Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

天津市纪庄子污水处理厂恶臭气体排放研究

2011年,在天津市纪庄子污水处理厂内采集空气样品,并对其中恶臭气体的浓度、扩散模式、影响范围及污水厂内各主要构筑物间相关系数进行了分析研究。结果表明,污水处理厂格栅处恶臭气体浓度最高,为4.31 ng/mL,其中95.61%为H2S气体,其他构筑物恶臭气体浓度范围为0.09～0.32 ng/mL,恶臭气体浓度较前处理工艺相比有大幅度减少;各主要构筑物排放的恶臭气体符合高斯气体扩散模式,恶臭影响范围为厂界外100 m以内;格栅处恶臭气体的排放对于厂界处恶臭气体浓度的贡献度最大,为42.68%;格栅、初沉池、脱水机房、二沉池之间的相关度在90%以上。     

Removal of heavy metal ions from aqueous solution using red loess as an adsorbent

The adsorption behaviors of heavy metals onto novel low-cost adsorbent, red loess, were investigated. Red loess was characterized by X-ray diffraction, scanning electron microscopy and Fourier transform infrared spectra. The results indicated that red loess mainly consisted of silicate, ferric and aluminum oxides. Solution pH, adsorbent dosage, initial metal concentration, contact time and temperature significantly influenced the efficiency of heavy metals removal. The adsorption reached equilibrium at 4 hr, and the experimental equilibrium data were fitted to Langmuir monolayer adsorption model. The adsorption of Cu(II) and Zn(II) onto red loess was endothermic, while the adsorption of Pb(II) was exothermic. The maximum adsorption capacities of red loess for Pb(II), Cu(II) and Zn(II) were estimated to be 113.6, 34.2 and 17.5 mg/g, respectively at 25°C and pH 6. The maximum removal efficiencies were 100% for Pb(II) at pH 7, 100% for Cu(II) at pH 8, and 80% for Zn(II) at pH 8. The used adsorbents were readily regenerated using dilute HC1 solution, indicating that red loess has a high reusability. All the above results demonstrated that red loess could be used as a possible alternative low-cost adsorbent for the removal of heavy metals from aqueous solution.     

碳酸根对磷酸钙沉淀反应回收磷的影响简

以模拟的厌氧消化液为处理对象,通过小试实验,考察不同初始磷浓度C_P、Ca/P物质的量比、pH和温度下,碳酸根（CO₃^2-）对磷酸钙沉淀反应回收磷的影响;利用扫描电镜（SEM）、X射线衍射仪（XRD）和傅里叶变换红外光谱（FTIR）对沉淀产物进行表征。结果表明,高浓度的CO₃^2-对以磷酸钙沉淀反应去除和回收磷的效率影响较大;C_P相同时,CO₃^2-浓度（C_CO3^2-）越大,P的去除率越低,低C_P（20 mg/L）时尤为显著;当C_CO3^2-相同时,随着C_P的增大,反应速率加快,P的去除率逐渐升高,但升高幅度越来越小;增大Ca/P比和pH能提高P的去除率,降低CO₃^2-对磷酸钙沉淀反应的抑制作用,综合考虑实际效果,应选择Ca/P比为3.33,pH为9.0作为适宜的反应条件;升高温度对降低CO₃^2-对磷酸钙沉淀反应的抑制作用贡献不大。在C_P为60 mg/L,Ca/P比为1.67,pH为9.0,温度为20℃的条件下,当C _CO3^2-为0时,得到的沉淀产物主要为羟基磷灰石HAP;当C _CO3^2-为30 mmol/L时,得到的沉淀产物为磷酸钙和碳酸合磷灰石的混合物。     

三维电极电催化氧化法处理废水的研究进展

综述了近几年国内外在三维电极电化学反应器方面的最新研究进展,分析了电源的输出形式、阴阳极板的布置方式、粒子电极的填充方式等因素对废水处理效果的影响,探讨了碳纳米材料等新材料在粒子电极载体上的应用,最后介绍了三维电极法与其他技术联用的最新研究,并指出了三维电极法存在的问题及今后的研究方向。     

渗滤液耦合矿化垃圾制备甲烷氧化菌菌液

利用甲烷氧化菌菌液增加材料中甲烷氧化菌的数量,可以得到高甲烷氧化率的填埋场甲烷生物氧化覆盖材料。研究发现,渗滤液原水和渗滤液处理尾水均能促进甲烷氧化菌的生长,可利用渗滤液耦合矿化垃圾混合培养制备甲烷氧化菌菌液用于填埋场甲烷减排。填埋龄长的渗滤液原水有着较好的培养效果,得到的菌液在4 d内最高甲烷氧化速率达到2.68 mL/h,超过甲烷氧化菌培养液(nitrate minimal salt medium,NMS)的实验结果。渗滤液中总氮、无机碳、总有机碳和Ni元素的含量对甲烷氧化菌的培养过程影响较大,适用于甲烷氧化培养的渗滤液应满足:总氮1 400 mg/L,总有机碳55 mg/L,Ni元素0.4 mg/L,总磷含量较高。     

污泥转移SBR工艺处理低浓度生活污水

污泥转移SBR工艺是一种通过内部污泥回流实现污泥在不同SBR隔室间转移,从而增加污泥利用效率,提高系统除污效能的新工艺。以设计规模为240 m3/d、处理低浓度生活污水的工艺系统为对象,研究了新工艺在不同泥转移量(污泥回流比)下的除污性能,并与系统以传统SBR方式运行的情况进行了对比。结果表明,新工艺可以有效提高SBR反应器的容积利用率;采用30%的污泥回流比进行污泥转移,新工艺的处理能力比传统SBR工艺提高近1/2,除磷效率从46%提升至85%。出水各项水质指标均能达到国家排放标准的要求。     

水稻与棉花秸秆不同预处理厌氧发酵产沼气

以猪粪为接种物,以棉花秸秆和水稻秸秆为发酵原料,分别对秸秆进行稀碱法预处理和稀碱法与超声波联合预处理,在发酵温度为(37±1)℃的条件下进行厌氧发酵产沼气的研究。结果表明,以联合预处理的秸秆为发酵原料,厌氧发酵的各项指标均比以稀碱预处理秸秆发酵的效果好,其中累积产气量和沼气中甲烷含量分别提高35.23%和2.4%,发酵后TS、VS含量相对减少2.6%～10.94%,发酵液代谢产物中的有机酸丙酮酸、乙酸和柠檬酸含量相对减少23.9%～25.9%、20.24%～24.53%和41.08%～45.91%。     

3种典型微生物农药对家蚕的毒性研究

苏云金芽孢杆菌、球孢白僵菌以及棉铃虫核型多角体病毒是细菌类、真菌类和病毒类微生物农药的典型代表。为了明确微生物农药对家蚕的毒性影响,选取以上3种典型微生物农药,分别探究其对家蚕的毒性。结果显示:苏云金杆菌原药对家蚕LC50值为1.33×105CFU·m L-1;球孢白僵菌原药对家蚕LC50值为1.14×106CFU·m L-1;棉铃虫核型多角体病毒母药对家蚕LC50值大于1.00×108PIB·m L-1。与此同时,通过进一步试验,明确了以上3种微生物农药对家蚕结茧率、死笼率、全茧量、茧层量等关键指标的影响。结果显示:除了棉铃虫核型多角体病毒母药,高浓度苏云金杆菌原药、球孢白僵菌原药对家蚕的结茧率和死笼率均具有显著影响;3种微生物农药对家蚕产茧能力指标全茧量、茧层量以及蛹重均无显著性影响。     

酸析法和碱析法处理草浆造纸黑液的效果对比

对比了酸析法和碱析法对碱法草浆造纸黑液中木质素的去除效果,并分析了聚合氯化铝(PAC)絮凝剂对酸析和碱析后木质素的絮凝效果。实验结果表明:酸析法和碱析法都能有效析出造纸黑液中的木质素,酸析法对色度的去除效果要优于碱析法;当造纸黑液pH为3时,COD去除率达到72.0%,色度去除率为97.7%;当造纸黑液pH为13时,COD去除率达到55.0%,色度去除率为22.3%;PAC对于酸析后木质素有较好的絮凝效果,当废水温度为55℃、PAC加入量为45mL/L时,COD去除率可以达到79.5%,色度去除率为98.5%;PAC絮凝剂对于碱析后的造纸黑液色度的去除效果较差。