基于白碳黑的水化硅酸钙制备及其磷回收特性简

以白碳黑、硅灰、硅藻土和硅胶筛选硅质原料,并与钙质原料电石渣制备了水化硅酸钙。借助XRF、BET、FTIR等表征手段,通过多次重复除磷实验,研究了硅质原料特性对水化硅酸钙回收磷性能的影响。结果表明,白碳黑具有极高的反应活性,因此可作为制备具有磷回收特性的水化硅酸钙的硅质原料。结合XRD等表征发现,白碳黑的有效利用率是影响水化硅酸钙回收磷性能的关键,该利用率取决于白碳黑与电石渣的摩尔配比以及水热反应温度。当电石渣与白碳黑的摩尔比为1.6：1,反应温度为170℃时,白碳黑具有最佳的利用效率。该条件制备的水化硅酸钙可作为晶种,在其表面结晶形成羟基磷灰石,从而达到磷回收的目的,磷回收后固体物质中的磷含量为19.05%。     

Ni2 +对活性污泥活性及群落多样性的影响简

通过检测活性污泥的电子传递体系活性以及生物多样性,研究Ni²⁺对活性污泥微生物活性及群落多样性的影响。结果表明：与对照系统相比,5 mg/L的Ni²⁺对2,3,5-triphenylteltrazolium chloride（TTC-ETS）活性未产生显著的影响;但当Ni²⁺的浓度进一步增大到10、20和40 mg/L后,其对序批式反应器内活性污泥TTC-ETS活性的抑制率分别达到（36.79±11.14）%、（55.88±13.90）%和（70.97±6.78）%。低浓度Ni²⁺能增强活性污泥微生物对碳源的利用,但高于10 mg/L的Ni²⁺则显著抑制了活性污泥微生物对碳源的利用。各个SBR系统中微生物群落最常见的物种相近,物种丰富度和均一性则均有所不同,其中群落物种丰富度随着Ni²⁺浓度的增加而逐渐减小。TTC-ETS活性、平均每孔颜色变化率、Shannon指数和Simpson指数,与Ni²⁺的胁迫浓度之间的显著相关性表明,它们均可有效地表征Ni²⁺胁迫对活性污泥微生物活性及群落多样性的影响程度。     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。     

US-UV-Fenton降解硝基苯

采用超声波(US)、紫外光(UV)和Fenton联合降解硝基苯,初步探讨了其作用规律。研究结果表明,UV可以促进双氧水转化自由基的效率,而US同时具有强化传质作用和超声氧化作用,两者均能够强化Fenton氧化硝基苯的降解过程。正交实验结果表明,H2O2初始浓度是硝基苯降解和矿化的最显著影响因素,反应时间和超声功率是矿化的显著影响因素。最佳反应条件为:H2O2500 mg/L、Fe2+10 mg/L、反应时间60 min、超声波功率100 W,此时,硝基苯完全降解,TOC去除率达到73.0%。Fenton、UV/Fenton和US/UV/Fenton降解硝基苯过程均符合伪一级反应动力学模式,反应速率常数分别为3.37×10-2、3.81×10-2和5.10×10-2min-1。     

磷石膏水热法合成硫酸钙晶须

以磷石膏为原料,二水合硫酸钙、硫酸镁、甘油为添加剂,采用水热法合成硫酸钙晶须,考察了料浆含量、反应温度、反应时间、体系pH等因素对晶须的直径和长径比的影响;并采用SEM技术观察硫酸钙晶须的形貌。实验结果表明,当磷石膏含量2.5%（w）、反应温度130 ℃、反应时间4 h、体系pH 4时,制备得到的硫酸钙晶须长径比为56.24,平均直径为0.17 μm。SEM表征结果显示,硫酸钙晶须形貌规整、分散均匀、直径较小,达百纳米级。     

Behavior and mechanism of arsenate adsorption on activated natural siderite: evidences from FTIR and XANES analysis

Activated natural siderite (ANS) was used to investigate its characteristics and mechanisms of As(V) adsorption from aqueous solution. Batch tests were carried out to determine effects of contact time, initial As(V) concentration, temperature, pH, background electrolyte, and coexisting anions on As(V) adsorption. Arsenic(V) adsorption on ANS well-fitted pseudo-second-order kinetics. ANS showed a high-adsorption capacity of 2.19 mg/g estimated from Langmuir isotherm at 25 °C. Thermodynamic studies indicated that As(V) adsorption on ANS was spontaneous, favorable, and endothermic. ANS adsorbed As(V) efficiently in a relatively wide pH range between 2.0 and 10.0, although the removal efficiency was slightly higher in acidic conditions than that in basic conditions. Effects of background electrolyte and coexisting anions were not significant within the concentration ranges observed in high As groundwater. Results of XRD and Fe K-edge XANES analysis suggested ANS acted as an Fe(II)/(III) hybrid system, which was quite effective in adsorbing As from aqueous solution. There was no As redox transformation during adsorption, although Fe(II) oxidation occurred in the system. Two infrared bands at 787 and 872 cm^?1 after As(V) adsorption suggested that As(V) should be predominantly adsorbed on ANS via inner-sphere bidendate binuclear surface complexes.     

Formation of indoor nitrous acid (HONO) by light-induced NO<Subscript>2</Subscript> heterogeneous reactions with white wall paint

Gaseous nitrogen dioxide (NO₂) represents an oxidant that is present in relatively high concentrations in various indoor settings. Remarkably increased NO₂ levels up to 1.5 ppm are associated with homes using gas stoves. The heterogeneous reactions of NO₂ with adsorbed water on surfaces lead to the generation of nitrous acid (HONO). Here, we present a HONO source induced by heterogeneous reactions of NO₂ with selected indoor paint surfaces in the presence of light (300 nm?<?λ?<?400 nm). We demonstrate that the formation of HONO is much more pronounced at elevated relative humidity. In the presence of light (5.5 W m^?2), an increase of HONO production rate of up to 8.6?·?10⁹ molecules cm^?2 s^?1 was observed at [NO₂]?=?60 ppb and 50 % relative humidity (RH). At higher light intensity of 10.6 (W m^?2), the HONO production rate increased to 2.1?·?10¹⁰ molecules cm^?2 s^?1. A high NO₂ to HONO conversion yield of up to 84 % was observed. This result strongly suggests that a light-driven process of indoor HONO production is operational. This work highlights the potential of paint surfaces to generate HONO within indoor environments by light-induced NO₂ heterogeneous reactions.     

Scanning electron microscopic investigations of root structural modifications arising from growth in crude oil-contaminated sand

The choice of plant for phytoremediation success requires knowledge of how plants respond to contaminant exposure, especially their roots which are instrumental in supporting rhizosphere activity. In this study, we investigated the responses of plants with different architectures represented by beetroot (Beta vulgaris), a eudicot with a central taproot and many narrower lateral roots, and tall fescue (Festuca arundinacea), a monocot possessing a mass of threadlike fibrous roots to grow in crude oil-treated sand. In this paper, scanning electron microscopy was used to investigate modifications to plant root structure caused by growth in crude oil-contaminated sand. Root structural disorders were evident and included enhanced thickening in the endodermis, increased width of the root cortical zone and smaller diameter of xylem vessels. Inhibition in the rate of root elongation correlated with the increase in cell wall thickening and was dramatically pronounced in beetroot compared to the roots of treated fescue. The latter possessed significantly fewer (p?<?0.001) and significantly shorter (p?<?0.001) root hairs compared to control plants. Possibly, root hairs that absorb the hydrophobic contaminants may prevent contaminant absorption into the main root and concomitant axile root thickening by being sloughed off from roots. Tall fescue exhibited greater root morphological adaptability to growth in crude oil-treated sand than beetroot and, thus, a potential for long-term phytoremediation.     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。     

竹制填料生物接触氧化工艺处理污染河水简

针对受污染的湖溪河水质特征,以传统弹性塑料填料做对比,研究以竹球和竹丝为填料的生物接触氧化工艺,考察填料的挂膜时间、生物量和污水处理效果;确定连续曝气和间歇曝气时反应器的最优运行工况：连续曝气时为HRT=7.5 h,DO=3 mg/L;间歇曝气时为厌氧1.2 h、好氧6.3 h交替运行。实验结果表明,与弹性塑料填料相比,竹制填料挂膜速度快,竹球填料的水处理效果最好;连续曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别为66.7%、47.9%、57.1%和30.6%;间歇曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别64.08%、39.95%、60.7%和54.68%;竹制填料可替代传统的塑料填料作为生物接触氧化工艺的载体填料。