);IN-1处于缺氧环境,存在硫酸盐还原和反硝化作用,使得土壤pH值从7.86±0.03降低至7.27±0.03,土壤总氮从2.53±0.13 g/kg降低至0.77±0.04 g/kg;厌氧菌的种群数量是IN-1(10.43±0.71×104CFU/g)IN-3(6.74±0.39×104CFU/g)IN-2(5.15±0.42×104CFU/g),放线菌数量与石油烃含量显著负相关(r=-0.989,p=0.0110.05);IN-3对饱和份和芳香份的降解率最高,分别达到了70.27%和54.52%,远高于IN-2和IN-1;模拟蒸馏结果表明,IN-3正构烷烃得到了很大程度的去除,缺氧的IN-1对正构烷烃去除得较少;厌氧菌数量与胶质和沥青质去除率之间成正相关关系,对于污染源较为分散的污染区域,采用原位生物强化修复时可以考虑引入厌氧修复。     

污泥静态好氧发酵中堆体板结与通风的研究

为研究污泥静态好氧发酵中板结对强制通风和发酵进程的影响,降低通风能耗,基于理论研究确定了压降为强制通风风量的决定性因素,并通过实验获取不同发酵阶段和强制通风条件下的堆体通风量和抗剪强度数据,分析堆体内板结的形成规律,通过计算验证板结的形成和消失对通风的影响,提出了需要改善通风的时间节点;然后基于风机的变频控制研究了风机功率变化对强制通风的影响。提出的通风解决方案采用阶段变频通风,实现了堆体温度和通风风量的有效控制。     

湿式纤维层非稳态过滤净化阻力的研究

在干式纤维层过滤净化阻力的理论基础上,提出清洗水均匀分布于纤维丝表面的基本假设,使湿式过滤中对液滴、液膜、液珠的分析简单具体化。并通过实验结论归纳出净化阻力随时间的变化规律,导出湿式纤维层非稳态过滤净化阻力的表达式,并用实验验证了其准确性。     

聚合物驱采出水中聚丙烯酰胺的微生物联合降解作用研究

通过对2株细菌的培养降解实验研究聚丙烯酰胺(hydrolyzed polyacrylamide,HPAM)降解菌对水环境下聚丙烯酰胺的降解作用,讨论协同降解机理。2株降解聚丙烯酰胺的菌株假单胞菌CJ419、枯草芽孢杆菌FA16在初始30℃废水样品上培养,定期测量细菌生物量和HPAM降解率。培养30 d后CJ419和FA16对聚合物的降解率最大值分别达到30.4%和25%,而以1∶1比例的混合菌降解率最大值达到80.3%。对2株菌胞外各组分研究表明:混合菌降解HPAM的机理主要由胞外降解酶系水解聚合物侧链基团导致HPAM降解为小分子物质,同时生长过程中降解菌还会释放非蛋白还原性物质引发氧化反应共同参与HPAM降解。     

Pb and Cd binding to natural freshwater biofilms developed at different pH: the important role of culture pH

The effects of solution pH on adsorption of trace metals to different types of natural aquatic solid materials have been studied extensively, but few studies have been carried out to investigate the effect of pH at which the solid materials were formed on the adsorption. The purpose of present study is to examine this effect of culture pH on metal adsorption to natural freshwater biofilms. The adsorption of Pb and Cd to biofilms which were developed at different culture pH values (ranging from 6.5 to 9.0) was measured at the same adsorption pH value (6.5). The culture pH had considerable effects on both composition and metal adsorption ability of the biofilms. Higher culture pH usually promoted the accumulation of organic material and Fe oxides in the biofilms. The culture pH also affected the quantity and species of algae in the biofilms. The adsorption of Pb and Cd to the biofilms generally increased with the increase of culture pH. This increase was minor at lower pH range and significant at higher pH range and was more remarkable for Cd adsorption than for Pb adsorption. The notable contribution of organic material to the adsorption at higher culture pH values was also observed. The profound impacts of culture pH on adsorption behavior of biofilms mainly resulted from the variation of total contents of the biofilm components and were also affected by the alteration of composition and properties of the components.     

Contamination status of dioxins in sediment cores from the Three Gorges Dam area, China

In order to screen dioxin pollution in sediment of Three Gorges Dam (TGD) area, three sediment cores were obtained from two sites in 2010~2011; each core was divided into different samples with every 10 cm depth. Sediment dating determined by radiometry (¹³⁷Cs, ²¹⁰Pb) and concentrations of dioxins were analyzed by high-resolution gas chromatography/mass spectrometry. The results indicated: Sediment dating showed no significant difference among all the samples from the same core and the two locations (ANOVA, p?>?0.05). The total amount of polychlorinated dibenzo-p-dioxins (PCDD)/Fs in all sample ranged from 30.7 to 371 pg/g dry weight (d.w.), with the mean value of 66.2 pg/g d.w. PCDDs occupied 60.33~85.22 % of dioxins in each sample, and PCDFs contributed to a very small extend. There was no significant difference in the dioxin concentration between 2010 and 2011 and in the two locations (t test, p?>?0.05), but the vertical distribution of dioxins showed significant different in different depths. Toxic equivalent (TEQ) (WHO 2005, Humans) of samples ranged from 0.15 to 1.60 pg/g d.w.; the mean was 0.41 pg/g d.w. No significant difference was found in TEQ between 2010 and 2011(t test, p?>?0.05). It could be concluded that the distribution of dioxins showed the spatial heterogeneous which resulted from the strong mixing and sediment deposition characteristics. Dioxin concentration in sediment cores was low with very low environmental risk potential. Dioxins at the two sites had the same origin, and exogenous input was the main source. It is the first report on the dioxins concentrations in sediment cores in the TGD area.